Short answer: the ELAC DBR62. It ranks #55 of 131 bookshelf speakers by sound quality at $678.97; the Sonus Faber Lumina II Amator ranks #107 and costs $2000, so there is not much of a tradeoff to weigh.
What the ELAC DBR62 offers: Two-way design with a 6.5” woofer and 1” dome tweeter in a shallow waveguide, with the tweeter positioned close to the woofer for near-point-source coherence - giving more vertical listening leeway than typical two-ways. Notably forgiving of placement and aiming: sounds good from directly on-axis all the way to 30° of toe-out (parallel with the rear wall), making it more room-independent than many speakers this price. Wide horizontal radiation of about ±70° until the tweeter starts beaming, right in the reviewer’s preferred sweet spot. A mild, wide-Q bass bump centered around 100Hz adds a bit of extra punch that the reviewer personally likes. On-axis linearity within about ±2.5dB, with a strong measured preference score of 5.3. Distortion stays below 3% at both 86dB and 96dB until around 50Hz. Vertical sweet spot of about ±10-20° works well for multi-row home theater seating. The reviewer calls it “the epitome of a good speaker” for its price, with no reservations recommending it. Watch for: A slight recess in the 1-2kHz region reduces vocal presence somewhat compared to other speakers in direct comparison. A mild hot spot around 4-5kHz can read as slight sibilance when pointed directly on-axis. Low-to-mid sensitivity (about 84.3dB) combined with a current draw that behaves like roughly 2.4 ohms between 100-200Hz means it’s best driven by a dedicated 4-ohm-capable amplifier rather than an AVR. A diffraction dip from the baffle edge is visible in measurements - typical of any standard rectangular-baffle speaker and not correctable without a much more expensive curved-baffle design. Multitone distortion testing suggests some potential midrange distortion could be audible on certain material, though the reviewer didn’t personally notice it. Minor resonances appear around 700Hz and 1-1.5kHz, possibly tied to the enclosure, port, or cone/surround edge termination, though their audible impact appears minimal. F3 of 53Hz means a subwoofer is still needed for real bass extension below about 40Hz.
What the Sonus Faber Lumina II Amator offers: Solid bass extension for a bookshelf (F3 63Hz, F10 43Hz), reaching about 50Hz in-room. Decent sensitivity and wide, consistent horizontal dispersion (~60-70 degrees) - better directivity than expected for a two-way design. Gorgeous, luxury-grade cabinet design. Watch for: Very bright treble, running 3-6dB above the midrange depending on measurement angle - independently corroborated by other owners online, not just one reviewer’s opinion. Causes audible sibilance and a forward, grainy character. Notably the brightest of three Sonus Faber models Erin’s Audio Corner has tested, even brighter than the brand’s own Sonetto II G2. A mechanical resonance/ringing artifact shows up around 1kHz in measurements. Needs a subwoofer for anything below about 50Hz.
Buy the ELAC DBR62. It ranks higher for sound quality than the Sonus Faber Lumina II Amator and costs less, so there is no real case for the other one.
If sound quality matters at all to you, skip the Sonus Faber Lumina II Amator. It ranks near the bottom of the 131 bookshelf speakers, so look higher up the list instead.
Specifications Side By Side
| ELAC DBR62 | Sonus Faber Lumina II Amator | |
|---|---|---|
| Price | $678.97 | $2000 |
| Ranked | #55 of 131 in Large Size Bookshelf Speakers | #107 of 131 in Large Size Bookshelf Speakers |
| Bass Extension (-10dB) | 41Hz (measured, Erin’s Audio Corner) | 43Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 53Hz (measured, Erin’s Audio Corner) | 63Hz (measured, Erin’s Audio Corner) |
| Dimensions | 14.1"H x 8.2"W x 10.8"D (358.1 x 208.3 x 274.3 mm) | 12" x 7.1" x 10.4" (304 x 180 x 263 mm) |
| Impedance | 6 ohms nominal, 5.2 ohms minimum (measured above 80Hz, Erin’s Audio Corner) | 4 ohms nominal, 3.9 ohms minimum (measured, Erin’s Audio Corner) |
| Sensitivity | 84.3dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin’s Audio Corner; 86dB manufacturer specified) | 86.9dB (2.83V/1m, measured by Erin’s Audio Corner) |
| Drivers | 6.5" Aramid Fiber woofer, 1" soft dome tweeter | 1.14" DAD (Damped Apex Dome) tweeter, 5.9" paper cone woofer |
| Weight | 18.1 lbs / 8.2 kg each | 12.8 lbs / 5.8 kg |
| Woofer Cabinet | ported, front | Bass reflex, ported |
| Frequency Response | - | 55Hz - 24kHz (Manufacturer specified) |
| Crossover Frequency | - | 2600Hz |
| Recommended Power | - | 30W - 150W |
| Country of Origin | - | Italy (Vicenza) |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- KEF Q350 vs JBL HDI-1600
- Power Sound Audio MT-110-M vs ELAC Uni-Fi Reference UBR62
- MoFi SourcePoint 8 vs Klipsch RP-600M
- JBL Studio 630 vs Sonus Faber Lumina II Amator
- KEF Q350 vs Sonus Faber Lumina II Amator
Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
ELAC DBR62: $678.97 Amazon Crutchfield eBay
Pros: Two-way design with a 6.5” woofer and 1” dome tweeter in a shallow waveguide, with the tweeter positioned close to the woofer for near-point-source coherence - giving more vertical listening leeway than typical two-ways. Notably forgiving of placement and aiming: sounds good from directly on-axis all the way to 30° of toe-out (parallel with the rear wall), making it more room-independent than many speakers this price. Wide horizontal radiation of about ±70° until the tweeter starts beaming, right in the reviewer’s preferred sweet spot. A mild, wide-Q bass bump centered around 100Hz adds a bit of extra punch that the reviewer personally likes. On-axis linearity within about ±2.5dB, with a strong measured preference score of 5.3. Distortion stays below 3% at both 86dB and 96dB until around 50Hz. Vertical sweet spot of about ±10-20° works well for multi-row home theater seating. The reviewer calls it “the epitome of a good speaker” for its price, with no reservations recommending it.
Cons: A slight recess in the 1-2kHz region reduces vocal presence somewhat compared to other speakers in direct comparison. A mild hot spot around 4-5kHz can read as slight sibilance when pointed directly on-axis. Low-to-mid sensitivity (about 84.3dB) combined with a current draw that behaves like roughly 2.4 ohms between 100-200Hz means it’s best driven by a dedicated 4-ohm-capable amplifier rather than an AVR. A diffraction dip from the baffle edge is visible in measurements - typical of any standard rectangular-baffle speaker and not correctable without a much more expensive curved-baffle design. Multitone distortion testing suggests some potential midrange distortion could be audible on certain material, though the reviewer didn’t personally notice it. Minor resonances appear around 700Hz and 1-1.5kHz, possibly tied to the enclosure, port, or cone/surround edge termination, though their audible impact appears minimal. F3 of 53Hz means a subwoofer is still needed for real bass extension below about 40Hz.
Full ELAC DBR62 review and specifications →
| Bass Extension (-10dB) | 41Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 53Hz (measured, Erin's Audio Corner) |
| Dimensions | 14.1"H x 8.2"W x 10.8"D (358.1 x 208.3 x 274.3 mm) |
| Drivers | 6.5" Aramid Fiber woofer, 1" soft dome tweeter |
| Impedance | 6 ohms nominal, 5.2 ohms minimum (measured above 80Hz, Erin's Audio Corner) |
| Sensitivity | 84.3dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin's Audio Corner; 86dB manufacturer specified) |
| Weight | 18.1 lbs / 8.2 kg each |
| Woofer Cabinet | ported, front |
- Links
- Reviews, Comparisons and Sound Samples
- Erin’s Audio Corner: Top 3 Things You Need to Know About ELAC DBR62 Before You Buy More from Erin’s Audio Corner →
- Erin’s Audio Corner Website Elac DBR62
- Erin’s Audio Corner: 5 AWESOME SPEAKERS Under $1000 You Won’t Regret
- Erin’s Audio Corner: My Top Picks of 2023: Must-Haves Under $3000
- Audio Science Review Measurements More from Audio Science Review →
- Erin’s Audio Corner Measurements (spinorama.org)
- Reddit Search for ELAC DBR62 Review
- Head-to-Head Comparisons
- ELAC DBR62 vs ELAC Uni-Fi Reference UBR62
- ELAC DBR62 vs Yamaha NS-800A
- ELAC DBR62 vs Definitive Technology Demand D11
- ELAC DBR62 vs Technics SB-C700
- ELAC DBR62 vs Dynaudio Contour 20i
- ELAC DBR62 vs SVS Ultra Bookshelf
- ELAC DBR62 vs Revel Concerta2 M16
- ELAC DBR62 vs JBL HDI-1600
- See all 35 comparisons
Sonus Faber Lumina II Amator: $2000 Crutchfield eBay
Pros: Solid bass extension for a bookshelf (F3 63Hz, F10 43Hz), reaching about 50Hz in-room. Decent sensitivity and wide, consistent horizontal dispersion (~60-70 degrees) - better directivity than expected for a two-way design. Gorgeous, luxury-grade cabinet design.
Cons: Very bright treble, running 3-6dB above the midrange depending on measurement angle - independently corroborated by other owners online, not just one reviewer’s opinion. Causes audible sibilance and a forward, grainy character. Notably the brightest of three Sonus Faber models Erin’s Audio Corner has tested, even brighter than the brand’s own Sonetto II G2. A mechanical resonance/ringing artifact shows up around 1kHz in measurements. Needs a subwoofer for anything below about 50Hz.
Full Sonus Faber Lumina II Amator review and specifications →
| Bass Extension (-10dB) | 43Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 63Hz (measured, Erin's Audio Corner) |
| Country of Origin | Italy (Vicenza) |
| Crossover Frequency | 2600Hz |
| Dimensions | 12" x 7.1" x 10.4" (304 x 180 x 263 mm) |
| Drivers | 1.14" DAD (Damped Apex Dome) tweeter, 5.9" paper cone woofer |
| Frequency Response | 55Hz - 24kHz (Manufacturer specified) |
| Impedance | 4 ohms nominal, 3.9 ohms minimum (measured, Erin's Audio Corner) |
| Recommended Power | 30W - 150W |
| Sensitivity | 86.9dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 12.8 lbs / 5.8 kg |
| Woofer Cabinet | Bass reflex, ported |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Sonus Faber Lumina II Amator vs KEF Q350
- Sonus Faber Lumina II Amator vs Klipsch RP-600M
- Sonus Faber Lumina II Amator vs Pylon Jasper Monitor 18
- Sonus Faber Lumina II Amator vs Wharfedale Diamond 9.1
- Sonus Faber Lumina II Amator vs Sonus Faber Sonetto II G2
- Sonus Faber Lumina II Amator vs Triangle Borea BR03
- Sonus Faber Lumina II Amator vs B&W 805S
- Sonus Faber Lumina II Amator vs Emotiva Airmotiv B2+
- See all 22 comparisons