Short answer: the MoFi SourcePoint 888 for better sound quality, the Klipsch RP-8000F II for the lower price. The MoFi SourcePoint 888 ranks #4 of 71 floorstanding speakers at $5500. The Klipsch RP-8000F II ranks #52 at $1800, $3700 cheaper.
What the Klipsch RP-8000F II offers: Highest sensitivity of the RP II floorstander line (~92dB measured) and the best dynamics/compression behavior of the three under load - the cleanest at high output. Dual 8-inch woofers and the highest power handling in the line. Watch for: Mid-bass sounds lean despite the dual 8-inch woofers, and bass extension disappointed for its size - expected to reach 50Hz, didn’t get there in-room. Has its own edgy upper-mid bump (2-6kHz) that’s harder to EQ out than the other two models’ issues, since it stems from the vertical horn/woofer offset rather than simple tonal balance. The most placement-critical of the three, with the narrowest horizontal (~40-50 degrees) and vertical (+5/-10 degrees) dispersion.
What the MoFi SourcePoint 888 offers: Three-way vented design: an 8” coaxial mid-range/1.25” dome tweeter driver plus two additional 8” woofers crossed at about 130Hz, giving genuinely full-range output (F3 34Hz, F10 26Hz) other than the deepest subsonic content. Ranked by the reviewer among his personal top three speakers out of roughly 200 tested, alongside the KEF Blade 2 Meta and Dutch & Dutch 8C, despite costing a small fraction of either. Excellent compression/dynamic-range linearity, holding its own against much pricier speakers like the March Audio Sointuva AWG, KEF Reference 1 Meta, and KEF Blade 2 Meta. On-axis (0°) and 30°-off-axis estimated in-room responses track within about 1-1.5dB of each other above 500Hz, so tonal balance barely changes with placement or listening angle - excellent for multi-seat home theater or entertaining. Wide horizontal dispersion of about ±60°. Distortion stays low: under 1% at 86dB, and under 1% above 200Hz even at 96dB, with multitone distortion mostly under 1% as well. Not a difficult amplifier load (5-ohm minimum impedance, 4.2-ohm minimum EPDR). Checks the three boxes the reviewer considers essential for a home theater speaker: low compression, low distortion, and excellent directivity. Watch for: A significant investment, best ordered from a dealer with a good return policy. Large and heavy floorstander (about 96 lbs, 42” tall) requiring real floor space and rear clearance. Positioning is fairly specific: needs about 2 feet from the rear wall - closer causes boominess in the 40-50Hz region, farther loses bass extension. Vertical dispersion (about ±50°) is narrower than horizontal (about ±60°), since the two 8” woofers are spaced vertically apart on a tower cabinet, causing some vertical mismatch at lower frequencies. A small on-axis dip around 500Hz and a deliberately lower tweeter level (about 0.5dB below the midrange) are intentional design choices for smoother in-room response, but mean the raw on-axis measurement isn’t perfectly flat. A mild diffraction-related dip appears around 3kHz in directivity measurements. Toeing the speaker out more than about 10° starts to noticeably reduce top-end energy.
Buy the Klipsch RP-8000F II if the price matters more than sound quality. Buy the MoFi SourcePoint 888 if sound quality matters more than the price.
Specifications Side By Side
| Klipsch RP-8000F II | MoFi SourcePoint 888 | |
|---|---|---|
| Price | $1800 | $5500 |
| Ranked | #52 of 71 in Large Size Floorstanding Speakers | #4 of 71 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 33Hz (measured, Erin’s Audio Corner) | 26Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 67Hz (measured, Erin’s Audio Corner) | 34Hz (measured, Erin’s Audio Corner) |
| Sensitivity | 92dB (2.83V/1m, measured by Erin’s Audio Corner) | 85.6dB (measured, Erin’s Audio Corner) |
| Drivers | 1" titanium tweeter with 90x90 Tractrix horn, dual 8" cerametallic woofers | Dual 8" paper cone woofers, 8" Paper Cone midrange, 1.25" wide roll soft dome tweeter |
| Weight | 61.3 lbs / 27.8 kg | 94.8 lbs / 43 kg each |
| Impedance | 8 ohms nominal (3.7 ohms minimum above 80Hz, measured by Erin’s Audio Corner) | 6 ohms nominal, 5 ohms minimum (measured, Erin’s Audio Corner) |
| Frequency Response | 35Hz - 25kHz (+-3dB, Manufacturer specified) | - |
| Crossover Frequency | 1630Hz | - |
| Output Power | 150W continuous, 600W peak | - |
| Dimensions | 43.1" x 10.8" x 18.3" (1095 x 275 x 464 mm) | 41.2"H x 12.6"W x 16.1"D (1046.5 x 320 x 408.9 mm) |
| Woofer Cabinet | ported, rear | ported, rear |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Klipsch Forte IV vs Dynaudio Emit 30
- MoFi SourcePoint V10 Master Edition vs Polk T50
- Dynaudio Emit 30 vs Revel F228Be
- Klipsch Forte IV vs Klipsch RP-8000F II
- MoFi SourcePoint 888 vs Revel F206
Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Klipsch RP-8000F II: $1800 Amazon eBay
Pros: Highest sensitivity of the RP II floorstander line (~92dB measured) and the best dynamics/compression behavior of the three under load - the cleanest at high output. Dual 8-inch woofers and the highest power handling in the line.
Cons: Mid-bass sounds lean despite the dual 8-inch woofers, and bass extension disappointed for its size - expected to reach 50Hz, didn’t get there in-room. Has its own edgy upper-mid bump (2-6kHz) that’s harder to EQ out than the other two models’ issues, since it stems from the vertical horn/woofer offset rather than simple tonal balance. The most placement-critical of the three, with the narrowest horizontal (~40-50 degrees) and vertical (+5/-10 degrees) dispersion.
Full Klipsch RP-8000F II review and specifications →
| Bass Extension (-10dB) | 33Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 67Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 1630Hz |
| Dimensions | 43.1" x 10.8" x 18.3" (1095 x 275 x 464 mm) |
| Drivers | 1" titanium tweeter with 90x90 Tractrix horn, dual 8" cerametallic woofers |
| Frequency Response | 35Hz - 25kHz (+-3dB, Manufacturer specified) |
| Impedance | 8 ohms nominal (3.7 ohms minimum above 80Hz, measured by Erin's Audio Corner) |
| Output Power | 150W continuous, 600W peak |
| Sensitivity | 92dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 61.3 lbs / 27.8 kg |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Klipsch RP-8000F II vs Dynaudio Emit 30
- Klipsch RP-8000F II vs Klipsch RP-6000F II
- Klipsch RP-8000F II vs SVS Ultra Evolution Pinnacle
- Klipsch RP-8000F II vs Polk T50
- Klipsch RP-8000F II vs Klipsch RP-5000F II
- Klipsch RP-8000F II vs KLH Model Five
- Klipsch RP-8000F II vs KEF Q11 Meta
- Klipsch RP-8000F II vs Focal Aria Evo X N°2
- See all 42 comparisons
MoFi SourcePoint 888: $5500 Crutchfield eBay
Pros: Three-way vented design: an 8” coaxial mid-range/1.25” dome tweeter driver plus two additional 8” woofers crossed at about 130Hz, giving genuinely full-range output (F3 34Hz, F10 26Hz) other than the deepest subsonic content. Ranked by the reviewer among his personal top three speakers out of roughly 200 tested, alongside the KEF Blade 2 Meta and Dutch & Dutch 8C, despite costing a small fraction of either. Excellent compression/dynamic-range linearity, holding its own against much pricier speakers like the March Audio Sointuva AWG, KEF Reference 1 Meta, and KEF Blade 2 Meta. On-axis (0°) and 30°-off-axis estimated in-room responses track within about 1-1.5dB of each other above 500Hz, so tonal balance barely changes with placement or listening angle - excellent for multi-seat home theater or entertaining. Wide horizontal dispersion of about ±60°. Distortion stays low: under 1% at 86dB, and under 1% above 200Hz even at 96dB, with multitone distortion mostly under 1% as well. Not a difficult amplifier load (5-ohm minimum impedance, 4.2-ohm minimum EPDR). Checks the three boxes the reviewer considers essential for a home theater speaker: low compression, low distortion, and excellent directivity.
Cons: A significant investment, best ordered from a dealer with a good return policy. Large and heavy floorstander (about 96 lbs, 42” tall) requiring real floor space and rear clearance. Positioning is fairly specific: needs about 2 feet from the rear wall - closer causes boominess in the 40-50Hz region, farther loses bass extension. Vertical dispersion (about ±50°) is narrower than horizontal (about ±60°), since the two 8” woofers are spaced vertically apart on a tower cabinet, causing some vertical mismatch at lower frequencies. A small on-axis dip around 500Hz and a deliberately lower tweeter level (about 0.5dB below the midrange) are intentional design choices for smoother in-room response, but mean the raw on-axis measurement isn’t perfectly flat. A mild diffraction-related dip appears around 3kHz in directivity measurements. Toeing the speaker out more than about 10° starts to noticeably reduce top-end energy.
Full MoFi SourcePoint 888 review and specifications →
| Bass Extension (-10dB) | 26Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 34Hz (measured, Erin's Audio Corner) |
| Dimensions | 41.2"H x 12.6"W x 16.1"D (1046.5 x 320 x 408.9 mm) |
| Drivers | Dual 8" paper cone woofers, 8" Paper Cone midrange, 1.25" wide roll soft dome tweeter |
| Impedance | 6 ohms nominal, 5 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 85.6dB (measured, Erin's Audio Corner) |
| Weight | 94.8 lbs / 43 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Erin’s Audio Corner: Why the MoFi SourcePoint 888 Could Be Your Last Speaker Purchase More from Erin’s Audio Corner →
- Erin’s Audio Corner: My Absolute Favorite Products of 2024 Revealed
- Erin’s Audio Corner Website: MoFi SourcePoint 888
- Erin’s Audio Corner Measurements (spinorama.org)
- Reddit Search for MoFi SourcePoint 888 Review
- Head-to-Head Comparisons
- MoFi SourcePoint 888 vs MoFi SourcePoint V10 Master Edition
- MoFi SourcePoint 888 vs KEF Blade Two Meta
- MoFi SourcePoint 888 vs GR-Research NX-Treme
- MoFi SourcePoint 888 vs JBL HDI-3800
- MoFi SourcePoint 888 vs Revel F328Be
- MoFi SourcePoint 888 vs KEF R5 Meta
- MoFi SourcePoint 888 vs KEF R5
- MoFi SourcePoint 888 vs Revel F226Be
- See all 27 comparisons