Short answer: the MoFi SourcePoint V10 Master Edition on measured sound quality, the JBL Stage 2 280F on price. The MoFi SourcePoint V10 Master Edition ranks #3 of 71 floorstanding speakers at $7995. The JBL Stage 2 280F ranks #62 at $529.95, $7465.05 cheaper.
What the MoFi SourcePoint V10 Master Edition offers: Extended bass to approximately 30 Hz in-room without subwoofer; images with excellent precision indicating tight frequency response matching between speakers. Integrated bass management with three-way treble attenuation switches for room tuning. New design from Andrew Jones represents reviewer personal second choice (behind only KEF Blade 2 Meta at 29k) among hundreds of systems auditioned; ranks above Dutch & Dutch 8C, JBL 4367, and JBL M2. Watch for: Moderate sensitivity (~89 dB) means amplifier power requirements higher than many alternatives. Deep bass extension ends above subsonic frequencies (pipe organ territory below 17 Hz requires subwoofer).
What the JBL Stage 2 280F offers: Genuinely impressive output capability and low compression/distortion for the price, courtesy of the dual 8” woofers - the reviewer’s standout praise for this pair. High sensitivity (89.5dB measured) and low impedance make it easy to drive. Decent bass extension (F3 48Hz, F10 30Hz) reaches about 50Hz in-room. Horizontal dispersion is reasonably consistent (~55 degrees), meaning the speaker takes reasonably well to EQ correction. Watch for: Explicitly called out as disappointing relative to expectations for the JBL name and this price point - lacks native linearity compared to similarly-priced alternatives like the Polk Reserve R500, which the reviewer recommends instead for anyone who doesn’t want to rely on EQ. Treble falls off a cliff above about 10-12kHz, giving a notable lack of air/space that needs real correction (a wide +Q0.5 boost from 10-20kHz) to fix. A sharp impedance resonance around 900Hz-1.1kHz is nearly impossible to EQ out cleanly even with narrow filters. Elevated multitone distortion in the 600Hz-2.5kHz range, tied to the midwoofer rather than the tweeter. Compared to the similarly-priced Klipsch RP-6000F II/RP-8000F II, this JBL is less directive and native-flat but does extend roughly 20Hz deeper in the bass - a real tradeoff either way, not a clean win.
Buy the MoFi SourcePoint V10 Master Edition when sound quality outweighs the price for you, and the JBL Stage 2 280F when the price outweighs sound quality instead.
If sound quality matters at all to you, skip the JBL Stage 2 280F. It ranks near the bottom of the 71 floorstanding speakers, so look higher up the list instead.
Still deciding? The full Passive Home rankings cover every ranked option.
Specifications Side By Side
| MoFi SourcePoint V10 Master Edition | JBL Stage 2 280F | |
|---|---|---|
| Price | $7995 per pair | $529.95 per pair |
| Ranked | #3 of 71 in Large Size Floorstanding Speakers | #62 of 71 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 25Hz (measured, Erin's Audio Corner) | 30Hz (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 38Hz (measured, Erin's Audio Corner) | 48Hz (measured, Erin's Audio Corner) |
| Dimensions | 48.8"H x 15.5"W x 19.9"D (1239.5 x 393.7 x 505.5 mm) | 43.8" x 14.1" x 16.5" (1113 x 358 x 419 mm) |
| Impedance | 6 ohms nominal, 5.3 ohms minimum (measured, Erin's Audio Corner) | 6 ohms nominal, 3.9 ohms minimum (measured, Erin's Audio Corner) |
| Drivers | 10" woofer, 10" paper‑cone concentric midrange, 1.25" soft‑dome concentric tweeter | 1" anodized aluminum dome tweeter with HDI waveguide, dual 8" polycellulose woofers |
| Sensitivity | 88.8dB (measured, Erin's Audio Corner) | 89.5dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 160.9 lbs (73 kg) | 55.1 lbs (25 kg) each |
| Woofer Cabinet | passive radiator | ported, rear |
| Spinorama Preference Score | 4.09 | 3.84 |
| Spinorama Preference Score with Perfect Sub | 5.40 | 5.29 |
| Crossover Frequency | - | 1.1kHz, 2.1kHz |
| Power Handling | - | 125W RMS |
Related Speaker Comparisons
More worthwhile head-to-heads for MoFi SourcePoint V10 Master Edition:
- GR-Research NX-Treme vs MoFi SourcePoint V10 Master Edition
- KEF Blade Two Meta vs MoFi SourcePoint V10 Master Edition
- MoFi SourcePoint 888 vs MoFi SourcePoint V10 Master Edition
- Radiant Acoustics Clarity 66 vs MoFi SourcePoint V10 Master Edition
- MoFi SourcePoint V10 Master Edition vs Ascend Acoustics ELX Ribbon Tower
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
MoFi SourcePoint V10 Master Edition: $7995 per pair Crutchfield eBay
Pros: Extended bass to approximately 30 Hz in-room without subwoofer; images with excellent precision indicating tight frequency response matching between speakers. Integrated bass management with three-way treble attenuation switches for room tuning. New design from Andrew Jones represents reviewer personal second choice (behind only KEF Blade 2 Meta at 29k) among hundreds of systems auditioned; ranks above Dutch & Dutch 8C, JBL 4367, and JBL M2. Measured bass extension of 38Hz (-3dB), with a measured sensitivity of 88.8dB.
Cons: Moderate sensitivity (~89 dB) means amplifier power requirements higher than many alternatives. Deep bass extension ends above subsonic frequencies (pipe organ territory below 17 Hz requires subwoofer).
Full MoFi SourcePoint V10 Master Edition review and specifications →
| Bass Extension (-10dB) | 25Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 38Hz (measured, Erin's Audio Corner) |
| Dimensions | 48.8"H x 15.5"W x 19.9"D (1239.5 x 393.7 x 505.5 mm) |
| Drivers | 10" woofer, 10" paper‑cone concentric midrange, 1.25" soft‑dome concentric tweeter |
| Impedance | 6 ohms nominal, 5.3 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 88.8dB (measured, Erin's Audio Corner) |
| Spinorama Preference Score | 4.09 |
| Spinorama Preference Score with Perfect Sub | 5.40 |
| Weight | 160.9 lbs (73 kg) |
| Woofer Cabinet | passive radiator |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- MoFi SourcePoint V10 Master Edition vs KEF Blade Two Meta
- MoFi SourcePoint V10 Master Edition vs MoFi SourcePoint 888
- MoFi SourcePoint V10 Master Edition vs GR-Research NX-Treme
- MoFi SourcePoint V10 Master Edition vs Radiant Acoustics Clarity 66
- MoFi SourcePoint V10 Master Edition vs Ascend Acoustics ELX Ribbon Tower
- MoFi SourcePoint V10 Master Edition vs JBL HDI-3800
- MoFi SourcePoint V10 Master Edition vs Revel F328Be
- MoFi SourcePoint V10 Master Edition vs Revel F226Be
- See all 28 comparisons
JBL Stage 2 280F: $529.95 per pair Amazon eBay
Pros: Genuinely impressive output capability and low compression/distortion for the price, courtesy of the dual 8” woofers - the reviewer’s standout praise for this pair. High sensitivity (89.5dB measured) and low impedance make it easy to drive. Decent bass extension (F3 48Hz, F10 30Hz) reaches about 50Hz in-room. Horizontal dispersion is reasonably consistent (~55 degrees), meaning the speaker takes reasonably well to EQ correction. Measured bass extension of 48Hz (-3dB), with a measured sensitivity of 89.5dB.
Cons: Explicitly called out as disappointing relative to expectations for the JBL name and this price point - lacks native linearity compared to similarly-priced alternatives like the Polk Reserve R500, which the reviewer recommends instead for anyone who doesn’t want to rely on EQ. Treble falls off a cliff above about 10-12kHz, giving a notable lack of air/space that needs real correction (a wide +Q0.5 boost from 10-20kHz) to fix. A sharp impedance resonance around 900Hz-1.1kHz is nearly impossible to EQ out cleanly even with narrow filters. Elevated multitone distortion in the 600Hz-2.5kHz range, tied to the midwoofer rather than the tweeter. Compared to the similarly-priced Klipsch RP-6000F II/RP-8000F II, this JBL is less directive and native-flat but does extend roughly 20Hz deeper in the bass - a real tradeoff either way, not a clean win.
Full JBL Stage 2 280F review and specifications →
| Bass Extension (-10dB) | 30Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 48Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 1.1kHz, 2.1kHz |
| Dimensions | 43.8" x 14.1" x 16.5" (1113 x 358 x 419 mm) |
| Drivers | 1" anodized aluminum dome tweeter with HDI waveguide, dual 8" polycellulose woofers |
| Impedance | 6 ohms nominal, 3.9 ohms minimum (measured, Erin's Audio Corner) |
| Power Handling | 125W RMS |
| Sensitivity | 89.5dB (2.83V/1m, measured by Erin's Audio Corner) |
| Spinorama Preference Score | 3.84 |
| Spinorama Preference Score with Perfect Sub | 5.29 |
| Weight | 55.1 lbs (25 kg) each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- JBL Stage 2 280F vs Magnepan LRS+
- JBL Stage 2 280F vs Infinity Reference 253
- JBL Stage 2 280F vs Sony SS-CS3
- JBL Stage 2 280F vs Focal Aria Evo X N°2
- JBL Stage 2 280F vs JBL Studio 590
- JBL Stage 2 280F vs Polk T50
- JBL Stage 2 280F vs Triangle Esprit Antal Ez
- JBL Stage 2 280F vs Klipsch RP-6000F II
- See all 37 comparisons