Short answer: the MoFi SourcePoint V10 Master Edition on measured sound quality, the Dynaudio Emit 30 on price. The MoFi SourcePoint V10 Master Edition ranks #3 of 71 floorstanding speakers at $7995. The Dynaudio Emit 30 ranks #53 at $1274.25, $6720.75 cheaper.
What the MoFi SourcePoint V10 Master Edition offers: Extended bass to approximately 30 Hz in-room without subwoofer; images with excellent precision indicating tight frequency response matching between speakers. Integrated bass management with three-way treble attenuation switches for room tuning. New design from Andrew Jones represents reviewer personal second choice (behind only KEF Blade 2 Meta at 29k) among hundreds of systems auditioned; ranks above Dutch & Dutch 8C, JBL 4367, and JBL M2. Watch for: Moderate sensitivity (~89 dB) means amplifier power requirements higher than many alternatives. Deep bass extension ends above subsonic frequencies (pipe organ territory below 17 Hz requires subwoofer).
What the Dynaudio Emit 30 offers: A 2.5-way floorstander: two 5.25” mid-woofers paired with a roughly 1” dome tweeter, driven through dual rear bass-reflex ports. The two woofers hand off at staggered crossover points (around 1kHz and 3.5kHz) rather than sharing one, which avoids the acoustic lobing a shared crossover point would cause between the tweeter and the lower woofer, and adds a few dB of sensitivity in the process. Genuinely deep bass for a speaker around this price - measured F3 near 44Hz and extends audibly down to about 40Hz in-room without much difficulty. Harmonic distortion measures clean and low at both 86dB and 96dB SPL/1m. Good CTA-2034 sound power and uniform directivity mean the speaker takes EQ correction well if a listener wants to dial in its one tonal weak point. Dynamic range and compression performance are strong overall, with only a minor, high-Q compression artifact tied to a cone-edge resonance that’s unlikely to be audible. Wide, consistent horizontal dispersion around ±70° with just a small ~10° narrowing between 1-3kHz, and a reasonably forgiving ±20° vertical window centered on the tweeter axis. Watch for: A dip and inconsistency in the lower-treble presence region (roughly 2-5kHz) makes the top end sound uneven - sometimes soft, sometimes forward - depending on the specific instrument or frequency being reproduced; male vocals can lack presence and cymbals can lack sizzle as a result. A cone-edge surround resonance shows up around 1-1.3kHz in burst-decay measurements (a trait the reviewer has also seen on other Dynaudio models) and lines up with elevated multitone distortion across roughly 600Hz-1.5kHz. An enclosure resonance appears around 350Hz in the impedance curve. Placed too close to a rear wall, the dual ports make the bass noticeably boomy - pulling the speaker out is needed to keep the low end from overloading the room. Fully resolving the top-end inconsistency needs a modest EQ correction (roughly +2dB with a Q of about 1, centered 3-6kHz), so out-of-the-box tonal accuracy in that band isn’t quite class-leading despite otherwise strong measured performance.
Buy the MoFi SourcePoint V10 Master Edition if sound quality matters more than the price. Buy the Dynaudio Emit 30 if the price matters more than sound quality.
Looking for alternatives? See the complete Passive Home rankings.
Specifications Side By Side
| MoFi SourcePoint V10 Master Edition | Dynaudio Emit 30 | |
|---|---|---|
| Price | $7995 per pair | $1,274.25 per pair |
| Ranked | #3 of 71 in Large Size Floorstanding Speakers | #53 of 71 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 25Hz (measured, Erin's Audio Corner) | 36Hz (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 38Hz (measured, Erin's Audio Corner) | 44Hz (measured, Erin's Audio Corner) |
| Dimensions | 48.8"H x 15.5"W x 19.9"D (1239.5 x 393.7 x 505.5 mm) | 35.4"H x 6.7"W x 10.7"D (900.0 x 170.0 x 272.0 mm) |
| Impedance | 6 ohms nominal, 5.3 ohms minimum (measured, Erin's Audio Corner) | 4 ohms |
| Drivers | 10" woofer, 10" paper‑cone concentric midrange, 1.25" soft‑dome concentric tweeter | Dual 5.25" mid-woofers, 1" soft dome tweeter |
| Sensitivity | 88.8dB (measured, Erin's Audio Corner) | 87dB |
| Weight | 160.9 lbs (73 kg) | 34.2 lbs (15.5 kg) |
| Woofer Cabinet | passive radiator | ported, rear (dual) |
| Spinorama Preference Score | 4.09 | 2.97 |
| Spinorama Preference Score with Perfect Sub | 5.40 | 4.81 |
| Frequency Response | - | 44Hz - 25kHz (±3dB, manufacturer specified) |
| Power Handling | - | 180W (IEC rated) |
| Country | - | Denmark |
Related Speaker Comparisons
More worthwhile head-to-heads for MoFi SourcePoint V10 Master Edition:
- GR-Research NX-Treme vs MoFi SourcePoint V10 Master Edition
- KEF Blade Two Meta vs MoFi SourcePoint V10 Master Edition
- MoFi SourcePoint 888 vs MoFi SourcePoint V10 Master Edition
- Radiant Acoustics Clarity 66 vs MoFi SourcePoint V10 Master Edition
- MoFi SourcePoint V10 Master Edition vs Ascend Acoustics ELX Ribbon Tower
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
MoFi SourcePoint V10 Master Edition: $7995 per pair Crutchfield eBay
Pros: Extended bass to approximately 30 Hz in-room without subwoofer; images with excellent precision indicating tight frequency response matching between speakers. Integrated bass management with three-way treble attenuation switches for room tuning. New design from Andrew Jones represents reviewer personal second choice (behind only KEF Blade 2 Meta at 29k) among hundreds of systems auditioned; ranks above Dutch & Dutch 8C, JBL 4367, and JBL M2. Measured bass extension of 38Hz (-3dB), with a measured sensitivity of 88.8dB.
Cons: Moderate sensitivity (~89 dB) means amplifier power requirements higher than many alternatives. Deep bass extension ends above subsonic frequencies (pipe organ territory below 17 Hz requires subwoofer).
Full MoFi SourcePoint V10 Master Edition review and specifications →
| Bass Extension (-10dB) | 25Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 38Hz (measured, Erin's Audio Corner) |
| Dimensions | 48.8"H x 15.5"W x 19.9"D (1239.5 x 393.7 x 505.5 mm) |
| Drivers | 10" woofer, 10" paper‑cone concentric midrange, 1.25" soft‑dome concentric tweeter |
| Impedance | 6 ohms nominal, 5.3 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 88.8dB (measured, Erin's Audio Corner) |
| Spinorama Preference Score | 4.09 |
| Spinorama Preference Score with Perfect Sub | 5.40 |
| Weight | 160.9 lbs (73 kg) |
| Woofer Cabinet | passive radiator |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- MoFi SourcePoint V10 Master Edition vs KEF Blade Two Meta
- MoFi SourcePoint V10 Master Edition vs MoFi SourcePoint 888
- MoFi SourcePoint V10 Master Edition vs GR-Research NX-Treme
- MoFi SourcePoint V10 Master Edition vs Radiant Acoustics Clarity 66
- MoFi SourcePoint V10 Master Edition vs Ascend Acoustics ELX Ribbon Tower
- MoFi SourcePoint V10 Master Edition vs JBL HDI-3800
- MoFi SourcePoint V10 Master Edition vs Revel F328Be
- MoFi SourcePoint V10 Master Edition vs Revel F226Be
- See all 28 comparisons
Dynaudio Emit 30: $1,274.25 per pair Amazon eBay
Pros: A 2.5-way floorstander: two 5.25” mid-woofers paired with a roughly 1” dome tweeter, driven through dual rear bass-reflex ports. The two woofers hand off at staggered crossover points (around 1kHz and 3.5kHz) rather than sharing one, which avoids the acoustic lobing a shared crossover point would cause between the tweeter and the lower woofer, and adds a few dB of sensitivity in the process. Genuinely deep bass for a speaker around this price - measured F3 near 44Hz and extends audibly down to about 40Hz in-room without much difficulty. Harmonic distortion measures clean and low at both 86dB and 96dB SPL/1m. Good CTA-2034 sound power and uniform directivity mean the speaker takes EQ correction well if a listener wants to dial in its one tonal weak point. Dynamic range and compression performance are strong overall, with only a minor, high-Q compression artifact tied to a cone-edge resonance that’s unlikely to be audible. Wide, consistent horizontal dispersion around ±70° with just a small ~10° narrowing between 1-3kHz, and a reasonably forgiving ±20° vertical window centered on the tweeter axis. Measured bass extension of 44Hz (-3dB).
Cons: A dip and inconsistency in the lower-treble presence region (roughly 2-5kHz) makes the top end sound uneven - sometimes soft, sometimes forward - depending on the specific instrument or frequency being reproduced; male vocals can lack presence and cymbals can lack sizzle as a result. A cone-edge surround resonance shows up around 1-1.3kHz in burst-decay measurements (a trait the reviewer has also seen on other Dynaudio models) and lines up with elevated multitone distortion across roughly 600Hz-1.5kHz. An enclosure resonance appears around 350Hz in the impedance curve. Placed too close to a rear wall, the dual ports make the bass noticeably boomy - pulling the speaker out is needed to keep the low end from overloading the room. Fully resolving the top-end inconsistency needs a modest EQ correction (roughly +2dB with a Q of about 1, centered 3-6kHz), so out-of-the-box tonal accuracy in that band isn’t quite class-leading despite otherwise strong measured performance.
Full Dynaudio Emit 30 review and specifications →
| Bass Extension (-10dB) | 36Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 44Hz (measured, Erin's Audio Corner) |
| Country | Denmark |
| Dimensions | 35.4"H x 6.7"W x 10.7"D (900.0 x 170.0 x 272.0 mm) |
| Drivers | Dual 5.25" mid-woofers, 1" soft dome tweeter |
| Frequency Response | 44Hz - 25kHz (±3dB, manufacturer specified) |
| Impedance | 4 ohms |
| Power Handling | 180W (IEC rated) |
| Sensitivity | 87dB |
| Spinorama Preference Score | 2.97 |
| Spinorama Preference Score with Perfect Sub | 4.81 |
| Weight | 34.2 lbs (15.5 kg) |
| Woofer Cabinet | ported, rear (dual) |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Dynaudio Emit 30 vs Klipsch RP-6000F II
- Dynaudio Emit 30 vs Klipsch RP-8000F II
- Dynaudio Emit 30 vs Polk T50
- Dynaudio Emit 30 vs SVS Ultra Evolution Pinnacle
- Dynaudio Emit 30 vs Focal Aria Evo X N°2
- Dynaudio Emit 30 vs Klipsch RP-5000F II
- Dynaudio Emit 30 vs Sony SS-CS3
- Dynaudio Emit 30 vs Infinity Reference 253
- See all 43 comparisons