ELAC Debut 2.0 B6.2 vs MoFi SourcePoint 10

Last updated: August 9, 2026

Short answer: the MoFi SourcePoint 10 for the higher ranking, the ELAC Debut 2.0 B6.2 for the lower price. The MoFi SourcePoint 10 ranks #8 of 47 bookshelf speakers at $3500. The ELAC Debut 2.0 B6.2 ranks #32 at $479, $3021 cheaper.

What the ELAC Debut 2.0 B6.2 gets right: Reasonably flat on-axis and listening-window response with reasonably even horizontal directivity. The tradeoff: A good size resonant peak around 700hz, directivity error around 3.3khz.

On the MoFi SourcePoint 10 side: Andrew Jones-designed concentric/coincident driver delivers best-in-class sound power and early-reflections directivity in the reviewer’s. Set against that: Like virtually all coincident designs, sounds notably bright pointed directly on-axis due to a deliberate treble lift (meant to compensate.

Buy the ELAC Debut 2.0 B6.2 if the price matters more than the ranking. Buy the MoFi SourcePoint 10 if the ranking matters more than the price.

Specifications Side By Side

ELAC Debut 2.0 B6.2 MoFi SourcePoint 10
Price$479.00$3500
Ranked#32 of 47 in Large Size Bookshelf Speakers#8 of 47 in Large Size Bookshelf Speakers
Bass Extension (-10dB)40Hz38Hz
Bass Extension (-3dB)64Hz56Hz
Impedance6 ohms8 ohms
Sensitivity86.5dB88dB
Drivers25mm tweeter + 165mm woofer10" Paper-pulp Cone woofer, 1.25-inch soft-dome tweeter
Weight29.1 lbs / 13.2 kg46.3 lbs / 21.0 kg each
Dimensions-22.5"H x 14.5"W x 16.6"D (571.5 x 368.3 x 421.6 mm)
Woofer Cabinet-Rear ported

The Two Speakers In Full

ELAC Debut 2.0 B6.2: $479.00 Crutchfield Amazon

ELAC Debut 2.0 B6.2 ranking card

Pros: Reasonably flat on-axis and listening-window response with reasonably even horizontal directivity. Its larger-than-typical woofer lets it play very loud with minimal distortion, and minimum impedance stays a comfortable 5 ohms.

Cons: A good size resonant peak around 700hz, directivity error around 3.3khz. Predicted in-room response shows a lack of energy between 1-2kHz and a bit too much above that, which the reviewer thought would sound bright. Distortion at 96dB SPL/1m shows two harmonic peaks the reviewer says “should not be there,” one from woofer breakup around 400Hz and another around 7-8kHz from the tweeter. Cumulative spectral decay (waterfall) shows the same 700Hz resonance lingering. The reviewer needed EQ (taming the 700Hz peak, filling in the 1-2kHz dip, and trimming the highs) to get it sounding its best.

Bass Extension (-10dB)40Hz
Bass Extension (-3dB)64Hz
Drivers25mm tweeter + 165mm woofer
Impedance6 ohms
Sensitivity86.5dB
Weight29.1 lbs / 13.2 kg

MoFi SourcePoint 10: $3500 Crutchfield

MoFi SourcePoint 10 ranking card

Pros: Andrew Jones-designed concentric/coincident driver delivers best-in-class sound power and early-reflections directivity in the reviewer’s testing - a genuine “point source” design. Vertical and horizontal radiation patterns closely match each other (about ±50° horizontal, ±30-40° vertical), a hallmark benefit of a well-executed concentric driver. Distortion stays low - under 1% above 100Hz at 86dB, and under 3% up to 100Hz even at 96dB, better than the reviewer expected from a low-excursion waveguide-loaded woofer. Surprisingly strong dynamic capability with little audible compression at both low and high volume. Widely spaced (about 11 feet apart) with roughly 15° of toe-out produced a huge, expansive soundstage without significant loss of imaging precision. Solidly built cabinet (about 40 lbs, heavily braced) minimizes cabinet resonance.

Cons: Like virtually all coincident designs, sounds notably bright pointed directly on-axis due to a deliberate treble lift (meant to compensate for the 28mm tweeter’s earlier beaming versus a typical 25mm/1” tweeter) combined with a diffraction dip/peak from the waveguide edge; needs about 15° of toe-out to sound neutral, and even then benefits from an extra 1-2dB of treble EQ. Toeing out further (to 30°) flattens the treble further but introduces a dip in the midrange-to-tweeter crossover region - there’s no single toe-out angle that fixes everything at once. F3 of 56Hz and F10 of 38Hz (about 40Hz in-room) mean genuine deep bass is limited; the reviewer would pair it with a sealed 10” or 12” subwoofer for regular daily listening. Bass extension and cabinet placement trade off against midrange cleanliness: placing it close to a wall for more bass risks a wall-bounce suckout in the midrange (roughly 200-500Hz depending on distance). Not perfectly time-aligned between tweeter and woofer (about 0.4ms delta), an inherent limitation of passive coincident drivers versus actively time-corrected designs. Some resonances appear in measurements, likely port-related. Minimum impedance around 6.4 ohms with EPDR near 3 ohms, so the reviewer recommends sticking with a 4-ohm-rated amplifier to be safe.

Bass Extension (-10dB)38Hz
Bass Extension (-3dB)56Hz
Dimensions22.5"H x 14.5"W x 16.6"D (571.5 x 368.3 x 421.6 mm)
Drivers10" Paper-pulp Cone woofer, 1.25-inch soft-dome tweeter
Impedance8 ohms
Sensitivity88dB
Weight46.3 lbs / 21.0 kg each
Woofer CabinetRear ported

As an Amazon Associate I earn from qualifying purchases.

Product prices and availability were last checked August 9, 2026 at 6:57 AM UTC and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.