Short answer: the Edifier R1280T. It ranks #36 of 64 powered bookshelf speakers by sound quality at $129.97; the Neumi BS5P ranks #60 and costs $150, so there is not much of a tradeoff to weigh.
What the Edifier R1280T offers: ASR’s Klippel-based measurements found the woofer handled a demanding bass-heavy track without bottoming out or audible distortion, and distortion stayed low and inaudible at a normal 86dB SPL listening level. Built-in remote and bass/treble tone controls, no separate preamp needed. Watch for: On-axis response is jagged rather than neutral, with a woofer resonance around 5kHz and a tweeter peak near 10kHz that also show up in the directivity data, making off-axis/room response uneven too - the reviewer’s raw impression was “a bit bass heavy and after a track or two, somewhat bright,” and he recommends EQ correction. Vertical listening window is narrow, so the tweeter needs to be angled toward the ears. Pushed to 96dB SPL the tonal balance shifts noticeably, a sign of compression starting even though the driver doesn’t audibly break up.
What the Neumi BS5P offers: Exceptionally broad connectivity for the price: Bluetooth, optical, coaxial and RCA inputs, remote control and 75W total amplification. The 5-inch fiberglass woofer/1-inch silk-dome platform has generally useful directivity outside port resonances and therefore responds well to corrective EQ. Compact dimensions and ample nearfield volume make it practical for a desk or small room. Watch for: The original firmware Erin reviewed produces a pronounced V-curve—excess midbass and treble with recessed dialogue/midrange—and is a fidelity step backward from the passive BS5. Nearfield treble above 8kHz rises as much as 4dB relative to farfield, distortion is already substantial at 86dB, and compression becomes severe above 96dB. Port resonances further contaminate the response. Erin later measured improved firmware, but buyers must confirm revision. Passive sensitivity and impedance are not applicable.
Buy the Edifier R1280T. It ranks higher for sound quality than the Neumi BS5P and costs less, so there is no real case for the other one.
If sound quality matters at all to you, skip the Neumi BS5P. It ranks near the bottom of the 64 powered bookshelf speakers, so look higher up the list instead.
Specifications Side By Side
| Edifier R1280T | Neumi BS5P | |
|---|---|---|
| Price | $129.97 | $150/pair |
| Ranked | #36 of 64 in Medium Size Powered Bookshelf Speakers | #60 of 64 in Medium Size Powered Bookshelf Speakers |
| Bass Extension (-3dB) | 80Hz (measured, Audio Science Review) | 90.8Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-10dB) | 62Hz (measured, Audio Science Review) | 56.1Hz (measured, Erin’s Audio Corner) |
| Dimensions | 9.2"H x 7.7"W x 5.7"D (234 x 196 x 146 mm) | - |
| Frequency Response | 52Hz - 20kHz (Manufacturer specified) | - |
| Inputs | 2x RCA Input | Bluetooth, optical, coaxial and RCA |
| Outputs | None | - |
| Weight | 10.8 lbs / 4.9 kg | - |
| Drivers | 4" (102mm) woofer | 1" silk-dome tweeter; 5" fiberglass woofer |
| App | No | - |
| Bluetooth | No | - |
| EQ | No | - |
| Output Power | 42w RMS Total | - |
| Bass Extension | - | Erin’s response shows usable midbass but limited deep-bass headroom |
| Sensitivity | - | Not applicable (active DSP loudspeaker) |
| Power | - | 75W total |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Edifier R1280DB vs Presonus Eris E5 XT
- Edifier R1280DB vs JBL One Series 104
- Edifier MR4 vs Edifier R1280DB
- Edifier MR4 vs Neumi BS5P
- Edifier R1280DB vs Edifier R1280T
Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Edifier R1280T: $129.97 Amazon eBay
Pros: ASR’s Klippel-based measurements found the woofer handled a demanding bass-heavy track without bottoming out or audible distortion, and distortion stayed low and inaudible at a normal 86dB SPL listening level. Built-in remote and bass/treble tone controls, no separate preamp needed.
Cons: On-axis response is jagged rather than neutral, with a woofer resonance around 5kHz and a tweeter peak near 10kHz that also show up in the directivity data, making off-axis/room response uneven too - the reviewer’s raw impression was “a bit bass heavy and after a track or two, somewhat bright,” and he recommends EQ correction. Vertical listening window is narrow, so the tweeter needs to be angled toward the ears. Pushed to 96dB SPL the tonal balance shifts noticeably, a sign of compression starting even though the driver doesn’t audibly break up.
Full Edifier R1280T review and specifications →
| App | No |
|---|---|
| Bass Extension (-10dB) | 62Hz (measured, Audio Science Review) |
| Bass Extension (-3dB) | 80Hz (measured, Audio Science Review) |
| Bluetooth | No |
| Dimensions | 9.2"H x 7.7"W x 5.7"D (234 x 196 x 146 mm) |
| Drivers | 4" (102mm) woofer |
| EQ | No |
| Frequency Response | 52Hz - 20kHz (Manufacturer specified) |
| Inputs | 2x RCA Input |
| Output Power | 42w RMS Total |
| Outputs | None |
| Weight | 10.8 lbs / 4.9 kg |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Edifier R1280T vs Edifier R1280DB
- Edifier R1280T vs Audioengine A5+ Classic
- Edifier R1280T vs Focal Alpha 50 EVO
- Edifier R1280T vs Topping MA4
- Edifier R1280T vs Presonus Eris E5
- Edifier R1280T vs Vanatoo Transparent One Encore Plus
- Edifier R1280T vs Edifier R2000DB
- Edifier R1280T vs Edifier MR4
- See all 44 comparisons
Neumi BS5P: $150/pair Amazon eBay
Pros: Exceptionally broad connectivity for the price: Bluetooth, optical, coaxial and RCA inputs, remote control and 75W total amplification. The 5-inch fiberglass woofer/1-inch silk-dome platform has generally useful directivity outside port resonances and therefore responds well to corrective EQ. Compact dimensions and ample nearfield volume make it practical for a desk or small room.
Cons: The original firmware Erin reviewed produces a pronounced V-curve—excess midbass and treble with recessed dialogue/midrange—and is a fidelity step backward from the passive BS5. Nearfield treble above 8kHz rises as much as 4dB relative to farfield, distortion is already substantial at 86dB, and compression becomes severe above 96dB. Port resonances further contaminate the response. Erin later measured improved firmware, but buyers must confirm revision. Passive sensitivity and impedance are not applicable.
Full Neumi BS5P review and specifications →
| Bass Extension | Erin's response shows usable midbass but limited deep-bass headroom |
|---|---|
| Bass Extension (-10dB) | 56.1Hz (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 90.8Hz (measured, Erin's Audio Corner) |
| Drivers | 1" silk-dome tweeter; 5" fiberglass woofer |
| Inputs | Bluetooth, optical, coaxial and RCA |
| Power | 75W total |
| Sensitivity | Not applicable (active DSP loudspeaker) |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons