Short answer: the Klipsch Forte IV for better sound quality, the Sony SS-CS3 for the lower price. The Klipsch Forte IV ranks #41 of 68 floorstanding speakers at $5499.98. The Sony SS-CS3 ranks #59 at $450, $5049.98 cheaper.
What the Klipsch Forte IV offers: Three-way heritage design: a 1” titanium tweeter and 1.75” compression driver for the midrange mated to a 12” woofer, plus a 15” passive radiator for extra bass reinforcement. Genuinely resonance-free cabinet, a clear improvement over the notably boomy, resonant Heresy 4 in the same lineup. Surprisingly wide, expansive soundstage that beat both the Heresy 4 and a KEF LS50 Wireless 2 in direct comparison - images occasionally appeared several feet outside the physical speaker location. Deeper bass extension than the Heresy 4 (F3 of 82Hz, about 10Hz lower). Distortion measures well below 1% at 86dB and stays mostly within 1% even at 96dB. Comes as a factory-matched serial-numbered pair, backed by an unusually generous 10-year warranty. Mostly above 4 ohms impedance, so it’s compatible with AVRs, solid-state, or tube amplifiers. More neutral overall than other Klipsch models the reviewer has tested, making it a reasonable pick for listeners who already like the “Klipsch sound” but want something more balanced. Watch for: Contrary to the classic Klipsch reputation for being forward and bright, this model is actually somewhat recessed in the 1.5-4kHz “presence” region, which can make some tracks sound dull or lacking in detail. A peak around 6kHz reads as sibilant and “painful” when seated exactly on the tweeter axis; sitting a bit above that axis reduces it somewhat. Klipsch’s marketed 99dB sensitivity figure is an in-room rating that assumes 3-6dB of boundary gain - anechoic sensitivity measures closer to 94dB, which the manufacturer does disclose but can still mislead buyers comparing spec sheets. Radiation width isn’t consistent across all frequencies - a noticeable notch around 2-3kHz interrupts otherwise wide dispersion, which can cause a fundamental tone and its harmonics to image in slightly different places in the soundstage. Uses shallow low-pass crossover slopes (despite Klipsch’s steep-crossover marketing, which applies only to the high-pass side), likely contributing to some of the measured dips and possible cone-breakup artifacts. Some compression shows up around the midrange crossover point at very high output (102dB), though likely only audible at extreme volumes. At around $5,000/pair, a significant investment, and still needs a subwoofer for material extending below about 50Hz.
What the Sony SS-CS3 offers: Affordable entry-level floorstanding tower offering solid sensitivity (88.6dB SPL at 2.83V/1m), making it easy to power with standard budget AVRs. Harmonic distortion remains reasonably low at moderate listening levels (86dB SPL) when high-pass filtered above 80-100Hz with a dedicated subwoofer. Front-ported design allows relatively close placement to front boundaries without excessive port occlusion. Watch for: Severe cabinet and driver resonances plague the passband between 100Hz and 600Hz, imparting audible coloration and chesty resonances to male vocals and acoustic instruments. Irregular frequency response peaks and dips make automated receiver room correction difficult to equalize effectively. Poor low-frequency extension (F3 of 72Hz, F10 of 39Hz) for a floorstander, combined with rapid distortion escalation below 80Hz at higher SPLs (96dB+). Supertweeter driver adds crossover complexity without providing audible high-frequency benefit within the human hearing spectrum.
Buy the Klipsch Forte IV if sound quality matters more than the price. Buy the Sony SS-CS3 if the price matters more than sound quality.
If sound quality matters at all to you, skip the Sony SS-CS3. It ranks near the bottom of the 68 floorstanding speakers, so look higher up the list instead.
Specifications Side By Side
| Klipsch Forte IV | Sony SS-CS3 | |
|---|---|---|
| Price | $5,499.98 | $450.00 Discontinued |
| Ranked | #41 of 68 in Large Size Floorstanding Speakers | #59 of 68 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 39Hz (measured, Erin’s Audio Corner) | 39Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 82Hz (measured, Erin’s Audio Corner) | 72Hz (measured, Erin’s Audio Corner) |
| Sensitivity | 93.8dB (measured average, Erin’s Audio Corner; manufacturer rates 99dB in-room / ~94dB anechoic) | 88.6dB (measured average, Erin’s Audio Corner) |
| Drivers | 1x 12" (305mm) fiber-composite woofer + 15" passive radiator, 1x 1.75" compression driver midrange on horn, 1x 1" titanium compression tweeter on horn | 0.75 in. supertweeter, 0.98 in. polyester main tweeter, dual 5.12 in. MRC woofers |
| Weight | 117.3 lbs / 53.2 kg | 25.4 lbs / 11.5 kg each |
| Woofer Cabinet | passive radiator | ported, front |
| Impedance | 8 ohms | 6 ohms nominal |
| Dimensions | 36"H x 16.5"W x 13"D (914.4 x 419.1 x 330.2 mm) | 36.3"H x 9.1"W x 10.2"D (922 x 230 x 260 mm) |
| Discontinued | - | Yes |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- KEF R11 Meta vs Focal Aria Evo X N°2
- JBL HDI-3600 vs Focal Aria Evo X N°2
- Klipsch Heresy IV vs Focal Aria Evo X N°2
- Definitive Technology BP-9020 vs Klipsch Forte IV
- Klipsch Forte IV vs Infinity Reference 253
Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Klipsch Forte IV: $5,499.98 Amazon Crutchfield eBay
Pros: Three-way heritage design: a 1” titanium tweeter and 1.75” compression driver for the midrange mated to a 12” woofer, plus a 15” passive radiator for extra bass reinforcement. Genuinely resonance-free cabinet, a clear improvement over the notably boomy, resonant Heresy 4 in the same lineup. Surprisingly wide, expansive soundstage that beat both the Heresy 4 and a KEF LS50 Wireless 2 in direct comparison - images occasionally appeared several feet outside the physical speaker location. Deeper bass extension than the Heresy 4 (F3 of 82Hz, about 10Hz lower). Distortion measures well below 1% at 86dB and stays mostly within 1% even at 96dB. Comes as a factory-matched serial-numbered pair, backed by an unusually generous 10-year warranty. Mostly above 4 ohms impedance, so it’s compatible with AVRs, solid-state, or tube amplifiers. More neutral overall than other Klipsch models the reviewer has tested, making it a reasonable pick for listeners who already like the “Klipsch sound” but want something more balanced.
Cons: Contrary to the classic Klipsch reputation for being forward and bright, this model is actually somewhat recessed in the 1.5-4kHz “presence” region, which can make some tracks sound dull or lacking in detail. A peak around 6kHz reads as sibilant and “painful” when seated exactly on the tweeter axis; sitting a bit above that axis reduces it somewhat. Klipsch’s marketed 99dB sensitivity figure is an in-room rating that assumes 3-6dB of boundary gain - anechoic sensitivity measures closer to 94dB, which the manufacturer does disclose but can still mislead buyers comparing spec sheets. Radiation width isn’t consistent across all frequencies - a noticeable notch around 2-3kHz interrupts otherwise wide dispersion, which can cause a fundamental tone and its harmonics to image in slightly different places in the soundstage. Uses shallow low-pass crossover slopes (despite Klipsch’s steep-crossover marketing, which applies only to the high-pass side), likely contributing to some of the measured dips and possible cone-breakup artifacts. Some compression shows up around the midrange crossover point at very high output (102dB), though likely only audible at extreme volumes. At around $5,000/pair, a significant investment, and still needs a subwoofer for material extending below about 50Hz.
Full Klipsch Forte IV review and specifications →
| Bass Extension (-10dB) | 39Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 82Hz (measured, Erin's Audio Corner) |
| Dimensions | 36"H x 16.5"W x 13"D (914.4 x 419.1 x 330.2 mm) |
| Drivers | 1x 12" (305mm) fiber-composite woofer + 15" passive radiator, 1x 1.75" compression driver midrange on horn, 1x 1" titanium compression tweeter on horn |
| Impedance | 8 ohms |
| Sensitivity | 93.8dB (measured average, Erin's Audio Corner; manufacturer rates 99dB in-room / ~94dB anechoic) |
| Weight | 117.3 lbs / 53.2 kg |
| Woofer Cabinet | passive radiator |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Klipsch Forte IV vs Infinity Primus 360
- Klipsch Forte IV vs Definitive Technology BP-9020
- Klipsch Forte IV vs Polk Audio XT60
- Klipsch Forte IV vs Klipsch Heresy IV
- Klipsch Forte IV vs KEF Q11 Meta
- Klipsch Forte IV vs Polk Reserve R500
- Klipsch Forte IV vs ELAC Debut 3.0 DF63
- Klipsch Forte IV vs Klipsch RP-5000F II
- See all 40 comparisons
Sony SS-CS3: $450.00 Discontinued eBay
Pros: Affordable entry-level floorstanding tower offering solid sensitivity (88.6dB SPL at 2.83V/1m), making it easy to power with standard budget AVRs. Harmonic distortion remains reasonably low at moderate listening levels (86dB SPL) when high-pass filtered above 80-100Hz with a dedicated subwoofer. Front-ported design allows relatively close placement to front boundaries without excessive port occlusion.
Cons: Severe cabinet and driver resonances plague the passband between 100Hz and 600Hz, imparting audible coloration and chesty resonances to male vocals and acoustic instruments. Irregular frequency response peaks and dips make automated receiver room correction difficult to equalize effectively. Poor low-frequency extension (F3 of 72Hz, F10 of 39Hz) for a floorstander, combined with rapid distortion escalation below 80Hz at higher SPLs (96dB+). Supertweeter driver adds crossover complexity without providing audible high-frequency benefit within the human hearing spectrum. Discontinued.
Full Sony SS-CS3 review and specifications →
| Bass Extension (-10dB) | 39Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 72Hz (measured, Erin's Audio Corner) |
| Dimensions | 36.3"H x 9.1"W x 10.2"D (922 x 230 x 260 mm) |
| Discontinued | Yes |
| Drivers | 0.75 in. supertweeter, 0.98 in. polyester main tweeter, dual 5.12 in. MRC woofers |
| Impedance | 6 ohms nominal |
| Sensitivity | 88.6dB (measured average, Erin's Audio Corner) |
| Weight | 25.4 lbs / 11.5 kg each |
| Woofer Cabinet | ported, front |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons


