Klipsch Forte IV vs JBL 4367

Last updated: October 8, 2026

Short answer: the Klipsch Forte IV, if you are buying new. The JBL 4367 ranks higher than it (#16 vs #101 of 188 floorstanding speakers, 4.6/5 vs 4.0/5) but is discontinued, so only consider it used; the Klipsch Forte IV is still sold new at $5,499.98. The JBL 4367’s replacement, the JBL 4369, is rated 4.7/5.

Klipsch Forte IV vs JBL 4367

The case for the Klipsch Forte IV: Three-way heritage design: a 1” titanium tweeter and 1.75” compression driver for the midrange mated to a 12” woofer, plus a 15” passive radiator for extra bass reinforcement. The catch: Contrary to the classic Klipsch reputation for being forward and bright, this model is actually somewhat recessed in the 1.5-4kHz “presence” region, which can make some tracks sound dull or lacking in detail.

The JBL 4367 is the more accurate, deeper-bass choice. Three-way design pairing a 15” front-ported woofer with a compression driver on a controlled-dispersion horn/waveguide, crossed over at 700Hz. Its measured preference score, a predictor of how neutral it sounds, is 5.07 against 3.78 for the Klipsch Forte IV. Its bass reaches about 43Hz before falling 3dB, against 82Hz for the Klipsch Forte IV. The catch: At roughly $16500/pair, this is a major investment: the reviewer recommends buying from a dealer with a liberal return policy.

Buy the Klipsch Forte IV if you want one new; the JBL 4367 is discontinued, so only look for it used.

Want more options? Browse the full Passive Home rankings.

Specifications Side By Side

Klipsch Forte IV JBL 4367
Price$5,499.98 per pair$16,500 per pair Discontinued
Ranked#101 of 188 in Large Size Floorstanding Speakers#16 of 188 in Large Size Floorstanding Speakers
Bass Extension (-10dB)39Hz (measured, Erin’s Audio Corner)31Hz (measured, Erin’s Audio Corner)
Bass Extension (-3dB)82Hz (measured, Erin’s Audio Corner)43Hz (measured, Erin’s Audio Corner)
Sensitivity93.8dB (measured average, Erin’s Audio Corner; manufacturer rates 99dB in-room / ~94dB anechoic)92.5dB (measured average, Erin’s Audio Corner)
Drivers1x 12” (305mm) fiber-composite woofer + 15” passive radiator, 1x 1.75” compression driver midrange on horn, 1x 1” titanium compression tweeter on horn15” (380mm) 2216Nd-1 Dual Differential Drive® woofer, 3” (75mm) D2430K dual compression tweeter
Weight117.3 lbs (53.2 kg)119 lbs (54 kg) each
Woofer Cabinetpassive radiatorported, front
Impedance8 ohms4 ohms nominal (5.3 ohms minimum above 80Hz, measured by Erin’s Audio Corner)
Dimensions36”H x 16.5”W x 13”D (914.4 x 419.1 x 330.2 mm)37.2”H x 22.2”W x 16.8”D (944.9 x 563.9 x 426.7 mm)
Spinorama Preference Score3.785.07
Spinorama Preference Score with Perfect Sub5.726.88
DIY KitNoNo

More worthwhile head-to-heads for JBL 4367:

Prices on this page were last checked October 7, 2026 at 9:25 PM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.

As an eBay Partner, we may be compensated if you make a purchase.

The Two Speakers In Full

Klipsch Forte IV: $5,499.98 per pair Amazon Crutchfield eBay

Klipsch Forte IV ranking card

Same family: the Klipsch Heresy IV (smaller floorstanding, ranked lower, rated 2.3/5), the Klipsch Cornwall IV (larger floorstanding, ranked lower, estimated 2.8/5), the Klipsch La Scala AL6 (larger floorstanding, ranked lower, estimated 2.8/5) and the Klipsch Klipschorn AK7 (larger floorstanding, ranked lower, estimated 3/5).

Pros: Three-way heritage design: a 1” titanium tweeter and 1.75” compression driver for the midrange mated to a 12” woofer, plus a 15” passive radiator for extra bass reinforcement. Genuinely resonance-free cabinet, a clear improvement over the notably boomy, resonant Heresy 4 in the same lineup. Surprisingly wide, expansive soundstage that beat both the Heresy 4 and a KEF LS50 Wireless 2 in direct comparison: images occasionally appeared several feet outside the physical speaker location. Deeper bass extension than the Heresy 4 (F3 of 82Hz, about 10Hz lower). Distortion measures well below 1% at 86dB and stays mostly within 1% even at 96dB. Comes as a factory-matched serial-numbered pair, backed by an unusually generous 10-year warranty. Mostly above 4 ohms impedance, so it’s compatible with AVRs, solid-state, or tube amplifiers. More neutral overall than other Klipsch models the reviewer has tested, making it a reasonable pick for listeners who already like the “Klipsch sound” but want something more balanced. Measured bass extension of 82Hz (-3dB), with a measured sensitivity of 93.8dB.

Cons: Contrary to the classic Klipsch reputation for being forward and bright, this model is actually somewhat recessed in the 1.5-4kHz “presence” region, which can make some tracks sound dull or lacking in detail. A peak around 6kHz reads as sibilant and “painful” when seated exactly on the tweeter axis; sitting a bit above that axis reduces it somewhat. Klipsch’s marketed 99dB sensitivity figure is an in-room rating that assumes 3-6dB of boundary gain: anechoic sensitivity measures closer to 94dB, which the manufacturer does disclose but can still mislead buyers comparing spec sheets. Radiation width isn’t consistent across all frequencies: a noticeable notch around 2-3kHz interrupts otherwise wide dispersion, which can cause a fundamental tone and its harmonics to image in slightly different places in the soundstage. Uses shallow low-pass crossover slopes (despite Klipsch’s steep-crossover marketing, which applies only to the high-pass side), likely contributing to some of the measured dips and possible cone-breakup artifacts. Some compression shows up around the midrange crossover point at very high output (102dB), though likely only audible at extreme volumes. At around $5500/pair, a significant investment, and still needs a subwoofer for material extending below about 50Hz.

Bass Extension (-10dB)39Hz (measured, Erin’s Audio Corner)
Bass Extension (-3dB)82Hz (measured, Erin’s Audio Corner)
DIY KitNo
Dimensions36”H x 16.5”W x 13”D (914.4 x 419.1 x 330.2 mm)
Drivers1x 12” (305mm) fiber-composite woofer + 15” passive radiator, 1x 1.75” compression driver midrange on horn, 1x 1” titanium compression tweeter on horn
Impedance8 ohms
Sensitivity93.8dB (measured average, Erin’s Audio Corner; manufacturer rates 99dB in-room / ~94dB anechoic)
Spinorama Preference Score3.78
Spinorama Preference Score with Perfect Sub5.72
Weight117.3 lbs (53.2 kg)
Woofer Cabinetpassive radiator

JBL 4367: $16,500 per pair Discontinued eBay

JBL 4367 ranking card

Newer model: the JBL 4369, ranked higher, estimated 4.7/5.

Same family: the JBL 4309 (smallest bookshelf, rated 3.3/5), the JBL 4312G (bookshelf, estimated 3.9/5), the JBL 4349 (largest bookshelf, rated 3.6/5) and the JBL 4369 (larger floorstanding, ranked higher, estimated 4.7/5).

Pros: Three-way design pairing a 15” front-ported woofer with a compression driver on a controlled-dispersion horn/waveguide, crossed over at 700Hz. On-axis frequency response is nearly dead flat, holding within about ±1.5dB, with the listening window tracking it closely except right at the crossover. Distortion stays below 1% THD across the entire audible band at both 86dB and 96dB. Compression/dynamic-range linearity is exceptional: within about a quarter of a dB from 76dB to 102dB, among the best the reviewer has measured. High sensitivity (about 92.6dB average) eases the amplifier match despite the speaker’s size. Minimal rear radiation thanks to the 15” woofer’s directivity and front-firing ports: rear energy runs about 20dB down from the primary wavefront, giving it a near-cardioid radiation pattern. Well-controlled horn directivity keeps the soundstage from noticeably shifting in width across the 700Hz crossover region. A natural high-frequency rolloff above about 7-8kHz gives it an easy, non-fatiguing character for extended listening sessions. Measured bass extension of 43Hz (-3dB), with a measured sensitivity of 92.5dB.

Cons: At roughly $16500/pair, this is a major investment: the reviewer recommends buying from a dealer with a liberal return policy. Vertical response shows dips beyond about ±10-20°, with a larger null further out: an inherent trade-off of mating a 15” woofer to a horn compression driver at a 700Hz crossover, since crossing lower would hurt power handling and dynamic range. Horizontal directivity isn’t perfectly consistent with frequency: narrow (about ±20°) through 200-800Hz, briefly widening to near ±50° above the crossover, then narrowing again at high frequency. An unusual, non-constant pattern. The high-frequency rolloff that gives it an easy-listening character also reduces the sense of air and space in the soundstage when listening from off-center seats. Massive and heavy (about 120 lbs, roughly 36-37” tall): needs to be raised on a stand to bring the horn to ear level, and isn’t something one person easily moves alone. Only modest EQ adjustment is available on the speaker itself (about ±1-2dB bass/treble trim). Discontinued.

Bass Extension (-10dB)31Hz (measured, Erin’s Audio Corner)
Bass Extension (-3dB)43Hz (measured, Erin’s Audio Corner)
DIY KitNo
Dimensions37.2”H x 22.2”W x 16.8”D (944.9 x 563.9 x 426.7 mm)
Drivers15” (380mm) 2216Nd-1 Dual Differential Drive® woofer, 3” (75mm) D2430K dual compression tweeter
Impedance4 ohms nominal (5.3 ohms minimum above 80Hz, measured by Erin’s Audio Corner)
Sensitivity92.5dB (measured average, Erin’s Audio Corner)
Spinorama Preference Score5.07
Spinorama Preference Score with Perfect Sub6.88
Weight119 lbs (54 kg) each
Woofer Cabinetported, front