Short answer: the Emotiva Airmotiv T2+. It ranks #30 of 71 floorstanding speakers by sound quality at $999; the Dynaudio Emit 30 ranks #53 and costs $1274.25, so there is not much of a tradeoff to weigh.
What the Dynaudio Emit 30 offers: A 2.5-way floorstander: two 5.25” mid-woofers paired with a roughly 1” dome tweeter, driven through dual rear bass-reflex ports. The two woofers hand off at staggered crossover points (around 1kHz and 3.5kHz) rather than sharing one, which avoids the acoustic lobing a shared crossover point would cause between the tweeter and the lower woofer, and adds a few dB of sensitivity in the process. Genuinely deep bass for a speaker around this price - measured F3 near 44Hz and extends audibly down to about 40Hz in-room without much difficulty. Harmonic distortion measures clean and low at both 86dB and 96dB SPL/1m. Good CTA-2034 sound power and uniform directivity mean the speaker takes EQ correction well if a listener wants to dial in its one tonal weak point. Dynamic range and compression performance are strong overall, with only a minor, high-Q compression artifact tied to a cone-edge resonance that’s unlikely to be audible. Wide, consistent horizontal dispersion around ±70° with just a small ~10° narrowing between 1-3kHz, and a reasonably forgiving ±20° vertical window centered on the tweeter axis. Watch for: A dip and inconsistency in the lower-treble presence region (roughly 2-5kHz) makes the top end sound uneven - sometimes soft, sometimes forward - depending on the specific instrument or frequency being reproduced; male vocals can lack presence and cymbals can lack sizzle as a result. A cone-edge surround resonance shows up around 1-1.3kHz in burst-decay measurements (a trait the reviewer has also seen on other Dynaudio models) and lines up with elevated multitone distortion across roughly 600Hz-1.5kHz. An enclosure resonance appears around 350Hz in the impedance curve. Placed too close to a rear wall, the dual ports make the bass noticeably boomy - pulling the speaker out is needed to keep the low end from overloading the room. Fully resolving the top-end inconsistency needs a modest EQ correction (roughly +2dB with a Q of about 1, centered 3-6kHz), so out-of-the-box tonal accuracy in that band isn’t quite class-leading despite otherwise strong measured performance.
What the Emotiva Airmotiv T2+ offers: High-value three-way tower with strong output and unusually deep usable sealed-room bass for the price. Erin measured F3 at 62Hz and F10 at 32Hz, with sensitivity just under 90dB/2.83V/1m. Dual 8-inch woven-fiber woofers relieve the 5.25-inch midrange, and the 32mm folded-ribbon tweeter provides broad horizontal coverage. Approximately +/-2.5dB response linearity, solid cabinet bracing and low compression allow substantial playback levels; the gradual low-frequency roll-off integrates well with either room gain or a subwoofer. Watch for: The nominal 4-ohm system approaches 3 ohms near 100Hz in Erin’s measurement, so a high-current amplifier is preferable. Horizontal and especially vertical directivity through the midrange/tweeter transition is less uniform than the best waveguided or coaxial designs; listener height and nearby reflections matter, and EQ cannot correct the narrowing mismatch. The large rear-ported cabinet needs placement clearance, and its deep F10 should not be confused with flat 30Hz output at cinema levels.
Buy the Emotiva Airmotiv T2+. It ranks higher for sound quality than the Dynaudio Emit 30 and costs less, so there is no real case for the other one.
Specifications Side By Side
| Dynaudio Emit 30 | Emotiva Airmotiv T2+ | |
|---|---|---|
| Price | $1,274.25 | $999/pair |
| Ranked | #53 of 71 in Large Size Floorstanding Speakers | #30 of 71 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 36Hz (measured, Erin’s Audio Corner) | 32Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 44Hz (measured, Erin’s Audio Corner) | 62Hz (measured, Erin’s Audio Corner) |
| Drivers | Dual 5.25" mid-woofers, 1" soft dome tweeter | 32mm folded-ribbon tweeter; 5.25" midrange; dual 8" woofers |
| Weight | 34.2 lbs / 15.5 kg | 56.9 lb each |
| Sensitivity | 87dB | Approximately 89.5dB/2.83V/1m (measured, Erin’s Audio Corner) |
| Impedance | 4 ohms | Approximately 3 ohms minimum near 100Hz (measured, Erin’s Audio Corner) |
| Dimensions | 35.4"H x 6.7"W x 10.7"D (900.0 x 170.0 x 272.0 mm) | 42.7"H x 12.2"W x 12.3"D |
| Woofer Cabinet | ported, rear (dual) | ported, rear |
| Frequency Response | 44Hz - 25kHz (±3dB, manufacturer specified) | - |
| Power Handling | 180W (IEC rated) | - |
| Country of Origin | Denmark | - |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Klipsch RP-8000F II vs Sony SS-CS3
- Definitive Technology BP-9020 vs Klipsch RP-8000F II
- Klipsch RP-8000F II vs Infinity Reference 253
- KEF Q11 Meta vs Emotiva Airmotiv T2+
- Emotiva Airmotiv T2+ vs Q Acoustics 5040
Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Dynaudio Emit 30: $1,274.25 Amazon eBay
Pros: A 2.5-way floorstander: two 5.25” mid-woofers paired with a roughly 1” dome tweeter, driven through dual rear bass-reflex ports. The two woofers hand off at staggered crossover points (around 1kHz and 3.5kHz) rather than sharing one, which avoids the acoustic lobing a shared crossover point would cause between the tweeter and the lower woofer, and adds a few dB of sensitivity in the process. Genuinely deep bass for a speaker around this price - measured F3 near 44Hz and extends audibly down to about 40Hz in-room without much difficulty. Harmonic distortion measures clean and low at both 86dB and 96dB SPL/1m. Good CTA-2034 sound power and uniform directivity mean the speaker takes EQ correction well if a listener wants to dial in its one tonal weak point. Dynamic range and compression performance are strong overall, with only a minor, high-Q compression artifact tied to a cone-edge resonance that’s unlikely to be audible. Wide, consistent horizontal dispersion around ±70° with just a small ~10° narrowing between 1-3kHz, and a reasonably forgiving ±20° vertical window centered on the tweeter axis.
Cons: A dip and inconsistency in the lower-treble presence region (roughly 2-5kHz) makes the top end sound uneven - sometimes soft, sometimes forward - depending on the specific instrument or frequency being reproduced; male vocals can lack presence and cymbals can lack sizzle as a result. A cone-edge surround resonance shows up around 1-1.3kHz in burst-decay measurements (a trait the reviewer has also seen on other Dynaudio models) and lines up with elevated multitone distortion across roughly 600Hz-1.5kHz. An enclosure resonance appears around 350Hz in the impedance curve. Placed too close to a rear wall, the dual ports make the bass noticeably boomy - pulling the speaker out is needed to keep the low end from overloading the room. Fully resolving the top-end inconsistency needs a modest EQ correction (roughly +2dB with a Q of about 1, centered 3-6kHz), so out-of-the-box tonal accuracy in that band isn’t quite class-leading despite otherwise strong measured performance.
Full Dynaudio Emit 30 review and specifications →
| Bass Extension (-10dB) | 36Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 44Hz (measured, Erin's Audio Corner) |
| Country of Origin | Denmark |
| Dimensions | 35.4"H x 6.7"W x 10.7"D (900.0 x 170.0 x 272.0 mm) |
| Drivers | Dual 5.25" mid-woofers, 1" soft dome tweeter |
| Frequency Response | 44Hz - 25kHz (±3dB, manufacturer specified) |
| Impedance | 4 ohms |
| Power Handling | 180W (IEC rated) |
| Sensitivity | 87dB |
| Weight | 34.2 lbs / 15.5 kg |
| Woofer Cabinet | ported, rear (dual) |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Dynaudio Emit 30 vs Klipsch RP-6000F II
- Dynaudio Emit 30 vs Klipsch RP-8000F II
- Dynaudio Emit 30 vs Polk T50
- Dynaudio Emit 30 vs SVS Ultra Evolution Pinnacle
- Dynaudio Emit 30 vs Focal Aria Evo X N°2
- Dynaudio Emit 30 vs Klipsch RP-5000F II
- Dynaudio Emit 30 vs Sony SS-CS3
- Dynaudio Emit 30 vs Infinity Reference 253
- See all 40 comparisons
Emotiva Airmotiv T2+: $999/pair Emotiva eBay
Pros: High-value three-way tower with strong output and unusually deep usable sealed-room bass for the price. Erin measured F3 at 62Hz and F10 at 32Hz, with sensitivity just under 90dB/2.83V/1m. Dual 8-inch woven-fiber woofers relieve the 5.25-inch midrange, and the 32mm folded-ribbon tweeter provides broad horizontal coverage. Approximately +/-2.5dB response linearity, solid cabinet bracing and low compression allow substantial playback levels; the gradual low-frequency roll-off integrates well with either room gain or a subwoofer.
Cons: The nominal 4-ohm system approaches 3 ohms near 100Hz in Erin’s measurement, so a high-current amplifier is preferable. Horizontal and especially vertical directivity through the midrange/tweeter transition is less uniform than the best waveguided or coaxial designs; listener height and nearby reflections matter, and EQ cannot correct the narrowing mismatch. The large rear-ported cabinet needs placement clearance, and its deep F10 should not be confused with flat 30Hz output at cinema levels.
Full Emotiva Airmotiv T2+ review and specifications →
| Bass Extension (-10dB) | 32Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 62Hz (measured, Erin's Audio Corner) |
| Dimensions | 42.7"H x 12.2"W x 12.3"D |
| Drivers | 32mm folded-ribbon tweeter; 5.25" midrange; dual 8" woofers |
| Impedance | Approximately 3 ohms minimum near 100Hz (measured, Erin's Audio Corner) |
| Sensitivity | Approximately 89.5dB/2.83V/1m (measured, Erin's Audio Corner) |
| Weight | 56.9 lb each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Emotiva Airmotiv T2+ vs Polk Audio Reserve R700
- Emotiva Airmotiv T2+ vs JBL HDI-3600
- Emotiva Airmotiv T2+ vs Q Acoustics 5040
- Emotiva Airmotiv T2+ vs KEF R11 Meta
- Emotiva Airmotiv T2+ vs PSB Imagine T65
- Emotiva Airmotiv T2+ vs ELAC Debut 3.0 DF63
- Emotiva Airmotiv T2+ vs Polk Reserve R500
- Emotiva Airmotiv T2+ vs Revel Concerta2 F35
- See all 24 comparisons