Short answer: the Linkwitz Lab LXmini. It ranks #38 of 74 floorstanding speakers by sound quality, rated 4.2/5, at $505. The Jamo S807 ranks #70, rated 2.8/5, at $299, $206 cheaper, a saving that is not big enough to make up the sound-quality gap.
Why pick the Linkwitz Lab LXmini: Open-baffle/dipole upper driver and cylindrical woofer enclosure create a very large, open soundstage with unusually little cabinet signature. The tradeoff: This is not a conventional passive pair: it requires a construction-plan license, assembly, miniDSP, four matched amplifier channels and careful gain/setup work, so the apparent kit price is not the complete system cost.
Why pick the Jamo S807: A slim 2.5-way tower with two 5-inch woofers and a 1-inch tweeter in a shallow waveguide, with a front slot port so it can sit closer to a wall. Watch for: Erin’s Audio Corner’s measurements show a smiley-face tuning: boosted bass around 80Hz and boosted treble with the dialogue range sitting 3 to 5dB lower, plus a resonance near 400Hz.
One note: the Jamo S807 is discontinued and no longer widely available new.
Buy the Linkwitz Lab LXmini. It is rated higher for sound quality, and the $206 saving on the Jamo S807 is not enough to make up the difference.
Looking for alternatives? See the complete Passive Home rankings.
Specifications Side By Side
| Linkwitz Lab LXmini | Jamo S807 | |
|---|---|---|
| Price | $610.00 per pair | $299.00 per pair Discontinued |
| Ranked | #38 of 74 in Large Size Floorstanding Speakers | #70 of 74 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 33Hz (measured, Erin’s Audio Corner) | 36.2Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 50Hz (measured, Erin’s Audio Corner) | 51.9Hz (measured, Erin’s Audio Corner) |
| Sensitivity | 85dB upper driver / 87dB woofer @ 1W/1m (individual driver specifications; complete active-DSP system sensitivity is not directly specified) | 84dB (measured average 300Hz-3kHz, Erin’s Audio Corner; 90dB manufacturer specified) |
| Impedance | 4 ohms upper driver / 8 ohms woofer nominal (separate actively bi-amplified loads; manufacturer specified) | 8 ohms nominal (manufacturer specified) |
| Drivers | 6.5” SEAS woofer in sealed tube, 4” SEAS full-range dipole driver | 2x 5” woofer, 1” tweeter with waveguide (2.5-way) |
| Crossover Frequency | 700Hz LR2, active DSP | - |
| Amplifier Power | Four channels, 50W/channel minimum with identical voltage gain | - |
| Woofer Cabinet | sealed cylindrical enclosure; open-baffle upper driver | ported, front slot |
| Spinorama Preference Score | 3.89 (measured, spinorama.org) | 3.84 |
| Spinorama Preference Score with Perfect Sub | 5.77 (measured, spinorama.org) | 5.94 |
| DIY Kit | Yes | No |
| Power Handling | - | 100W rated, 200W peak (manufacturer specified) |
| Dimensions | - | 36”H x 7.5”W x 9.9”D (915 x 191 x 252 mm) |
| Weight | - | 26 lbs (11.8 kg) each |
Related Speaker Comparisons
More top alternatives to Linkwitz Lab LXmini:
- Revel Concerta2 F35 vs Linkwitz Lab LXmini
- ELAC Debut 3.0 DF63 vs Linkwitz Lab LXmini
- Polk Reserve R500 vs Linkwitz Lab LXmini
- Linkwitz Lab LXmini vs Infinity Primus 360
- Polk T50 vs Jamo S807
Prices on this page were last checked September 30, 2026 at 2:57 PM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Linkwitz Lab LXmini: $610.00 per pair Madisound LXmini Kit eBay
Pros: Open-baffle/dipole upper driver and cylindrical woofer enclosure create a very large, open soundstage with unusually little cabinet signature. Erin praised the stable, well-controlled directivity: despite using a nominal full-range upper driver, off-axis response retains composure beyond its beaming region and the directivity index is smooth enough for reliable DSP voicing. Imaging can be precisely adjusted through placement and toe angle. Erin measured F3 at 50Hz and F10 at 33Hz, impressive for the narrow footprint, and found the system satisfying for much music without a subwoofer. The supplied miniDSP configuration is readily editable; broad shelf correction near 550Hz and a handful of narrow filters can make the response substantially more linear. The kit is mechanically simple, highly customizable and based on well-documented Linkwitz engineering. Measured bass extension of 50Hz (-3dB).
Cons: This is not a conventional passive pair: it requires a construction-plan license, assembly, miniDSP, four matched amplifier channels and careful gain/setup work, so the apparent kit price is not the complete system cost. Output below about 50Hz lacks kick-drum weight and benefits from subwoofers. Erin found rising second-order distortion near 1.5kHz on both samples, accompanied by an impedance blip that may indicate an enclosure reflection or driver-compliance effect. At high output the system behaves as if electronically limited even with miniDSP limiting bypassed, reducing bass and subjective dynamics. Default voicing is less linear than expected, with irregularities above roughly 2kHz, though its controlled directivity makes these correctable. Dipole rear radiation demands meaningful distance from the front wall and makes placement less flexible than a box speaker.
Full Linkwitz Lab LXmini review and specifications →
| Amplifier Power | Four channels, 50W/channel minimum with identical voltage gain |
|---|---|
| Bass Extension (-10dB) | 33Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 50Hz (measured, Erin’s Audio Corner) |
| Crossover Frequency | 700Hz LR2, active DSP |
| DIY Kit | Yes |
| Drivers | 6.5” SEAS woofer in sealed tube, 4” SEAS full-range dipole driver |
| Impedance | 4 ohms upper driver / 8 ohms woofer nominal (separate actively bi-amplified loads; manufacturer specified) |
| Sensitivity | 85dB upper driver / 87dB woofer @ 1W/1m (individual driver specifications; complete active-DSP system sensitivity is not directly specified) |
| Spinorama Preference Score | 3.89 (measured, spinorama.org) |
| Spinorama Preference Score with Perfect Sub | 5.77 (measured, spinorama.org) |
| Woofer Cabinet | sealed cylindrical enclosure; open-baffle upper driver |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
Jamo S807: $299.00 per pair Discontinued Amazon eBay
Pros: A slim 2.5-way tower with two 5-inch woofers and a 1-inch tweeter in a shallow waveguide, with a front slot port so it can sit closer to a wall. Its 8-ohm load stays close to 8 ohms across the range in Erin’s Audio Corner’s measurements, so any receiver drives it easily, and harmonic distortion stays under 0.5% above 200Hz at an 85dB level. Metal fasteners on top accept Jamo’s S8 ATM Dolby Atmos elevation module. Measured bass extension of 51.9Hz (-3dB), with a measured sensitivity of 84dB.
Cons: Erin’s Audio Corner’s measurements show a smiley-face tuning: boosted bass around 80Hz and boosted treble with the dialogue range sitting 3 to 5dB lower, plus a resonance near 400Hz. The listening window spans 4.6dB between 300Hz and 5kHz, the predicted in-room response is rough (0.39 smoothness) and the preference score is 3.84 (5.94 with an ideal subwoofer). Measured sensitivity is about 84dB against the 90dB claim, and it loses about 2dB to compression at 40Hz at loud listening levels. Erin’s verdict was not to buy it. Jamo has phased out the Studio 8 series it belongs to, so it is mainly a used buy. Discontinued.
Full Jamo S807 review and specifications →
| Bass Extension (-10dB) | 36.2Hz (measured, Erin’s Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 51.9Hz (measured, Erin’s Audio Corner) |
| DIY Kit | No |
| Dimensions | 36”H x 7.5”W x 9.9”D (915 x 191 x 252 mm) |
| Drivers | 2x 5” woofer, 1” tweeter with waveguide (2.5-way) |
| Impedance | 8 ohms nominal (manufacturer specified) |
| Power Handling | 100W rated, 200W peak (manufacturer specified) |
| Sensitivity | 84dB (measured average 300Hz-3kHz, Erin’s Audio Corner; 90dB manufacturer specified) |
| Spinorama Preference Score | 3.84 |
| Spinorama Preference Score with Perfect Sub | 5.94 |
| Weight | 26 lbs (11.8 kg) each |
| Woofer Cabinet | ported, front slot |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons