Polk Audio XT60 vs Klipsch RP-6000F II

Last updated: August 19, 2026

Short answer: the Polk Audio XT60. It ranks #36 of 59 floorstanding speakers by sound quality at $229; the Klipsch RP-6000F II ranks #47 and costs $1500, so there is not much of a tradeoff to weigh.

The case for the Polk Audio XT60: Passive-radiator-loaded design (6.5” woofer plus two 6.5” passive radiators) gives deeper bass than the driver size alone would suggest - 43.9Hz at -3dB / 38.1Hz at -10dB, genuinely competitive extension for a budget tower. The tradeoff: Bass alignment Q is the highest, least-controlled figure in this entire batch, consistent with owner reports of a slightly loose, boomy low end at higher volumes.

What the Klipsch RP-6000F II offers: Highest power handling and clean, well-behaved compression at typical volumes. The catch: Worse baffle-step coloration than the smaller RP-5000F II (3-4dB swing vs 2dB), plus a sibilance issue the 5000F doesn’t have - a real regression in tonal balance despite the higher price.

Buy the Polk Audio XT60. It ranks higher for sound quality than the Klipsch RP-6000F II and costs less, so there is no real case for the other one.

If sound quality matters at all to you, skip the Klipsch RP-6000F II. It ranks near the bottom of the 59 floorstanding speakers, so look higher up the list instead.

Polk Audio XT60 vs Klipsch RP-6000F II

Specifications Side By Side

Polk Audio XT60 Klipsch RP-6000F II
Price$229$1500
Ranked#36 of 59 in Large Size Floorstanding Speakers#47 of 59 in Large Size Floorstanding Speakers
Bass Extension (-10dB)38.1Hz (measured, spinorama.org)33Hz (measured, Erin’s Audio Corner)
Bass Extension (-3dB)43.9Hz (measured, spinorama.org)67Hz (measured, Erin’s Audio Corner)
Impedance4/8-ohm compatible8 ohms nominal (3.7 ohms minimum, measured, Erin’s Audio Corner)
Sensitivity86dB (1W/1m)90dB (2.83V/1m, measured by Erin’s Audio Corner)
Drivers1" Terylene dome tweeter, 6.5" bilaminate polypropylene woofer, 2x 6.5" passive radiators1" titanium tweeter with Tractrix horn, dual 6.5" cerametallic woofers
Weight20 lbs / 9.07 kg (20 lb) each49.4 lbs / 22.4 kg
Woofer CabinetPassive radiator-loadedported, rear
Dimensions19.05 x 92.5 x 23.09cm (7.5 x 36.4 x 9.09 in) each39.6" x 9.3" x 17.6" (1006 x 236 x 446 mm)
Frequency Response-38Hz - 25kHz (+-3dB, Manufacturer specified)
Crossover Frequency-1770Hz
Output Power-125W continuous, 500W peak

More useful head-to-heads from the same speaker class:

The Two Speakers In Full

Polk Audio XT60: $229 Amazon Bhphotovideo Crutchfield

Polk Audio XT60 ranking card

Pros: Passive-radiator-loaded design (6.5” woofer plus two 6.5” passive radiators) gives deeper bass than the driver size alone would suggest - 43.9Hz at -3dB / 38.1Hz at -10dB, genuinely competitive extension for a budget tower. Hi-Res Audio certified, Dolby Atmos/DTS:X compatible, and works with either 4- or 8-ohm amplifier outputs.

Cons: Bass alignment Q (lfq 0.96) is the highest, least-controlled figure in this entire batch, consistent with owner reports of a slightly loose, boomy low end at higher volumes. On-axis deviation (nbd_on_axis 0.512) is also the roughest measured figure in the batch. The vinyl-wrapped (not wood veneer) cabinet reads as budget up close per owner reviews, and at least one owner reported blowing a driver under sustained heavy bass - some caution is warranted with bass-heavy source material at volume.

Bass Extension (-10dB)38.1Hz (measured, spinorama.org)
Bass Extension (-3dB)43.9Hz (measured, spinorama.org)
Dimensions19.05 x 92.5 x 23.09cm (7.5 x 36.4 x 9.09 in) each
Drivers1" Terylene dome tweeter, 6.5" bilaminate polypropylene woofer, 2x 6.5" passive radiators
Impedance4/8-ohm compatible
Sensitivity86dB (1W/1m)
Weight20 lbs / 9.07 kg (20 lb) each
Woofer CabinetPassive radiator-loaded

As an eBay Partner, we may be compensated if you make a purchase.

Klipsch RP-6000F II: $1500 Amazon

Klipsch RP-6000F II ranking card

Pros: Highest power handling and clean, well-behaved compression at typical volumes. Precise imaging from the controlled horn directivity.

Cons: Worse baffle-step coloration than the smaller RP-5000F II (3-4dB swing vs 2dB), plus a sibilance issue the 5000F doesn’t have - a real regression in tonal balance despite the higher price. Bass extension is mixed - less deep at -3dB (67Hz) than the 5000F - and needs a subwoofer regardless. Narrow horizontal dispersion (~50-60 degrees).

Bass Extension (-10dB)33Hz (measured, Erin's Audio Corner)
Bass Extension (-3dB)67Hz (measured, Erin's Audio Corner)
Crossover Frequency1770Hz
Dimensions39.6" x 9.3" x 17.6" (1006 x 236 x 446 mm)
Drivers1" titanium tweeter with Tractrix horn, dual 6.5" cerametallic woofers
Frequency Response38Hz - 25kHz (+-3dB, Manufacturer specified)
Impedance8 ohms nominal (3.7 ohms minimum, measured, Erin's Audio Corner)
Output Power125W continuous, 500W peak
Sensitivity90dB (2.83V/1m, measured by Erin's Audio Corner)
Weight49.4 lbs / 22.4 kg
Woofer Cabinetported, rear

As an eBay Partner, we may be compensated if you make a purchase.