The Revel M126Be ranks #31 out of 105 total Large Size Bookshelf Speakers for sound quality. See Top Recommended Speakers By Attribute for all the top speaker suggestions.
Brand: Revel
Prices on this page were last checked August 22, 2026 at 5:11 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
#31 Revel M126Be: $4400 Crutchfield eBay
Pros: Two-way design pairing a 6.5” midwoofer with a 1” beryllium dome tweeter, the smaller sibling to the reviewer’s favorite Revel F226Be. Wide, immersive stereo imaging - hard-panned sounds in test tracks localized 2-3 feet outside the physical speaker positions without losing pinpoint precision. Horizontal radiation of about 60-70°, landing right in the reviewer’s preferred range for an enveloping yet still well-focused soundstage. Extended bass-shelf tuning (similar in concept to the KEF R3 Meta) combines with in-room gain for a more linear low end rather than a boomy hump. Diffraction dips visible on-axis around 3kHz and 7kHz largely disappear in the estimated in-room response, since they fill in as you move off-axis. Distortion stays within 3% down to about 100Hz at both 86dB and 96dB output - strong performance for a 6.5” bookshelf woofer. Can be driven by a standard AVR thanks to a manageable 4.9-ohm minimum impedance.
Cons: At $4,400/pair, the reviewer doesn’t consider it a strong value - an improvement over Revel’s less expensive M106 and Performa3 models, but not proportional to the price jump. Bass tops out around 50Hz in-room; a subwoofer is still needed for real low-end extension. Vertical placement is fairly critical - there’s a notable hole in the response around the 1.7kHz crossover if you sit above the tweeter axis. Toeing the speaker out to a full 30° introduces a roughly 1dB discontinuity in the midrange along with high-frequency rolloff; the reviewer recommends staying close to on-axis or within about 10°. An unexplained jump in distortion appears right at the 1.7kHz crossover point under compression testing, which may be linked to an occasional “glaring” quality the reviewer noticed in the 2-3kHz region at very high volumes (92-93dB from 2 meters). A mild 2-3kHz forwardness occasionally stood out on some tracks, correctable with about 1dB of EQ, though the reviewer considers it minor.
How it compares: Just above it: Ascend Acoustics Sierra-LX - $2802 cheaper, 5.1Hz lower bass extension (-3dB). Just below it: ELAC VELA BS 403 - $1501 cheaper, 1.8Hz lower bass extension (-3dB).
| Bass Extension (-10dB) | 44Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 103Hz (measured, Erin's Audio Corner) |
| Dimensions | 15.2"H x 8.3"W x 10.3"D (386.1 x 210.8 x 261.6 mm) |
| Drivers | 6.5" Deep Ceramic Composite (DCC) Aluminum Cone with cast frame woofer, 1" Beryllium dome with acoustic lens waveguide tweeter |
| Impedance | 6 ohms nominal (4.9 ohms minimum, measured, Erin's Audio Corner) |
| Sensitivity | 86.1dB (measured, Erin's Audio Corner) |
| Weight | 22 lbs / 10.0 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Revel M126Be vs ELAC VELA BS 403
- Revel M126Be vs Wharfedale Linton 85
- Revel M126Be vs Selah Audio Purezza
- Revel M126Be vs Emotiva Airmotiv XB2
- Revel M126Be vs Dynaudio Heritage Special
- Revel M126Be vs Radiant Acoustics Clarity 6.2
- Revel M126Be vs ELAC Debut 3.0 DB63
- Revel M126Be vs JBL HDI-1600
- Revel M126Be vs Wharfedale Super Linton
- Revel M126Be vs Revel Concerta2 M16
- Revel M126Be vs JTR Noesis 210HT
- Revel M126Be vs Yamaha NS-800A