Short answer: the MoFi SourcePoint 10 if sound quality matters most, the SVS Prime Bookshelf if price matters most. The MoFi SourcePoint 10 ranks #26 of 130 bookshelf speakers at $3795. The SVS Prime Bookshelf ranks #88 at $699, $3096 cheaper.
What the SVS Prime Bookshelf offers: Reasonable sensitivity for the price at about 87dB, and the 6.5” woofer sits in its own dedicated sealed sub-compartment inside the cabinet for cleaner midrange/bass separation. Overall response stays within about ±3dB from 80Hz-16kHz, which the reviewer calls reasonable for the price point. Wide, consistent horizontal radiation. Toeing the speakers 30 degrees off-axis smooths the in-room response noticeably if the on-axis tonal balance isn’t to your taste. Watch for: A scooped mid-range paired with a boosted upper mid-range creates an audibly uneven tonal balance, and there’s an additional dip in the treble around 4-5kHz that reads as slightly tinny relative to the recessed mid-range. Measured minimum impedance dips below 4 ohms (EPDR even lower), so an 8-ohm-only amplifier or AVR may struggle - a 4-ohm-stable amp or separate amplification is recommended. Bass extension is modest (F3 72Hz, F10 49Hz measured) - SVS clearly designed this to be paired with one of their subwoofers rather than to stand fully alone. Compared directly against its pricier sibling, the SVS Ultra Bookshelf, in the same review, the reviewer found the Ultra noticeably more tonally neutral.
What the MoFi SourcePoint 10 offers: Andrew Jones-designed concentric/coincident driver delivers best-in-class sound power and early-reflections directivity in the reviewer’s testing - a genuine “point source” design. Vertical and horizontal radiation patterns closely match each other (about ±50° horizontal, ±30-40° vertical), a hallmark benefit of a well-executed concentric driver. Distortion stays low - under 1% above 100Hz at 86dB, and under 3% up to 100Hz even at 96dB, better than the reviewer expected from a low-excursion waveguide-loaded woofer. Surprisingly strong dynamic capability with little audible compression at both low and high volume. Widely spaced (about 11 feet apart) with roughly 15° of toe-out produced a huge, expansive soundstage without significant loss of imaging precision. Solidly built cabinet (about 40 lbs, heavily braced) minimizes cabinet resonance. Watch for: Like virtually all coincident designs, sounds notably bright pointed directly on-axis due to a deliberate treble lift (meant to compensate for the 28mm tweeter’s earlier beaming versus a typical 25mm/1” tweeter) combined with a diffraction dip/peak from the waveguide edge; needs about 15° of toe-out to sound neutral, and even then benefits from an extra 1-2dB of treble EQ. Toeing out further (to 30°) flattens the treble further but introduces a dip in the midrange-to-tweeter crossover region - there’s no single toe-out angle that fixes everything at once. F3 of 56Hz and F10 of 38Hz (about 40Hz in-room) mean genuine deep bass is limited; the reviewer would pair it with a sealed 10” or 12” subwoofer for regular daily listening. Bass extension and cabinet placement trade off against midrange cleanliness: placing it close to a wall for more bass risks a wall-bounce suckout in the midrange (roughly 200-500Hz depending on distance). Not perfectly time-aligned between tweeter and woofer (about 0.4ms delta), an inherent limitation of passive coincident drivers versus actively time-corrected designs. Some resonances appear in measurements, likely port-related. Minimum impedance around 6.4 ohms with EPDR near 3 ohms, so the reviewer recommends sticking with a 4-ohm-rated amplifier to be safe.
Buy the SVS Prime Bookshelf if the price is the priority over sound quality, or the MoFi SourcePoint 10 if sound quality is the priority over the price.
Still deciding? The full Passive Home rankings cover every ranked option.
Specifications Side By Side
| SVS Prime Bookshelf | MoFi SourcePoint 10 | |
|---|---|---|
| Price | $699.00 per pair | $3795 per pair |
| Ranked | #88 of 130 in Large Size Bookshelf Speakers | #26 of 130 in Large Size Bookshelf Speakers |
| Drivers | 6.5" polypropylene cone woofer with aluminum shorting ring (sealed sub-compartment), 1" aluminum dome tweeter | 10" Paper-pulp Cone woofer, 1.25-inch soft-dome tweeter |
| Weight | 15.5 lbs (7.03 kg) each | 46.3 lbs (21.0 kg) each |
| Impedance | 8 ohms nominal, 3.9 ohms minimum (measured, Erin's Audio Corner) | 8 ohms nominal, 6.4 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 87dB (measured average, Erin's Audio Corner) | 88.2dB (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 72Hz (measured, Erin's Audio Corner) | 56Hz (measured, Erin's Audio Corner) |
| Bass Extension (-10dB) | 49Hz (measured, Erin's Audio Corner) | 38Hz (measured, Erin's Audio Corner) |
| Frequency Response | 48Hz - 25kHz ±3dB (manufacturer specified) | - |
| Spinorama Preference Score | 4.26 | 3.25 |
| Spinorama Preference Score with Perfect Sub | 6.88 | 5.27 |
| Dimensions | - | 22.5"H x 14.5"W x 16.6"D (571.5 x 368.3 x 421.6 mm) |
| Woofer Cabinet | - | ported, rear |
Related Speaker Comparisons
More worthwhile head-to-heads for MoFi SourcePoint 10:
- MoFi SourcePoint 10 vs Perlisten S4b
- KEF Reference 1 Meta vs MoFi SourcePoint 10
- GR-Research NX-Studio vs MoFi SourcePoint 10
- AsciLab C6B vs MoFi SourcePoint 10
- Audio First Cadentia 3 vs MoFi SourcePoint 10
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
SVS Prime Bookshelf: $699.00 per pair Amazon eBay
Pros: Reasonable sensitivity for the price at about 87dB, and the 6.5” woofer sits in its own dedicated sealed sub-compartment inside the cabinet for cleaner midrange/bass separation. Overall response stays within about ±3dB from 80Hz-16kHz, which the reviewer calls reasonable for the price point. Wide, consistent horizontal radiation. Toeing the speakers 30 degrees off-axis smooths the in-room response noticeably if the on-axis tonal balance isn’t to your taste. Measured bass extension of 72Hz (-3dB), with a measured sensitivity of 87dB.
Cons: A scooped mid-range paired with a boosted upper mid-range creates an audibly uneven tonal balance, and there’s an additional dip in the treble around 4-5kHz that reads as slightly tinny relative to the recessed mid-range. Measured minimum impedance dips below 4 ohms (EPDR even lower), so an 8-ohm-only amplifier or AVR may struggle - a 4-ohm-stable amp or separate amplification is recommended. Bass extension is modest (F3 72Hz, F10 49Hz measured) - SVS clearly designed this to be paired with one of their subwoofers rather than to stand fully alone. Compared directly against its pricier sibling, the SVS Ultra Bookshelf, in the same review, the reviewer found the Ultra noticeably more tonally neutral.
Full SVS Prime Bookshelf review and specifications →
| Bass Extension (-10dB) | 49Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 72Hz (measured, Erin's Audio Corner) |
| Drivers | 6.5" polypropylene cone woofer with aluminum shorting ring (sealed sub-compartment), 1" aluminum dome tweeter |
| Frequency Response | 48Hz - 25kHz ±3dB (manufacturer specified) |
| Impedance | 8 ohms nominal, 3.9 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 87dB (measured average, Erin's Audio Corner) |
| Spinorama Preference Score | 4.26 |
| Spinorama Preference Score with Perfect Sub | 6.88 |
| Weight | 15.5 lbs (7.03 kg) each |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- SVS Prime Bookshelf vs KEF Q3 Meta
- SVS Prime Bookshelf vs ELAC Debut 2.0 B6.2
- SVS Prime Bookshelf vs Polk Monitor XT20
- SVS Prime Bookshelf vs Dynaudio Special Forty
- SVS Prime Bookshelf vs Sonus Faber Lumina II
- SVS Prime Bookshelf vs Infinity IL10
- SVS Prime Bookshelf vs XTZ Spirit 4
- SVS Prime Bookshelf vs Focal Aria 906
- See all 55 comparisons
MoFi SourcePoint 10: $3795 per pair Crutchfield eBay
Pros: Andrew Jones-designed concentric/coincident driver delivers best-in-class sound power and early-reflections directivity in the reviewer’s testing - a genuine “point source” design. Vertical and horizontal radiation patterns closely match each other (about ±50° horizontal, ±30-40° vertical), a hallmark benefit of a well-executed concentric driver. Distortion stays low - under 1% above 100Hz at 86dB, and under 3% up to 100Hz even at 96dB, better than the reviewer expected from a low-excursion waveguide-loaded woofer. Surprisingly strong dynamic capability with little audible compression at both low and high volume. Widely spaced (about 11 feet apart) with roughly 15° of toe-out produced a huge, expansive soundstage without significant loss of imaging precision. Solidly built cabinet (about 40 lbs, heavily braced) minimizes cabinet resonance. Measured bass extension of 56Hz (-3dB), with a measured sensitivity of 88.2dB.
Cons: Like virtually all coincident designs, sounds notably bright pointed directly on-axis due to a deliberate treble lift (meant to compensate for the 28mm tweeter’s earlier beaming versus a typical 25mm/1” tweeter) combined with a diffraction dip/peak from the waveguide edge; needs about 15° of toe-out to sound neutral, and even then benefits from an extra 1-2dB of treble EQ. Toeing out further (to 30°) flattens the treble further but introduces a dip in the midrange-to-tweeter crossover region - there’s no single toe-out angle that fixes everything at once. F3 of 56Hz and F10 of 38Hz (about 40Hz in-room) mean genuine deep bass is limited; the reviewer would pair it with a sealed 10” or 12” subwoofer for regular daily listening. Bass extension and cabinet placement trade off against midrange cleanliness: placing it close to a wall for more bass risks a wall-bounce suckout in the midrange (roughly 200-500Hz depending on distance). Not perfectly time-aligned between tweeter and woofer (about 0.4ms delta), an inherent limitation of passive coincident drivers versus actively time-corrected designs. Some resonances appear in measurements, likely port-related. Minimum impedance around 6.4 ohms with EPDR near 3 ohms, so the reviewer recommends sticking with a 4-ohm-rated amplifier to be safe.
Full MoFi SourcePoint 10 review and specifications →
| Bass Extension (-10dB) | 38Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 56Hz (measured, Erin's Audio Corner) |
| Dimensions | 22.5"H x 14.5"W x 16.6"D (571.5 x 368.3 x 421.6 mm) |
| Drivers | 10" Paper-pulp Cone woofer, 1.25-inch soft-dome tweeter |
| Impedance | 8 ohms nominal, 6.4 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 88.2dB (measured, Erin's Audio Corner) |
| Spinorama Preference Score | 3.25 |
| Spinorama Preference Score with Perfect Sub | 5.27 |
| Weight | 46.3 lbs (21.0 kg) each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- MoFi SourcePoint 10 vs Radiant Acoustics Clarity 6.2
- MoFi SourcePoint 10 vs Wharfedale Super Linton
- MoFi SourcePoint 10 vs Dynaudio Heritage Special
- MoFi SourcePoint 10 vs Ascend Acoustics CMT-340 SE2
- MoFi SourcePoint 10 vs Arendal 1528 Monitor 8
- MoFi SourcePoint 10 vs Wharfedale Linton 85
- MoFi SourcePoint 10 vs AsciLab F6Bs
- MoFi SourcePoint 10 vs Ascend Acoustics Sierra-LX
- See all 48 comparisons