Short answer: the JBL 4367 for better sound quality, the Polk T50 for the lower price. The JBL 4367 ranks #12 of 71 floorstanding speakers at $16500. The Polk T50 ranks #55 at $209, $16291 cheaper.
What the Polk T50 offers: Pretty deep bass for the price. Distortion at 86dB SPL/1m is reasonably controlled outside a narrow spike around 250Hz. The reviewer notes performance is “not too bad for a budget speaker” once the two main tonal issues are addressed with EQ. Watch for: 5dB peak at 1khz, 4dB bright top end from 11khz on up. Just okay vertical off axis. Impedance and phase show several resonances between 200Hz-1kHz, with a minimum impedance of 4.2 ohms. Distortion rises substantially at 96dB SPL/1m across the midrange, with repeated peaks between 100Hz-2kHz.
What the JBL 4367 offers: Three-way design pairing a 15” front-ported woofer with a compression driver on a controlled-dispersion horn/waveguide, crossed over at 700Hz. On-axis frequency response is nearly dead flat, holding within about ±1.5dB, with the listening window tracking it closely except right at the crossover. Distortion stays below 1% THD across the entire audible band at both 86dB and 96dB. Compression/dynamic-range linearity is exceptional - within about a quarter of a dB from 76dB to 102dB, among the best the reviewer has measured. High sensitivity (about 92.6dB average) eases the amplifier match despite the speaker’s size. Minimal rear radiation thanks to the 15” woofer’s directivity and front-firing ports - rear energy runs about 20dB down from the primary wavefront, giving it a near-cardioid radiation pattern. Well-controlled horn directivity keeps the soundstage from noticeably shifting in width across the 700Hz crossover region. A natural high-frequency rolloff above about 7-8kHz gives it an easy, non-fatiguing character for extended listening sessions. Watch for: At roughly $16,500/pair, this is a major investment - the reviewer recommends buying from a dealer with a liberal return policy. Vertical response shows dips beyond about ±10-20°, with a larger null further out - an inherent trade-off of mating a 15” woofer to a horn compression driver at a 700Hz crossover, since crossing lower would hurt power handling and dynamic range. Horizontal directivity isn’t perfectly consistent with frequency: narrow (about ±20°) through 200-800Hz, briefly widening to near ±50° above the crossover, then narrowing again at high frequency - an unusual, non-constant pattern. The high-frequency rolloff that gives it an easy-listening character also reduces the sense of air and space in the soundstage when listening from off-center seats. Massive and heavy (about 120 lbs, roughly 36-37” tall) - needs to be raised on a stand to bring the horn to ear level, and isn’t something one person easily moves alone. Only modest EQ adjustment is available on the speaker itself (about ±1-2dB bass/treble trim).
Buy the Polk T50 if the price matters more than sound quality. Buy the JBL 4367 if sound quality matters more than the price.
If sound quality matters at all to you, skip the Polk T50. It ranks near the bottom of the 71 floorstanding speakers, so look higher up the list instead.
Specifications Side By Side
| Polk T50 | JBL 4367 | |
|---|---|---|
| Price | $209.00 | $16500 |
| Ranked | #55 of 71 in Large Size Floorstanding Speakers | #12 of 71 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 38Hz (measured, Audio Science Review) | 31Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 47Hz (measured, Audio Science Review) | 43Hz (measured, Erin’s Audio Corner) |
| Impedance | 4 ohms nominal (4.2 ohms minimum, measured by Audio Science Review) | 4 ohms nominal (5.3 ohms minimum above 80Hz, measured by Erin’s Audio Corner) |
| Drivers | 2x 6.5" bi-laminate paper cone woofers, 1x 1" Terylene dome tweeter + 2x 8" passive bass radiators | 15" (380mm) 2216Nd-1 Dual Differential Drive® woofer, 3" (75mm) D2430K dual compression tweeter |
| Weight | 75.4 lbs / 34.2 kg | 119 lbs / 54 kg each |
| Sensitivity | 86.3dB (2.83V/1m, measured by Audio Science Review) | 92.5dB (measured average, Erin’s Audio Corner) |
| Dimensions | 40.4"H x 9.3"W x 12.5"D (1026.2 x 235.0 x 317.5 mm) | 37.2"H x 22.2"W x 16.8"D (944.9 x 563.9 x 426.7 mm) |
| Woofer Cabinet | passive radiator | ported, front |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Revel F226Be vs MoFi SourcePoint V10 Master Edition
- Revel F226Be vs Dali Rubikore 6
- Revel F226Be vs Bose 901 Series V
- Definitive Technology BP-9020 vs JBL 4367
- JBL 4367 vs JBL Studio 698
Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Polk T50: $209.00 Amazon eBay
Pros: Pretty deep bass for the price. Distortion at 86dB SPL/1m is reasonably controlled outside a narrow spike around 250Hz. The reviewer notes performance is “not too bad for a budget speaker” once the two main tonal issues are addressed with EQ.
Cons: 5dB peak at 1khz, 4dB bright top end from 11khz on up. Just okay vertical off axis. Impedance and phase show several resonances between 200Hz-1kHz, with a minimum impedance of 4.2 ohms. Distortion rises substantially at 96dB SPL/1m across the midrange, with repeated peaks between 100Hz-2kHz.
Full Polk T50 review and specifications →
| Bass Extension (-10dB) | 38Hz (measured, Audio Science Review) |
|---|---|
| Bass Extension (-3dB) | 47Hz (measured, Audio Science Review) |
| Dimensions | 40.4"H x 9.3"W x 12.5"D (1026.2 x 235.0 x 317.5 mm) |
| Drivers | 2x 6.5" bi-laminate paper cone woofers, 1x 1" Terylene dome tweeter + 2x 8" passive bass radiators |
| Impedance | 4 ohms nominal (4.2 ohms minimum, measured by Audio Science Review) |
| Sensitivity | 86.3dB (2.83V/1m, measured by Audio Science Review) |
| Weight | 75.4 lbs / 34.2 kg |
| Woofer Cabinet | passive radiator |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
JBL 4367: $16500 eBay
Pros: Three-way design pairing a 15” front-ported woofer with a compression driver on a controlled-dispersion horn/waveguide, crossed over at 700Hz. On-axis frequency response is nearly dead flat, holding within about ±1.5dB, with the listening window tracking it closely except right at the crossover. Distortion stays below 1% THD across the entire audible band at both 86dB and 96dB. Compression/dynamic-range linearity is exceptional - within about a quarter of a dB from 76dB to 102dB, among the best the reviewer has measured. High sensitivity (about 92.6dB average) eases the amplifier match despite the speaker’s size. Minimal rear radiation thanks to the 15” woofer’s directivity and front-firing ports - rear energy runs about 20dB down from the primary wavefront, giving it a near-cardioid radiation pattern. Well-controlled horn directivity keeps the soundstage from noticeably shifting in width across the 700Hz crossover region. A natural high-frequency rolloff above about 7-8kHz gives it an easy, non-fatiguing character for extended listening sessions.
Cons: At roughly $16,500/pair, this is a major investment - the reviewer recommends buying from a dealer with a liberal return policy. Vertical response shows dips beyond about ±10-20°, with a larger null further out - an inherent trade-off of mating a 15” woofer to a horn compression driver at a 700Hz crossover, since crossing lower would hurt power handling and dynamic range. Horizontal directivity isn’t perfectly consistent with frequency: narrow (about ±20°) through 200-800Hz, briefly widening to near ±50° above the crossover, then narrowing again at high frequency - an unusual, non-constant pattern. The high-frequency rolloff that gives it an easy-listening character also reduces the sense of air and space in the soundstage when listening from off-center seats. Massive and heavy (about 120 lbs, roughly 36-37” tall) - needs to be raised on a stand to bring the horn to ear level, and isn’t something one person easily moves alone. Only modest EQ adjustment is available on the speaker itself (about ±1-2dB bass/treble trim).
Full JBL 4367 review and specifications →
| Bass Extension (-10dB) | 31Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 43Hz (measured, Erin's Audio Corner) |
| Dimensions | 37.2"H x 22.2"W x 16.8"D (944.9 x 563.9 x 426.7 mm) |
| Drivers | 15" (380mm) 2216Nd-1 Dual Differential Drive® woofer, 3" (75mm) D2430K dual compression tweeter |
| Impedance | 4 ohms nominal (5.3 ohms minimum above 80Hz, measured by Erin's Audio Corner) |
| Sensitivity | 92.5dB (measured average, Erin's Audio Corner) |
| Weight | 119 lbs / 54 kg each |
| Woofer Cabinet | ported, front |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons