Short answer: the SVS Ultra Evolution Pinnacle for better sound quality, the Klipsch RP-6000F II for the lower price. The SVS Ultra Evolution Pinnacle ranks #39 of 56 floorstanding speakers at $4999.98. The Klipsch RP-6000F II ranks #44 at $1500, $3499.98 cheaper.
What the SVS Ultra Evolution Pinnacle offers: A large curved-baffle tower built for time alignment: a 1” dome tweeter flanked by two 5.25” midranges above two 8” mid-bass drivers, plus a matching pair of 8” drivers and dual ports on the back. Watch for: Not a fully linear speaker: a dip in the upper midrange followed closely by a peak (roughly 2-3kHz) gives vocals and other midrange content a shouty, forward quality that toe-out alone doesn’t resolve.
What the Klipsch RP-6000F II gets right: Highest power handling and clean, well-behaved compression at typical volumes. The catch: Worse baffle-step coloration than the smaller RP-5000F II (3-4dB swing vs 2dB), plus a sibilance issue the 5000F doesn’t have - a real regression in tonal balance despite the higher price.
Buy the SVS Ultra Evolution Pinnacle if sound quality matters more than the price. Buy the Klipsch RP-6000F II if the price matters more than sound quality.
If sound quality matters at all to you, skip the Klipsch RP-6000F II. It ranks near the bottom of the 56 floorstanding speakers, so look higher up the list instead.
Specifications Side By Side
| SVS Ultra Evolution Pinnacle | Klipsch RP-6000F II | |
|---|---|---|
| Price | $4,999.98 | $1500 |
| Ranked | #39 of 56 in Large Size Floorstanding Speakers | #44 of 56 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 27Hz (measured, Erin’s Audio Corner) | 33Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 40Hz (measured, Erin’s Audio Corner) | 67Hz (measured, Erin’s Audio Corner) |
| Drivers | 1" dome tweeter, two 5.25" midranges, four 8" mid-bass drivers (2 front, 2 rear) | 1" titanium tweeter with Tractrix horn, dual 6.5" cerametallic woofers |
| Weight | 100.1 lbs / 45.4 kg (100 lb) each | 49.4 lbs / 22.4 kg |
| Sensitivity | 88.1dB (measured, Erin’s Audio Corner) | 90dB (2.83V/1m, measured by Erin’s Audio Corner) |
| Impedance | 6 ohms nominal, 2.6 ohms minimum (measured, Erin’s Audio Corner) | 8 ohms nominal (3.7 ohms minimum, measured, Erin’s Audio Corner) |
| Dimensions | 49"H x 12"W x 18"D (1245.0 x 305.0 x 457.0 mm) | 39.6" x 9.3" x 17.6" (1006 x 236 x 446 mm) |
| Woofer Cabinet | ported, rear (dual) | ported, rear |
| Frequency Response | 24Hz - 40kHz (±3dB, Manufacturer specified) | 38Hz - 25kHz (+-3dB, Manufacturer specified) |
| Crossovers | 140Hz & 1.8kHz | - |
| Recommended Power | 20-300W | - |
| Crossover Frequency | - | 1770Hz |
| Output Power | - | 125W continuous, 500W peak |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Klipsch Forte IV vs Klipsch RP-5000F II
- MoFi SourcePoint 888 vs Polk T50
- Klipsch Forte IV vs Polk T50
- SVS Ultra Evolution Pinnacle vs Dynaudio Emit 30
- KEF Q11 Meta vs SVS Ultra Evolution Pinnacle
The Two Speakers In Full
SVS Ultra Evolution Pinnacle: $4,999.98 SVS
Pros: A large curved-baffle tower built for time alignment: a 1” dome tweeter flanked by two 5.25” midranges above two 8” mid-bass drivers, plus a matching pair of 8” drivers and dual ports on the back. Impulse-response testing shows a single clean arrival rather than the staggered tweeter-then-woofer arrival typical of conventional flat-baffle designs, confirming genuinely effective time alignment. Excellent build quality throughout. Very wide, consistent horizontal radiation around ±70-80° gives a large, enveloping soundstage. Capable of very high output with very low harmonic distortion - the reviewer says this measured the lowest harmonic distortion of any speaker he has tested to date, at both 86dB and 96dB output, with distortion staying under 1% down to 40Hz.
Cons: Not a fully linear speaker: a dip in the upper midrange followed closely by a peak (roughly 2-3kHz) gives vocals and other midrange content a shouty, forward quality that toe-out alone doesn’t resolve, pointing to a genuine on-axis response issue rather than just room reflections. A wide, high-Q bass bump around 70-80Hz makes the speaker sound boomy unless pulled at least 3 feet from the rear wall or tamed with EQ (a -3dB cut with a Q of 1 around 70Hz worked well in testing). Minimum impedance dips to about 2.6 ohms around 80Hz, a genuinely demanding load - the reviewer could not drive these to satisfying output with budget-oriented amplifiers and receivers, and recommends a robust stereo amp or monoblocks instead. At around 100 lbs and roughly 4 feet tall with the tweeter about 32.5” off the ground, seating position matters: straying beyond about 10° of the tweeter axis loses real detail in the upper midrange, and the crossover region shows lobing that shifts from about 10° to 50° between 2-4kHz. Multitone distortion and dynamic compression both increase in that same upper-midrange/tweeter region at higher output, consistent with the on-axis dip-then-peak character.
Full SVS Ultra Evolution Pinnacle review and specifications →
| Bass Extension (-10dB) | 27Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 40Hz (measured, Erin's Audio Corner) |
| Crossovers | 140Hz & 1.8kHz |
| Dimensions | 49"H x 12"W x 18"D (1245.0 x 305.0 x 457.0 mm) |
| Drivers | 1" dome tweeter, two 5.25" midranges, four 8" mid-bass drivers (2 front, 2 rear) |
| Frequency Response | 24Hz - 40kHz (±3dB, Manufacturer specified) |
| Impedance | 6 ohms nominal, 2.6 ohms minimum (measured, Erin's Audio Corner) |
| Recommended Power | 20-300W |
| Sensitivity | 88.1dB (measured, Erin's Audio Corner) |
| Weight | 100.1 lbs / 45.4 kg (100 lb) each |
| Woofer Cabinet | ported, rear (dual) |
As an eBay Partner, we may be compensated if you make a purchase.
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- SVS Ultra Evolution Pinnacle vs Klipsch RP-5000F II
- SVS Ultra Evolution Pinnacle vs Klipsch RP-8000F II
- SVS Ultra Evolution Pinnacle vs KEF Q11 Meta
- SVS Ultra Evolution Pinnacle vs Dynaudio Emit 30
- SVS Ultra Evolution Pinnacle vs Klipsch Heresy IV
- SVS Ultra Evolution Pinnacle vs Klipsch Forte IV
- SVS Ultra Evolution Pinnacle vs Polk T50
- SVS Ultra Evolution Pinnacle vs Focal Aria Evo X N°2
- See all 13 comparisons
Klipsch RP-6000F II: $1500 Amazon
Pros: Highest power handling and clean, well-behaved compression at typical volumes. Precise imaging from the controlled horn directivity.
Cons: Worse baffle-step coloration than the smaller RP-5000F II (3-4dB swing vs 2dB), plus a sibilance issue the 5000F doesn’t have - a real regression in tonal balance despite the higher price. Bass extension is mixed - less deep at -3dB (67Hz) than the 5000F - and needs a subwoofer regardless. Narrow horizontal dispersion (~50-60 degrees).
Full Klipsch RP-6000F II review and specifications →
| Bass Extension (-10dB) | 33Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 67Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 1770Hz |
| Dimensions | 39.6" x 9.3" x 17.6" (1006 x 236 x 446 mm) |
| Drivers | 1" titanium tweeter with Tractrix horn, dual 6.5" cerametallic woofers |
| Frequency Response | 38Hz - 25kHz (+-3dB, Manufacturer specified) |
| Impedance | 8 ohms nominal (3.7 ohms minimum, measured, Erin's Audio Corner) |
| Output Power | 125W continuous, 500W peak |
| Sensitivity | 90dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 49.4 lbs / 22.4 kg |
| Woofer Cabinet | ported, rear |
As an eBay Partner, we may be compensated if you make a purchase.
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Klipsch RP-6000F II vs Dynaudio Emit 30
- Klipsch RP-6000F II vs Polk T50
- Klipsch RP-6000F II vs Klipsch RP-8000F II
- Klipsch RP-6000F II vs Focal Aria Evo X N°2
- Klipsch RP-6000F II vs Sony SS-CS3
- Klipsch RP-6000F II vs Infinity Reference 253
- Klipsch RP-6000F II vs JBL Stage 2 280F
- Klipsch RP-6000F II vs Klipsch RP-5000F II
- See all 12 comparisons