Short answer: the Polk Reserve R500 for better sound quality, the Polk T50 for the lower price. The Polk Reserve R500 ranks #36 of 68 floorstanding speakers at $699. The Polk T50 ranks #55 at $249, $450 cheaper.
What the Polk T50 offers: Pretty deep bass for the price. Distortion at 86dB SPL/1m is reasonably controlled outside a narrow spike around 250Hz. The reviewer notes performance is “not too bad for a budget speaker” once the two main tonal issues are addressed with EQ. Watch for: 5dB peak at 1khz, 4dB bright top end from 11khz on up. Just okay vertical off axis. Impedance and phase show several resonances between 200Hz-1kHz, with a minimum impedance of 4.2 ohms. Distortion rises substantially at 96dB SPL/1m across the midrange, with repeated peaks between 100Hz-2kHz.
What the Polk Reserve R500 offers: Dual 5.25” midwoofers paired with a ring radiator tweeter in a floorstanding tower design. Surprisingly neutral overall compared to Polk’s smaller bookshelf models - notably more even-handed than the brighter-sounding R200 the reviewer tested previously. Good linearity on-axis, within about -3/+2dB. Sensitivity close to 86dB, easily driven to adequate levels in a small-to-medium room with a 100W-capable amplifier. Takes very well to EQ - a single band of correction (about a 2dB cut around 4-5kHz) resolves the main tonal issue and transforms the sound. Dynamic range and compression performance is solidly “medium,” holding up fine through about 20dB of level increase before higher-frequency and bass output start to taper at extreme volumes. Watch for: A bump around 4-6kHz gives a “shouty,” mildly sibilant quality in the lower treble. Counterintuitively, toeing the speaker out to reduce brightness makes this worse rather than better, since the ring-radiator tweeter’s directivity narrows rapidly above about 6-7kHz - pointed on-axis retains enough top-end air to balance the bump, but toed away that air drops off and the shoutiness stands out more. Bass is adequate for its 5.25” woofers but lacks real weight below about 40-50Hz; a subwoofer is still needed for movies and bass-heavy music. A cabinet resonance around 160-170Hz subtracts from rather than adds boom to the mid-bass region. Vertical listening window is fairly narrow - sitting more than about 10-20° above or below the tweeter axis causes a suckout in the 2-5kHz range, reducing clarity and attack. Multitone distortion ramps up noticeably around 1kHz, and crossing over to a subwoofer at 80Hz doesn’t meaningfully reduce it - likely a surround-related effect rather than excursion-related. Without applying corrective EQ, the reviewer says the 4-6kHz brightness would make it harder to live with day to day.
Buy the Polk T50 if the price matters more than sound quality. Buy the Polk Reserve R500 if sound quality matters more than the price.
If sound quality matters at all to you, skip the Polk T50. It ranks near the bottom of the 68 floorstanding speakers, so look higher up the list instead.
Specifications Side By Side
| Polk T50 | Polk Reserve R500 | |
|---|---|---|
| Price | $249.00 | $699.00 |
| Ranked | #55 of 68 in Large Size Floorstanding Speakers | #36 of 68 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 38Hz (measured, Audio Science Review) | 33Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 47Hz (measured, Audio Science Review) | 51Hz (measured, Erin’s Audio Corner) |
| Impedance | 4 ohms nominal (4.2 ohms minimum, measured by Audio Science Review) | 4.1 ohms minimum above 80Hz (measured, Erin’s Audio Corner; 8 ohms nominal per manufacturer) |
| Drivers | 2x 6.5" bi-laminate paper cone woofers, 1x 1" Terylene dome tweeter + 2x 8" passive bass radiators | Two 5.25" Turbine Cone woofer, 1" Pinnacle Ring Radiator tweeter |
| Weight | 75.4 lbs / 34.2 kg | 39.2 lbs / 17.8 kg each |
| Sensitivity | 86.3dB (2.83V/1m, measured by Audio Science Review) | 86.2dB (measured, Erin’s Audio Corner) |
| Dimensions | 40.4"H x 9.3"W x 12.5"D (1026.2 x 235.0 x 317.5 mm) | 40.3"H x 6.8"W x 12.4"D (1023.6 x 172.7 x 315 mm) |
| Woofer Cabinet | passive radiator | ported, rear |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- ELAC Debut 3.0 DF63 vs Polk Audio XT60
- ELAC Debut 3.0 DF63 vs Definitive Technology BP-9020
- ELAC Debut 3.0 DF63 vs Linkwitz Lab LXmini
- Polk Reserve R500 vs Polk Audio XT60
- Polk T50 vs ELAC Debut 3.0 DF63
Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Polk T50: $249.00 Amazon eBay
Pros: Pretty deep bass for the price. Distortion at 86dB SPL/1m is reasonably controlled outside a narrow spike around 250Hz. The reviewer notes performance is “not too bad for a budget speaker” once the two main tonal issues are addressed with EQ.
Cons: 5dB peak at 1khz, 4dB bright top end from 11khz on up. Just okay vertical off axis. Impedance and phase show several resonances between 200Hz-1kHz, with a minimum impedance of 4.2 ohms. Distortion rises substantially at 96dB SPL/1m across the midrange, with repeated peaks between 100Hz-2kHz.
Full Polk T50 review and specifications →
| Bass Extension (-10dB) | 38Hz (measured, Audio Science Review) |
|---|---|
| Bass Extension (-3dB) | 47Hz (measured, Audio Science Review) |
| Dimensions | 40.4"H x 9.3"W x 12.5"D (1026.2 x 235.0 x 317.5 mm) |
| Drivers | 2x 6.5" bi-laminate paper cone woofers, 1x 1" Terylene dome tweeter + 2x 8" passive bass radiators |
| Impedance | 4 ohms nominal (4.2 ohms minimum, measured by Audio Science Review) |
| Sensitivity | 86.3dB (2.83V/1m, measured by Audio Science Review) |
| Weight | 75.4 lbs / 34.2 kg |
| Woofer Cabinet | passive radiator |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
Polk Reserve R500: $699.00 Amazon eBay
Pros: Dual 5.25” midwoofers paired with a ring radiator tweeter in a floorstanding tower design. Surprisingly neutral overall compared to Polk’s smaller bookshelf models - notably more even-handed than the brighter-sounding R200 the reviewer tested previously. Good linearity on-axis, within about -3/+2dB. Sensitivity close to 86dB, easily driven to adequate levels in a small-to-medium room with a 100W-capable amplifier. Takes very well to EQ - a single band of correction (about a 2dB cut around 4-5kHz) resolves the main tonal issue and transforms the sound. Dynamic range and compression performance is solidly “medium,” holding up fine through about 20dB of level increase before higher-frequency and bass output start to taper at extreme volumes.
Cons: A bump around 4-6kHz gives a “shouty,” mildly sibilant quality in the lower treble. Counterintuitively, toeing the speaker out to reduce brightness makes this worse rather than better, since the ring-radiator tweeter’s directivity narrows rapidly above about 6-7kHz - pointed on-axis retains enough top-end air to balance the bump, but toed away that air drops off and the shoutiness stands out more. Bass is adequate for its 5.25” woofers but lacks real weight below about 40-50Hz; a subwoofer is still needed for movies and bass-heavy music. A cabinet resonance around 160-170Hz subtracts from rather than adds boom to the mid-bass region. Vertical listening window is fairly narrow - sitting more than about 10-20° above or below the tweeter axis causes a suckout in the 2-5kHz range, reducing clarity and attack. Multitone distortion ramps up noticeably around 1kHz, and crossing over to a subwoofer at 80Hz doesn’t meaningfully reduce it - likely a surround-related effect rather than excursion-related. Without applying corrective EQ, the reviewer says the 4-6kHz brightness would make it harder to live with day to day.
Full Polk Reserve R500 review and specifications →
| Bass Extension (-10dB) | 33Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 51Hz (measured, Erin's Audio Corner) |
| Dimensions | 40.3"H x 6.8"W x 12.4"D (1023.6 x 172.7 x 315 mm) |
| Drivers | Two 5.25" Turbine Cone woofer, 1" Pinnacle Ring Radiator tweeter |
| Impedance | 4.1 ohms minimum above 80Hz (measured, Erin's Audio Corner; 8 ohms nominal per manufacturer) |
| Sensitivity | 86.2dB (measured, Erin's Audio Corner) |
| Weight | 39.2 lbs / 17.8 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Polk Reserve R500 vs ELAC Debut 3.0 DF63
- Polk Reserve R500 vs Linkwitz Lab LXmini
- Polk Reserve R500 vs PSB Imagine T65
- Polk Reserve R500 vs Definitive Technology BP-9020
- Polk Reserve R500 vs Q Acoustics 5040
- Polk Reserve R500 vs Polk Audio Reserve R700
- Polk Reserve R500 vs Infinity Primus 360
- Polk Reserve R500 vs Klipsch Forte IV
- See all 22 comparisons