Short answer: the JBL HDI-1600 for better sound quality, the Dynaudio Emit 20 for the lower price. The JBL HDI-1600 ranks #44 of 131 bookshelf speakers at $1980. The Dynaudio Emit 20 ranks #76 at $1049, $931 cheaper.
What the Dynaudio Emit 20 offers: Two-way design with a 28mm Esotar soft dome tweeter (Hexis-damped) and an 18cm mid-woofer, using a first-order crossover on the tweeter and second-order on the woofer. Exceptional bass extension for a bookshelf speaker - reaches a clean, authoritative 40Hz in-room, rare enough that the reviewer says most listeners could skip a subwoofer for typical music. Very low distortion across the board, staying below 1% THD down to 40Hz at 86dB and below 3% even at 96dB - unusually clean bass performance where most two-way bookshelf speakers start rising in distortion around 80Hz. Wide, remarkably consistent horizontal directivity (about ±50-60°) that holds steady up to roughly 13kHz - rare for a speaker in this format, thanks to a beveled tweeter edge that acts as a mild waveguide. Excellent compression and dynamic-range linearity at the frequency extremes, actually showing slight bass enhancement rather than the sharp low-end compression common in similarly-sized bookshelf speakers. Watch for: A resonance around 600-800Hz gives snares and similar percussion a muffled, flat quality lacking impact - confirmed as originating in the woofer itself (isolated via measurements of the raw driver out of the cabinet), and attempts at constrained-layer damping didn’t resolve it. A peak around 4kHz adds a sharp, edgy quality to some male vocals. A roughly 5dB boost above 10kHz gives cymbals and hi-hats excess shimmer that can sound unnatural, especially pointed directly on-axis. Vertical dispersion shows two separate crossover-related notches (above and below the tweeter reference line around 5kHz) rather than the usual single one, a direct consequence of the shallow crossover slopes used on both drivers. Multitone distortion is elevated in the midrange, possibly due to the woofer’s magnet structure lacking a shorting ring. Best aimed slightly off-axis (about 10-15° of toe-out) to tame the excess high-frequency shimmer, rather than pointed straight at the listener.
What the JBL HDI-1600 offers: CEA2034 spinorama is very flat in the critical mid-to-upper frequencies, with a slight bass boost that should have a good subjective effect and very smooth early-window directivity. Predicted in-room response in a simulated average listening room closely tracks the reviewer’s own preferred target curve. Watch for: A dip appears above 10kHz on-axis. Cumulative spectral decay (waterfall) shows some messiness around the crossover along with a 700Hz resonance. Harmonic distortion rises to nearly 2% right at the 1.9kHz crossover point at 96dB SPL/1m.
Buy the Dynaudio Emit 20 if the price matters more than sound quality. Buy the JBL HDI-1600 if sound quality matters more than the price.
Specifications Side By Side
| Dynaudio Emit 20 | JBL HDI-1600 | |
|---|---|---|
| Price | $1,049.00 | $1980 Discontinued |
| Ranked | #76 of 131 in Large Size Bookshelf Speakers | #44 of 131 in Large Size Bookshelf Speakers |
| Bass Extension (-10dB) | 33Hz (measured, Erin’s Audio Corner) | 55Hz (measured, Audio Science Review) |
| Bass Extension (-3dB) | 54Hz (measured, Erin’s Audio Corner) | 70Hz (measured, Audio Science Review) |
| Drivers | 7.1" Magnesium Silicate Polymer woofer, 1.1" Cerotar soft dome with Hexis tweeter | 1" tweeter + 6.5" woofer |
| Weight | 12.8 lbs / 5.8 kg | 53.4 lbs / 24.2 kg |
| Sensitivity | 83.5dB (measured, Erin’s Audio Corner; 86dB manufacturer specified) | 85dB (2.83V/1m, measured, Audio Science Review) |
| Impedance | 6 ohms nominal (5.5 ohms minimum above 80Hz, measured, Erin’s Audio Corner) | 4 ohms nominal (measured, Audio Science Review) |
| Dimensions | 14.6"H x 8.1"W x 12.3"D (370.0 x 205.0 x 312.0 mm) | 14.6"H x 9.1"W x 11.4"D (370.0 x 230.0 x 288.9 mm) |
| Woofer Cabinet | ported, rear | ported, rear |
| Discontinued | - | Yes |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Klipsch RP-600M II vs B&W 805S
- KEF R3 Meta vs Klipsch RP-600M II
- Klipsch RP-600M II vs Wharfedale Super Linton
- Dynaudio Emit 20 vs Sonus Faber Lumina II Amator
- JBL HDI-1600 vs Definitive Technology Demand D11
Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Dynaudio Emit 20: $1,049.00 Amazon eBay
Pros: Two-way design with a 28mm Esotar soft dome tweeter (Hexis-damped) and an 18cm mid-woofer, using a first-order crossover on the tweeter and second-order on the woofer. Exceptional bass extension for a bookshelf speaker - reaches a clean, authoritative 40Hz in-room, rare enough that the reviewer says most listeners could skip a subwoofer for typical music. Very low distortion across the board, staying below 1% THD down to 40Hz at 86dB and below 3% even at 96dB - unusually clean bass performance where most two-way bookshelf speakers start rising in distortion around 80Hz. Wide, remarkably consistent horizontal directivity (about ±50-60°) that holds steady up to roughly 13kHz - rare for a speaker in this format, thanks to a beveled tweeter edge that acts as a mild waveguide. Excellent compression and dynamic-range linearity at the frequency extremes, actually showing slight bass enhancement rather than the sharp low-end compression common in similarly-sized bookshelf speakers.
Cons: A resonance around 600-800Hz gives snares and similar percussion a muffled, flat quality lacking impact - confirmed as originating in the woofer itself (isolated via measurements of the raw driver out of the cabinet), and attempts at constrained-layer damping didn’t resolve it. A peak around 4kHz adds a sharp, edgy quality to some male vocals. A roughly 5dB boost above 10kHz gives cymbals and hi-hats excess shimmer that can sound unnatural, especially pointed directly on-axis. Vertical dispersion shows two separate crossover-related notches (above and below the tweeter reference line around 5kHz) rather than the usual single one, a direct consequence of the shallow crossover slopes used on both drivers. Multitone distortion is elevated in the midrange, possibly due to the woofer’s magnet structure lacking a shorting ring. Best aimed slightly off-axis (about 10-15° of toe-out) to tame the excess high-frequency shimmer, rather than pointed straight at the listener.
Full Dynaudio Emit 20 review and specifications →
| Bass Extension (-10dB) | 33Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 54Hz (measured, Erin's Audio Corner) |
| Dimensions | 14.6"H x 8.1"W x 12.3"D (370.0 x 205.0 x 312.0 mm) |
| Drivers | 7.1" Magnesium Silicate Polymer woofer, 1.1" Cerotar soft dome with Hexis tweeter |
| Impedance | 6 ohms nominal (5.5 ohms minimum above 80Hz, measured, Erin's Audio Corner) |
| Sensitivity | 83.5dB (measured, Erin's Audio Corner; 86dB manufacturer specified) |
| Weight | 12.8 lbs / 5.8 kg |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Dynaudio Emit 20 vs Klipsch RP-600M II
- Dynaudio Emit 20 vs JBL Studio 630
- Dynaudio Emit 20 vs Behringer B2030P
- Dynaudio Emit 20 vs Infinity IL10
- Dynaudio Emit 20 vs Infinity Reference R162
- Dynaudio Emit 20 vs Dynaudio Special Forty
- Dynaudio Emit 20 vs ELAC Debut 2.0 B6.2
- Dynaudio Emit 20 vs SVS Prime Bookshelf
- See all 35 comparisons
JBL HDI-1600: $1980 Discontinued Crutchfield eBay
Pros: CEA2034 spinorama is very flat in the critical mid-to-upper frequencies, with a slight bass boost that should have a good subjective effect and very smooth early-window directivity. Predicted in-room response in a simulated average listening room closely tracks the reviewer’s own preferred target curve.
Cons: A dip appears above 10kHz on-axis. Cumulative spectral decay (waterfall) shows some messiness around the crossover along with a 700Hz resonance. Harmonic distortion rises to nearly 2% right at the 1.9kHz crossover point at 96dB SPL/1m. Discontinued.
Full JBL HDI-1600 review and specifications →
| Bass Extension (-10dB) | 55Hz (measured, Audio Science Review) |
|---|---|
| Bass Extension (-3dB) | 70Hz (measured, Audio Science Review) |
| Dimensions | 14.6"H x 9.1"W x 11.4"D (370.0 x 230.0 x 288.9 mm) |
| Discontinued | Yes |
| Drivers | 1" tweeter + 6.5" woofer |
| Impedance | 4 ohms nominal (measured, Audio Science Review) |
| Sensitivity | 85dB (2.83V/1m, measured, Audio Science Review) |
| Weight | 53.4 lbs / 24.2 kg |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- JBL HDI-1600 vs Arendal 1723 Bookshelf S THX
- JBL HDI-1600 vs Revel Concerta2 M16
- JBL HDI-1600 vs ELAC Debut 3.0 DB63
- JBL HDI-1600 vs Emotiva Airmotiv XB2
- JBL HDI-1600 vs ELAC VELA BS 403
- JBL HDI-1600 vs ELAC Uni-Fi Reference UBR62
- JBL HDI-1600 vs Revel M126Be
- JBL HDI-1600 vs Ascend Acoustics Sierra-LX
- See all 26 comparisons