Wharfedale Super Linton vs Ascend Acoustics Sierra-2EX V2

Last updated: September 16, 2026

Short answer: the Wharfedale Super Linton if sound quality matters most, the Ascend Acoustics Sierra-2EX V2 if price matters most. The Wharfedale Super Linton ranks #24 of 130 bookshelf speakers at $2699. The Ascend Acoustics Sierra-2EX V2 ranks #38 at $1748, $951 cheaper.

Wharfedale Super Linton vs Ascend Acoustics Sierra-2EX V2

What the Wharfedale Super Linton offers: Three-way design with a 1” soft dome tweeter, 5” woven Kevlar mid-range, and 8” woven Kevlar woofer in a dual rear-ported, heavily damped MDF/particle-board cabinet. Comes as a genuinely matched pair (measured within about 1dB of each other) and includes custom matching stands. A major dynamic-range improvement over the original Heritage Linton - kick drums retain their impact from low to high volume instead of compressing, the standout objective improvement in this update. Fixes the original Linton’s main flaw: a 1-3kHz scoop that made it sound a bit soft and subdued is filled in here, giving noticeably more attack and dynamic punch. About 3dB more sensitivity than the original Linton (measured ~88.2dB), meaning roughly half the amplifier power for the same output. Wide horizontal radiation of about ±70°, right in the reviewer’s preferred range for an enveloping soundstage. Lower midrange distortion than the original Linton. Bass-shelf tuning intentionally allows closer-to-wall placement (about 1 foot worked well) without excess boominess, more flexible than the original Linton in that regard. Watch for: Rolls off earlier than the original Linton (F3 77Hz versus the original’s 52Hz), a deliberate trade-off for the closer-wall-placement flexibility. On-axis, there’s a mild treble lift around 4-6kHz that can sound a touch sibilant, though the reviewer found it not very noteworthy in practice. Diffraction shows up around 1.5-2kHz on-axis; needs about 10° of toe-out to smooth this out, though going further to 30° starts to lose some top-end air. Distortion peaks slightly higher than the original Linton in the 50-70Hz region. Minimum impedance dips to about 3 ohms around 150Hz, so a 4-ohm-stable amplifier is recommended for best results. Vertical dispersion of about ±20° means multi-row home theater seating outside that window will hear reduced top-end. Asymmetrical design requires attention to setup (tweeters need to face outward) for the most linear in-room response. A costly upgrade for existing Linton owners if the original’s specific flaws didn’t bother them.

What the Ascend Acoustics Sierra-2EX V2 offers: A RAAL true ribbon tweeter is paired with a custom SEAS Excel Curv woofer, with the crossover optimized against Klippel NFS measurement data. Listening window smoothness measures 0.45, a moderate but usable figure for a compact standmount. Pairs are hand matched within +/-1.5dB and shipped with their own individual frequency response printout, backed by a 7 year parts and labor warranty from direct USA assembly in Orange County, California. Watch for: On axis deviation (measured average absolute deviation 0.454) is the roughest of any speaker in this batch, meaning a listener sitting dead center may notice more on axis unevenness than the smoother AsciLab or Ascend tower models nearby. Bass extension is modest for the price class at a measured 51.3Hz at -6dB. Ascend sells direct only, with no dealer network or third party retailers for an in person audition.

Buy the Wharfedale Super Linton when sound quality outweighs the price for you, and the Ascend Acoustics Sierra-2EX V2 when the price outweighs sound quality instead.

Looking for alternatives? See the complete Passive Home rankings.

Specifications Side By Side

Wharfedale Super Linton Ascend Acoustics Sierra-2EX V2
Price$2,699.00 per pair$1,748 per pair
Ranked#24 of 130 in Large Size Bookshelf Speakers#38 of 130 in Large Size Bookshelf Speakers
Bass Extension (-10dB)34Hz (measured, Erin's Audio Corner)42.4Hz (measured, spinorama.org vendor data)
Bass Extension (-3dB)77Hz (measured, Erin's Audio Corner)58.6Hz (measured, spinorama.org vendor data)
Dimensions23.8"H x 11.8"W x 13"D (604.5 x 299.7 x 330.2 mm)14.3"H x 7.5"W x 10.5"D (362 x 190 x 267 mm)
Impedance4 ohms nominal (3 ohms minimum, measured, Erin's Audio Corner)8 ohms nominal
Drivers8"(200mm) black woven Kevlar® cone woofer, 5"(135mm) black woven Kevlar® cone midrange, 1" (25mm) soft dome tweeterRAAL 10mm true ribbon tweeter, 6" SEAS Excel Curv cone woofer
Sensitivity88.2dB (measured, Erin's Audio Corner)85dB @ 2.83V/1m anechoic (manufacturer)
Weight43.7 lbs (19.8 kg) each20.1 lbs (9.1 kg) each
Woofer Cabinetported, rear-
Spinorama Preference Score5.285.14
Spinorama Preference Score with Perfect Sub7.127.22
Enclosure-ported
Power Handling-150W continuous, 300W peak
Frequency Response-51-27,000Hz +/-3dB (manufacturer)
Bass Extension (-6dB)-51.3Hz (measured, spinorama.org vendor data)
Warranty-7 years parts and labor
Country-United States

More top alternatives to Wharfedale Super Linton:

Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.

As an eBay Partner, we may be compensated if you make a purchase.

The Two Speakers In Full

Wharfedale Super Linton: $2,699.00 per pair Amazon Crutchfield eBay

Wharfedale Super Linton ranking card

Pros: Three-way design with a 1” soft dome tweeter, 5” woven Kevlar mid-range, and 8” woven Kevlar woofer in a dual rear-ported, heavily damped MDF/particle-board cabinet. Comes as a genuinely matched pair (measured within about 1dB of each other) and includes custom matching stands. A major dynamic-range improvement over the original Heritage Linton - kick drums retain their impact from low to high volume instead of compressing, the standout objective improvement in this update. Fixes the original Linton’s main flaw: a 1-3kHz scoop that made it sound a bit soft and subdued is filled in here, giving noticeably more attack and dynamic punch. About 3dB more sensitivity than the original Linton (measured ~88.2dB), meaning roughly half the amplifier power for the same output. Wide horizontal radiation of about ±70°, right in the reviewer’s preferred range for an enveloping soundstage. Lower midrange distortion than the original Linton. Bass-shelf tuning intentionally allows closer-to-wall placement (about 1 foot worked well) without excess boominess, more flexible than the original Linton in that regard. Measured bass extension of 77Hz (-3dB), with a measured sensitivity of 88.2dB.

Cons: Rolls off earlier than the original Linton (F3 77Hz versus the original’s 52Hz), a deliberate trade-off for the closer-wall-placement flexibility. On-axis, there’s a mild treble lift around 4-6kHz that can sound a touch sibilant, though the reviewer found it not very noteworthy in practice. Diffraction shows up around 1.5-2kHz on-axis; needs about 10° of toe-out to smooth this out, though going further to 30° starts to lose some top-end air. Distortion peaks slightly higher than the original Linton in the 50-70Hz region. Minimum impedance dips to about 3 ohms around 150Hz, so a 4-ohm-stable amplifier is recommended for best results. Vertical dispersion of about ±20° means multi-row home theater seating outside that window will hear reduced top-end. Asymmetrical design requires attention to setup (tweeters need to face outward) for the most linear in-room response. A costly upgrade for existing Linton owners if the original’s specific flaws didn’t bother them.

Bass Extension (-10dB)34Hz (measured, Erin's Audio Corner)
Bass Extension (-3dB)77Hz (measured, Erin's Audio Corner)
Dimensions23.8"H x 11.8"W x 13"D (604.5 x 299.7 x 330.2 mm)
Drivers8"(200mm) black woven Kevlar® cone woofer, 5"(135mm) black woven Kevlar® cone midrange, 1" (25mm) soft dome tweeter
Impedance4 ohms nominal (3 ohms minimum, measured, Erin's Audio Corner)
Sensitivity88.2dB (measured, Erin's Audio Corner)
Spinorama Preference Score5.28
Spinorama Preference Score with Perfect Sub7.12
Weight43.7 lbs (19.8 kg) each
Woofer Cabinetported, rear

Ascend Acoustics Sierra-2EX V2: $1,748 per pair Ascend Acoustics eBay

Ascend Acoustics Sierra-2EX V2 ranking card

Pros: A RAAL true ribbon tweeter is paired with a custom SEAS Excel Curv woofer, with the crossover optimized against Klippel NFS measurement data. Listening window smoothness measures 0.45, a moderate but usable figure for a compact standmount. Pairs are hand matched within +/-1.5dB and shipped with their own individual frequency response printout, backed by a 7 year parts and labor warranty from direct USA assembly in Orange County, California. Measured bass extension of 58.6Hz (-3dB).

Cons: On axis deviation (measured average absolute deviation 0.454) is the roughest of any speaker in this batch, meaning a listener sitting dead center may notice more on axis unevenness than the smoother AsciLab or Ascend tower models nearby. Bass extension is modest for the price class at a measured 51.3Hz at -6dB. Ascend sells direct only, with no dealer network or third party retailers for an in person audition.

Bass Extension (-10dB)42.4Hz (measured, spinorama.org vendor data)
Bass Extension (-3dB)58.6Hz (measured, spinorama.org vendor data)
Bass Extension (-6dB)51.3Hz (measured, spinorama.org vendor data)
CountryUnited States
Dimensions14.3"H x 7.5"W x 10.5"D (362 x 190 x 267 mm)
DriversRAAL 10mm true ribbon tweeter, 6" SEAS Excel Curv cone woofer
Enclosureported
Frequency Response51-27,000Hz +/-3dB (manufacturer)
Impedance8 ohms nominal
Power Handling150W continuous, 300W peak
Sensitivity85dB @ 2.83V/1m anechoic (manufacturer)
Spinorama Preference Score5.14
Spinorama Preference Score with Perfect Sub7.22
Warranty7 years parts and labor
Weight20.1 lbs (9.1 kg) each