Short answer: the V10 Master Edition if budget allows, the 888 if it doesn’t. The V10 Master Edition ranks #4 of 71 large floorstanding speakers against the 888’s #3, and it costs $2500 more.
Both are exceptional by Erin’s Audio Corner’s measurements, and the reviewer ranks them almost back to back. The 888 is described as among the reviewer’s personal top three speakers out of roughly 200 tested, alongside the KEF Blade 2 Meta and Dutch & Dutch 8C, despite costing a fraction of either. The V10 Master Edition, a newer Andrew Jones design, ranks as the reviewer’s personal second choice behind only the KEF Blade 2 Meta, ahead of the Dutch & Dutch 8C, JBL 4367, and JBL M2. In measured performance, the two are close: the 888 shows excellent compression and dynamic-range linearity and on-axis/30-degree-off-axis tracking within about 1 to 1.5dB above 500Hz, meaning its tonal balance barely shifts with listening position.
Bass extension and cabinet size are the clearest physical differences. The V10 Master Edition reaches slightly deeper at -10dB (25Hz versus 26Hz) but the 888 actually holds on further at -3dB (34Hz versus 38Hz for the V10). The V10 Master Edition is also dramatically larger and heavier at roughly 161 lbs against the 888’s roughly 95 lbs per speaker, and uses a passive-radiator woofer cabinet with three-way treble attenuation switches for room tuning, while the 888 is ported.
The 888 is pickier about placement, the V10 Master Edition is pickier about amplification. Our notes say the 888 needs about two feet of rear wall clearance, with boominess if placed closer and lost extension if placed farther, and loses top-end energy if toed out more than about 10 degrees. The V10 Master Edition’s lower sensitivity, about 89dB against the 888’s roughly 86dB, means it demands more amplifier power to reach the same volume.
Buy the 888 if you want nearly the same caliber of measured performance for $2500 less, and have the floor space for careful placement.
Buy the V10 Master Edition if you have the budget and amplifier power to spare. Erin’s Audio Corner ranks it as close to a personal favorite as any speaker reviewed.
Specifications Side By Side
| MoFi SourcePoint 888 | MoFi SourcePoint V10 Master Edition | |
|---|---|---|
| Price | $5500 | $8000 |
| Ranked | #4 of 71 in Large Size Floorstanding Speakers | #3 of 71 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 26Hz (measured, Erin’s Audio Corner) | 25Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 34Hz (measured, Erin’s Audio Corner) | 38Hz (measured, Erin’s Audio Corner) |
| Dimensions | 41.2"H x 12.6"W x 16.1"D (1046.5 x 320 x 408.9 mm) | 48.8"H x 15.5"W x 19.9"D (1239.5 x 393.7 x 505.5 mm) |
| Impedance | 6 ohms nominal, 5 ohms minimum (measured, Erin’s Audio Corner) | 6 ohms nominal, 5.3 ohms minimum (measured, Erin’s Audio Corner) |
| Drivers | Dual 8" paper cone woofers, 8" Paper Cone midrange, 1.25" wide roll soft dome tweeter | 10" woofer, 10" paper‑cone concentric midrange, 1.25" soft‑dome concentric tweeter |
| Sensitivity | 85.6dB (measured, Erin’s Audio Corner) | 88.8dB (measured, Erin’s Audio Corner) |
| Weight | 94.8 lbs / 43 kg each | 160.9 lbs / 73 kg |
| Woofer Cabinet | ported, rear | passive radiator |
Related Speaker Comparisons
More top alternatives to MoFi SourcePoint V10 Master Edition:
- GR-Research NX-Treme vs MoFi SourcePoint V10 Master Edition
- KEF Blade Two Meta vs MoFi SourcePoint V10 Master Edition
- JBL HDI-3800 vs MoFi SourcePoint V10 Master Edition
- MoFi SourcePoint V10 Master Edition vs Revel F328Be
- Revel F226Be vs MoFi SourcePoint V10 Master Edition
Prices on this page were last checked September 8, 2026 at 6:02 PM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
MoFi SourcePoint 888: $5500 Crutchfield eBay
Pros: Three-way vented design: an 8” coaxial mid-range/1.25” dome tweeter driver plus two additional 8” woofers crossed at about 130Hz, giving genuinely full-range output (F3 34Hz, F10 26Hz) other than the deepest subsonic content. Ranked by the reviewer among his personal top three speakers out of roughly 200 tested, alongside the KEF Blade 2 Meta and Dutch & Dutch 8C, despite costing a small fraction of either. Excellent compression/dynamic-range linearity, holding its own against much pricier speakers like the March Audio Sointuva AWG, KEF Reference 1 Meta, and KEF Blade 2 Meta. On-axis (0°) and 30°-off-axis estimated in-room responses track within about 1-1.5dB of each other above 500Hz, so tonal balance barely changes with placement or listening angle - excellent for multi-seat home theater or entertaining. Wide horizontal dispersion of about ±60°. Distortion stays low: under 1% at 86dB, and under 1% above 200Hz even at 96dB, with multitone distortion mostly under 1% as well. Not a difficult amplifier load (5-ohm minimum impedance, 4.2-ohm minimum EPDR). Checks the three boxes the reviewer considers essential for a home theater speaker: low compression, low distortion, and excellent directivity.
Cons: A significant investment, best ordered from a dealer with a good return policy. Large and heavy floorstander (about 96 lbs, 42” tall) requiring real floor space and rear clearance. Positioning is fairly specific: needs about 2 feet from the rear wall - closer causes boominess in the 40-50Hz region, farther loses bass extension. Vertical dispersion (about ±50°) is narrower than horizontal (about ±60°), since the two 8” woofers are spaced vertically apart on a tower cabinet, causing some vertical mismatch at lower frequencies. A small on-axis dip around 500Hz and a deliberately lower tweeter level (about 0.5dB below the midrange) are intentional design choices for smoother in-room response, but mean the raw on-axis measurement isn’t perfectly flat. A mild diffraction-related dip appears around 3kHz in directivity measurements. Toeing the speaker out more than about 10° starts to noticeably reduce top-end energy.
Full MoFi SourcePoint 888 review and specifications →
| Bass Extension (-10dB) | 26Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 34Hz (measured, Erin's Audio Corner) |
| Dimensions | 41.2"H x 12.6"W x 16.1"D (1046.5 x 320 x 408.9 mm) |
| Drivers | Dual 8" paper cone woofers, 8" Paper Cone midrange, 1.25" wide roll soft dome tweeter |
| Impedance | 6 ohms nominal, 5 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 85.6dB (measured, Erin's Audio Corner) |
| Weight | 94.8 lbs / 43 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- MoFi SourcePoint 888 vs KEF Blade Two Meta
- MoFi SourcePoint 888 vs GR-Research NX-Treme
- MoFi SourcePoint 888 vs JBL HDI-3800
- MoFi SourcePoint 888 vs Revel F328Be
- MoFi SourcePoint 888 vs KEF R5 Meta
- MoFi SourcePoint 888 vs KEF R5
- MoFi SourcePoint 888 vs Revel F226Be
- MoFi SourcePoint 888 vs JBL 4367
- See all 27 comparisons
MoFi SourcePoint V10 Master Edition: $8000 Crutchfield eBay
Pros: Extended bass to approximately 30 Hz in-room without subwoofer; images with excellent precision indicating tight frequency response matching between speakers. Integrated bass management with three-way treble attenuation switches for room tuning. New design from Andrew Jones represents reviewer personal second choice (behind only KEF Blade 2 Meta at 29k) among hundreds of systems auditioned; ranks above Dutch & Dutch 8C, JBL 4367, and JBL M2.
Cons: Moderate sensitivity (~89 dB) means amplifier power requirements higher than many alternatives. Deep bass extension ends above subsonic frequencies (pipe organ territory below 17 Hz requires subwoofer).
Full MoFi SourcePoint V10 Master Edition review and specifications →
| Bass Extension (-10dB) | 25Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 38Hz (measured, Erin's Audio Corner) |
| Dimensions | 48.8"H x 15.5"W x 19.9"D (1239.5 x 393.7 x 505.5 mm) |
| Drivers | 10" woofer, 10" paper‑cone concentric midrange, 1.25" soft‑dome concentric tweeter |
| Impedance | 6 ohms nominal, 5.3 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 88.8dB (measured, Erin's Audio Corner) |
| Weight | 160.9 lbs / 73 kg |
| Woofer Cabinet | passive radiator |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- MoFi SourcePoint V10 Master Edition vs KEF Blade Two Meta
- MoFi SourcePoint V10 Master Edition vs GR-Research NX-Treme
- MoFi SourcePoint V10 Master Edition vs JBL HDI-3800
- MoFi SourcePoint V10 Master Edition vs Revel F328Be
- MoFi SourcePoint V10 Master Edition vs Revel F226Be
- MoFi SourcePoint V10 Master Edition vs Revel F208
- MoFi SourcePoint V10 Master Edition vs JBL Studio 698
- MoFi SourcePoint V10 Master Edition vs Revel Concerta2 F35
- See all 12 comparisons