Sennheiser IE 200 vs Truthear x Crinacle Zero

Last updated: October 11, 2026

Short answer: a tie on sound quality. Both are rated 4.4/5 (#90 and #91 of 450 in-ear headphones), so choose on features and fit.

Sennheiser IE 200 vs Truthear x Crinacle Zero

What the Sennheiser IE 200 does well: Bass and midrange land almost exactly on the Harman target in oratory1990’s measurement, within about 0.5 dB from 60 Hz to 3 kHz, which gives a natural tonal balance and a preference score of 79. Watch for: The presence region from 3 to 6 kHz sits about 5 dB under target, with a 5.7 dB dip near 4.4 kHz, so vocals and snare attacks sound a little recessed.

The case for the Truthear x Crinacle Zero: Oratory1990’s measurement gives it a preference score of 79 with a 1.61 dB deviation, and its two dynamic drivers stay within about 1.3 dB of target from 60 Hz up to 10 kHz. The tradeoff: A 4.5 dB peak near 8 kHz and 2.4 dB of extra air above 10 kHz give it a brighter tilt than target, so sibilant vocals and cymbals can sound edgy.

Buy the Sennheiser IE 200 or the Truthear x Crinacle Zero on features: they are rated the same for sound quality at close to the same price.

Want more options? Browse the full Headphones rankings.

Specifications Side By Side

Sennheiser IE 200 Truthear x Crinacle Zero
Price$129.95-
Ranked#90 of 450 in In-Ear Headphones#91 of 450 in In-Ear Headphones
Form FactorIn-earIn-ear
Harman Preference Score79 (measured by oratory1990, via AutoEQ)79 (measured by oratory1990, via AutoEQ)
Deviation From Target1.86 dB standard deviation1.61 dB standard deviation
Tonal Tilt-0.02 (negative is warmer, positive brighter)+0.46 (negative is warmer, positive brighter)
Sub-bass ExtensionWithin 6 dB of target down to 20 Hz (-1.8 dB at 30 Hz)Within 6 dB of target down to 20 Hz (-2.5 dB at 30 Hz)
ConnectionWiredWired
Driver TypeDynamicDynamic
Drivers1 x 7mm dynamic1 x 10mm dynamic + 1 x 7.8mm dynamic
Impedance16 ohms10 ohms
Sensitivity119 dB SPL/V117.5 dB
Weight0 lbs (4 g) per earphone-
Frequency Response6Hz - 20kHz (Manufacturer specified)20Hz - 39.5kHz (Manufacturer specified)
BackClosedClosed

More worthwhile head-to-heads for Sennheiser IE 200:

Prices on this page were last checked October 11, 2026 at 4:59 PM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.

As an eBay Partner, we may be compensated if you make a purchase.

The Two Headphones In Full

Sennheiser IE 200: $129.95 Amazon eBay

Sennheiser IE 200 ranking card

Pros: Bass and midrange land almost exactly on the Harman target in oratory1990’s measurement, within about 0.5 dB from 60 Hz to 3 kHz, which gives a natural tonal balance and a preference score of 79. At 16 ohms and 119 dB SPL/V sensitivity it plays loud straight from a phone with no amp. Each earpiece weighs only 4 g, and the single 7mm dynamic driver is a simple, wired design with no battery to charge.

Cons: The presence region from 3 to 6 kHz sits about 5 dB under target, with a 5.7 dB dip near 4.4 kHz, so vocals and snare attacks sound a little recessed. The top octave runs about 5.8 dB hot, which adds sparkle that can read as thin or bright on some recordings. The Final Audio A4000 and Shuoer S12 carry higher ratings at lower prices.

BackClosed
ConnectionWired
Deviation From Target1.86 dB standard deviation
Driver TypeDynamic
Drivers1 x 7mm dynamic
Form FactorIn-ear
Frequency Response6Hz - 20kHz (Manufacturer specified)
Harman Preference Score79 (measured by oratory1990, via AutoEQ)
Impedance16 ohms
Sensitivity119 dB SPL/V
Sub-bass ExtensionWithin 6 dB of target down to 20 Hz (-1.8 dB at 30 Hz)
Tonal Tilt-0.02 (negative is warmer, positive brighter)
Weight0 lbs (4 g) per earphone
EQ preset to match the Harman target

Set a preamp of -4.3 dB, then add these filters in any parametric equalizer (Wavelet, Equalizer APO, Peace, or a player with parametric EQ). Calculated by AutoEQ from its measured frequency response.

FilterFrequencyGainQ
Low shelf105 Hz+0.3 dB0.70
Peak4,135 Hz+4.3 dB1.83
Peak1,520 Hz-1.9 dB1.99
Peak180 Hz-1.2 dB1.14
Peak67 Hz+1.0 dB1.34
High shelf10,000 Hz-6.1 dB0.70
Peak727 Hz+0.8 dB1.79
Peak5,480 Hz+1.2 dB3.96
Peak1,154 Hz-0.6 dB3.44
Peak2,978 Hz+0.4 dB3.96

Truthear x Crinacle Zero AliExpress eBay

Truthear x Crinacle Zero ranking card

Pros: Oratory1990’s measurement gives it a preference score of 79 with a 1.61 dB deviation, and its two dynamic drivers stay within about 1.3 dB of target from 60 Hz up to 10 kHz. Bass from 60 to 200 Hz runs 1.2 dB above target, adding warmth and punch that suit warm and V-shaped tastes. Sub-bass reaches down to 20 Hz within 6 dB of target.

Cons: A 4.5 dB peak near 8 kHz and 2.4 dB of extra air above 10 kHz give it a brighter tilt than target, so sibilant vocals and cymbals can sound edgy. Its 10 ohm impedance is unusually low, so a source with high output impedance can shift its tuning, and it has no microphone for calls.

ReleasedJul 2022 (4 years ago)
BackClosed
ConnectionWired
Deviation From Target1.61 dB standard deviation
Driver TypeDynamic
Drivers1 x 10mm dynamic + 1 x 7.8mm dynamic
Form FactorIn-ear
Frequency Response20Hz - 39.5kHz (Manufacturer specified)
Harman Preference Score79 (measured by oratory1990, via AutoEQ)
Impedance10 ohms
Sensitivity117.5 dB
Sub-bass ExtensionWithin 6 dB of target down to 20 Hz (-2.5 dB at 30 Hz)
Tonal Tilt+0.46 (negative is warmer, positive brighter)
EQ preset to match the Harman target

Set a preamp of -4.3 dB, then add these filters in any parametric equalizer (Wavelet, Equalizer APO, Peace, or a player with parametric EQ). Calculated by AutoEQ from its measured frequency response.

FilterFrequencyGainQ
Low shelf105 Hz+6.7 dB0.70
Peak254 Hz+3.6 dB0.38
Peak71 Hz-7.3 dB0.42
Peak4,967 Hz-2.5 dB3.55
Peak2,574 Hz-1.4 dB1.07
High shelf10,000 Hz-2.1 dB0.70
Peak352 Hz-0.6 dB2.27
Peak658 Hz+0.6 dB2.25
Peak207 Hz+0.6 dB3.05
Peak1,186 Hz-0.4 dB2.72