Short answer: the Audio-Technica ATH-R50x. It ranks #52 of 216 over-ear headphones by sound quality, rated 4.1/5, at $169. The Beyerdynamic DT 770 Pro ranks #63, rated 4.0/5, at $154.99, $14.01 cheaper, which does not close the gap in sound quality.
Why pick the Audio-Technica ATH-R50x: A preference score of 83 and the smoothest deviation in this group at 1.67 dB make for a very even response, with bass from 60 to 200 Hz and low mids within 0.6 dB of target. Watch for: Sub-bass is about 6 dB low under 60 Hz, so deep rumble is lacking.
Why pick the Beyerdynamic DT 770 Pro: A preference score of 82 in oratory1990’s measurement reflects a lively closed-back sound with extra low end: sub-bass is about 3.4 dB above target, which adds weight to kick drums and bass lines. Watch for: A 7.8 dB dip near 3.75 kHz pulls back vocal presence, while a 5 dB peak near 8.1 kHz and treble about 2.6 dB above target make cymbals and S sounds sharp.
Buy the Audio-Technica ATH-R50x. It is rated higher for sound quality, and saving $14.01 with the Beyerdynamic DT 770 Pro does not make up for the sound-quality gap.
Looking for alternatives? See the complete Headphones rankings.
Specifications Side By Side
| Audio-Technica ATH-R50x | Beyerdynamic DT 770 Pro | |
|---|---|---|
| Price | $169.00 | $154.99 |
| Ranked | #52 of 216 in Over-Ear Headphones | #63 of 216 in Over-Ear Headphones |
| Form Factor | Over-ear | Over-ear |
| Harman Preference Score | 83 (measured by oratory1990, via AutoEQ) | 82 (measured by oratory1990, via AutoEQ) |
| Deviation From Target | 1.67 dB standard deviation | 2.31 dB standard deviation |
| Tonal Tilt | +0.64 (negative is warmer, positive brighter) | -0.19 (negative is warmer, positive brighter) |
| Sub-bass Extension | Falls 6 dB below target at 30 Hz (-6.4 dB at 30 Hz) | Within 6 dB of target down to 20 Hz (+3.5 dB at 30 Hz) |
| Connection | Wired | Wired |
| Back | Open | Closed |
| Driver Type | Dynamic | Dynamic |
| Drivers | 1 x 45mm dynamic | - |
| Impedance | 50 ohms | 80 ohms |
| Sensitivity | 93.3 dB/mW | 96 dB SPL |
| Weight | 0.5 lbs (207 g) | - |
| Frequency Response | 5Hz - 40kHz (Manufacturer specified) | 5Hz - 35kHz (Manufacturer specified) |
Related Headphone Comparisons
More top alternatives to Audio-Technica ATH-R50x:
- Beyerdynamic DT 880 vs Audio-Technica ATH-R50x
- Beyerdynamic TYGR 300 R vs Audio-Technica ATH-R50x
- AKG K371 vs Audio-Technica ATH-R50x
- AKG K702 vs Audio-Technica ATH-R50x
- Audio-Technica ATH-R50x vs HIFIMAN Sundara
Prices on this page were last checked October 11, 2026 at 4:59 PM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Headphones In Full
Audio-Technica ATH-R50x: $169.00 Amazon eBay
Pros: A preference score of 83 and the smoothest deviation in this group at 1.67 dB make for a very even response, with bass from 60 to 200 Hz and low mids within 0.6 dB of target. At 50 ohms and 93.3 dB/mW sensitivity it can be driven by most portable sources, and at 207 g it is light. It costs less than the AKG K701 and AKG K702 while holding the same rating.
Cons: Sub-bass is about 6 dB low under 60 Hz, so deep rumble is lacking. Treble is slightly forward, with presence about 2 dB high, 6 to 10 kHz about 2.6 dB high and a 4.8 dB peak near 6.3 kHz, which can make vocals and cymbals bright. Its tilt of 0.64 leans bright, and the open back leaks sound.
Full Audio-Technica ATH-R50x review and specifications →
| Released | Jan 2025 (1 year ago) |
|---|---|
| Back | Open |
| Connection | Wired |
| Deviation From Target | 1.67 dB standard deviation |
| Driver Type | Dynamic |
| Drivers | 1 x 45mm dynamic |
| Form Factor | Over-ear |
| Frequency Response | 5Hz - 40kHz (Manufacturer specified) |
| Harman Preference Score | 83 (measured by oratory1990, via AutoEQ) |
| Impedance | 50 ohms |
| Sensitivity | 93.3 dB/mW |
| Sub-bass Extension | Falls 6 dB below target at 30 Hz (-6.4 dB at 30 Hz) |
| Tonal Tilt | +0.64 (negative is warmer, positive brighter) |
| Weight | 0.5 lbs (207 g) |
EQ preset to match the Harman target
Set a preamp of -6.2 dB, then add these filters in any parametric equalizer (Wavelet, Equalizer APO, Peace, or a player with parametric EQ). Calculated by AutoEQ from its measured frequency response.
| Filter | Frequency | Gain | Q |
|---|---|---|---|
| Low shelf | 105 Hz | +7.2 dB | 0.70 |
| Peak | 482 Hz | +2.4 dB | 0.92 |
| Peak | 60 Hz | -4.8 dB | 0.60 |
| Peak | 6,204 Hz | -3.3 dB | 1.70 |
| Peak | 38 Hz | +2.3 dB | 1.60 |
| High shelf | 10,000 Hz | -2.1 dB | 0.70 |
| Peak | 1,497 Hz | -1.4 dB | 3.40 |
| Peak | 851 Hz | +0.5 dB | 2.04 |
| Peak | 4,628 Hz | +1.6 dB | 4.12 |
| Peak | 3,874 Hz | -2.5 dB | 6.00 |
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
Beyerdynamic DT 770 Pro: $154.99 Amazon eBay
Pros: A preference score of 82 in oratory1990’s measurement reflects a lively closed-back sound with extra low end: sub-bass is about 3.4 dB above target, which adds weight to kick drums and bass lines. The closed back isolates well for tracking or noisy rooms. At 80 ohms and 96 dB SPL it works with most interfaces and decent amps.
Cons: A 7.8 dB dip near 3.75 kHz pulls back vocal presence, while a 5 dB peak near 8.1 kHz and treble about 2.6 dB above target make cymbals and S sounds sharp. The deviation of 2.3 dB is the least smooth of the group. The 80 ohm impedance is demanding for a phone alone.
Full Beyerdynamic DT 770 Pro review and specifications →
| Back | Closed |
|---|---|
| Connection | Wired |
| Deviation From Target | 2.31 dB standard deviation |
| Driver Type | Dynamic |
| Form Factor | Over-ear |
| Frequency Response | 5Hz - 35kHz (Manufacturer specified) |
| Harman Preference Score | 82 (measured by oratory1990, via AutoEQ) |
| Impedance | 80 ohms |
| Sensitivity | 96 dB SPL |
| Sub-bass Extension | Within 6 dB of target down to 20 Hz (+3.5 dB at 30 Hz) |
| Tonal Tilt | -0.19 (negative is warmer, positive brighter) |
EQ preset to match the Harman target
Set a preamp of -5.1 dB, then add these filters in any parametric equalizer (Wavelet, Equalizer APO, Peace, or a player with parametric EQ). Calculated by AutoEQ from its measured frequency response.
| Filter | Frequency | Gain | Q |
|---|---|---|---|
| Low shelf | 105 Hz | -3.0 dB | 0.70 |
| Peak | 6,430 Hz | -4.2 dB | 0.97 |
| Peak | 3,684 Hz | +6.8 dB | 2.88 |
| Peak | 213 Hz | +3.5 dB | 2.46 |
| Peak | 139 Hz | -3.9 dB | 4.92 |
| High shelf | 10,000 Hz | -5.4 dB | 0.70 |
| Peak | 93 Hz | +3.5 dB | 3.00 |
| Peak | 9,561 Hz | +2.3 dB | 1.86 |
| Peak | 45 Hz | -1.3 dB | 1.74 |
| Peak | 119 Hz | -2.1 dB | 5.83 |
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons