Short answer: the PSB Imagine T65 for better sound quality, the Dynaudio Emit 30 for the lower price. The PSB Imagine T65 ranks #34 of 68 floorstanding speakers at $2699. The Dynaudio Emit 30 ranks #53 at $1274.25, $1424.75 cheaper.
What the PSB Imagine T65 offers: Three-way design with dual 6.5” woven carbon fiber woofers delivers genuinely strong, extended low end for a $2,699 tower - among the better performers Erin has measured in this price class. Distortion shows a clean second-order character with clear separation from third-order all the way up to 96 dB, indicating a well-controlled motor. Compression data shows enhancement rather than compression below about 50-60 Hz, so the bass can sound louder as you turn it up rather than choking off. Wide, forgiving vertical listening window (about ±25°) thanks to the 3-way layout, giving more seating and placement flexibility than most towers. Plenty of dynamic headroom for home theater use or a two-channel system - 100W drove it comfortably in Erin’s room. Watch for: Noticeable dip in the midrange/crossover region that Erin flagged as affecting dialogue and vocal clarity, though he notes a couple bands of EQ smooths it out. Some horizontal dispersion mismatch (about 10-15° of ballooning between 1-3 kHz) between the midrange and tweeter can add extra perceived attack or detail if your room’s sidewalls are reflective. Dips to 4 ohms, so it wants an amplifier comfortable driving a 4-ohm load. Distortion climbs above 3% around 60 Hz at 96 dB, though it’s benign second-order distortion.
What the Dynaudio Emit 30 offers: A 2.5-way floorstander: two 5.25” mid-woofers paired with a roughly 1” dome tweeter, driven through dual rear bass-reflex ports. The two woofers hand off at staggered crossover points (around 1kHz and 3.5kHz) rather than sharing one, which avoids the acoustic lobing a shared crossover point would cause between the tweeter and the lower woofer, and adds a few dB of sensitivity in the process. Genuinely deep bass for a speaker around this price - measured F3 near 44Hz and extends audibly down to about 40Hz in-room without much difficulty. Harmonic distortion measures clean and low at both 86dB and 96dB SPL/1m. Good CTA-2034 sound power and uniform directivity mean the speaker takes EQ correction well if a listener wants to dial in its one tonal weak point. Dynamic range and compression performance are strong overall, with only a minor, high-Q compression artifact tied to a cone-edge resonance that’s unlikely to be audible. Wide, consistent horizontal dispersion around ±70° with just a small ~10° narrowing between 1-3kHz, and a reasonably forgiving ±20° vertical window centered on the tweeter axis. Watch for: A dip and inconsistency in the lower-treble presence region (roughly 2-5kHz) makes the top end sound uneven - sometimes soft, sometimes forward - depending on the specific instrument or frequency being reproduced; male vocals can lack presence and cymbals can lack sizzle as a result. A cone-edge surround resonance shows up around 1-1.3kHz in burst-decay measurements (a trait the reviewer has also seen on other Dynaudio models) and lines up with elevated multitone distortion across roughly 600Hz-1.5kHz. An enclosure resonance appears around 350Hz in the impedance curve. Placed too close to a rear wall, the dual ports make the bass noticeably boomy - pulling the speaker out is needed to keep the low end from overloading the room. Fully resolving the top-end inconsistency needs a modest EQ correction (roughly +2dB with a Q of about 1, centered 3-6kHz), so out-of-the-box tonal accuracy in that band isn’t quite class-leading despite otherwise strong measured performance.
Buy the PSB Imagine T65 if sound quality matters more than the price. Buy the Dynaudio Emit 30 if the price matters more than sound quality.
If sound quality matters at all to you, skip the Dynaudio Emit 30. It ranks near the bottom of the 68 floorstanding speakers, so look higher up the list instead.
Specifications Side By Side
| PSB Imagine T65 | Dynaudio Emit 30 | |
|---|---|---|
| Price | $2,699 | $1,274.25 |
| Ranked | #34 of 68 in Large Size Floorstanding Speakers | #53 of 68 in Large Size Floorstanding Speakers |
| Drivers | 1" titanium dome tweeter, 5.25" woven carbon fiber midrange, 2x 6.5" woven carbon fiber woofers | Dual 5.25" mid-woofers, 1" soft dome tweeter |
| Crossovers | 600Hz & 2000Hz, 4th-order Linkwitz-Riley | - |
| Dimensions | 38-13/16"H x 8-3/8"W x 13.5"D (986 x 213 x 343mm) | 35.4"H x 6.7"W x 10.7"D (900.0 x 170.0 x 272.0 mm) |
| Weight | 44 lbs each | 34.2 lbs / 15.5 kg |
| Impedance | 8 ohms nominal (3.3 ohms minimum measured by Erin’s Audio Corner; manufacturer specifies 4 ohms minimum) | 4 ohms |
| Sensitivity | 85.1dB (measured average, Erin’s Audio Corner) | 87dB |
| Recommended Power | 20-200W | - |
| Bass Reflex | Dual rear slot ports, individual woofer chambers | - |
| Bass Extension (-3dB) | 47Hz (measured average, Erin’s Audio Corner) | 44Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-10dB) | 26Hz (measured average, Erin’s Audio Corner) | 36Hz (measured, Erin’s Audio Corner) |
| Frequency Response | 28Hz - 20kHz (±1.5dB, manufacturer specified) | 44Hz - 25kHz (±3dB, manufacturer specified) |
| Woofer Cabinet | - | ported, rear (dual) |
| Power Handling | - | 180W (IEC rated) |
| Country of Origin | - | Denmark |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Klipsch RP-6000F II vs Focal Aria Evo X N°2
- ELAC Debut 3.0 DF63 vs Klipsch Heresy IV
- KEF R11 Meta vs ELAC Debut 3.0 DF63
- PSB Imagine T65 vs KEF Q11 Meta
- PSB Imagine T65 vs Magnepan LRS+
Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
PSB Imagine T65: $2,699 The Audio Factory eBay
Pros: Three-way design with dual 6.5” woven carbon fiber woofers delivers genuinely strong, extended low end for a $2,699 tower - among the better performers Erin has measured in this price class. Distortion shows a clean second-order character with clear separation from third-order all the way up to 96 dB, indicating a well-controlled motor. Compression data shows enhancement rather than compression below about 50-60 Hz, so the bass can sound louder as you turn it up rather than choking off. Wide, forgiving vertical listening window (about ±25°) thanks to the 3-way layout, giving more seating and placement flexibility than most towers. Plenty of dynamic headroom for home theater use or a two-channel system - 100W drove it comfortably in Erin’s room.
Cons: Noticeable dip in the midrange/crossover region that Erin flagged as affecting dialogue and vocal clarity, though he notes a couple bands of EQ smooths it out. Some horizontal dispersion mismatch (about 10-15° of ballooning between 1-3 kHz) between the midrange and tweeter can add extra perceived attack or detail if your room’s sidewalls are reflective. Dips to 4 ohms, so it wants an amplifier comfortable driving a 4-ohm load. Distortion climbs above 3% around 60 Hz at 96 dB, though it’s benign second-order distortion.
Full PSB Imagine T65 review and specifications →
| Bass Extension (-10dB) | 26Hz (measured average, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 47Hz (measured average, Erin's Audio Corner) |
| Bass Reflex | Dual rear slot ports, individual woofer chambers |
| Crossovers | 600Hz & 2000Hz, 4th-order Linkwitz-Riley |
| Dimensions | 38-13/16"H x 8-3/8"W x 13.5"D (986 x 213 x 343mm) |
| Drivers | 1" titanium dome tweeter, 5.25" woven carbon fiber midrange, 2x 6.5" woven carbon fiber woofers |
| Frequency Response | 28Hz - 20kHz (±1.5dB, manufacturer specified) |
| Impedance | 8 ohms nominal (3.3 ohms minimum measured by Erin's Audio Corner; manufacturer specifies 4 ohms minimum) |
| Recommended Power | 20-200W |
| Sensitivity | 85.1dB (measured average, Erin's Audio Corner) |
| Weight | 44 lbs each |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- PSB Imagine T65 vs Q Acoustics 5040
- PSB Imagine T65 vs ELAC Debut 3.0 DF63
- PSB Imagine T65 vs Polk Audio Reserve R700
- PSB Imagine T65 vs Polk Reserve R500
- PSB Imagine T65 vs Emotiva Airmotiv T2+
- PSB Imagine T65 vs Definitive Technology BP-9020
- PSB Imagine T65 vs JBL HDI-3600
- PSB Imagine T65 vs Infinity Primus 360
- See all 29 comparisons
Dynaudio Emit 30: $1,274.25 Amazon eBay
Pros: A 2.5-way floorstander: two 5.25” mid-woofers paired with a roughly 1” dome tweeter, driven through dual rear bass-reflex ports. The two woofers hand off at staggered crossover points (around 1kHz and 3.5kHz) rather than sharing one, which avoids the acoustic lobing a shared crossover point would cause between the tweeter and the lower woofer, and adds a few dB of sensitivity in the process. Genuinely deep bass for a speaker around this price - measured F3 near 44Hz and extends audibly down to about 40Hz in-room without much difficulty. Harmonic distortion measures clean and low at both 86dB and 96dB SPL/1m. Good CTA-2034 sound power and uniform directivity mean the speaker takes EQ correction well if a listener wants to dial in its one tonal weak point. Dynamic range and compression performance are strong overall, with only a minor, high-Q compression artifact tied to a cone-edge resonance that’s unlikely to be audible. Wide, consistent horizontal dispersion around ±70° with just a small ~10° narrowing between 1-3kHz, and a reasonably forgiving ±20° vertical window centered on the tweeter axis.
Cons: A dip and inconsistency in the lower-treble presence region (roughly 2-5kHz) makes the top end sound uneven - sometimes soft, sometimes forward - depending on the specific instrument or frequency being reproduced; male vocals can lack presence and cymbals can lack sizzle as a result. A cone-edge surround resonance shows up around 1-1.3kHz in burst-decay measurements (a trait the reviewer has also seen on other Dynaudio models) and lines up with elevated multitone distortion across roughly 600Hz-1.5kHz. An enclosure resonance appears around 350Hz in the impedance curve. Placed too close to a rear wall, the dual ports make the bass noticeably boomy - pulling the speaker out is needed to keep the low end from overloading the room. Fully resolving the top-end inconsistency needs a modest EQ correction (roughly +2dB with a Q of about 1, centered 3-6kHz), so out-of-the-box tonal accuracy in that band isn’t quite class-leading despite otherwise strong measured performance.
Full Dynaudio Emit 30 review and specifications →
| Bass Extension (-10dB) | 36Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 44Hz (measured, Erin's Audio Corner) |
| Country of Origin | Denmark |
| Dimensions | 35.4"H x 6.7"W x 10.7"D (900.0 x 170.0 x 272.0 mm) |
| Drivers | Dual 5.25" mid-woofers, 1" soft dome tweeter |
| Frequency Response | 44Hz - 25kHz (±3dB, manufacturer specified) |
| Impedance | 4 ohms |
| Power Handling | 180W (IEC rated) |
| Sensitivity | 87dB |
| Weight | 34.2 lbs / 15.5 kg |
| Woofer Cabinet | ported, rear (dual) |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Dynaudio Emit 30 vs Klipsch RP-6000F II
- Dynaudio Emit 30 vs Klipsch RP-8000F II
- Dynaudio Emit 30 vs Polk T50
- Dynaudio Emit 30 vs SVS Ultra Evolution Pinnacle
- Dynaudio Emit 30 vs Focal Aria Evo X N°2
- Dynaudio Emit 30 vs Klipsch RP-5000F II
- Dynaudio Emit 30 vs Sony SS-CS3
- Dynaudio Emit 30 vs Infinity Reference 253
- See all 28 comparisons