Revel F226Be Review: Rated 4.6/5

Last updated: October 21, 2026

The Revel F226Be is rated 4.6/5 for sound quality, #15 of 228 Large Size Floorstanding Speakers. See all Passive Home rankings for every top pick.

Prices on this page were last checked November 18, 2026 at 8:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.

As an eBay Partner, we may be compensated if you make a purchase.

Brand: Revel

#15 Revel F226Be: $5,999.90 per pair Crutchfield $2,999.95 eBay

Older model: the Revel F206 (ranked lower, rated 4.5/5). See every Revel Performa generation.

Same family: the Revel M126Be (bookshelf, rated 4.3/5), the Revel F228Be (larger floorstanding, ranked lower, rated 4.5/5), the Revel F328Be (larger floorstanding, ranked higher, rated 4.7/5) and the Revel C426Be (center, rated 4/5).

Pros: Compact, highly accurate three way towers with a beryllium tweeter and remarkably clean drivers. A compact three-way tower with a beryllium tweeter, excellent ±1.5dB on-axis linearity and a 5.96 preference score. The beryllium dome sits in an acoustic lens waveguide above a dedicated 5.25” mid-range and dual 6.5” woofers (not a coaxial layout), all Deep Ceramic Composite aluminum cones engineered specifically to avoid breakup outside their crossover bands. It measures that way: neither the woofers nor the mid-range show breakup spikes even well outside their intended pass bands, and even the front port measures unusually clean (only a mild ~3dB bump around 150Hz, well controlled versus the resonances the reviewer typically sees from ports). On-axis response holds within about ±1.5dB above roughly 65Hz and off-axis behavior tracks it closely, with only mild, subdued peaking around 4-6kHz that doesn’t show up as real resonance in the spinorama data. Average sensitivity around 90dB (2.83V/1m), notably higher than some competing three-way designs and most bookshelf speakers, translating directly into better dynamic range at both low and high listening levels: one reviewer specifically praised its ability to deliver full transient impact (snare hits, kick drum) even at quiet, conversational volumes rather than needing to be cranked up to feel dynamic. Wide, consistent horizontal radiation of about ±60-70° at the -6dB point, landing right in the reviewer’s preferred range for an enveloping soundstage without excess diffusion, and exceptionally wide vertical dispersion: roughly ±80° up to 10kHz and still ±70° above that, which one reviewer called the widest vertical radiation pattern he had measured to date. Distortion stays under 3% even at 104dB SPL, and in real-world testing up to 105dB from 12-14 feet away, full-range with no crossover, the reviewer heard no audible mechanical noise, port chuffing, or compression at all. Flat enough on- and off-axis response that toeing the speaker 10-15° away from the listener preserves the same tonal balance rather than changing it, and the wide, well-controlled directivity lets sidewall reflections reinforce rather than smear the soundstage. Measured bass extension of 56Hz (-3dB), with a measured sensitivity of 89.7dB.

Cons: Minimum impedance dips to about 3.7-4 ohms below roughly 500Hz despite the 8-ohm nominal rating, so it wants a genuine 4-ohm-capable two-channel amplifier; budget AVRs rated only for 6 or 8 ohms may struggle. F3 of 56Hz and F10 of 36Hz mean it doesn’t extend nearly as low as some three-way rivals with larger woofers: a dedicated subwoofer (10-12”, or 15” for content below 30Hz) is recommended for home theater or bass-heavy music, even though the speaker itself can play surprisingly loud without one. Vertical directivity tolerance is tighter in the crossover handoff region than a true coaxial design would offer, since the tweeter, midrange, and woofers are physically separated: a mild directivity bump appears around 2-2.5kHz that’s typical of non-coaxial multi-way speakers, though not audibly problematic within about ±10° vertically. On-axis, the top end reads as a bit bright according to one reviewer’s subjective impression, generally benefiting from some toe-out. High-gloss cabinet finish can create distracting reflections if used behind a projector screen in a home theater setup. Front-ported, so it can technically sit close to a wall, but doing so makes the bass boomier.

Is the Revel F226Be right for you?

Buy it if

  • you want measurably neutral sound (preference score 8.2 with a subwoofer).

Skip it if

  • you need to move it often (26 kg each).
ReleasedJan 2020 (6 years ago)
Bass Extension (-10dB)36Hz (measured, Erin’s Audio Corner)
Bass Extension (-3dB)56Hz (measured, Erin’s Audio Corner)
DIY KitNo
Dimensions41.3”H x 9.8”W x 13.7”D (1049 x 248.9 x 348 mm)
DriversTwo 6.5” (165mm) Deep Ceramic Composite aluminum cones, with cast frames woofer, 5-1/4” (130mm) Deep Ceramic Composite aluminum cone, with cast frame midrange, 1” (25mm) Beryllium dome, with acoustic lens waveguide tweeter
Impedance8 ohms nominal (3.7 ohms minimum, measured, Erin’s Audio Corner)
Sensitivity89.7dB (measured, Erin’s Audio Corner)
Spinorama Preference Score5.96 (spinorama.org)
Spinorama Preference Score with Perfect Sub8.15 (spinorama.org)
Weight58.2 lbs (26.4 kg) each
Woofer Cabinetported, front

Price history (per pair)

$5,999.90$15,400Jul 29, 2026 to Nov 11, 2026: $15,400Jul 2026Nov 2026

$5,999.90 is the lowest price we have tracked since Jul 2026.

Head-to-Head Comparisons

51 comparisons

More Revel speakers →