Revel Concerta2 F35 vs Bose 901 Series V

Last updated: August 24, 2026

Short answer: the Revel Concerta2 F35. It ranks #23 of 68 floorstanding speakers by sound quality; the Bose 901 Series V ranks #68.

What the Revel Concerta2 F35 offers: Two-and-a-half-way, four-driver design: a 1” aluminum dome tweeter on a waveguide, a 5.25” mid-range, and dual 5.25” mid-bass drivers in a rear-ported cabinet. Measured sensitivity of 89.4dB closely matches the 90dB spec, and distortion looks good at both 86dB and 96dB, holding up well even with a high-pass filter applied. At its sale price (around $900/pair, down from full retail), the reviewer calls it a “no-brainer,” undercutting comparable budget floorstanders like the ELAC DF63. Frequency response and directivity mismatches are largely EQ-able, since most of what shows up in measurements traces to physical tweeter/mid-range separation rather than a fundamental flaw. Compression is fairly well controlled for the price - about 1dB of loss around 100Hz under long-term compression, described as “par for the course” at this cost. Watch for: F3 of 61Hz and F10 of 39Hz mean a subwoofer is needed for real bass extension. A dip in the lower midrange/2-3kHz region reduces attack and detail, and a peak around 5kHz adds some edge and sibilance in the lower treble. A peak in off-axis energy around 3kHz reflects off sidewalls at roughly 60-70° off-axis and arrives louder than the direct sound - this specific issue can’t be fixed with EQ (boosting the direct sound would boost the stronger reflection too) and would need acoustic absorption to properly address, though the reviewer considers it a minor, optional fix at this price. A couple of minor resonances appear in the impedance plot, including one around 300Hz that may partly explain a subtle sense of vocal warmth noticed in listening, though it’s more likely room-related. Minimum impedance around 3.8 ohms. Short-term compression testing shows some increased distortion in the tweeter and higher-frequency compression at loud output.

What the Bose 901 Series V offers: Historically distinctive direct/reflecting architecture uses eight rear-firing and one front-firing full-range drivers to create a very large, room-filling presentation. Erin measured a benign 6.2-ohm minimum impedance, so the raw electrical load is easier than many modern four-ohm speakers. The supplied active equalizer offers user-adjustable tonal balance and is integral to obtaining usable bandwidth. Watch for: Even with the required EQ, Erin measured only about 81dB sensitivity, grossly non-flat response, numerous impedance/resonance irregularities and very high distortion. Output above roughly 90-95dB at his seat became audibly poor; multitone testing reached only about 98dB before the distortion limit. The reflection-dominant radiation prevents precise imaging and makes results strongly room-dependent. It requires the proprietary equalizer and substantial amplifier power despite its benign impedance.

Buy the Revel Concerta2 F35 if sound quality matters more than the price. Buy the Bose 901 Series V if the price matters more than sound quality.

If sound quality matters at all to you, skip the Bose 901 Series V. It ranks near the bottom of the 68 floorstanding speakers, so look higher up the list instead.

Revel Concerta2 F35 vs Bose 901 Series V

Specifications Side By Side

Revel Concerta2 F35 Bose 901 Series V
Price$900Used availability Discontinued
Ranked#23 of 68 in Large Size Floorstanding Speakers#68 of 68 in Large Size Floorstanding Speakers
Bass Extension (-10dB)50Hz (measured, Erin’s Audio Corner)34.5Hz (measured, Erin’s Audio Corner)
Bass Extension (-3dB)70Hz (measured, Erin’s Audio Corner)55.8Hz (measured, Erin’s Audio Corner)
Dimensions40.3"H x 8.4"W x 12.2"D (1023.6 x 213.4 x 309.9 mm)-
Impedance6 ohms nominal (3.8 ohms minimum, measured by Erin’s Audio Corner)6.2 ohms minimum (measured, Erin’s Audio Corner)
Sensitivity89.4dB (measured, Erin’s Audio Corner; 90dB manufacturer specified)Approximately 81dB/2.83V/1m with tested EQ setting (measured, Erin’s Audio Corner)
Drivers3x 5.25" deep anodized aluminum cone woofers, 1" Aluminum TweeterNine full-range drivers: eight rear-firing, one front-firing
Weight41 lbs / 18.6 kg each-
Woofer Cabinetported, rear-
Bass Extension-Strongly dependent on supplied active equalizer and room (measured, Erin’s Audio Corner)
Discontinued-Yes
DSP-External analog active equalizer required

More useful head-to-heads from the same speaker class:

Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.

As an eBay Partner, we may be compensated if you make a purchase.

The Two Speakers In Full

Revel Concerta2 F35: $900 Crutchfield eBay

Revel Concerta2 F35 ranking card

Pros: Two-and-a-half-way, four-driver design: a 1” aluminum dome tweeter on a waveguide, a 5.25” mid-range, and dual 5.25” mid-bass drivers in a rear-ported cabinet. Measured sensitivity of 89.4dB closely matches the 90dB spec, and distortion looks good at both 86dB and 96dB, holding up well even with a high-pass filter applied. At its sale price (around $900/pair, down from full retail), the reviewer calls it a “no-brainer,” undercutting comparable budget floorstanders like the ELAC DF63. Frequency response and directivity mismatches are largely EQ-able, since most of what shows up in measurements traces to physical tweeter/mid-range separation rather than a fundamental flaw. Compression is fairly well controlled for the price - about 1dB of loss around 100Hz under long-term compression, described as “par for the course” at this cost.

Cons: F3 of 61Hz and F10 of 39Hz mean a subwoofer is needed for real bass extension. A dip in the lower midrange/2-3kHz region reduces attack and detail, and a peak around 5kHz adds some edge and sibilance in the lower treble. A peak in off-axis energy around 3kHz reflects off sidewalls at roughly 60-70° off-axis and arrives louder than the direct sound - this specific issue can’t be fixed with EQ (boosting the direct sound would boost the stronger reflection too) and would need acoustic absorption to properly address, though the reviewer considers it a minor, optional fix at this price. A couple of minor resonances appear in the impedance plot, including one around 300Hz that may partly explain a subtle sense of vocal warmth noticed in listening, though it’s more likely room-related. Minimum impedance around 3.8 ohms. Short-term compression testing shows some increased distortion in the tweeter and higher-frequency compression at loud output.

Bass Extension (-10dB)50Hz (measured, Erin's Audio Corner)
Bass Extension (-3dB)70Hz (measured, Erin's Audio Corner)
Dimensions40.3"H x 8.4"W x 12.2"D (1023.6 x 213.4 x 309.9 mm)
Drivers3x 5.25" deep anodized aluminum cone woofers, 1" Aluminum Tweeter
Impedance6 ohms nominal (3.8 ohms minimum, measured by Erin's Audio Corner)
Sensitivity89.4dB (measured, Erin's Audio Corner; 90dB manufacturer specified)
Weight41 lbs / 18.6 kg each
Woofer Cabinetported, rear

Bose 901 Series V: Used availability Discontinued Amazon eBay

Bose 901 Series V ranking card

Pros: Historically distinctive direct/reflecting architecture uses eight rear-firing and one front-firing full-range drivers to create a very large, room-filling presentation. Erin measured a benign 6.2-ohm minimum impedance, so the raw electrical load is easier than many modern four-ohm speakers. The supplied active equalizer offers user-adjustable tonal balance and is integral to obtaining usable bandwidth.

Cons: Even with the required EQ, Erin measured only about 81dB sensitivity, grossly non-flat response, numerous impedance/resonance irregularities and very high distortion. Output above roughly 90-95dB at his seat became audibly poor; multitone testing reached only about 98dB before the distortion limit. The reflection-dominant radiation prevents precise imaging and makes results strongly room-dependent. It requires the proprietary equalizer and substantial amplifier power despite its benign impedance. Discontinued.

Bass ExtensionStrongly dependent on supplied active equalizer and room (measured, Erin's Audio Corner)
Bass Extension (-10dB)34.5Hz (measured, Erin's Audio Corner)
Bass Extension (-3dB)55.8Hz (measured, Erin's Audio Corner)
DSPExternal analog active equalizer required
DiscontinuedYes
DriversNine full-range drivers: eight rear-firing, one front-firing
Impedance6.2 ohms minimum (measured, Erin's Audio Corner)
SensitivityApproximately 81dB/2.83V/1m with tested EQ setting (measured, Erin's Audio Corner)