Short answer: the KEF LS50 Meta for better sound quality, the Jamo S 803 for the lower price. The KEF LS50 Meta ranks #4 of 87 bookshelf speakers at $1599. The Jamo S 803 ranks #84 at $119.99, $1479.01 cheaper.
What the KEF LS50 Meta offers: Uni-Q concentric driver mounts a 1” vented aluminum dome tweeter at the center of a 5.25” aluminum cone woofer, rated 79Hz-20kHz+. Speaker-to-speaker matching measured tight at roughly 0.5dB deviation between the pair tested, versus 2-3dB seen on some other speakers - likely why imaging stayed so precise. Imaging stays tight and focused even toed out, unlike most coincident designs where toe-out typically diffuses the image, giving more of an oval-shaped soundstage than a hard rectangular boundary. Horizontal and vertical directivity both hold to about ±50° at the -6dB point, so tonality stays consistent across roughly a 100° listening cone. The extended bass shelf is deliberately tuned for near-wall/boundary placement rather than the usual “pull it 3 feet into the room” advice, playing lower without excess boominess when placed close to a wall. At $1,000 (a frequent sale price versus $1,600 list), called a no-brainer for a compact stand-mount speaker. Independent ASR Klippel measurements corroborate this: very good directivity with the on- and off-axis curves tracking closely, and a predicted in-room response the reviewer called “very close to ideal.” Watch for: F3 of 67Hz and F10 of 42Hz mean it doesn’t get much below 50Hz in-room; a subwoofer is recommended for real bass. A 2-3dB scoop around 2-4kHz shows up in both the listening window and sound power measurements, matching a subjectively noticed lack of attack and vocal clarity that the reviewer wanted to correct with about 2dB of EQ. An on-axis diffraction dip around 8kHz smooths out with about 15° of toe-out (typical for concentric designs, but still present at 0°). Distortion is elevated at low frequencies since the single 5.25” cone shares surface area with the tweeter housing, reducing effective radiating area; multitone distortion crosses the 3% threshold at 96dB/1m, making roughly 88dB or below the safer output ceiling. Moderate sensitivity (~83dB average) needed 2-3dB more amplifier gain than typical in testing. Adding a subwoofer at an 80Hz crossover only helps lower-midrange distortion, not the elevated distortion in the 1-2kHz and above-5kHz regions. ASR’s own Klippel testing found the same pattern in starker terms: THD is very good at 86dB SPL/1m but climbs past 100% in the bass at 96dB SPL/1m, confirming this is not a near-field speaker for high-output bass-heavy material. Cumulative spectral decay (waterfall) also shows a couple of resonances lingering in the 1-2kHz region.
What the Jamo S 803 offers: Low pair price, compact dimensions and a front slot port suit inexpensive desktop or surround installations. The pronounced 80-100Hz hump supplies immediate punch and can sound impressive in a short demonstration. Harmonic distortion at 86dB is broadly typical for an inexpensive 5-inch two-way, and high-passing near 80Hz reduces some woofer-driven midrange distortion. The cabinet also accepts Jamo’s matching top-mounted Atmos module. Watch for: A textbook V-shaped response rather than accurate reproduction. Erin measured only about 81dB average sensitivity from 300Hz-3kHz, far below Jamo’s 87dB claim; bass around 80-100Hz and the treble are each roughly 5dB above that midrange reference. The bass is therefore resonant one-note punch rather than deep extension. Horizontal coverage is only about +/-50 degrees, while the midwoofer narrows before the tweeter widens abruptly, creating a directivity discontinuity that EQ cannot repair around 4kHz. Vertical tolerance is especially asymmetric: roughly 10 degrees above tweeter axis is usable, but moving below it rapidly damages the response. At high output, compression and multitone distortion become audible; an 80Hz crossover helps but does not correct the native tonality. Erin’s conclusion was an unequivocal pass in favor of a more neutral alternative.
Buy the KEF LS50 Meta if sound quality matters more than the price. Buy the Jamo S 803 if the price matters more than sound quality.
If sound quality matters at all to you, skip the Jamo S 803. It ranks near the bottom of the 87 bookshelf speakers, so look higher up the list instead.
Specifications Side By Side
| KEF LS50 Meta | Jamo S 803 | |
|---|---|---|
| Price | $1,599.00 | $119.99 |
| Ranked | #4 of 87 in Medium Size Bookshelf Speakers | #84 of 87 in Medium Size Bookshelf Speakers |
| Bass Extension (-10dB) | 43Hz (measured, Erin’s Audio Corner) | 48.7Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 68Hz (measured, Erin’s Audio Corner) | 60.1Hz (measured, Erin’s Audio Corner) |
| Dimensions | 11.9"H x 7.9"W x 11"D (302 x 200 x 280.5 mm) | 13.9"H x 7.5"W x 9.9"D (353 x 191 x 252 mm) |
| Impedance | 8 ohms nominal (3.7 ohms minimum above 80Hz, measured by Erin’s Audio Corner) | 8 ohms nominal (manufacturer specified) |
| Sensitivity | 83dB (measured average, Erin’s Audio Corner; 85dB manufacturer specified) | 81dB (measured average 300Hz-3kHz, Erin’s Audio Corner; 87dB manufacturer specified) |
| Drivers | 130 mm (5.25 in.) aluminium cone woofer, 25 mm (1 in.) vented aluminium dome with Metamaterial Absorption tweeter | 5" polyfiber woofer, 1" soft-dome tweeter with waveguide |
| Weight | 17.2 lbs / 7.8 kg each | 13 lbs / 5.9 kg each |
| Woofer Cabinet | ported, rear | ported, front slot |
| Frequency Response | - | 57Hz-26kHz (manufacturer specified) |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Ascend Sierra 1 v2 vs Pioneer Elite SP-EBS73-LR
- Ascend Sierra 1 v2 vs Monitor Audio Silver 50 7G
- Dynaudio Emit M10 vs Ascend Sierra 1 v2
- KEF LS50 Meta vs Parts Express Copperhead Desktop Kit
- KEF LS50 Meta vs Polk T15
Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
KEF LS50 Meta: $1,599.00 Amazon Crutchfield eBay
Pros: Uni-Q concentric driver mounts a 1” vented aluminum dome tweeter at the center of a 5.25” aluminum cone woofer, rated 79Hz-20kHz+. Speaker-to-speaker matching measured tight at roughly 0.5dB deviation between the pair tested, versus 2-3dB seen on some other speakers - likely why imaging stayed so precise. Imaging stays tight and focused even toed out, unlike most coincident designs where toe-out typically diffuses the image, giving more of an oval-shaped soundstage than a hard rectangular boundary. Horizontal and vertical directivity both hold to about ±50° at the -6dB point, so tonality stays consistent across roughly a 100° listening cone. The extended bass shelf is deliberately tuned for near-wall/boundary placement rather than the usual “pull it 3 feet into the room” advice, playing lower without excess boominess when placed close to a wall. At $1,000 (a frequent sale price versus $1,600 list), called a no-brainer for a compact stand-mount speaker. Independent ASR Klippel measurements corroborate this: very good directivity with the on- and off-axis curves tracking closely, and a predicted in-room response the reviewer called “very close to ideal.”
Cons: F3 of 67Hz and F10 of 42Hz mean it doesn’t get much below 50Hz in-room; a subwoofer is recommended for real bass. A 2-3dB scoop around 2-4kHz shows up in both the listening window and sound power measurements, matching a subjectively noticed lack of attack and vocal clarity that the reviewer wanted to correct with about 2dB of EQ. An on-axis diffraction dip around 8kHz smooths out with about 15° of toe-out (typical for concentric designs, but still present at 0°). Distortion is elevated at low frequencies since the single 5.25” cone shares surface area with the tweeter housing, reducing effective radiating area; multitone distortion crosses the 3% threshold at 96dB/1m, making roughly 88dB or below the safer output ceiling. Moderate sensitivity (~83dB average) needed 2-3dB more amplifier gain than typical in testing. Adding a subwoofer at an 80Hz crossover only helps lower-midrange distortion, not the elevated distortion in the 1-2kHz and above-5kHz regions. ASR’s own Klippel testing found the same pattern in starker terms: THD is very good at 86dB SPL/1m but climbs past 100% in the bass at 96dB SPL/1m, confirming this is not a near-field speaker for high-output bass-heavy material. Cumulative spectral decay (waterfall) also shows a couple of resonances lingering in the 1-2kHz region.
Full KEF LS50 Meta review and specifications →
| Bass Extension (-10dB) | 43Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 68Hz (measured, Erin's Audio Corner) |
| Dimensions | 11.9"H x 7.9"W x 11"D (302 x 200 x 280.5 mm) |
| Drivers | 130 mm (5.25 in.) aluminium cone woofer, 25 mm (1 in.) vented aluminium dome with Metamaterial Absorption tweeter |
| Impedance | 8 ohms nominal (3.7 ohms minimum above 80Hz, measured by Erin's Audio Corner) |
| Sensitivity | 83dB (measured average, Erin's Audio Corner; 85dB manufacturer specified) |
| Weight | 17.2 lbs / 7.8 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Erin’s Audio Corner: Unveiling the KEF LS50 Meta: The Truth Behind the Hype More from Erin’s Audio Corner →
- Erin’s Audio Corner Website KEF LS50 Meta
- Audio Science Review KEF LS50 Meta More from Audio Science Review →
- GR-Research: KEF LS50 Meta! Worthy of HYPE? More from GR-Research →
- Erin’s Audio Corner: My Top Picks of 2023: Must-Haves Under $3000
- Erin’s Audio Corner Measurements (spinorama.org)
- Reddit Search for KEF LS50 Meta Review
- Head-to-Head Comparisons
- KEF LS50 Meta vs Ascend Sierra 1 v2
- KEF LS50 Meta vs Ascend Acoustics Luna V2 Mini-Monitor Ribbon
- KEF LS50 Meta vs Philharmonic Ceramic Mini
- KEF LS50 Meta vs XMechanik Mechano23 DIY
- KEF LS50 Meta vs Audio First Fidelia
- KEF LS50 Meta vs Arendal 1961 Monitor
- KEF LS50 Meta vs SunAudio Purified 4
- KEF LS50 Meta vs Ascend Acoustics Luna V2 Mini-Monitor Titan
- See all 61 comparisons
Jamo S 803: $119.99 Amazon Crutchfield eBay
Pros: Low pair price, compact dimensions and a front slot port suit inexpensive desktop or surround installations. The pronounced 80-100Hz hump supplies immediate punch and can sound impressive in a short demonstration. Harmonic distortion at 86dB is broadly typical for an inexpensive 5-inch two-way, and high-passing near 80Hz reduces some woofer-driven midrange distortion. The cabinet also accepts Jamo’s matching top-mounted Atmos module.
Cons: A textbook V-shaped response rather than accurate reproduction. Erin measured only about 81dB average sensitivity from 300Hz-3kHz, far below Jamo’s 87dB claim; bass around 80-100Hz and the treble are each roughly 5dB above that midrange reference. The bass is therefore resonant one-note punch rather than deep extension. Horizontal coverage is only about +/-50 degrees, while the midwoofer narrows before the tweeter widens abruptly, creating a directivity discontinuity that EQ cannot repair around 4kHz. Vertical tolerance is especially asymmetric: roughly 10 degrees above tweeter axis is usable, but moving below it rapidly damages the response. At high output, compression and multitone distortion become audible; an 80Hz crossover helps but does not correct the native tonality. Erin’s conclusion was an unequivocal pass in favor of a more neutral alternative.
Full Jamo S 803 review and specifications →
| Bass Extension (-10dB) | 48.7Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 60.1Hz (measured, Erin's Audio Corner) |
| Dimensions | 13.9"H x 7.5"W x 9.9"D (353 x 191 x 252 mm) |
| Drivers | 5" polyfiber woofer, 1" soft-dome tweeter with waveguide |
| Frequency Response | 57Hz-26kHz (manufacturer specified) |
| Impedance | 8 ohms nominal (manufacturer specified) |
| Sensitivity | 81dB (measured average 300Hz-3kHz, Erin's Audio Corner; 87dB manufacturer specified) |
| Weight | 13 lbs / 5.9 kg each |
| Woofer Cabinet | ported, front slot |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons