Short answer: the Shure SE215. It ranks #961 of 1291 in-ear headphones by sound quality, rated 3.1/5, at $94. The Sivga Que UTG ranks #1013, rated 2.9/5, at $89, $5 cheaper, which does not close the gap in sound quality.
What the Shure SE215 does well: Bass from 60 to 200 Hz is lifted by about 4.2 dB with low mids up 2.2 dB, giving a warm, full sound that suits rock, pop and hip hop. The tradeoff: Treble from 6 to 10 kHz is about 3 dB low with a 5.9 dB dip near 6.7 kHz, and the top octave is down 2.7 dB, so cymbals and air sound dull.
What the Sivga Que UTG does well: Lower mids sit within about 0.5 dB of target, keeping voices and guitars natural. The catch: An 11.1 dB peak near 11.9 kHz can make cymbals and sibilance sound sharp.
Buy the Shure SE215. It is rated higher for sound quality, and saving $5 with the Sivga Que UTG does not make up for the sound-quality gap.
Looking for alternatives? See the complete Headphones rankings.
Bass from 60 to 200 Hz is lifted by about 4.2 dB with low mids up 2.2 dB, giving a warm, full sound that suits rock, pop and hip hop.
Amazon $94.00 eBay
Lower mids sit within about 0.5 dB of target, keeping voices and guitars natural.
Amazon $89.00 eBayPrices on this page were last checked October 16, 2026 at 5:46 PM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
Specifications Side By Side
| Shure SE215 | Sivga Que UTG | |
|---|---|---|
| Price | $94.00 | $89.00 |
| Ranked | #961 of 1291 in In-Ear Headphones | #1013 of 1291 in In-Ear Headphones |
| Form Factor | In-ear | In-ear |
| Harman Preference Score | 63 (measured by oratory1990, via AutoEQ) | 61 (median of 10 squig.link measurements, calibrated to AutoEQ) |
| Deviation From Target | 2.78 dB standard deviation | 2.99 dB standard deviation |
| Tonal Tilt | -0.78 (negative is warmer, positive brighter) | +0.83 (negative is warmer, positive brighter) |
| Sub-bass Extension | Within 6 dB of target down to 20 Hz (-1.0 dB at 30 Hz) | Within 6 dB of target down to 20 Hz (-5.6 dB at 30 Hz) |
| Connection | Wired | Wired |
| Driver Type | Dynamic | Dynamic |
| Drivers | 1 x dynamic | 1 x 10mm dynamic (flat UTG glass diaphragm) |
| Impedance | 17 ohms | 32 ohms |
| Sensitivity | 107 dB SPL/mW | - |
| Frequency Response | 22Hz - 17.5kHz (Manufacturer specified) | 20Hz - 20kHz |
| Back | Closed | Closed |
Frequency Response Compared
Both headphones’ measurements overlaid on the Harman target. Above the target sounds louder in that range, below it quieter. Each curve is the median of several independent measurements, shifted so its 500 Hz to 2 kHz average sits at 0 dB, so only the tuning is compared.
Measurement data: the Shure SE215 from aden, ducbloke, ekaudio, superreview, suporsalad and yoshiultra; the Sivga Que UTG from aftersound, atechreviews, audioamigo, eplv, gadgetgenerations, joycesreview, musicafe, practiphile, soundcheck39 and tonedeafmonk, all via squig.link.
Related Headphone Comparisons
How Shure SE215 compares with other leading options: