Short answer: the KEF Reference 203 for better sound quality, the Infinity Reference 253 for the lower price. The KEF Reference 203 ranks #13 of 71 floorstanding speakers at $5000. The Infinity Reference 253 ranks #60 at $400, $4600 cheaper.
What the KEF Reference 203 offers: An unusually accomplished 4-way design for its era: excellent on-axis linearity (within about +/-3dB), genuinely good directivity both horizontally (~55 degrees) and vertically (~40-50 degrees), and an estimated in-room response that closely matches what the reviewer actually heard. Distortion is excellent - under 1% harmonic above 80Hz at both 86dB and 96dB, and multitone stays around 1% even at 96dB. Bass reaches a real F3 of 51Hz (F10 37Hz), with in-room extension into the low-mid-40s. The reviewer’s overall listening notes were essentially “nothing stood out bad or good” - a genuinely neutral, accurate speaker with a distinctive rounded-baffle look that avoids the diffraction issues a flat baffle this wide would normally have. Watch for: This is a 20+ year old, long-discontinued speaker only findable secondhand (Facebook Marketplace, Craigslist, audio forums) - condition, driver matching, and component aging vary by unit, so audition before buying if at all possible. Demands a robust amplifier: impedance dips to about 3.6 ohms with an EPDR of 2.2 ohms. The small supertweeter shows minor breakup artifacts at the extremes of the vertical polar plot and some compression at very high output in the top octave, though neither was audible in normal listening.
What the Infinity Reference 253 offers: Horizontal beamwidth of about ±60 degrees is fairly smooth and well controlled. Really amazing value for the performance. Watch for: CEA2034 spinorama and predicted in-room response both show elevated treble above 4kHz (“too hot”), a dip around 2kHz, and bass shelved down relative to the midrange. Vertical directivity requires staying at or below the tweeter axis for accurate tonal balance. Distortion at 96dB SPL/1m is broadly elevated above the reviewer’s audibility threshold across much of the midrange. Minimum impedance dips to 4.2 ohms.
Buy the KEF Reference 203 if sound quality matters more than the price. Buy the Infinity Reference 253 if the price matters more than sound quality.
If sound quality matters at all to you, skip the Infinity Reference 253. It ranks near the bottom of the 71 floorstanding speakers, so look higher up the list instead.

Specifications Side By Side
| KEF Reference 203 | Infinity Reference 253 | |
|---|---|---|
| Price | $5000 Discontinued | $400 used, Discontinued |
| Ranked | #13 of 71 in Large Size Floorstanding Speakers | #60 of 71 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 37Hz (measured, Erin’s Audio Corner) | 38Hz (measured, Audio Science Review) |
| Bass Extension (-3dB) | 51Hz (measured, Erin’s Audio Corner) | 78Hz (measured, Audio Science Review) |
| Dimensions | 1067H mm (42" tall) | 40.3"H x 6.8"W x 12.4"D (1023.6 x 172.7 x 315 mm) |
| Impedance | 8 ohms nominal (3.6 ohms minimum, measured, Erin’s Audio Corner; 3.2 ohms per manufacturer spec) | 6 ohms |
| Sensitivity | 88dB (2.83V/1m, measured by Erin’s Audio Corner) | 86.9dB (measured by Audio Science Review; 88dB manufacturer specified) |
| Drivers | 1x 0.75" supertweeter, coaxial 1" dome tweeter + 6.5" midrange, 2x 6.5" woofers | Dual 5.25" (130mm) CMMD™ woofers, 5.25" (130mm) flat-piston CMMD™ midrange, 1" (25mm) CMMD™ tweeter |
| Weight | 58 lbs / 26.3 kg (58 lb) | 39.2 lbs / 17.8 kg each |
| Woofer Cabinet | Bass reflex, with switchable flat/cut/lifted bass ports for wall placement | ported, rear |
| Crossover Frequency | 400Hz, 2.7kHz, 15kHz | - |
| Discontinued | Yes | Yes |
| Frequency Response | 55Hz - 55kHz ±3dB (Manufacturer specified) | - |
| Recommended Power | 50-200W | - |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- JBL HDI-3800 vs Sony SS-CS3
- JBL HDI-3800 vs Focal Chora 816
- Klipsch Forte IV vs Sony SS-CS3
- JBL HDI-3800 vs Infinity Reference 253
- KEF Reference 203 vs Sony SS-CS3
Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
KEF Reference 203: $5000 Discontinued eBay
Pros: An unusually accomplished 4-way design for its era: excellent on-axis linearity (within about +/-3dB), genuinely good directivity both horizontally (~55 degrees) and vertically (~40-50 degrees), and an estimated in-room response that closely matches what the reviewer actually heard. Distortion is excellent - under 1% harmonic above 80Hz at both 86dB and 96dB, and multitone stays around 1% even at 96dB. Bass reaches a real F3 of 51Hz (F10 37Hz), with in-room extension into the low-mid-40s. The reviewer’s overall listening notes were essentially “nothing stood out bad or good” - a genuinely neutral, accurate speaker with a distinctive rounded-baffle look that avoids the diffraction issues a flat baffle this wide would normally have.
Cons: This is a 20+ year old, long-discontinued speaker only findable secondhand (Facebook Marketplace, Craigslist, audio forums) - condition, driver matching, and component aging vary by unit, so audition before buying if at all possible. Demands a robust amplifier: impedance dips to about 3.6 ohms with an EPDR of 2.2 ohms. The small supertweeter shows minor breakup artifacts at the extremes of the vertical polar plot and some compression at very high output in the top octave, though neither was audible in normal listening. Discontinued.
Full KEF Reference 203 review and specifications →
| Bass Extension (-10dB) | 37Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 51Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 400Hz, 2.7kHz, 15kHz |
| Dimensions | 1067H mm (42" tall) |
| Discontinued | Yes |
| Drivers | 1x 0.75" supertweeter, coaxial 1" dome tweeter + 6.5" midrange, 2x 6.5" woofers |
| Frequency Response | 55Hz - 55kHz ±3dB (Manufacturer specified) |
| Impedance | 8 ohms nominal (3.6 ohms minimum, measured, Erin's Audio Corner; 3.2 ohms per manufacturer spec) |
| Recommended Power | 50-200W |
| Sensitivity | 88dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 58 lbs / 26.3 kg (58 lb) |
| Woofer Cabinet | Bass reflex, with switchable flat/cut/lifted bass ports for wall placement |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
Infinity Reference 253: $400 used, Discontinued eBay
Pros: Horizontal beamwidth of about ±60 degrees is fairly smooth and well controlled. Really amazing value for the performance.
Cons: CEA2034 spinorama and predicted in-room response both show elevated treble above 4kHz (“too hot”), a dip around 2kHz, and bass shelved down relative to the midrange. Vertical directivity requires staying at or below the tweeter axis for accurate tonal balance. Distortion at 96dB SPL/1m is broadly elevated above the reviewer’s audibility threshold across much of the midrange. Minimum impedance dips to 4.2 ohms. Discontinued.
Full Infinity Reference 253 review and specifications →
| Bass Extension (-10dB) | 38Hz (measured, Audio Science Review) |
|---|---|
| Bass Extension (-3dB) | 78Hz (measured, Audio Science Review) |
| Dimensions | 40.3"H x 6.8"W x 12.4"D (1023.6 x 172.7 x 315 mm) |
| Discontinued | Yes |
| Drivers | Dual 5.25" (130mm) CMMD™ woofers, 5.25" (130mm) flat-piston CMMD™ midrange, 1" (25mm) CMMD™ tweeter |
| Impedance | 6 ohms |
| Sensitivity | 86.9dB (measured by Audio Science Review; 88dB manufacturer specified) |
| Weight | 39.2 lbs / 17.8 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Infinity Reference 253 vs Sony SS-CS3
- Infinity Reference 253 vs JBL Stage 2 280F
- Infinity Reference 253 vs Focal Aria Evo X N°2
- Infinity Reference 253 vs Magnepan LRS+
- Infinity Reference 253 vs Polk T50
- Infinity Reference 253 vs Klipsch RP-6000F II
- Infinity Reference 253 vs Dynaudio Emit 30
- Infinity Reference 253 vs Klipsch RP-8000F II
- See all 33 comparisons

