Short answer: the Revel Concerta2 F35. It ranks #23 of 71 floorstanding speakers by sound quality at $900; the Perlisten S7t ranks #24 and costs $21990, so there is little reason to consider the other one.
What the Perlisten S7t offers: Measures a genuine -3dB extension point of 56.4Hz and a Harman-style -6dB in-room extension of 45Hz, with a strong 0.80 listening-window smoothness score and a mild, slightly warm on-axis tonal tilt (-0.13dB per octave) rather than a bright or forward balance. It was the first speaker in Perlisten’s S-Series to earn THX Dominus certification, and independent reviewers took notice: Audioholics called it one of the finest loudspeakers it has ever reviewed, with Stereophile, Hi-Fi News and The Absolute Sound all adding favorable coverage. Watch for: On-axis deviation of 0.178dB and a directivity-index standard deviation of 3.16 are solid without being exceptional, and a bass-alignment Q of 3.41 suggests a somewhat resonant, less tightly damped low-frequency rolloff. Pricing runs $19,990 to $23,990/pair depending on finish and dealer, since Perlisten has no fixed published MSRP and sells only through specialty AV dealers rather than mainstream retail.
What the Revel Concerta2 F35 offers: Two-and-a-half-way, four-driver design: a 1” aluminum dome tweeter on a waveguide, a 5.25” mid-range, and dual 5.25” mid-bass drivers in a rear-ported cabinet. Measured sensitivity of 89.4dB closely matches the 90dB spec, and distortion looks good at both 86dB and 96dB, holding up well even with a high-pass filter applied. At its sale price (around $900/pair, down from full retail), the reviewer calls it a “no-brainer,” undercutting comparable budget floorstanders like the ELAC DF63. Frequency response and directivity mismatches are largely EQ-able, since most of what shows up in measurements traces to physical tweeter/mid-range separation rather than a fundamental flaw. Compression is fairly well controlled for the price - about 1dB of loss around 100Hz under long-term compression, described as “par for the course” at this cost. Watch for: F3 of 61Hz and F10 of 39Hz mean a subwoofer is needed for real bass extension. A dip in the lower midrange/2-3kHz region reduces attack and detail, and a peak around 5kHz adds some edge and sibilance in the lower treble. A peak in off-axis energy around 3kHz reflects off sidewalls at roughly 60-70° off-axis and arrives louder than the direct sound - this specific issue can’t be fixed with EQ (boosting the direct sound would boost the stronger reflection too) and would need acoustic absorption to properly address, though the reviewer considers it a minor, optional fix at this price. A couple of minor resonances appear in the impedance plot, including one around 300Hz that may partly explain a subtle sense of vocal warmth noticed in listening, though it’s more likely room-related. Minimum impedance around 3.8 ohms. Short-term compression testing shows some increased distortion in the tweeter and higher-frequency compression at loud output.
Buy the Revel Concerta2 F35. It ranks higher for sound quality than the Perlisten S7t and costs less, so there is no real case for the other one.
Specifications Side By Side
| Perlisten S7t | Revel Concerta2 F35 | |
|---|---|---|
| Price | $21,990/pair | $900 |
| Ranked | #24 of 71 in Large Size Floorstanding Speakers | #23 of 71 in Large Size Floorstanding Speakers |
| Enclosure | 4-way, switchable bass reflex / acoustic suspension | - |
| Drivers | 28mm beryllium dome tweeter, 2x 28mm Textreme TPCD dome midranges, 4x 180mm (7") Textreme TPCD woofers | 3x 5.25" deep anodized aluminum cone woofers, 1" Aluminum Tweeter |
| Dimensions | 51"H x 9.4"W x 15.7"D (1295 x 240 x 400 mm) (51.0 x 9.5 x 15.7 in) | 40.3"H x 8.4"W x 12.2"D (1023.6 x 213.4 x 309.9 mm) |
| Weight | 122.8 lbs / 55.7 kg (122.5 lbs) each | 41 lbs / 18.6 kg each |
| Sensitivity | 92.2dB @ 2.83V/1m | 89.4dB (measured, Erin’s Audio Corner; 90dB manufacturer specified) |
| Impedance | 4 ohms nominal, 3.2 ohms minimum | 6 ohms nominal (3.8 ohms minimum, measured by Erin’s Audio Corner) |
| Power Handling | 100-600W RMS recommended amplifier power | - |
| Frequency Response | 80Hz-20kHz +/-1.5dB | - |
| Bass Extension (-10dB) | 22Hz (bass reflex) / 32Hz (acoustic suspension) | 50Hz (measured, Erin’s Audio Corner) |
| Max SPL | 117dB peak | - |
| Certification | THX Dominus | - |
| Warranty | 5 years, extendable to 6 with product registration | - |
| Country | Designed in the United States (Verona, Wisconsin) | - |
| Bass Extension (-3dB) | - | 70Hz (measured, Erin’s Audio Corner) |
| Woofer Cabinet | - | ported, rear |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- JBL 4367 vs Revel F206
- Revel F206 vs KEF Blade Two Meta
- Revel F328Be vs Revel F206
- Perlisten R5t vs Perlisten S7t
- KEF Blade Two Meta vs Revel Concerta2 F35
Prices on this page were last checked September 8, 2026 at 6:02 PM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Perlisten S7t: $21,990/pair The Music Room eBay
Pros: Measures a genuine -3dB extension point of 56.4Hz and a Harman-style -6dB in-room extension of 45Hz, with a strong 0.80 listening-window smoothness score and a mild, slightly warm on-axis tonal tilt (-0.13dB per octave) rather than a bright or forward balance. It was the first speaker in Perlisten’s S-Series to earn THX Dominus certification, and independent reviewers took notice: Audioholics called it one of the finest loudspeakers it has ever reviewed, with Stereophile, Hi-Fi News and The Absolute Sound all adding favorable coverage.
Cons: On-axis deviation of 0.178dB and a directivity-index standard deviation of 3.16 are solid without being exceptional, and a bass-alignment Q of 3.41 suggests a somewhat resonant, less tightly damped low-frequency rolloff. Pricing runs $19,990 to $23,990/pair depending on finish and dealer, since Perlisten has no fixed published MSRP and sells only through specialty AV dealers rather than mainstream retail.
Full Perlisten S7t review and specifications →
| Bass Extension (-10dB) | 22Hz (bass reflex) / 32Hz (acoustic suspension) |
|---|---|
| Certification | THX Dominus |
| Country | Designed in the United States (Verona, Wisconsin) |
| Dimensions | 51"H x 9.4"W x 15.7"D (1295 x 240 x 400 mm) (51.0 x 9.5 x 15.7 in) |
| Drivers | 28mm beryllium dome tweeter, 2x 28mm Textreme TPCD dome midranges, 4x 180mm (7") Textreme TPCD woofers |
| Enclosure | 4-way, switchable bass reflex / acoustic suspension |
| Frequency Response | 80Hz-20kHz +/-1.5dB |
| Impedance | 4 ohms nominal, 3.2 ohms minimum |
| Max SPL | 117dB peak |
| Power Handling | 100-600W RMS recommended amplifier power |
| Sensitivity | 92.2dB @ 2.83V/1m |
| Warranty | 5 years, extendable to 6 with product registration |
| Weight | 122.8 lbs / 55.7 kg (122.5 lbs) each |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
Revel Concerta2 F35: $900 Crutchfield eBay
Pros: Two-and-a-half-way, four-driver design: a 1” aluminum dome tweeter on a waveguide, a 5.25” mid-range, and dual 5.25” mid-bass drivers in a rear-ported cabinet. Measured sensitivity of 89.4dB closely matches the 90dB spec, and distortion looks good at both 86dB and 96dB, holding up well even with a high-pass filter applied. At its sale price (around $900/pair, down from full retail), the reviewer calls it a “no-brainer,” undercutting comparable budget floorstanders like the ELAC DF63. Frequency response and directivity mismatches are largely EQ-able, since most of what shows up in measurements traces to physical tweeter/mid-range separation rather than a fundamental flaw. Compression is fairly well controlled for the price - about 1dB of loss around 100Hz under long-term compression, described as “par for the course” at this cost.
Cons: F3 of 61Hz and F10 of 39Hz mean a subwoofer is needed for real bass extension. A dip in the lower midrange/2-3kHz region reduces attack and detail, and a peak around 5kHz adds some edge and sibilance in the lower treble. A peak in off-axis energy around 3kHz reflects off sidewalls at roughly 60-70° off-axis and arrives louder than the direct sound - this specific issue can’t be fixed with EQ (boosting the direct sound would boost the stronger reflection too) and would need acoustic absorption to properly address, though the reviewer considers it a minor, optional fix at this price. A couple of minor resonances appear in the impedance plot, including one around 300Hz that may partly explain a subtle sense of vocal warmth noticed in listening, though it’s more likely room-related. Minimum impedance around 3.8 ohms. Short-term compression testing shows some increased distortion in the tweeter and higher-frequency compression at loud output.
Full Revel Concerta2 F35 review and specifications →
| Bass Extension (-10dB) | 50Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 70Hz (measured, Erin's Audio Corner) |
| Dimensions | 40.3"H x 8.4"W x 12.2"D (1023.6 x 213.4 x 309.9 mm) |
| Drivers | 3x 5.25" deep anodized aluminum cone woofers, 1" Aluminum Tweeter |
| Impedance | 6 ohms nominal (3.8 ohms minimum, measured by Erin's Audio Corner) |
| Sensitivity | 89.4dB (measured, Erin's Audio Corner; 90dB manufacturer specified) |
| Weight | 41 lbs / 18.6 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Revel Concerta2 F35 vs Revel F206
- Revel Concerta2 F35 vs JBL Studio 698
- Revel Concerta2 F35 vs KEF R11 Meta
- Revel Concerta2 F35 vs Arendal 1961 Tower
- Revel Concerta2 F35 vs JBL HDI-3600
- Revel Concerta2 F35 vs Emotiva Airmotiv T2+
- Revel Concerta2 F35 vs Revel F228Be
- Revel Concerta2 F35 vs Revel F208
- See all 55 comparisons