Short answer: the Polk Audio Reserve R700. It ranks #32 of 68 floorstanding speakers by sound quality at $1199; the Klipsch RP-6000F II ranks #54 and costs $1500, so there is not much of a tradeoff to weigh.
What the Polk Audio Reserve R700 offers: Three-way design with a 1” ring radiator tweeter, 6.5” mid-range, and dual 8” mid-bass drivers in a ported, down-firing cabinet. On-axis frequency response holds within about ±2dB across most of its range, with genuinely deep bass extension (F3 40Hz) reaching into the mid-30s Hz in-room. Wide horizontal radiation of about ±70°, giving a strong, enveloping stereo width and stage-extension effect on well-recorded tracks. Good low-level dynamics - solid bass thump at quiet listening volumes without over-accentuation. Strong distortion and compression control through the bass and midrange. Real nominal impedance closer to 4 ohms than the marketed 8 ohms, so with the right amplifier it can be driven hard - a $3,000 two-channel integrated brought out significantly more life than a budget $300 unit could. Excellent value at its roughly $2,200/pair MSRP, ranking among the reviewer’s top picks under $2,500; outperforms the similarly-priced Klipsch RP-8000F II in bass extension and overall smoothness. Watch for: Compression in the high frequencies rises sharply between 96dB and 102dB output - a real limitation only at very high volumes (around 100dB at 3 meters), but a clear step down from pricier ($5,000+) towers. Horizontal directivity mismatch around 4-5kHz, where the tweeter flares wider than the midrange, can sound a bit forward - especially noticeable when toed out further into the room; sidewall absorption or curtains help tame it. Harmonic distortion crosses the reviewer’s 3% threshold around 7kHz at 96dB output, possibly contributing to that same forward quality at high volume. Narrow vertical sweet spot (about ±15° from the tweeter axis), typical of non-coaxial tower designs - more of a consideration for multi-row home theater seating than single-row listening. The ring-radiator tweeter narrows noticeably above about 7-8kHz, and toeing the speaker out more than about 20° causes the top end to fall off quickly. Needs at least 2 feet of clearance from the rear wall to avoid boomy, exaggerated bass, since it lacks the bass-shelf tuning some rivals use to allow closer wall placement. Compared to the pricier KEF R5 Meta, has narrower horizontal (and much narrower vertical) directivity, so seating flexibility is more limited.
What the Klipsch RP-6000F II offers: Highest power handling and clean, well-behaved compression at typical volumes. Precise imaging from the controlled horn directivity. Watch for: Worse baffle-step coloration than the smaller RP-5000F II (3-4dB swing vs 2dB), plus a sibilance issue the 5000F doesn’t have - a real regression in tonal balance despite the higher price. Bass extension is mixed - less deep at -3dB (67Hz) than the 5000F - and needs a subwoofer regardless. Narrow horizontal dispersion (~50-60 degrees).
Buy the Polk Audio Reserve R700. It ranks higher for sound quality than the Klipsch RP-6000F II and costs less, so there is no real case for the other one.
If sound quality matters at all to you, skip the Klipsch RP-6000F II. It ranks near the bottom of the 68 floorstanding speakers, so look higher up the list instead.
Specifications Side By Side
| Polk Audio Reserve R700 | Klipsch RP-6000F II | |
|---|---|---|
| Price | $1,199.00 | $1500 |
| Ranked | #32 of 68 in Large Size Floorstanding Speakers | #54 of 68 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 31Hz (measured, Erin’s Audio Corner) | 33Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 40Hz (measured, Erin’s Audio Corner) | 67Hz (measured, Erin’s Audio Corner) |
| Impedance | 4 ohms nominal, 3.5 ohms minimum (measured above 80Hz, Erin’s Audio Corner) | 8 ohms nominal (3.7 ohms minimum, measured, Erin’s Audio Corner) |
| Sensitivity | 87.5dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin’s Audio Corner) | 90dB (2.83V/1m, measured by Erin’s Audio Corner) |
| Drivers | 2x 8" polypropylene cone woofers, 1x 6.5" turbine cone midrange, 1x 1" Pinnacle ring radiator tweeter | 1" titanium tweeter with Tractrix horn, dual 6.5" cerametallic woofers |
| Weight | 102.1 lbs / 46.3 kg | 49.4 lbs / 22.4 kg |
| Woofer Cabinet | ported, down-firing | ported, rear |
| Dimensions | 45"H x 12.6"W x 16.9"D (1143.8 x 320.7 x 428.3 mm) | 39.6" x 9.3" x 17.6" (1006 x 236 x 446 mm) |
| Frequency Response | - | 38Hz - 25kHz (+-3dB, Manufacturer specified) |
| Crossover Frequency | - | 1770Hz |
| Output Power | - | 125W continuous, 500W peak |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Polk T50 vs Focal Aria Evo X N°2
- JBL Studio 698 vs Morel Avyra 633
- Dynaudio Emit 30 vs Magnepan LRS+
- Klipsch RP-5000F II vs Klipsch RP-6000F II
- KEF Q11 Meta vs Klipsch RP-6000F II
Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Polk Audio Reserve R700: $1,199.00 Amazon eBay
Pros: Three-way design with a 1” ring radiator tweeter, 6.5” mid-range, and dual 8” mid-bass drivers in a ported, down-firing cabinet. On-axis frequency response holds within about ±2dB across most of its range, with genuinely deep bass extension (F3 40Hz) reaching into the mid-30s Hz in-room. Wide horizontal radiation of about ±70°, giving a strong, enveloping stereo width and stage-extension effect on well-recorded tracks. Good low-level dynamics - solid bass thump at quiet listening volumes without over-accentuation. Strong distortion and compression control through the bass and midrange. Real nominal impedance closer to 4 ohms than the marketed 8 ohms, so with the right amplifier it can be driven hard - a $3,000 two-channel integrated brought out significantly more life than a budget $300 unit could. Excellent value at its roughly $2,200/pair MSRP, ranking among the reviewer’s top picks under $2,500; outperforms the similarly-priced Klipsch RP-8000F II in bass extension and overall smoothness.
Cons: Compression in the high frequencies rises sharply between 96dB and 102dB output - a real limitation only at very high volumes (around 100dB at 3 meters), but a clear step down from pricier ($5,000+) towers. Horizontal directivity mismatch around 4-5kHz, where the tweeter flares wider than the midrange, can sound a bit forward - especially noticeable when toed out further into the room; sidewall absorption or curtains help tame it. Harmonic distortion crosses the reviewer’s 3% threshold around 7kHz at 96dB output, possibly contributing to that same forward quality at high volume. Narrow vertical sweet spot (about ±15° from the tweeter axis), typical of non-coaxial tower designs - more of a consideration for multi-row home theater seating than single-row listening. The ring-radiator tweeter narrows noticeably above about 7-8kHz, and toeing the speaker out more than about 20° causes the top end to fall off quickly. Needs at least 2 feet of clearance from the rear wall to avoid boomy, exaggerated bass, since it lacks the bass-shelf tuning some rivals use to allow closer wall placement. Compared to the pricier KEF R5 Meta, has narrower horizontal (and much narrower vertical) directivity, so seating flexibility is more limited.
Full Polk Audio Reserve R700 review and specifications →
| Bass Extension (-10dB) | 31Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 40Hz (measured, Erin's Audio Corner) |
| Dimensions | 45"H x 12.6"W x 16.9"D (1143.8 x 320.7 x 428.3 mm) |
| Drivers | 2x 8" polypropylene cone woofers, 1x 6.5" turbine cone midrange, 1x 1" Pinnacle ring radiator tweeter |
| Impedance | 4 ohms nominal, 3.5 ohms minimum (measured above 80Hz, Erin's Audio Corner) |
| Sensitivity | 87.5dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin's Audio Corner) |
| Weight | 102.1 lbs / 46.3 kg |
| Woofer Cabinet | ported, down-firing |
- Links
- Reviews, Comparisons and Sound Samples
- Erin’s Audio Corner: My Top 5 Just Changed: Polk Audio Reserve R700 Review More from Erin’s Audio Corner →
- Erin’s Audio Corner: My Absolute Favorite Products of 2024 Revealed
- Erin’s Audio Corner Website: Polk Audio Reserve R700
- Erin’s Audio Corner Measurements (spinorama.org)
- Reddit Search for Polk Audio Reserve R700 Review
- Head-to-Head Comparisons
- Polk Audio Reserve R700 vs Q Acoustics 5040
- Polk Audio Reserve R700 vs Emotiva Airmotiv T2+
- Polk Audio Reserve R700 vs PSB Imagine T65
- Polk Audio Reserve R700 vs ELAC Debut 3.0 DF63
- Polk Audio Reserve R700 vs Polk Reserve R500
- Polk Audio Reserve R700 vs JBL HDI-3600
- Polk Audio Reserve R700 vs KEF R11 Meta
- Polk Audio Reserve R700 vs Definitive Technology BP-9020
- See all 27 comparisons
Klipsch RP-6000F II: $1500 Amazon eBay
Pros: Highest power handling and clean, well-behaved compression at typical volumes. Precise imaging from the controlled horn directivity.
Cons: Worse baffle-step coloration than the smaller RP-5000F II (3-4dB swing vs 2dB), plus a sibilance issue the 5000F doesn’t have - a real regression in tonal balance despite the higher price. Bass extension is mixed - less deep at -3dB (67Hz) than the 5000F - and needs a subwoofer regardless. Narrow horizontal dispersion (~50-60 degrees).
Full Klipsch RP-6000F II review and specifications →
| Bass Extension (-10dB) | 33Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 67Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 1770Hz |
| Dimensions | 39.6" x 9.3" x 17.6" (1006 x 236 x 446 mm) |
| Drivers | 1" titanium tweeter with Tractrix horn, dual 6.5" cerametallic woofers |
| Frequency Response | 38Hz - 25kHz (+-3dB, Manufacturer specified) |
| Impedance | 8 ohms nominal (3.7 ohms minimum, measured, Erin's Audio Corner) |
| Output Power | 125W continuous, 500W peak |
| Sensitivity | 90dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 49.4 lbs / 22.4 kg |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Klipsch RP-6000F II vs Dynaudio Emit 30
- Klipsch RP-6000F II vs Polk T50
- Klipsch RP-6000F II vs Klipsch RP-8000F II
- Klipsch RP-6000F II vs Focal Aria Evo X N°2
- Klipsch RP-6000F II vs Sony SS-CS3
- Klipsch RP-6000F II vs SVS Ultra Evolution Pinnacle
- Klipsch RP-6000F II vs Klipsch RP-5000F II
- Klipsch RP-6000F II vs Infinity Reference 253
- See all 19 comparisons