Short answer: the MoFi SourcePoint V10 Master Edition if sound quality matters most, the Klipsch Forte IV if price matters most. The MoFi SourcePoint V10 Master Edition ranks #3 of 71 floorstanding speakers at $8000. The Klipsch Forte IV ranks #41 at $5499.98, $2500.02 cheaper.
The case for the Klipsch Forte IV: Three-way heritage design: a 1” titanium tweeter and 1.75” compression driver for the midrange mated to a 12” woofer. Set against that: Contrary to the classic Klipsch reputation for being forward and bright.
What the MoFi SourcePoint V10 Master Edition gets right: Extended bass to approximately 30 Hz in-room without subwoofer. The catch: Moderate sensitivity (~89 dB) means amplifier power requirements higher than many alternatives.
Buy the Klipsch Forte IV if the price matters more than sound quality. Buy the MoFi SourcePoint V10 Master Edition if sound quality matters more than the price.
Specifications Side By Side
| Klipsch Forte IV | MoFi SourcePoint V10 Master Edition | |
|---|---|---|
| Price | $5,499.98 | $8000 |
| Ranked | #41 of 71 in Large Size Floorstanding Speakers | #3 of 71 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 39Hz (measured, Erin’s Audio Corner) | 25Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 82Hz (measured, Erin’s Audio Corner) | 38Hz (measured, Erin’s Audio Corner) |
| Sensitivity | 93.8dB (measured average, Erin’s Audio Corner; manufacturer rates 99dB in-room / ~94dB anechoic) | 88.8dB (measured, Erin’s Audio Corner) |
| Drivers | 1x 12" (305mm) fiber-composite woofer + 15" passive radiator, 1x 1.75" compression driver midrange on horn, 1x 1" titanium compression tweeter on horn | 10" woofer, 10" paper‑cone concentric midrange, 1.25" soft‑dome concentric tweeter |
| Weight | 117.3 lbs / 53.2 kg | 160.9 lbs / 73 kg |
| Woofer Cabinet | passive radiator | passive radiator |
| Impedance | 8 ohms | 6 ohms nominal, 5.3 ohms minimum (measured, Erin’s Audio Corner) |
| Dimensions | 36"H x 16.5"W x 13"D (914.4 x 419.1 x 330.2 mm) | 48.8"H x 15.5"W x 19.9"D (1239.5 x 393.7 x 505.5 mm) |
Related Speaker Comparisons
How MoFi SourcePoint V10 Master Edition compares with other leading options:
- GR-Research NX-Treme vs MoFi SourcePoint V10 Master Edition
- KEF Blade Two Meta vs MoFi SourcePoint V10 Master Edition
- MoFi SourcePoint 888 vs MoFi SourcePoint V10 Master Edition
- JBL HDI-3800 vs MoFi SourcePoint V10 Master Edition
- MoFi SourcePoint V10 Master Edition vs Revel F328Be
Prices on this page were last checked September 8, 2026 at 6:02 PM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Klipsch Forte IV: $5,499.98 Amazon Crutchfield eBay
Pros: Three-way heritage design: a 1” titanium tweeter and 1.75” compression driver for the midrange mated to a 12” woofer, plus a 15” passive radiator for extra bass reinforcement. Genuinely resonance-free cabinet, a clear improvement over the notably boomy, resonant Heresy 4 in the same lineup. Surprisingly wide, expansive soundstage that beat both the Heresy 4 and a KEF LS50 Wireless 2 in direct comparison - images occasionally appeared several feet outside the physical speaker location. Deeper bass extension than the Heresy 4 (F3 of 82Hz, about 10Hz lower). Distortion measures well below 1% at 86dB and stays mostly within 1% even at 96dB. Comes as a factory-matched serial-numbered pair, backed by an unusually generous 10-year warranty. Mostly above 4 ohms impedance, so it’s compatible with AVRs, solid-state, or tube amplifiers. More neutral overall than other Klipsch models the reviewer has tested, making it a reasonable pick for listeners who already like the “Klipsch sound” but want something more balanced.
Cons: Contrary to the classic Klipsch reputation for being forward and bright, this model is actually somewhat recessed in the 1.5-4kHz “presence” region, which can make some tracks sound dull or lacking in detail. A peak around 6kHz reads as sibilant and “painful” when seated exactly on the tweeter axis; sitting a bit above that axis reduces it somewhat. Klipsch’s marketed 99dB sensitivity figure is an in-room rating that assumes 3-6dB of boundary gain - anechoic sensitivity measures closer to 94dB, which the manufacturer does disclose but can still mislead buyers comparing spec sheets. Radiation width isn’t consistent across all frequencies - a noticeable notch around 2-3kHz interrupts otherwise wide dispersion, which can cause a fundamental tone and its harmonics to image in slightly different places in the soundstage. Uses shallow low-pass crossover slopes (despite Klipsch’s steep-crossover marketing, which applies only to the high-pass side), likely contributing to some of the measured dips and possible cone-breakup artifacts. Some compression shows up around the midrange crossover point at very high output (102dB), though likely only audible at extreme volumes. At around $5,000/pair, a significant investment, and still needs a subwoofer for material extending below about 50Hz.
Full Klipsch Forte IV review and specifications →
| Bass Extension (-10dB) | 39Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 82Hz (measured, Erin's Audio Corner) |
| Dimensions | 36"H x 16.5"W x 13"D (914.4 x 419.1 x 330.2 mm) |
| Drivers | 1x 12" (305mm) fiber-composite woofer + 15" passive radiator, 1x 1.75" compression driver midrange on horn, 1x 1" titanium compression tweeter on horn |
| Impedance | 8 ohms |
| Sensitivity | 93.8dB (measured average, Erin's Audio Corner; manufacturer rates 99dB in-room / ~94dB anechoic) |
| Weight | 117.3 lbs / 53.2 kg |
| Woofer Cabinet | passive radiator |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Klipsch Forte IV vs Infinity Primus 360
- Klipsch Forte IV vs Polk Audio XT70
- Klipsch Forte IV vs Definitive Technology BP-9020
- Klipsch Forte IV vs Polk Audio XT60
- Klipsch Forte IV vs Klipsch Heresy IV
- Klipsch Forte IV vs KEF Q11 Meta
- Klipsch Forte IV vs Polk Reserve R500
- Klipsch Forte IV vs ELAC Debut 3.0 DF63
- See all 44 comparisons
MoFi SourcePoint V10 Master Edition: $8000 Crutchfield eBay
Pros: Extended bass to approximately 30 Hz in-room without subwoofer; images with excellent precision indicating tight frequency response matching between speakers. Integrated bass management with three-way treble attenuation switches for room tuning. New design from Andrew Jones represents reviewer personal second choice (behind only KEF Blade 2 Meta at 29k) among hundreds of systems auditioned; ranks above Dutch & Dutch 8C, JBL 4367, and JBL M2.
Cons: Moderate sensitivity (~89 dB) means amplifier power requirements higher than many alternatives. Deep bass extension ends above subsonic frequencies (pipe organ territory below 17 Hz requires subwoofer).
Full MoFi SourcePoint V10 Master Edition review and specifications →
| Bass Extension (-10dB) | 25Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 38Hz (measured, Erin's Audio Corner) |
| Dimensions | 48.8"H x 15.5"W x 19.9"D (1239.5 x 393.7 x 505.5 mm) |
| Drivers | 10" woofer, 10" paper‑cone concentric midrange, 1.25" soft‑dome concentric tweeter |
| Impedance | 6 ohms nominal, 5.3 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 88.8dB (measured, Erin's Audio Corner) |
| Weight | 160.9 lbs / 73 kg |
| Woofer Cabinet | passive radiator |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- MoFi SourcePoint V10 Master Edition vs KEF Blade Two Meta
- MoFi SourcePoint V10 Master Edition vs MoFi SourcePoint 888
- MoFi SourcePoint V10 Master Edition vs GR-Research NX-Treme
- MoFi SourcePoint V10 Master Edition vs JBL HDI-3800
- MoFi SourcePoint V10 Master Edition vs Revel F328Be
- MoFi SourcePoint V10 Master Edition vs Revel F226Be
- MoFi SourcePoint V10 Master Edition vs Revel F208
- MoFi SourcePoint V10 Master Edition vs JBL Studio 698
- See all 12 comparisons