Short answer: the Wharfedale Super Linton on measured sound quality, the Sonus Faber Lumina II Amator on price. The Wharfedale Super Linton ranks #24 of 130 bookshelf speakers at $2699. The Sonus Faber Lumina II Amator ranks #106 at $2000, $699 cheaper.
What the Wharfedale Super Linton offers: Three-way design with a 1” soft dome tweeter, 5” woven Kevlar mid-range, and 8” woven Kevlar woofer in a dual rear-ported, heavily damped MDF/particle-board cabinet. Comes as a genuinely matched pair (measured within about 1dB of each other) and includes custom matching stands. A major dynamic-range improvement over the original Heritage Linton - kick drums retain their impact from low to high volume instead of compressing, the standout objective improvement in this update. Fixes the original Linton’s main flaw: a 1-3kHz scoop that made it sound a bit soft and subdued is filled in here, giving noticeably more attack and dynamic punch. About 3dB more sensitivity than the original Linton (measured ~88.2dB), meaning roughly half the amplifier power for the same output. Wide horizontal radiation of about ±70°, right in the reviewer’s preferred range for an enveloping soundstage. Lower midrange distortion than the original Linton. Bass-shelf tuning intentionally allows closer-to-wall placement (about 1 foot worked well) without excess boominess, more flexible than the original Linton in that regard. Watch for: Rolls off earlier than the original Linton (F3 77Hz versus the original’s 52Hz), a deliberate trade-off for the closer-wall-placement flexibility. On-axis, there’s a mild treble lift around 4-6kHz that can sound a touch sibilant, though the reviewer found it not very noteworthy in practice. Diffraction shows up around 1.5-2kHz on-axis; needs about 10° of toe-out to smooth this out, though going further to 30° starts to lose some top-end air. Distortion peaks slightly higher than the original Linton in the 50-70Hz region. Minimum impedance dips to about 3 ohms around 150Hz, so a 4-ohm-stable amplifier is recommended for best results. Vertical dispersion of about ±20° means multi-row home theater seating outside that window will hear reduced top-end. Asymmetrical design requires attention to setup (tweeters need to face outward) for the most linear in-room response. A costly upgrade for existing Linton owners if the original’s specific flaws didn’t bother them.
What the Sonus Faber Lumina II Amator offers: Solid bass extension for a bookshelf (F3 63Hz, F10 43Hz), reaching about 50Hz in-room. Decent sensitivity and wide, consistent horizontal dispersion (~60-70 degrees) - better directivity than expected for a two-way design. Gorgeous, luxury-grade cabinet design. Watch for: Very bright treble, running 3-6dB above the midrange depending on measurement angle - independently corroborated by other owners online, not just one reviewer’s opinion. Causes audible sibilance and a forward, grainy character. Notably the brightest of three Sonus Faber models Erin’s Audio Corner has tested, even brighter than the brand’s own Sonetto II G2. A mechanical resonance/ringing artifact shows up around 1kHz in measurements. Needs a subwoofer for anything below about 50Hz.
Buy the Wharfedale Super Linton when sound quality outweighs the price for you, and the Sonus Faber Lumina II Amator when the price outweighs sound quality instead.
Skip the Sonus Faber Lumina II Amator if sound quality matters to you. It ranks near the bottom of the 130 bookshelf speakers.
Looking for alternatives? See the complete Passive Home rankings.
Specifications Side By Side
| Wharfedale Super Linton | Sonus Faber Lumina II Amator | |
|---|---|---|
| Price | $2,699.00 per pair | $2000 per pair |
| Ranked | #24 of 130 in Large Size Bookshelf Speakers | #106 of 130 in Large Size Bookshelf Speakers |
| Bass Extension (-10dB) | 34Hz (measured, Erin's Audio Corner) | 43Hz (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 77Hz (measured, Erin's Audio Corner) | 63Hz (measured, Erin's Audio Corner) |
| Dimensions | 23.8"H x 11.8"W x 13"D (604.5 x 299.7 x 330.2 mm) | 12" x 7.1" x 10.4" (304 x 180 x 263 mm) |
| Impedance | 4 ohms nominal (3 ohms minimum, measured, Erin's Audio Corner) | 4 ohms nominal, 3.9 ohms minimum (measured, Erin's Audio Corner) |
| Drivers | 8"(200mm) black woven Kevlar® cone woofer, 5"(135mm) black woven Kevlar® cone midrange, 1" (25mm) soft dome tweeter | 1.14" DAD (Damped Apex Dome) tweeter, 5.9" paper cone woofer |
| Sensitivity | 88.2dB (measured, Erin's Audio Corner) | 86.9dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 43.7 lbs (19.8 kg) each | 12.8 lbs (5.8 kg) |
| Woofer Cabinet | ported, rear | Bass reflex, ported |
| Spinorama Preference Score | 5.28 | - |
| Spinorama Preference Score with Perfect Sub | 7.12 | - |
| Frequency Response | - | 55Hz - 24kHz (Manufacturer specified) |
| Crossover Frequency | - | 2600Hz |
| Recommended Power | - | 30W - 150W |
| Country | - | Italy (Vicenza) |
Related Speaker Comparisons
How Wharfedale Super Linton compares with other leading options:
- Wharfedale Super Linton vs Perlisten S4b
- Wharfedale Super Linton vs KEF Reference 1 Meta
- Wharfedale Super Linton vs GR-Research NX-Studio
- Wharfedale Super Linton vs AsciLab C6B
- Wharfedale Super Linton vs Audio First Cadentia 3
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Wharfedale Super Linton: $2,699.00 per pair Amazon Crutchfield eBay
Pros: Three-way design with a 1” soft dome tweeter, 5” woven Kevlar mid-range, and 8” woven Kevlar woofer in a dual rear-ported, heavily damped MDF/particle-board cabinet. Comes as a genuinely matched pair (measured within about 1dB of each other) and includes custom matching stands. A major dynamic-range improvement over the original Heritage Linton - kick drums retain their impact from low to high volume instead of compressing, the standout objective improvement in this update. Fixes the original Linton’s main flaw: a 1-3kHz scoop that made it sound a bit soft and subdued is filled in here, giving noticeably more attack and dynamic punch. About 3dB more sensitivity than the original Linton (measured ~88.2dB), meaning roughly half the amplifier power for the same output. Wide horizontal radiation of about ±70°, right in the reviewer’s preferred range for an enveloping soundstage. Lower midrange distortion than the original Linton. Bass-shelf tuning intentionally allows closer-to-wall placement (about 1 foot worked well) without excess boominess, more flexible than the original Linton in that regard. Measured bass extension of 77Hz (-3dB), with a measured sensitivity of 88.2dB.
Cons: Rolls off earlier than the original Linton (F3 77Hz versus the original’s 52Hz), a deliberate trade-off for the closer-wall-placement flexibility. On-axis, there’s a mild treble lift around 4-6kHz that can sound a touch sibilant, though the reviewer found it not very noteworthy in practice. Diffraction shows up around 1.5-2kHz on-axis; needs about 10° of toe-out to smooth this out, though going further to 30° starts to lose some top-end air. Distortion peaks slightly higher than the original Linton in the 50-70Hz region. Minimum impedance dips to about 3 ohms around 150Hz, so a 4-ohm-stable amplifier is recommended for best results. Vertical dispersion of about ±20° means multi-row home theater seating outside that window will hear reduced top-end. Asymmetrical design requires attention to setup (tweeters need to face outward) for the most linear in-room response. A costly upgrade for existing Linton owners if the original’s specific flaws didn’t bother them.
Full Wharfedale Super Linton review and specifications →
| Bass Extension (-10dB) | 34Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 77Hz (measured, Erin's Audio Corner) |
| Dimensions | 23.8"H x 11.8"W x 13"D (604.5 x 299.7 x 330.2 mm) |
| Drivers | 8"(200mm) black woven Kevlar® cone woofer, 5"(135mm) black woven Kevlar® cone midrange, 1" (25mm) soft dome tweeter |
| Impedance | 4 ohms nominal (3 ohms minimum, measured, Erin's Audio Corner) |
| Sensitivity | 88.2dB (measured, Erin's Audio Corner) |
| Spinorama Preference Score | 5.28 |
| Spinorama Preference Score with Perfect Sub | 7.12 |
| Weight | 43.7 lbs (19.8 kg) each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Erin’s Audio Corner: 5 Reasons Wharfedale Super Linton is the Hidden Gem of Audio Equipment More from Erin’s Audio Corner →
- Erin’s Audio Corner Website Wharfedale Super Linton Review
- Erin’s Audio Corner: Upgrade Your Sound with These 6 Surprisingly Affordable Speakers!
- Erin’s Audio Corner: My Absolute Favorite Products of 2024 Revealed
- Erin’s Audio Corner Measurements (spinorama.org)
- Head-to-Head Comparisons
- Wharfedale Super Linton vs Ascend Acoustics CMT-340 SE2
- Wharfedale Super Linton vs Arendal 1528 Monitor 8
- Wharfedale Super Linton vs MoFi SourcePoint 10
- Wharfedale Super Linton vs Radiant Acoustics Clarity 6.2
- Wharfedale Super Linton vs Dynaudio Heritage Special
- Wharfedale Super Linton vs AsciLab F6Bs
- Wharfedale Super Linton vs MoFi SourcePoint 8
- Wharfedale Super Linton vs Wharfedale Linton 85
- See all 51 comparisons
Sonus Faber Lumina II Amator: $2000 per pair Crutchfield eBay
Pros: Solid bass extension for a bookshelf (F3 63Hz, F10 43Hz), reaching about 50Hz in-room. Decent sensitivity and wide, consistent horizontal dispersion (~60-70 degrees) - better directivity than expected for a two-way design. Gorgeous, luxury-grade cabinet design. Measured bass extension of 63Hz (-3dB), with a measured sensitivity of 86.9dB.
Cons: Very bright treble, running 3-6dB above the midrange depending on measurement angle - independently corroborated by other owners online, not just one reviewer’s opinion. Causes audible sibilance and a forward, grainy character. Notably the brightest of three Sonus Faber models Erin’s Audio Corner has tested, even brighter than the brand’s own Sonetto II G2. A mechanical resonance/ringing artifact shows up around 1kHz in measurements. Needs a subwoofer for anything below about 50Hz.
Full Sonus Faber Lumina II Amator review and specifications →
| Bass Extension (-10dB) | 43Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 63Hz (measured, Erin's Audio Corner) |
| Country | Italy (Vicenza) |
| Crossover Frequency | 2600Hz |
| Dimensions | 12" x 7.1" x 10.4" (304 x 180 x 263 mm) |
| Drivers | 1.14" DAD (Damped Apex Dome) tweeter, 5.9" paper cone woofer |
| Frequency Response | 55Hz - 24kHz (Manufacturer specified) |
| Impedance | 4 ohms nominal, 3.9 ohms minimum (measured, Erin's Audio Corner) |
| Recommended Power | 30W - 150W |
| Sensitivity | 86.9dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 12.8 lbs (5.8 kg) |
| Woofer Cabinet | Bass reflex, ported |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Sonus Faber Lumina II Amator vs KEF Q350
- Sonus Faber Lumina II Amator vs Klipsch RP-600M
- Sonus Faber Lumina II Amator vs Pylon Jasper Monitor 18
- Sonus Faber Lumina II Amator vs Wharfedale Diamond 9.1
- Sonus Faber Lumina II Amator vs Sonus Faber Sonetto II G2
- Sonus Faber Lumina II Amator vs Triangle Borea BR03
- Sonus Faber Lumina II Amator vs B&W 805S
- Sonus Faber Lumina II Amator vs Emotiva Airmotiv B2+
- See all 57 comparisons