Short answer: the MoFi SourcePoint 10 if sound quality matters most, the Sonus Faber Lumina II Amator if price matters most. The MoFi SourcePoint 10 ranks #26 of 130 bookshelf speakers at $3795. The Sonus Faber Lumina II Amator ranks #106 at $2000, $1795 cheaper.
What the MoFi SourcePoint 10 offers: Andrew Jones-designed concentric/coincident driver delivers best-in-class sound power and early-reflections directivity in the reviewer’s testing - a genuine “point source” design. Vertical and horizontal radiation patterns closely match each other (about ±50° horizontal, ±30-40° vertical), a hallmark benefit of a well-executed concentric driver. Distortion stays low - under 1% above 100Hz at 86dB, and under 3% up to 100Hz even at 96dB, better than the reviewer expected from a low-excursion waveguide-loaded woofer. Surprisingly strong dynamic capability with little audible compression at both low and high volume. Widely spaced (about 11 feet apart) with roughly 15° of toe-out produced a huge, expansive soundstage without significant loss of imaging precision. Solidly built cabinet (about 40 lbs, heavily braced) minimizes cabinet resonance. Watch for: Like virtually all coincident designs, sounds notably bright pointed directly on-axis due to a deliberate treble lift (meant to compensate for the 28mm tweeter’s earlier beaming versus a typical 25mm/1” tweeter) combined with a diffraction dip/peak from the waveguide edge; needs about 15° of toe-out to sound neutral, and even then benefits from an extra 1-2dB of treble EQ. Toeing out further (to 30°) flattens the treble further but introduces a dip in the midrange-to-tweeter crossover region - there’s no single toe-out angle that fixes everything at once. F3 of 56Hz and F10 of 38Hz (about 40Hz in-room) mean genuine deep bass is limited; the reviewer would pair it with a sealed 10” or 12” subwoofer for regular daily listening. Bass extension and cabinet placement trade off against midrange cleanliness: placing it close to a wall for more bass risks a wall-bounce suckout in the midrange (roughly 200-500Hz depending on distance). Not perfectly time-aligned between tweeter and woofer (about 0.4ms delta), an inherent limitation of passive coincident drivers versus actively time-corrected designs. Some resonances appear in measurements, likely port-related. Minimum impedance around 6.4 ohms with EPDR near 3 ohms, so the reviewer recommends sticking with a 4-ohm-rated amplifier to be safe.
What the Sonus Faber Lumina II Amator offers: Solid bass extension for a bookshelf (F3 63Hz, F10 43Hz), reaching about 50Hz in-room. Decent sensitivity and wide, consistent horizontal dispersion (~60-70 degrees) - better directivity than expected for a two-way design. Gorgeous, luxury-grade cabinet design. Watch for: Very bright treble, running 3-6dB above the midrange depending on measurement angle - independently corroborated by other owners online, not just one reviewer’s opinion. Causes audible sibilance and a forward, grainy character. Notably the brightest of three Sonus Faber models Erin’s Audio Corner has tested, even brighter than the brand’s own Sonetto II G2. A mechanical resonance/ringing artifact shows up around 1kHz in measurements. Needs a subwoofer for anything below about 50Hz.
Buy the MoFi SourcePoint 10 if sound quality matters more than the price. Buy the Sonus Faber Lumina II Amator if the price matters more than sound quality.
Skip the Sonus Faber Lumina II Amator if sound quality matters to you. It ranks near the bottom of the 130 bookshelf speakers.
Still deciding? The full Passive Home rankings cover every ranked option.
Specifications Side By Side
| MoFi SourcePoint 10 | Sonus Faber Lumina II Amator | |
|---|---|---|
| Price | $3795 per pair | $2000 per pair |
| Ranked | #26 of 130 in Large Size Bookshelf Speakers | #106 of 130 in Large Size Bookshelf Speakers |
| Bass Extension (-10dB) | 38Hz (measured, Erin's Audio Corner) | 43Hz (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 56Hz (measured, Erin's Audio Corner) | 63Hz (measured, Erin's Audio Corner) |
| Dimensions | 22.5"H x 14.5"W x 16.6"D (571.5 x 368.3 x 421.6 mm) | 12" x 7.1" x 10.4" (304 x 180 x 263 mm) |
| Impedance | 8 ohms nominal, 6.4 ohms minimum (measured, Erin's Audio Corner) | 4 ohms nominal, 3.9 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 88.2dB (measured, Erin's Audio Corner) | 86.9dB (2.83V/1m, measured by Erin's Audio Corner) |
| Drivers | 10" Paper-pulp Cone woofer, 1.25-inch soft-dome tweeter | 1.14" DAD (Damped Apex Dome) tweeter, 5.9" paper cone woofer |
| Weight | 46.3 lbs (21.0 kg) each | 12.8 lbs (5.8 kg) |
| Woofer Cabinet | ported, rear | Bass reflex, ported |
| Spinorama Preference Score | 3.25 | - |
| Spinorama Preference Score with Perfect Sub | 5.27 | - |
| Frequency Response | - | 55Hz - 24kHz (Manufacturer specified) |
| Crossover Frequency | - | 2600Hz |
| Recommended Power | - | 30W - 150W |
| Country | - | Italy (Vicenza) |
Related Speaker Comparisons
More worthwhile head-to-heads for MoFi SourcePoint 10:
- MoFi SourcePoint 10 vs Perlisten S4b
- KEF Reference 1 Meta vs MoFi SourcePoint 10
- GR-Research NX-Studio vs MoFi SourcePoint 10
- AsciLab C6B vs MoFi SourcePoint 10
- Audio First Cadentia 3 vs MoFi SourcePoint 10
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
MoFi SourcePoint 10: $3795 per pair Crutchfield eBay
Pros: Andrew Jones-designed concentric/coincident driver delivers best-in-class sound power and early-reflections directivity in the reviewer’s testing - a genuine “point source” design. Vertical and horizontal radiation patterns closely match each other (about ±50° horizontal, ±30-40° vertical), a hallmark benefit of a well-executed concentric driver. Distortion stays low - under 1% above 100Hz at 86dB, and under 3% up to 100Hz even at 96dB, better than the reviewer expected from a low-excursion waveguide-loaded woofer. Surprisingly strong dynamic capability with little audible compression at both low and high volume. Widely spaced (about 11 feet apart) with roughly 15° of toe-out produced a huge, expansive soundstage without significant loss of imaging precision. Solidly built cabinet (about 40 lbs, heavily braced) minimizes cabinet resonance. Measured bass extension of 56Hz (-3dB), with a measured sensitivity of 88.2dB.
Cons: Like virtually all coincident designs, sounds notably bright pointed directly on-axis due to a deliberate treble lift (meant to compensate for the 28mm tweeter’s earlier beaming versus a typical 25mm/1” tweeter) combined with a diffraction dip/peak from the waveguide edge; needs about 15° of toe-out to sound neutral, and even then benefits from an extra 1-2dB of treble EQ. Toeing out further (to 30°) flattens the treble further but introduces a dip in the midrange-to-tweeter crossover region - there’s no single toe-out angle that fixes everything at once. F3 of 56Hz and F10 of 38Hz (about 40Hz in-room) mean genuine deep bass is limited; the reviewer would pair it with a sealed 10” or 12” subwoofer for regular daily listening. Bass extension and cabinet placement trade off against midrange cleanliness: placing it close to a wall for more bass risks a wall-bounce suckout in the midrange (roughly 200-500Hz depending on distance). Not perfectly time-aligned between tweeter and woofer (about 0.4ms delta), an inherent limitation of passive coincident drivers versus actively time-corrected designs. Some resonances appear in measurements, likely port-related. Minimum impedance around 6.4 ohms with EPDR near 3 ohms, so the reviewer recommends sticking with a 4-ohm-rated amplifier to be safe.
Full MoFi SourcePoint 10 review and specifications →
| Bass Extension (-10dB) | 38Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 56Hz (measured, Erin's Audio Corner) |
| Dimensions | 22.5"H x 14.5"W x 16.6"D (571.5 x 368.3 x 421.6 mm) |
| Drivers | 10" Paper-pulp Cone woofer, 1.25-inch soft-dome tweeter |
| Impedance | 8 ohms nominal, 6.4 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 88.2dB (measured, Erin's Audio Corner) |
| Spinorama Preference Score | 3.25 |
| Spinorama Preference Score with Perfect Sub | 5.27 |
| Weight | 46.3 lbs (21.0 kg) each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- MoFi SourcePoint 10 vs Radiant Acoustics Clarity 6.2
- MoFi SourcePoint 10 vs Wharfedale Super Linton
- MoFi SourcePoint 10 vs Dynaudio Heritage Special
- MoFi SourcePoint 10 vs Ascend Acoustics CMT-340 SE2
- MoFi SourcePoint 10 vs Arendal 1528 Monitor 8
- MoFi SourcePoint 10 vs Wharfedale Linton 85
- MoFi SourcePoint 10 vs AsciLab F6Bs
- MoFi SourcePoint 10 vs Ascend Acoustics Sierra-LX
- See all 48 comparisons
Sonus Faber Lumina II Amator: $2000 per pair Crutchfield eBay
Pros: Solid bass extension for a bookshelf (F3 63Hz, F10 43Hz), reaching about 50Hz in-room. Decent sensitivity and wide, consistent horizontal dispersion (~60-70 degrees) - better directivity than expected for a two-way design. Gorgeous, luxury-grade cabinet design. Measured bass extension of 63Hz (-3dB), with a measured sensitivity of 86.9dB.
Cons: Very bright treble, running 3-6dB above the midrange depending on measurement angle - independently corroborated by other owners online, not just one reviewer’s opinion. Causes audible sibilance and a forward, grainy character. Notably the brightest of three Sonus Faber models Erin’s Audio Corner has tested, even brighter than the brand’s own Sonetto II G2. A mechanical resonance/ringing artifact shows up around 1kHz in measurements. Needs a subwoofer for anything below about 50Hz.
Full Sonus Faber Lumina II Amator review and specifications →
| Bass Extension (-10dB) | 43Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 63Hz (measured, Erin's Audio Corner) |
| Country | Italy (Vicenza) |
| Crossover Frequency | 2600Hz |
| Dimensions | 12" x 7.1" x 10.4" (304 x 180 x 263 mm) |
| Drivers | 1.14" DAD (Damped Apex Dome) tweeter, 5.9" paper cone woofer |
| Frequency Response | 55Hz - 24kHz (Manufacturer specified) |
| Impedance | 4 ohms nominal, 3.9 ohms minimum (measured, Erin's Audio Corner) |
| Recommended Power | 30W - 150W |
| Sensitivity | 86.9dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 12.8 lbs (5.8 kg) |
| Woofer Cabinet | Bass reflex, ported |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Sonus Faber Lumina II Amator vs KEF Q350
- Sonus Faber Lumina II Amator vs Klipsch RP-600M
- Sonus Faber Lumina II Amator vs Pylon Jasper Monitor 18
- Sonus Faber Lumina II Amator vs Wharfedale Diamond 9.1
- Sonus Faber Lumina II Amator vs Sonus Faber Sonetto II G2
- Sonus Faber Lumina II Amator vs Triangle Borea BR03
- Sonus Faber Lumina II Amator vs B&W 805S
- Sonus Faber Lumina II Amator vs Emotiva Airmotiv B2+
- See all 57 comparisons