Short answer: the Infinity Primus 360. It ranks #40 of 71 floorstanding speakers by sound quality at $650; the Dynaudio Emit 30 ranks #53 and costs $1274.25, so there is not much of a tradeoff to weigh.
What the Dynaudio Emit 30 offers: A 2.5-way floorstander: two 5.25” mid-woofers paired with a roughly 1” dome tweeter, driven through dual rear bass-reflex ports. The two woofers hand off at staggered crossover points (around 1kHz and 3.5kHz) rather than sharing one, which avoids the acoustic lobing a shared crossover point would cause between the tweeter and the lower woofer, and adds a few dB of sensitivity in the process. Genuinely deep bass for a speaker around this price - measured F3 near 44Hz and extends audibly down to about 40Hz in-room without much difficulty. Harmonic distortion measures clean and low at both 86dB and 96dB SPL/1m. Good CTA-2034 sound power and uniform directivity mean the speaker takes EQ correction well if a listener wants to dial in its one tonal weak point. Dynamic range and compression performance are strong overall, with only a minor, high-Q compression artifact tied to a cone-edge resonance that’s unlikely to be audible. Wide, consistent horizontal dispersion around ±70° with just a small ~10° narrowing between 1-3kHz, and a reasonably forgiving ±20° vertical window centered on the tweeter axis. Watch for: A dip and inconsistency in the lower-treble presence region (roughly 2-5kHz) makes the top end sound uneven - sometimes soft, sometimes forward - depending on the specific instrument or frequency being reproduced; male vocals can lack presence and cymbals can lack sizzle as a result. A cone-edge surround resonance shows up around 1-1.3kHz in burst-decay measurements (a trait the reviewer has also seen on other Dynaudio models) and lines up with elevated multitone distortion across roughly 600Hz-1.5kHz. An enclosure resonance appears around 350Hz in the impedance curve. Placed too close to a rear wall, the dual ports make the bass noticeably boomy - pulling the speaker out is needed to keep the low end from overloading the room. Fully resolving the top-end inconsistency needs a modest EQ correction (roughly +2dB with a Q of about 1, centered 3-6kHz), so out-of-the-box tonal accuracy in that band isn’t quite class-leading despite otherwise strong measured performance.
What the Infinity Primus 360 offers: A three-way tower from 2005 (two 6.5” mid-woofers, a 4” mid-range, and a 0.75” dome tweeter, 8 ohms nominal) that holds up remarkably well by modern measurement standards: on-axis linearity is within about ±2dB, and the listening window stays consistent out to roughly ±30° horizontal and ±10° vertical off the mid-range axis. Horizontal directivity is well controlled out to about ±75° before tonality starts to drift, meaning the reflected sound in a room stays close in character to the direct sound - a speaker that takes EQ well without fighting itself. Harmonic distortion measures low at both 86dB and 96dB, and multitone distortion stays under the reviewer’s 3% threshold. Silky, smooth midrange with a rich lower-midrange/upper-bass character. No mechanical issues or surround degradation found in a 20-year-old pair, and a second unit measured within about 1-1.5dB of the first, suggesting good long-term consistency for the design. Watch for: Manufacturer-spec sensitivity of 93dB runs about 3-4dB optimistic versus the measured 89.4dB average. Bass output drops off fairly quickly below about 50Hz in-room (F3 53Hz, F10 37Hz), so a subwoofer is needed for real low-end extension. Resonances show up around 170Hz, 220Hz, and 350Hz. On-axis, the lower treble can sound a bit bright or sibilant when the speaker is aimed directly at the listener; toeing out about 10-15° (rather than the more extreme 30°) gave the best balance, and some sidewall acoustic absorption further tamed a 4-5kHz peak. Placed close to the rear wall, bass gets boomy - pulling the speakers out about a foot resolves most of it, with roughly 1.5 feet from the wall as a good compromise between bass character and typical room aesthetics. Straying beyond about 25° above or below the mid-range axis introduces audible suckout. No longer in production, so it’s a used/secondhand purchase only.
Buy the Infinity Primus 360. It ranks higher for sound quality than the Dynaudio Emit 30 and costs less, so there is no real case for the other one.
Specifications Side By Side
| Dynaudio Emit 30 | Infinity Primus 360 | |
|---|---|---|
| Price | $1,274.25 | $650.00 Discontinued |
| Ranked | #53 of 71 in Large Size Floorstanding Speakers | #40 of 71 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 36Hz (measured, Erin’s Audio Corner) | 37Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 44Hz (measured, Erin’s Audio Corner) | 53Hz (measured, Erin’s Audio Corner) |
| Drivers | Dual 5.25" mid-woofers, 1" soft dome tweeter | Two 6.5" mid-woofers, 4" mid-range, 0.75" dome tweeter |
| Weight | 34.2 lbs / 15.5 kg | 48.5 lbs (48.5 lbs / 22 kg) each |
| Sensitivity | 87dB | 89.4dB (measured, Erin’s Audio Corner; 93dB manufacturer specified) |
| Impedance | 4 ohms | 8 ohms nominal, 3.5 ohms minimum (measured, Erin’s Audio Corner) |
| Dimensions | 35.4"H x 6.7"W x 10.7"D (900.0 x 170.0 x 272.0 mm) | 39"H x 8-1/8"W x 13-7/8"D (990 x 208 x 330mm) |
| Woofer Cabinet | ported, rear (dual) | - |
| Frequency Response | 44Hz - 25kHz (±3dB, manufacturer specified) | 38Hz - 20kHz (±3dB, Manufacturer specified) |
| Power Handling | 180W (IEC rated) | - |
| Country of Origin | Denmark | - |
| Discontinued | - | Yes |
| Crossovers | - | 350Hz & 3.3kHz, 24dB/octave |
| Recommended Power | - | 10-200W |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Klipsch RP-6000F II vs Infinity Reference 253
- Klipsch RP-6000F II vs Sony SS-CS3
- Definitive Technology BP-9020 vs Klipsch RP-6000F II
- ELAC Debut 3.0 DF63 vs Dynaudio Emit 30
- Dynaudio Emit 30 vs JBL Stage 2 280F
Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Dynaudio Emit 30: $1,274.25 Amazon eBay
Pros: A 2.5-way floorstander: two 5.25” mid-woofers paired with a roughly 1” dome tweeter, driven through dual rear bass-reflex ports. The two woofers hand off at staggered crossover points (around 1kHz and 3.5kHz) rather than sharing one, which avoids the acoustic lobing a shared crossover point would cause between the tweeter and the lower woofer, and adds a few dB of sensitivity in the process. Genuinely deep bass for a speaker around this price - measured F3 near 44Hz and extends audibly down to about 40Hz in-room without much difficulty. Harmonic distortion measures clean and low at both 86dB and 96dB SPL/1m. Good CTA-2034 sound power and uniform directivity mean the speaker takes EQ correction well if a listener wants to dial in its one tonal weak point. Dynamic range and compression performance are strong overall, with only a minor, high-Q compression artifact tied to a cone-edge resonance that’s unlikely to be audible. Wide, consistent horizontal dispersion around ±70° with just a small ~10° narrowing between 1-3kHz, and a reasonably forgiving ±20° vertical window centered on the tweeter axis.
Cons: A dip and inconsistency in the lower-treble presence region (roughly 2-5kHz) makes the top end sound uneven - sometimes soft, sometimes forward - depending on the specific instrument or frequency being reproduced; male vocals can lack presence and cymbals can lack sizzle as a result. A cone-edge surround resonance shows up around 1-1.3kHz in burst-decay measurements (a trait the reviewer has also seen on other Dynaudio models) and lines up with elevated multitone distortion across roughly 600Hz-1.5kHz. An enclosure resonance appears around 350Hz in the impedance curve. Placed too close to a rear wall, the dual ports make the bass noticeably boomy - pulling the speaker out is needed to keep the low end from overloading the room. Fully resolving the top-end inconsistency needs a modest EQ correction (roughly +2dB with a Q of about 1, centered 3-6kHz), so out-of-the-box tonal accuracy in that band isn’t quite class-leading despite otherwise strong measured performance.
Full Dynaudio Emit 30 review and specifications →
| Bass Extension (-10dB) | 36Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 44Hz (measured, Erin's Audio Corner) |
| Country of Origin | Denmark |
| Dimensions | 35.4"H x 6.7"W x 10.7"D (900.0 x 170.0 x 272.0 mm) |
| Drivers | Dual 5.25" mid-woofers, 1" soft dome tweeter |
| Frequency Response | 44Hz - 25kHz (±3dB, manufacturer specified) |
| Impedance | 4 ohms |
| Power Handling | 180W (IEC rated) |
| Sensitivity | 87dB |
| Weight | 34.2 lbs / 15.5 kg |
| Woofer Cabinet | ported, rear (dual) |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Dynaudio Emit 30 vs Klipsch RP-6000F II
- Dynaudio Emit 30 vs Klipsch RP-8000F II
- Dynaudio Emit 30 vs Polk T50
- Dynaudio Emit 30 vs SVS Ultra Evolution Pinnacle
- Dynaudio Emit 30 vs Focal Aria Evo X N°2
- Dynaudio Emit 30 vs Klipsch RP-5000F II
- Dynaudio Emit 30 vs Sony SS-CS3
- Dynaudio Emit 30 vs Infinity Reference 253
- See all 40 comparisons
Infinity Primus 360: $650.00 Discontinued eBay
Pros: A three-way tower from 2005 (two 6.5” mid-woofers, a 4” mid-range, and a 0.75” dome tweeter, 8 ohms nominal) that holds up remarkably well by modern measurement standards: on-axis linearity is within about ±2dB, and the listening window stays consistent out to roughly ±30° horizontal and ±10° vertical off the mid-range axis. Horizontal directivity is well controlled out to about ±75° before tonality starts to drift, meaning the reflected sound in a room stays close in character to the direct sound - a speaker that takes EQ well without fighting itself. Harmonic distortion measures low at both 86dB and 96dB, and multitone distortion stays under the reviewer’s 3% threshold. Silky, smooth midrange with a rich lower-midrange/upper-bass character. No mechanical issues or surround degradation found in a 20-year-old pair, and a second unit measured within about 1-1.5dB of the first, suggesting good long-term consistency for the design.
Cons: Manufacturer-spec sensitivity of 93dB runs about 3-4dB optimistic versus the measured 89.4dB average. Bass output drops off fairly quickly below about 50Hz in-room (F3 53Hz, F10 37Hz), so a subwoofer is needed for real low-end extension. Resonances show up around 170Hz, 220Hz, and 350Hz. On-axis, the lower treble can sound a bit bright or sibilant when the speaker is aimed directly at the listener; toeing out about 10-15° (rather than the more extreme 30°) gave the best balance, and some sidewall acoustic absorption further tamed a 4-5kHz peak. Placed close to the rear wall, bass gets boomy - pulling the speakers out about a foot resolves most of it, with roughly 1.5 feet from the wall as a good compromise between bass character and typical room aesthetics. Straying beyond about 25° above or below the mid-range axis introduces audible suckout. No longer in production, so it’s a used/secondhand purchase only. Discontinued.
Full Infinity Primus 360 review and specifications →
| Bass Extension (-10dB) | 37Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 53Hz (measured, Erin's Audio Corner) |
| Crossovers | 350Hz & 3.3kHz, 24dB/octave |
| Dimensions | 39"H x 8-1/8"W x 13-7/8"D (990 x 208 x 330mm) |
| Discontinued | Yes |
| Drivers | Two 6.5" mid-woofers, 4" mid-range, 0.75" dome tweeter |
| Frequency Response | 38Hz - 20kHz (±3dB, Manufacturer specified) |
| Impedance | 8 ohms nominal, 3.5 ohms minimum (measured, Erin's Audio Corner) |
| Recommended Power | 10-200W |
| Sensitivity | 89.4dB (measured, Erin's Audio Corner; 93dB manufacturer specified) |
| Weight | 48.5 lbs (48.5 lbs / 22 kg) each |
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Infinity Primus 360 vs Definitive Technology BP-9020
- Infinity Primus 360 vs Klipsch Forte IV
- Infinity Primus 360 vs Linkwitz Lab LXmini
- Infinity Primus 360 vs Klipsch Heresy IV
- Infinity Primus 360 vs Polk Reserve R500
- Infinity Primus 360 vs ELAC Debut 3.0 DF63
- Infinity Primus 360 vs KEF Q11 Meta
- Infinity Primus 360 vs PSB Imagine T65
- See all 30 comparisons