Short answer: the ELAC Debut 2.0 B6.2. It ranks #88 of 131 bookshelf speakers by sound quality at $329; the Sonus Faber Lumina II Amator ranks #107 and costs $2000, so there is not much of a tradeoff to weigh.
What the ELAC Debut 2.0 B6.2 offers: Reasonably flat on-axis and listening-window response with reasonably even horizontal directivity, holding about ±60° up to roughly 8kHz for consistent stereo width whether aimed directly at the listener or toed out. Its larger-than-typical woofer lets it play very loud with minimal distortion, staying under about 1% THD down to 50Hz at 86dB, and minimum impedance stays a comfortable 5-6 ohms. In-room bass extension reaches about 50Hz without much trouble, enough for a solid kick-drum sound. Takes equalization very well - correcting the on-axis response doesn’t cost sensitivity through the midrange, and the underlying directivity behavior (diffraction, vertical mismatch) is mild enough that EQ alone gets most of the way to a well-balanced sound. Vertical tolerance is asymmetric and fairly forgiving: about 10° above the tweeter axis and 20° below it before tonal balance meaningfully shifts. One reviewer called it “a good speaker” with “a good price” rather than just good-for-the-price, and found it fairly neutral overall in-room. Watch for: A good size resonant peak around 700Hz stands out from an otherwise smooth response and lingers in cumulative spectral decay (waterfall) measurements - in one reviewer’s sighted A/B test, reducing it by about 5dB via EQ made a noticeable but not dramatic difference. Directivity error shows up around 3.3kHz, and the upper-midrange around 4-6kHz stood out as edgy and sharp, almost sibilant at times, in casual listening - the predicted in-room response shows a lack of energy between 1-2kHz and a bit too much above that, which one reviewer thought would sound bright. Distortion at 96dB SPL/1m shows two harmonic peaks the reviewer says “should not be there,” one from woofer breakup around 400Hz and another around 7-8kHz from the tweeter, and multitone distortion approaches 10% in the 500-800Hz range at that output level. Real compression shows up even at moderate volume and worsens at 96dB and above, with the woofer clearly giving up around 60-70Hz - a subwoofer is recommended for anyone wanting to listen loud, since running it full-range at high output costs real dynamic range in the midbass and bass. Don’t place it close to a wall - boundary reinforcement adds a midbass bump that undoes the otherwise smooth, linear response. Getting the best out of it takes EQ (taming the 700Hz peak, filling in the 1-2kHz dip, and trimming the highs).
What the Sonus Faber Lumina II Amator offers: Solid bass extension for a bookshelf (F3 63Hz, F10 43Hz), reaching about 50Hz in-room. Decent sensitivity and wide, consistent horizontal dispersion (~60-70 degrees) - better directivity than expected for a two-way design. Gorgeous, luxury-grade cabinet design. Watch for: Very bright treble, running 3-6dB above the midrange depending on measurement angle - independently corroborated by other owners online, not just one reviewer’s opinion. Causes audible sibilance and a forward, grainy character. Notably the brightest of three Sonus Faber models Erin’s Audio Corner has tested, even brighter than the brand’s own Sonetto II G2. A mechanical resonance/ringing artifact shows up around 1kHz in measurements. Needs a subwoofer for anything below about 50Hz.
Buy the ELAC Debut 2.0 B6.2. It ranks higher for sound quality than the Sonus Faber Lumina II Amator and costs less, so there is no real case for the other one.
If sound quality matters at all to you, skip the Sonus Faber Lumina II Amator. It ranks near the bottom of the 131 bookshelf speakers, so look higher up the list instead.
Specifications Side By Side
| ELAC Debut 2.0 B6.2 | Sonus Faber Lumina II Amator | |
|---|---|---|
| Price | $329.00 | $2000 |
| Ranked | #88 of 131 in Large Size Bookshelf Speakers | #107 of 131 in Large Size Bookshelf Speakers |
| Bass Extension (-10dB) | 40Hz (measured, Erin’s Audio Corner) | 43Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 64Hz (measured, Erin’s Audio Corner) | 63Hz (measured, Erin’s Audio Corner) |
| Impedance | 6 ohms nominal, 5.2 ohms minimum (measured, Erin’s Audio Corner) | 4 ohms nominal, 3.9 ohms minimum (measured, Erin’s Audio Corner) |
| Sensitivity | 86.5dB (measured, Audio Science Review) | 86.9dB (2.83V/1m, measured by Erin’s Audio Corner) |
| Drivers | 25mm tweeter + 165mm woofer | 1.14" DAD (Damped Apex Dome) tweeter, 5.9" paper cone woofer |
| Weight | 29.1 lbs / 13.2 kg | 12.8 lbs / 5.8 kg |
| Dimensions | 14.8"H x 7.7"W x 10.6"D (375.0 x 195.0 x 268.0 mm) | 12" x 7.1" x 10.4" (304 x 180 x 263 mm) |
| Woofer Cabinet | ported, front | Bass reflex, ported |
| Frequency Response | - | 55Hz - 24kHz (Manufacturer specified) |
| Crossover Frequency | - | 2600Hz |
| Recommended Power | - | 30W - 150W |
| Country of Origin | - | Italy (Vicenza) |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- SVS Prime Bookshelf vs Sonus Faber Lumina II
- Sonus Faber Lumina II vs KEF Q350
- Wharfedale Linton 85 vs SVS Prime Bookshelf
- Sonus Faber Lumina II Amator vs Klipsch RP-600M
- Sonus Faber Lumina II Amator vs Triangle Borea BR03
Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
ELAC Debut 2.0 B6.2: $329.00 Amazon Crutchfield eBay
Pros: Reasonably flat on-axis and listening-window response with reasonably even horizontal directivity, holding about ±60° up to roughly 8kHz for consistent stereo width whether aimed directly at the listener or toed out. Its larger-than-typical woofer lets it play very loud with minimal distortion, staying under about 1% THD down to 50Hz at 86dB, and minimum impedance stays a comfortable 5-6 ohms. In-room bass extension reaches about 50Hz without much trouble, enough for a solid kick-drum sound. Takes equalization very well - correcting the on-axis response doesn’t cost sensitivity through the midrange, and the underlying directivity behavior (diffraction, vertical mismatch) is mild enough that EQ alone gets most of the way to a well-balanced sound. Vertical tolerance is asymmetric and fairly forgiving: about 10° above the tweeter axis and 20° below it before tonal balance meaningfully shifts. One reviewer called it “a good speaker” with “a good price” rather than just good-for-the-price, and found it fairly neutral overall in-room.
Cons: A good size resonant peak around 700Hz stands out from an otherwise smooth response and lingers in cumulative spectral decay (waterfall) measurements - in one reviewer’s sighted A/B test, reducing it by about 5dB via EQ made a noticeable but not dramatic difference. Directivity error shows up around 3.3kHz, and the upper-midrange around 4-6kHz stood out as edgy and sharp, almost sibilant at times, in casual listening - the predicted in-room response shows a lack of energy between 1-2kHz and a bit too much above that, which one reviewer thought would sound bright. Distortion at 96dB SPL/1m shows two harmonic peaks the reviewer says “should not be there,” one from woofer breakup around 400Hz and another around 7-8kHz from the tweeter, and multitone distortion approaches 10% in the 500-800Hz range at that output level. Real compression shows up even at moderate volume and worsens at 96dB and above, with the woofer clearly giving up around 60-70Hz - a subwoofer is recommended for anyone wanting to listen loud, since running it full-range at high output costs real dynamic range in the midbass and bass. Don’t place it close to a wall - boundary reinforcement adds a midbass bump that undoes the otherwise smooth, linear response. Getting the best out of it takes EQ (taming the 700Hz peak, filling in the 1-2kHz dip, and trimming the highs).
Full ELAC Debut 2.0 B6.2 review and specifications →
| Bass Extension (-10dB) | 40Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 64Hz (measured, Erin's Audio Corner) |
| Dimensions | 14.8"H x 7.7"W x 10.6"D (375.0 x 195.0 x 268.0 mm) |
| Drivers | 25mm tweeter + 165mm woofer |
| Impedance | 6 ohms nominal, 5.2 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 86.5dB (measured, Audio Science Review) |
| Weight | 29.1 lbs / 13.2 kg |
| Woofer Cabinet | ported, front |
- Links
- Reviews, Comparisons and Sound Samples
- Erin’s Audio Corner: ELAC Debut 2.0 Review: A Good Budget Speaker More from Erin’s Audio Corner →
- Audio Science Review ELAC Debut 2.0 B6.2 More from Audio Science Review →
- Erin’s Audio Corner Website: ELAC Debut 2.0 B6.2
- Audio Science Review Measurements (spinorama.org)
- Reddit Search for ELAC Debut 2.0 B6.2 Review
- Head-to-Head Comparisons
- ELAC Debut 2.0 B6.2 vs SVS Prime Bookshelf
- ELAC Debut 2.0 B6.2 vs Dynaudio Special Forty
- ELAC Debut 2.0 B6.2 vs KEF Q3 Meta
- ELAC Debut 2.0 B6.2 vs Polk Monitor XT20
- ELAC Debut 2.0 B6.2 vs Infinity IL10
- ELAC Debut 2.0 B6.2 vs GR-Research X-LS Encore
- ELAC Debut 2.0 B6.2 vs Sonus Faber Lumina II
- ELAC Debut 2.0 B6.2 vs Focal Aria 906
- See all 34 comparisons
Sonus Faber Lumina II Amator: $2000 Crutchfield eBay
Pros: Solid bass extension for a bookshelf (F3 63Hz, F10 43Hz), reaching about 50Hz in-room. Decent sensitivity and wide, consistent horizontal dispersion (~60-70 degrees) - better directivity than expected for a two-way design. Gorgeous, luxury-grade cabinet design.
Cons: Very bright treble, running 3-6dB above the midrange depending on measurement angle - independently corroborated by other owners online, not just one reviewer’s opinion. Causes audible sibilance and a forward, grainy character. Notably the brightest of three Sonus Faber models Erin’s Audio Corner has tested, even brighter than the brand’s own Sonetto II G2. A mechanical resonance/ringing artifact shows up around 1kHz in measurements. Needs a subwoofer for anything below about 50Hz.
Full Sonus Faber Lumina II Amator review and specifications →
| Bass Extension (-10dB) | 43Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 63Hz (measured, Erin's Audio Corner) |
| Country of Origin | Italy (Vicenza) |
| Crossover Frequency | 2600Hz |
| Dimensions | 12" x 7.1" x 10.4" (304 x 180 x 263 mm) |
| Drivers | 1.14" DAD (Damped Apex Dome) tweeter, 5.9" paper cone woofer |
| Frequency Response | 55Hz - 24kHz (Manufacturer specified) |
| Impedance | 4 ohms nominal, 3.9 ohms minimum (measured, Erin's Audio Corner) |
| Recommended Power | 30W - 150W |
| Sensitivity | 86.9dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 12.8 lbs / 5.8 kg |
| Woofer Cabinet | Bass reflex, ported |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Sonus Faber Lumina II Amator vs KEF Q350
- Sonus Faber Lumina II Amator vs Klipsch RP-600M
- Sonus Faber Lumina II Amator vs Pylon Jasper Monitor 18
- Sonus Faber Lumina II Amator vs Wharfedale Diamond 9.1
- Sonus Faber Lumina II Amator vs Sonus Faber Sonetto II G2
- Sonus Faber Lumina II Amator vs Triangle Borea BR03
- Sonus Faber Lumina II Amator vs B&W 805S
- Sonus Faber Lumina II Amator vs Emotiva Airmotiv B2+
- See all 22 comparisons