Revel Concerta2 F35 Review: Ranked #28 of 139

Last updated: October 5, 2026

The Revel Concerta2 F35 ranks #28 out of 139 total Large Size Floorstanding Speakers for sound quality. See all Passive Home rankings for every top pick.

Brand: Revel

Prices on this page were last checked October 5, 2026 at 10:21 PM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.

As an eBay Partner, we may be compensated if you make a purchase.

#28 Revel Concerta2 F35: $900 per pair Crutchfield eBay

Smaller model: the Revel Concerta2 M16 (rated 4.1/5).

Larger model: the Revel Concerta2 F36 (ranked higher, estimated 4.6/5).

Pros: Two-and-a-half-way, four-driver design: a 1” aluminum dome tweeter on a waveguide, a 5.25” mid-range, and dual 5.25” mid-bass drivers in a rear-ported cabinet. Measured sensitivity of 89.4dB closely matches the 90dB spec, and distortion looks good at both 86dB and 96dB, holding up well even with a high-pass filter applied. At its sale price of $900/pair, down from full retail, the reviewer calls it a “no-brainer,” undercutting comparable budget floorstanders like the ELAC DF63. Frequency response and directivity mismatches are largely EQ-able, since most of what shows up in measurements traces to physical tweeter/mid-range separation rather than a fundamental flaw. Compression is fairly well controlled for the price: about 1dB of loss around 100Hz under long-term compression, described as “par for the course” at this cost. Measured bass extension of 70Hz (-3dB), with a measured sensitivity of 89.4dB.

Cons: F3 of 61Hz and F10 of 39Hz mean a subwoofer is needed for real bass extension. A dip in the lower midrange/2-3kHz region reduces attack and detail, and a peak around 5kHz adds some edge and sibilance in the lower treble. A peak in off-axis energy around 3kHz reflects off sidewalls at roughly 60-70° off-axis and arrives louder than the direct sound: this specific issue can’t be fixed with EQ (boosting the direct sound would boost the stronger reflection too) and would need acoustic absorption to properly address, though the reviewer considers it a minor, optional fix at this price. A couple of minor resonances appear in the impedance plot, including one around 300Hz that may partly explain a subtle sense of vocal warmth noticed in listening, though it’s more likely room-related. Minimum impedance around 3.8 ohms. Short-term compression testing shows some increased distortion in the tweeter and higher-frequency compression at loud output.

How it compares: Just above it: Revel F206 - $1100 more, 2.4Hz lower bass extension (-3dB). Just below it: Perlisten S7t - $21090 more, 2.8Hz higher bass extension (-3dB).

Bass Extension (-10dB)50Hz (measured, Erin’s Audio Corner)
Bass Extension (-3dB)70Hz (measured, Erin’s Audio Corner)
DIY KitNo
Dimensions40.3”H x 8.4”W x 12.2”D (1023.6 x 213.4 x 309.9 mm)
Drivers3x 5.25” deep anodized aluminum cone woofers, 1” Aluminum Tweeter
Impedance6 ohms nominal (3.8 ohms minimum, measured by Erin’s Audio Corner)
Sensitivity89.4dB (measured, Erin’s Audio Corner; 90dB manufacturer specified)
Spinorama Preference Score5.35
Spinorama Preference Score with Perfect Sub7.30
Weight41 lbs (18.6 kg) each
Woofer Cabinetported, rear

Head-to-Head Comparisons

56 comparisons

More Revel speakers →