Polk Audio Reserve R700 vs MoFi SourcePoint 888

Last updated: August 25, 2026

Short answer: the MoFi SourcePoint 888 for better sound quality, the Polk Audio Reserve R700 for the lower price. The MoFi SourcePoint 888 ranks #4 of 71 floorstanding speakers at $5500. The Polk Audio Reserve R700 ranks #32 at $1199, $4301 cheaper.

What the Polk Audio Reserve R700 offers: Three-way design with a 1” ring radiator tweeter, 6.5” mid-range, and dual 8” mid-bass drivers in a ported, down-firing cabinet. On-axis frequency response holds within about ±2dB across most of its range, with genuinely deep bass extension (F3 40Hz) reaching into the mid-30s Hz in-room. Wide horizontal radiation of about ±70°, giving a strong, enveloping stereo width and stage-extension effect on well-recorded tracks. Good low-level dynamics - solid bass thump at quiet listening volumes without over-accentuation. Strong distortion and compression control through the bass and midrange. Real nominal impedance closer to 4 ohms than the marketed 8 ohms, so with the right amplifier it can be driven hard - a $3,000 two-channel integrated brought out significantly more life than a budget $300 unit could. Excellent value at its roughly $2,200/pair MSRP, ranking among the reviewer’s top picks under $2,500; outperforms the similarly-priced Klipsch RP-8000F II in bass extension and overall smoothness. Watch for: Compression in the high frequencies rises sharply between 96dB and 102dB output - a real limitation only at very high volumes (around 100dB at 3 meters), but a clear step down from pricier ($5,000+) towers. Horizontal directivity mismatch around 4-5kHz, where the tweeter flares wider than the midrange, can sound a bit forward - especially noticeable when toed out further into the room; sidewall absorption or curtains help tame it. Harmonic distortion crosses the reviewer’s 3% threshold around 7kHz at 96dB output, possibly contributing to that same forward quality at high volume. Narrow vertical sweet spot (about ±15° from the tweeter axis), typical of non-coaxial tower designs - more of a consideration for multi-row home theater seating than single-row listening. The ring-radiator tweeter narrows noticeably above about 7-8kHz, and toeing the speaker out more than about 20° causes the top end to fall off quickly. Needs at least 2 feet of clearance from the rear wall to avoid boomy, exaggerated bass, since it lacks the bass-shelf tuning some rivals use to allow closer wall placement. Compared to the pricier KEF R5 Meta, has narrower horizontal (and much narrower vertical) directivity, so seating flexibility is more limited.

What the MoFi SourcePoint 888 offers: Three-way vented design: an 8” coaxial mid-range/1.25” dome tweeter driver plus two additional 8” woofers crossed at about 130Hz, giving genuinely full-range output (F3 34Hz, F10 26Hz) other than the deepest subsonic content. Ranked by the reviewer among his personal top three speakers out of roughly 200 tested, alongside the KEF Blade 2 Meta and Dutch & Dutch 8C, despite costing a small fraction of either. Excellent compression/dynamic-range linearity, holding its own against much pricier speakers like the March Audio Sointuva AWG, KEF Reference 1 Meta, and KEF Blade 2 Meta. On-axis (0°) and 30°-off-axis estimated in-room responses track within about 1-1.5dB of each other above 500Hz, so tonal balance barely changes with placement or listening angle - excellent for multi-seat home theater or entertaining. Wide horizontal dispersion of about ±60°. Distortion stays low: under 1% at 86dB, and under 1% above 200Hz even at 96dB, with multitone distortion mostly under 1% as well. Not a difficult amplifier load (5-ohm minimum impedance, 4.2-ohm minimum EPDR). Checks the three boxes the reviewer considers essential for a home theater speaker: low compression, low distortion, and excellent directivity. Watch for: A significant investment, best ordered from a dealer with a good return policy. Large and heavy floorstander (about 96 lbs, 42” tall) requiring real floor space and rear clearance. Positioning is fairly specific: needs about 2 feet from the rear wall - closer causes boominess in the 40-50Hz region, farther loses bass extension. Vertical dispersion (about ±50°) is narrower than horizontal (about ±60°), since the two 8” woofers are spaced vertically apart on a tower cabinet, causing some vertical mismatch at lower frequencies. A small on-axis dip around 500Hz and a deliberately lower tweeter level (about 0.5dB below the midrange) are intentional design choices for smoother in-room response, but mean the raw on-axis measurement isn’t perfectly flat. A mild diffraction-related dip appears around 3kHz in directivity measurements. Toeing the speaker out more than about 10° starts to noticeably reduce top-end energy.

Buy the Polk Audio Reserve R700 if the price matters more than sound quality. Buy the MoFi SourcePoint 888 if sound quality matters more than the price.

Buy the MoFi SourcePoint 888 at Crutchfield →Buy the Polk Audio Reserve R700 at Amazon ($1,199.00) →

Polk Audio Reserve R700 vs MoFi SourcePoint 888

Specifications Side By Side

Polk Audio Reserve R700 MoFi SourcePoint 888
Price$1,199.00$5500
Ranked#32 of 71 in Large Size Floorstanding Speakers#4 of 71 in Large Size Floorstanding Speakers
Bass Extension (-10dB)31Hz (measured, Erin’s Audio Corner)26Hz (measured, Erin’s Audio Corner)
Bass Extension (-3dB)40Hz (measured, Erin’s Audio Corner)34Hz (measured, Erin’s Audio Corner)
Impedance4 ohms nominal, 3.5 ohms minimum (measured above 80Hz, Erin’s Audio Corner)6 ohms nominal, 5 ohms minimum (measured, Erin’s Audio Corner)
Sensitivity87.5dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin’s Audio Corner)85.6dB (measured, Erin’s Audio Corner)
Drivers2x 8" polypropylene cone woofers, 1x 6.5" turbine cone midrange, 1x 1" Pinnacle ring radiator tweeterDual 8" paper cone woofers, 8" Paper Cone midrange, 1.25" wide roll soft dome tweeter
Weight102.1 lbs / 46.3 kg94.8 lbs / 43 kg each
Woofer Cabinetported, down-firingported, rear
Dimensions45"H x 12.6"W x 16.9"D (1143.8 x 320.7 x 428.3 mm)41.2"H x 12.6"W x 16.1"D (1046.5 x 320 x 408.9 mm)
Buy the MoFi SourcePoint 888 at Crutchfield →Buy the Polk Audio Reserve R700 at Amazon ($1,199.00) →

More useful head-to-heads from the same speaker class:

Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.

As an eBay Partner, we may be compensated if you make a purchase.

The Two Speakers In Full

Polk Audio Reserve R700: $1,199.00 Amazon eBay

Polk Audio Reserve R700 ranking card

Pros: Three-way design with a 1” ring radiator tweeter, 6.5” mid-range, and dual 8” mid-bass drivers in a ported, down-firing cabinet. On-axis frequency response holds within about ±2dB across most of its range, with genuinely deep bass extension (F3 40Hz) reaching into the mid-30s Hz in-room. Wide horizontal radiation of about ±70°, giving a strong, enveloping stereo width and stage-extension effect on well-recorded tracks. Good low-level dynamics - solid bass thump at quiet listening volumes without over-accentuation. Strong distortion and compression control through the bass and midrange. Real nominal impedance closer to 4 ohms than the marketed 8 ohms, so with the right amplifier it can be driven hard - a $3,000 two-channel integrated brought out significantly more life than a budget $300 unit could. Excellent value at its roughly $2,200/pair MSRP, ranking among the reviewer’s top picks under $2,500; outperforms the similarly-priced Klipsch RP-8000F II in bass extension and overall smoothness.

Cons: Compression in the high frequencies rises sharply between 96dB and 102dB output - a real limitation only at very high volumes (around 100dB at 3 meters), but a clear step down from pricier ($5,000+) towers. Horizontal directivity mismatch around 4-5kHz, where the tweeter flares wider than the midrange, can sound a bit forward - especially noticeable when toed out further into the room; sidewall absorption or curtains help tame it. Harmonic distortion crosses the reviewer’s 3% threshold around 7kHz at 96dB output, possibly contributing to that same forward quality at high volume. Narrow vertical sweet spot (about ±15° from the tweeter axis), typical of non-coaxial tower designs - more of a consideration for multi-row home theater seating than single-row listening. The ring-radiator tweeter narrows noticeably above about 7-8kHz, and toeing the speaker out more than about 20° causes the top end to fall off quickly. Needs at least 2 feet of clearance from the rear wall to avoid boomy, exaggerated bass, since it lacks the bass-shelf tuning some rivals use to allow closer wall placement. Compared to the pricier KEF R5 Meta, has narrower horizontal (and much narrower vertical) directivity, so seating flexibility is more limited.

Full Polk Audio Reserve R700 review and specifications →

Bass Extension (-10dB)31Hz (measured, Erin's Audio Corner)
Bass Extension (-3dB)40Hz (measured, Erin's Audio Corner)
Dimensions45"H x 12.6"W x 16.9"D (1143.8 x 320.7 x 428.3 mm)
Drivers2x 8" polypropylene cone woofers, 1x 6.5" turbine cone midrange, 1x 1" Pinnacle ring radiator tweeter
Impedance4 ohms nominal, 3.5 ohms minimum (measured above 80Hz, Erin's Audio Corner)
Sensitivity87.5dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin's Audio Corner)
Weight102.1 lbs / 46.3 kg
Woofer Cabinetported, down-firing
Check current price at Amazon ($1,199.00) →Search eBay for Polk Audio Reserve R700 →

MoFi SourcePoint 888: $5500 Crutchfield eBay

MoFi SourcePoint 888 ranking card

Pros: Three-way vented design: an 8” coaxial mid-range/1.25” dome tweeter driver plus two additional 8” woofers crossed at about 130Hz, giving genuinely full-range output (F3 34Hz, F10 26Hz) other than the deepest subsonic content. Ranked by the reviewer among his personal top three speakers out of roughly 200 tested, alongside the KEF Blade 2 Meta and Dutch & Dutch 8C, despite costing a small fraction of either. Excellent compression/dynamic-range linearity, holding its own against much pricier speakers like the March Audio Sointuva AWG, KEF Reference 1 Meta, and KEF Blade 2 Meta. On-axis (0°) and 30°-off-axis estimated in-room responses track within about 1-1.5dB of each other above 500Hz, so tonal balance barely changes with placement or listening angle - excellent for multi-seat home theater or entertaining. Wide horizontal dispersion of about ±60°. Distortion stays low: under 1% at 86dB, and under 1% above 200Hz even at 96dB, with multitone distortion mostly under 1% as well. Not a difficult amplifier load (5-ohm minimum impedance, 4.2-ohm minimum EPDR). Checks the three boxes the reviewer considers essential for a home theater speaker: low compression, low distortion, and excellent directivity.

Cons: A significant investment, best ordered from a dealer with a good return policy. Large and heavy floorstander (about 96 lbs, 42” tall) requiring real floor space and rear clearance. Positioning is fairly specific: needs about 2 feet from the rear wall - closer causes boominess in the 40-50Hz region, farther loses bass extension. Vertical dispersion (about ±50°) is narrower than horizontal (about ±60°), since the two 8” woofers are spaced vertically apart on a tower cabinet, causing some vertical mismatch at lower frequencies. A small on-axis dip around 500Hz and a deliberately lower tweeter level (about 0.5dB below the midrange) are intentional design choices for smoother in-room response, but mean the raw on-axis measurement isn’t perfectly flat. A mild diffraction-related dip appears around 3kHz in directivity measurements. Toeing the speaker out more than about 10° starts to noticeably reduce top-end energy.

Full MoFi SourcePoint 888 review and specifications →

Bass Extension (-10dB)26Hz (measured, Erin's Audio Corner)
Bass Extension (-3dB)34Hz (measured, Erin's Audio Corner)
Dimensions41.2"H x 12.6"W x 16.1"D (1046.5 x 320 x 408.9 mm)
DriversDual 8" paper cone woofers, 8" Paper Cone midrange, 1.25" wide roll soft dome tweeter
Impedance6 ohms nominal, 5 ohms minimum (measured, Erin's Audio Corner)
Sensitivity85.6dB (measured, Erin's Audio Corner)
Weight94.8 lbs / 43 kg each
Woofer Cabinetported, rear
Check current price at Crutchfield →Search eBay for MoFi SourcePoint 888 →