Short answer: the JBL HDI-3800 for better sound quality, the Polk Audio Reserve R700 for the lower price. The JBL HDI-3800 ranks #7 of 68 floorstanding speakers at $5000. The Polk Audio Reserve R700 ranks #32 at $1199, $3801 cheaper.
What the Polk Audio Reserve R700 offers: Three-way design with a 1” ring radiator tweeter, 6.5” mid-range, and dual 8” mid-bass drivers in a ported, down-firing cabinet. On-axis frequency response holds within about ±2dB across most of its range, with genuinely deep bass extension (F3 40Hz) reaching into the mid-30s Hz in-room. Wide horizontal radiation of about ±70°, giving a strong, enveloping stereo width and stage-extension effect on well-recorded tracks. Good low-level dynamics - solid bass thump at quiet listening volumes without over-accentuation. Strong distortion and compression control through the bass and midrange. Real nominal impedance closer to 4 ohms than the marketed 8 ohms, so with the right amplifier it can be driven hard - a $3,000 two-channel integrated brought out significantly more life than a budget $300 unit could. Excellent value at its roughly $2,200/pair MSRP, ranking among the reviewer’s top picks under $2,500; outperforms the similarly-priced Klipsch RP-8000F II in bass extension and overall smoothness. Watch for: Compression in the high frequencies rises sharply between 96dB and 102dB output - a real limitation only at very high volumes (around 100dB at 3 meters), but a clear step down from pricier ($5,000+) towers. Horizontal directivity mismatch around 4-5kHz, where the tweeter flares wider than the midrange, can sound a bit forward - especially noticeable when toed out further into the room; sidewall absorption or curtains help tame it. Harmonic distortion crosses the reviewer’s 3% threshold around 7kHz at 96dB output, possibly contributing to that same forward quality at high volume. Narrow vertical sweet spot (about ±15° from the tweeter axis), typical of non-coaxial tower designs - more of a consideration for multi-row home theater seating than single-row listening. The ring-radiator tweeter narrows noticeably above about 7-8kHz, and toeing the speaker out more than about 20° causes the top end to fall off quickly. Needs at least 2 feet of clearance from the rear wall to avoid boomy, exaggerated bass, since it lacks the bass-shelf tuning some rivals use to allow closer wall placement. Compared to the pricier KEF R5 Meta, has narrower horizontal (and much narrower vertical) directivity, so seating flexibility is more limited.
What the JBL HDI-3800 offers: 2410H-2 1” Teonex compression driver matched to a custom High-Definition Imaging (HDI) horn geometry achieves exceptional horizontal directivity control, high output capability, and effortless transient response. Triple 8” Advanced Aluminum Matrix woofers deliver deep, authoritative bass extension down to an F3 of 37Hz and F10 of 28Hz with minimal low-frequency compression. Outstanding sensitivity (92dB SPL at 2.83V/1m) and ultra-low THD/multitone distortion allow extremely high undistorted SPL output in large home theater spaces. Watch for: On-axis frequency response features a narrow upper-frequency elevation around 8-10kHz, performing noticeably smoother when toed out 10-20° off-axis. Vertical directivity handoff across the triple woofer layout creates vertical soundstage height tilt depending on listening distance and ear height. Minimum impedance dips to 3.8 ohms, requiring high-current amplifier stability. Substantial cabinet dimensions and 38kg weight require significant room real estate.
Buy the Polk Audio Reserve R700 if the price matters more than sound quality. Buy the JBL HDI-3800 if sound quality matters more than the price.
Specifications Side By Side
| Polk Audio Reserve R700 | JBL HDI-3800 | |
|---|---|---|
| Price | $1,199.00 | $5,000.00 Discontinued |
| Ranked | #32 of 68 in Large Size Floorstanding Speakers | #7 of 68 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 31Hz (measured, Erin’s Audio Corner) | 28Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 40Hz (measured, Erin’s Audio Corner) | 37Hz (measured, Erin’s Audio Corner) |
| Impedance | 4 ohms nominal, 3.5 ohms minimum (measured above 80Hz, Erin’s Audio Corner) | 4 ohms nominal (3.8 ohms minimum, measured by Erin’s Audio Corner) |
| Sensitivity | 87.5dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin’s Audio Corner) | 92dB (measured average, Erin’s Audio Corner) |
| Drivers | 2x 8" polypropylene cone woofers, 1x 6.5" turbine cone midrange, 1x 1" Pinnacle ring radiator tweeter | 1 in. 2410H-2 Teonex compression driver with HDI horn, triple 8 in. Advanced Aluminum Matrix cone woofers |
| Weight | 102.1 lbs / 46.3 kg | 83.8 lbs / 38.0 kg each |
| Woofer Cabinet | ported, down-firing | ported, rear |
| Dimensions | 45"H x 12.6"W x 16.9"D (1143.8 x 320.7 x 428.3 mm) | 43.3"H x 11.8"W x 16.4"D (1100.5 x 300.0 x 417.8 mm) |
| Discontinued | - | Yes |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Q Acoustics 5040 vs KEF Reference 203
- Q Acoustics 5040 vs Klipsch Forte IV
- JBL HDI-3600 vs Q Acoustics 5040
- KEF Reference 203 vs Polk Audio Reserve R700
- Klipsch RP-5000F II vs JBL HDI-3800
Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Polk Audio Reserve R700: $1,199.00 Amazon eBay
Pros: Three-way design with a 1” ring radiator tweeter, 6.5” mid-range, and dual 8” mid-bass drivers in a ported, down-firing cabinet. On-axis frequency response holds within about ±2dB across most of its range, with genuinely deep bass extension (F3 40Hz) reaching into the mid-30s Hz in-room. Wide horizontal radiation of about ±70°, giving a strong, enveloping stereo width and stage-extension effect on well-recorded tracks. Good low-level dynamics - solid bass thump at quiet listening volumes without over-accentuation. Strong distortion and compression control through the bass and midrange. Real nominal impedance closer to 4 ohms than the marketed 8 ohms, so with the right amplifier it can be driven hard - a $3,000 two-channel integrated brought out significantly more life than a budget $300 unit could. Excellent value at its roughly $2,200/pair MSRP, ranking among the reviewer’s top picks under $2,500; outperforms the similarly-priced Klipsch RP-8000F II in bass extension and overall smoothness.
Cons: Compression in the high frequencies rises sharply between 96dB and 102dB output - a real limitation only at very high volumes (around 100dB at 3 meters), but a clear step down from pricier ($5,000+) towers. Horizontal directivity mismatch around 4-5kHz, where the tweeter flares wider than the midrange, can sound a bit forward - especially noticeable when toed out further into the room; sidewall absorption or curtains help tame it. Harmonic distortion crosses the reviewer’s 3% threshold around 7kHz at 96dB output, possibly contributing to that same forward quality at high volume. Narrow vertical sweet spot (about ±15° from the tweeter axis), typical of non-coaxial tower designs - more of a consideration for multi-row home theater seating than single-row listening. The ring-radiator tweeter narrows noticeably above about 7-8kHz, and toeing the speaker out more than about 20° causes the top end to fall off quickly. Needs at least 2 feet of clearance from the rear wall to avoid boomy, exaggerated bass, since it lacks the bass-shelf tuning some rivals use to allow closer wall placement. Compared to the pricier KEF R5 Meta, has narrower horizontal (and much narrower vertical) directivity, so seating flexibility is more limited.
Full Polk Audio Reserve R700 review and specifications →
| Bass Extension (-10dB) | 31Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 40Hz (measured, Erin's Audio Corner) |
| Dimensions | 45"H x 12.6"W x 16.9"D (1143.8 x 320.7 x 428.3 mm) |
| Drivers | 2x 8" polypropylene cone woofers, 1x 6.5" turbine cone midrange, 1x 1" Pinnacle ring radiator tweeter |
| Impedance | 4 ohms nominal, 3.5 ohms minimum (measured above 80Hz, Erin's Audio Corner) |
| Sensitivity | 87.5dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin's Audio Corner) |
| Weight | 102.1 lbs / 46.3 kg |
| Woofer Cabinet | ported, down-firing |
- Links
- Reviews, Comparisons and Sound Samples
- Erin’s Audio Corner: My Top 5 Just Changed: Polk Audio Reserve R700 Review More from Erin’s Audio Corner →
- Erin’s Audio Corner: My Absolute Favorite Products of 2024 Revealed
- Erin’s Audio Corner Website: Polk Audio Reserve R700
- Erin’s Audio Corner Measurements (spinorama.org)
- Reddit Search for Polk Audio Reserve R700 Review
- Head-to-Head Comparisons
- Polk Audio Reserve R700 vs Q Acoustics 5040
- Polk Audio Reserve R700 vs Emotiva Airmotiv T2+
- Polk Audio Reserve R700 vs PSB Imagine T65
- Polk Audio Reserve R700 vs ELAC Debut 3.0 DF63
- Polk Audio Reserve R700 vs Polk Reserve R500
- Polk Audio Reserve R700 vs JBL HDI-3600
- Polk Audio Reserve R700 vs KEF R11 Meta
- Polk Audio Reserve R700 vs Definitive Technology BP-9020
- See all 32 comparisons
JBL HDI-3800: $5,000.00 Discontinued eBay
Pros: 2410H-2 1” Teonex compression driver matched to a custom High-Definition Imaging (HDI) horn geometry achieves exceptional horizontal directivity control, high output capability, and effortless transient response. Triple 8” Advanced Aluminum Matrix woofers deliver deep, authoritative bass extension down to an F3 of 37Hz and F10 of 28Hz with minimal low-frequency compression. Outstanding sensitivity (92dB SPL at 2.83V/1m) and ultra-low THD/multitone distortion allow extremely high undistorted SPL output in large home theater spaces.
Cons: On-axis frequency response features a narrow upper-frequency elevation around 8-10kHz, performing noticeably smoother when toed out 10-20° off-axis. Vertical directivity handoff across the triple woofer layout creates vertical soundstage height tilt depending on listening distance and ear height. Minimum impedance dips to 3.8 ohms, requiring high-current amplifier stability. Substantial cabinet dimensions and 38kg weight require significant room real estate. Discontinued.
Full JBL HDI-3800 review and specifications →
| Bass Extension (-10dB) | 28Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 37Hz (measured, Erin's Audio Corner) |
| Dimensions | 43.3"H x 11.8"W x 16.4"D (1100.5 x 300.0 x 417.8 mm) |
| Discontinued | Yes |
| Drivers | 1 in. 2410H-2 Teonex compression driver with HDI horn, triple 8 in. Advanced Aluminum Matrix cone woofers |
| Impedance | 4 ohms nominal (3.8 ohms minimum, measured by Erin's Audio Corner) |
| Sensitivity | 92dB (measured average, Erin's Audio Corner) |
| Weight | 83.8 lbs / 38.0 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Erin’s Audio Corner: JBL HDI-3800 Floorstanding Speaker Review More from Erin’s Audio Corner →
- Erin’s Audio Corner: Choosing the Ultimate Speaker: JBL Studio 698 or HDI-3800?
- Erin’s Audio Corner Website JBL HDI-3800
- Erin’s Audio Corner Measurements (spinorama.org)
- Reddit Search for JBL HDI-3800 Review
- Head-to-Head Comparisons