ELAC DBR62 vs AsciLab C6B

Last updated: August 25, 2026

Short answer: the AsciLab C6B for better sound quality, the ELAC DBR62 for the lower price. The AsciLab C6B ranks #7 of 131 bookshelf speakers at $1145. The ELAC DBR62 ranks #55 at $678.97, $466.03 cheaper.

What the ELAC DBR62 offers: Two-way design with a 6.5” woofer and 1” dome tweeter in a shallow waveguide, with the tweeter positioned close to the woofer for near-point-source coherence - giving more vertical listening leeway than typical two-ways. Notably forgiving of placement and aiming: sounds good from directly on-axis all the way to 30° of toe-out (parallel with the rear wall), making it more room-independent than many speakers this price. Wide horizontal radiation of about ±70° until the tweeter starts beaming, right in the reviewer’s preferred sweet spot. A mild, wide-Q bass bump centered around 100Hz adds a bit of extra punch that the reviewer personally likes. On-axis linearity within about ±2.5dB, with a strong measured preference score of 5.3. Distortion stays below 3% at both 86dB and 96dB until around 50Hz. Vertical sweet spot of about ±10-20° works well for multi-row home theater seating. The reviewer calls it “the epitome of a good speaker” for its price, with no reservations recommending it. Watch for: A slight recess in the 1-2kHz region reduces vocal presence somewhat compared to other speakers in direct comparison. A mild hot spot around 4-5kHz can read as slight sibilance when pointed directly on-axis. Low-to-mid sensitivity (about 84.3dB) combined with a current draw that behaves like roughly 2.4 ohms between 100-200Hz means it’s best driven by a dedicated 4-ohm-capable amplifier rather than an AVR. A diffraction dip from the baffle edge is visible in measurements - typical of any standard rectangular-baffle speaker and not correctable without a much more expensive curved-baffle design. Multitone distortion testing suggests some potential midrange distortion could be audible on certain material, though the reviewer didn’t personally notice it. Minor resonances appear around 700Hz and 1-1.5kHz, possibly tied to the enclosure, port, or cone/surround edge termination, though their audible impact appears minimal. F3 of 53Hz means a subwoofer is still needed for real bass extension below about 40Hz.

What the AsciLab C6B offers: Two-way design pairing a 1” aluminum ceramic dome tweeter on a large waveguide with a 6” aluminum ceramic cone woofer, crossed over at 1.1kHz, plus a rear passive radiator. Unusual trait: horizontal radiation actually widens at higher frequencies instead of narrowing like most two-way designs, which keeps image focus and soundstage depth consistent whether you toe the speakers in or out (5-10° off-axis was the sweet spot in testing). Vertical radiation also stays wide straight through the 2kHz crossover region, so the sound doesn’t collapse when standing up - unusual at this price. CA2034 measurements show strong on-axis linearity, listening window, early reflections, and directivity. Midrange and tweeter distortion stay very low even at 96dB, holding up against a $5,900 Arendal speaker in that regard despite roughly a 5x price gap. At $935 (about $1,135 shipped to the US), the reviewer calls it the best-value bookshelf speaker he’s tested, rivaling speakers 2-5x the price. Watch for: Bass rolls off around 50Hz in-room (F3 54Hz, F10 35Hz), so a subwoofer is needed for real extension below that. Low-frequency harmonic distortion increases substantially at 96dB versus 86dB, though it’s second-order and less audible than it looks on paper. Minimum impedance dips to 2.6 ohms (EPDR as low as 1.2 ohms), so it wants an amplifier comfortable driving 4-ohm loads, ideally 100W or more. At 102dB, compression noticeably eats into midrange, bass, and some treble output. Shipping to the US adds roughly $200 on top of the $935 price. Against the reviewer’s reference Audiofirst Fidelia at a similar price, has slightly less lower-midrange body (about 1dB difference) and a smaller perceived soundstage size.

Buy the ELAC DBR62 if the price matters more than sound quality. Buy the AsciLab C6B if sound quality matters more than the price.

Buy the AsciLab C6B at Ascilab →Buy the ELAC DBR62 at Amazon ($678.97) →

ELAC DBR62 vs AsciLab C6B

Specifications Side By Side

ELAC DBR62 AsciLab C6B
Price$678.97$1145
Ranked#55 of 131 in Large Size Bookshelf Speakers#7 of 131 in Large Size Bookshelf Speakers
Bass Extension (-10dB)41Hz (measured, Erin’s Audio Corner)35Hz (measured, Erin’s Audio Corner)
Bass Extension (-3dB)53Hz (measured, Erin’s Audio Corner)54Hz (measured, Erin’s Audio Corner)
Dimensions14.1"H x 8.2"W x 10.8"D (358.1 x 208.3 x 274.3 mm)15.7"H x 8"W x 10.4"D (398.8 x 203.2 x 264.2 mm)
Impedance6 ohms nominal, 5.2 ohms minimum (measured above 80Hz, Erin’s Audio Corner)4 ohms nominal, 2.6 ohms minimum (measured, Erin’s Audio Corner)
Sensitivity84.3dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin’s Audio Corner; 86dB manufacturer specified)85.6dB (measured, Erin’s Audio Corner)
Drivers6.5" Aramid Fiber woofer, 1" soft dome tweeter6" Aluminium Ceramic Cone with cast Aluminium Chassis woofer, 1" Aluminium Ceramic Dome tweeter
Weight18.1 lbs / 8.2 kg each18.5 lbs / 8.4 kg each
Woofer Cabinetported, frontpassive radiator
Buy the AsciLab C6B at Ascilab →Buy the ELAC DBR62 at Amazon ($678.97) →

More useful head-to-heads from the same speaker class:

Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.

As an eBay Partner, we may be compensated if you make a purchase.

The Two Speakers In Full

ELAC DBR62: $678.97 Amazon Crutchfield eBay

ELAC DBR62 ranking card

Pros: Two-way design with a 6.5” woofer and 1” dome tweeter in a shallow waveguide, with the tweeter positioned close to the woofer for near-point-source coherence - giving more vertical listening leeway than typical two-ways. Notably forgiving of placement and aiming: sounds good from directly on-axis all the way to 30° of toe-out (parallel with the rear wall), making it more room-independent than many speakers this price. Wide horizontal radiation of about ±70° until the tweeter starts beaming, right in the reviewer’s preferred sweet spot. A mild, wide-Q bass bump centered around 100Hz adds a bit of extra punch that the reviewer personally likes. On-axis linearity within about ±2.5dB, with a strong measured preference score of 5.3. Distortion stays below 3% at both 86dB and 96dB until around 50Hz. Vertical sweet spot of about ±10-20° works well for multi-row home theater seating. The reviewer calls it “the epitome of a good speaker” for its price, with no reservations recommending it.

Cons: A slight recess in the 1-2kHz region reduces vocal presence somewhat compared to other speakers in direct comparison. A mild hot spot around 4-5kHz can read as slight sibilance when pointed directly on-axis. Low-to-mid sensitivity (about 84.3dB) combined with a current draw that behaves like roughly 2.4 ohms between 100-200Hz means it’s best driven by a dedicated 4-ohm-capable amplifier rather than an AVR. A diffraction dip from the baffle edge is visible in measurements - typical of any standard rectangular-baffle speaker and not correctable without a much more expensive curved-baffle design. Multitone distortion testing suggests some potential midrange distortion could be audible on certain material, though the reviewer didn’t personally notice it. Minor resonances appear around 700Hz and 1-1.5kHz, possibly tied to the enclosure, port, or cone/surround edge termination, though their audible impact appears minimal. F3 of 53Hz means a subwoofer is still needed for real bass extension below about 40Hz.

Full ELAC DBR62 review and specifications →

Bass Extension (-10dB)41Hz (measured, Erin's Audio Corner)
Bass Extension (-3dB)53Hz (measured, Erin's Audio Corner)
Dimensions14.1"H x 8.2"W x 10.8"D (358.1 x 208.3 x 274.3 mm)
Drivers6.5" Aramid Fiber woofer, 1" soft dome tweeter
Impedance6 ohms nominal, 5.2 ohms minimum (measured above 80Hz, Erin's Audio Corner)
Sensitivity84.3dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin's Audio Corner; 86dB manufacturer specified)
Weight18.1 lbs / 8.2 kg each
Woofer Cabinetported, front
Check current price at Amazon ($678.97) →Check current price at Crutchfield →Search eBay for ELAC DBR62 →

AsciLab C6B: $1145 Ascilab eBay

AsciLab C6B ranking card

Pros: Two-way design pairing a 1” aluminum ceramic dome tweeter on a large waveguide with a 6” aluminum ceramic cone woofer, crossed over at 1.1kHz, plus a rear passive radiator. Unusual trait: horizontal radiation actually widens at higher frequencies instead of narrowing like most two-way designs, which keeps image focus and soundstage depth consistent whether you toe the speakers in or out (5-10° off-axis was the sweet spot in testing). Vertical radiation also stays wide straight through the 2kHz crossover region, so the sound doesn’t collapse when standing up - unusual at this price. CA2034 measurements show strong on-axis linearity, listening window, early reflections, and directivity. Midrange and tweeter distortion stay very low even at 96dB, holding up against a $5,900 Arendal speaker in that regard despite roughly a 5x price gap. At $935 (about $1,135 shipped to the US), the reviewer calls it the best-value bookshelf speaker he’s tested, rivaling speakers 2-5x the price.

Cons: Bass rolls off around 50Hz in-room (F3 54Hz, F10 35Hz), so a subwoofer is needed for real extension below that. Low-frequency harmonic distortion increases substantially at 96dB versus 86dB, though it’s second-order and less audible than it looks on paper. Minimum impedance dips to 2.6 ohms (EPDR as low as 1.2 ohms), so it wants an amplifier comfortable driving 4-ohm loads, ideally 100W or more. At 102dB, compression noticeably eats into midrange, bass, and some treble output. Shipping to the US adds roughly $200 on top of the $935 price. Against the reviewer’s reference Audiofirst Fidelia at a similar price, has slightly less lower-midrange body (about 1dB difference) and a smaller perceived soundstage size.

Full AsciLab C6B review and specifications →

Bass Extension (-10dB)35Hz (measured, Erin's Audio Corner)
Bass Extension (-3dB)54Hz (measured, Erin's Audio Corner)
Dimensions15.7"H x 8"W x 10.4"D (398.8 x 203.2 x 264.2 mm)
Drivers6" Aluminium Ceramic Cone with cast Aluminium Chassis woofer, 1" Aluminium Ceramic Dome tweeter
Impedance4 ohms nominal, 2.6 ohms minimum (measured, Erin's Audio Corner)
Sensitivity85.6dB (measured, Erin's Audio Corner)
Weight18.5 lbs / 8.4 kg each
Woofer Cabinetpassive radiator
Check current price at Ascilab →Search eBay for AsciLab C6B →