Neumann KH80 DSP vs Neumi BS5P

Last updated: August 24, 2026

Short answer: the Neumann KH80 DSP for better sound quality, the Neumi BS5P for the lower price. The Neumann KH80 DSP ranks #7 of 60 powered bookshelf speakers at $598.98. The Neumi BS5P ranks #56 at $150, $448.98 cheaper.

What the Neumann KH80 DSP offers: Compact 2-way nearfield monitor - a 1” tweeter in an elliptical waveguide over a 4” mid-woofer, crossed over around 1.8kHz with steep 48dB/octave slopes. Exceptionally linear on-axis response, within about ±1.5dB, with essentially nothing worth equalizing beyond a minor, likely port-related wrinkle around 800Hz. Vertical dispersion is unusually wide and consistent for a monitor this size, holding together to roughly ±40° versus the ±20° or so typical of similarly compact designs - a benefit of the steep crossover slopes and waveguide minimizing comb filtering, so listening height and seating posture matter less than on most small monitors. Back-panel switches (freestanding, small/medium/large desk) tailor the low-mid response to compensate for desk-boundary reflections. Distortion in the midrange doesn’t change when high-passed to a subwoofer at 80Hz, showing the drivers already have a clean distortion profile on their own. Maintains good composure and linearity up to about 96dB SPL down to roughly 80Hz before an active protection circuit engages; tested with dense multitone program material rather than a sine sweep, output around 96dB costs only about 1dB in the midrange, putting realistic maximum SPL near 95dB. Watch for: High price for its size, at roughly $1,000/pair. The horizontal pattern stays wide and essentially constant out to about ±30° before beaming and narrowing further out (then flattening again near 2kHz) - a wide, controlled pattern in absolute terms, but one that reflects more high-frequency energy off nearby sidewalls than a narrower design would. At greater listening distances or in more reflective rooms (tested around 6 feet away at 75-80dB), that shows up as a top end that reads a bit hot despite the speaker measuring essentially flat on-axis - a byproduct of its directivity rather than its tonal balance, and mostly moot for genuine nearfield desktop use inside about a meter. The estimated in-room response shows a shallow dip around 1-2kHz and a treble trend running 2-3dB above the midrange in that same far-field estimate. Multitone distortion for a single speaker climbs into the 3-5% range at 96dB SPL, though that’s only really relevant well above typical nearfield listening levels. Bass rolls off below its F3 of 57Hz (F10 48Hz), so the 4” mid-woofer still needs a subwoofer for real low-end content. The companion app for EQ/setup is iPad-only, with no Android or Bluetooth option despite being control-only, and the in-room calibration microphone is a separate purchase in most cases. In a separate comparison test, the smoother-measuring KH80 actually sounded smaller and less present than the cheaper JBL 305P MKII, which had more perceived bass and clarity despite measuring worse on paper.

What the Neumi BS5P offers: Exceptionally broad connectivity for the price: Bluetooth, optical, coaxial and RCA inputs, remote control and 75W total amplification. The 5-inch fiberglass woofer/1-inch silk-dome platform has generally useful directivity outside port resonances and therefore responds well to corrective EQ. Compact dimensions and ample nearfield volume make it practical for a desk or small room. Watch for: The original firmware Erin reviewed produces a pronounced V-curve—excess midbass and treble with recessed dialogue/midrange—and is a fidelity step backward from the passive BS5. Nearfield treble above 8kHz rises as much as 4dB relative to farfield, distortion is already substantial at 86dB, and compression becomes severe above 96dB. Port resonances further contaminate the response. Erin later measured improved firmware, but buyers must confirm revision. Passive sensitivity and impedance are not applicable.

Buy the Neumann KH80 DSP if sound quality matters more than the price. Buy the Neumi BS5P if the price matters more than sound quality.

If sound quality matters at all to you, skip the Neumi BS5P. It ranks near the bottom of the 60 powered bookshelf speakers, so look higher up the list instead.

Buy the Neumann KH80 DSP at Amazon ($598.98) →Buy the Neumi BS5P at Amazon ($150/pair) →

Neumann KH80 DSP vs Neumi BS5P

Specifications Side By Side

Neumann KH80 DSP Neumi BS5P
Price$598.98$150/pair
Ranked#7 of 60 in Medium Size Powered Bookshelf Speakers#56 of 60 in Medium Size Powered Bookshelf Speakers
Dimensions13.6"H x 10.8"W x 9.6"D (345.4 x 274.3 x 243.8 mm)-
Frequency Response57 Hz - 25 kHz (+-3 dB) (Manufacturer specified)-
InputsXLRBluetooth, optical, coaxial and RCA
Weight9 lbs / 4.1 kg each-
Drivers4.1" woofer, 1" fabric dome tweeter1" silk-dome tweeter; 5" fiberglass woofer
AppYes (MA 1 alignment)-
Bass Extension (-10dB)51Hz (measured, Erin’s Audio Corner)56.1Hz (measured, Erin’s Audio Corner)
Bass Extension (-3dB)57Hz (measured, Erin’s Audio Corner)90.8Hz (measured, Erin’s Audio Corner)
BluetoothNo-
DSPYes-
EQYes (via DSP)-
Max SPL110.7dB @ 1m-
Sensitivity91.9dB (measured at 0.3V/1m, Erin’s Audio Corner)Not applicable (active DSP loudspeaker)
Output Power140W (90W woofer + 50W tweeter)-
Bass Extension-Erin’s response shows usable midbass but limited deep-bass headroom
Power-75W total
Buy the Neumann KH80 DSP at Amazon ($598.98) →Buy the Neumi BS5P at Amazon ($150/pair) →

More useful head-to-heads from the same speaker class:

Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.

As an eBay Partner, we may be compensated if you make a purchase.

The Two Speakers In Full

Neumann KH80 DSP: $598.98 Amazon Bhphotovideo eBay

Neumann KH80 DSP ranking card

Pros: Compact 2-way nearfield monitor - a 1” tweeter in an elliptical waveguide over a 4” mid-woofer, crossed over around 1.8kHz with steep 48dB/octave slopes. Exceptionally linear on-axis response, within about ±1.5dB, with essentially nothing worth equalizing beyond a minor, likely port-related wrinkle around 800Hz. Vertical dispersion is unusually wide and consistent for a monitor this size, holding together to roughly ±40° versus the ±20° or so typical of similarly compact designs - a benefit of the steep crossover slopes and waveguide minimizing comb filtering, so listening height and seating posture matter less than on most small monitors. Back-panel switches (freestanding, small/medium/large desk) tailor the low-mid response to compensate for desk-boundary reflections. Distortion in the midrange doesn’t change when high-passed to a subwoofer at 80Hz, showing the drivers already have a clean distortion profile on their own. Maintains good composure and linearity up to about 96dB SPL down to roughly 80Hz before an active protection circuit engages; tested with dense multitone program material rather than a sine sweep, output around 96dB costs only about 1dB in the midrange, putting realistic maximum SPL near 95dB.

Cons: High price for its size, at roughly $1,000/pair. The horizontal pattern stays wide and essentially constant out to about ±30° before beaming and narrowing further out (then flattening again near 2kHz) - a wide, controlled pattern in absolute terms, but one that reflects more high-frequency energy off nearby sidewalls than a narrower design would. At greater listening distances or in more reflective rooms (tested around 6 feet away at 75-80dB), that shows up as a top end that reads a bit hot despite the speaker measuring essentially flat on-axis - a byproduct of its directivity rather than its tonal balance, and mostly moot for genuine nearfield desktop use inside about a meter. The estimated in-room response shows a shallow dip around 1-2kHz and a treble trend running 2-3dB above the midrange in that same far-field estimate. Multitone distortion for a single speaker climbs into the 3-5% range at 96dB SPL, though that’s only really relevant well above typical nearfield listening levels. Bass rolls off below its F3 of 57Hz (F10 48Hz), so the 4” mid-woofer still needs a subwoofer for real low-end content. The companion app for EQ/setup is iPad-only, with no Android or Bluetooth option despite being control-only, and the in-room calibration microphone is a separate purchase in most cases. In a separate comparison test, the smoother-measuring KH80 actually sounded smaller and less present than the cheaper JBL 305P MKII, which had more perceived bass and clarity despite measuring worse on paper.

Full Neumann KH80 DSP review and specifications →

AppYes (MA 1 alignment)
Bass Extension (-10dB)51Hz (measured, Erin's Audio Corner)
Bass Extension (-3dB)57Hz (measured, Erin's Audio Corner)
BluetoothNo
DSPYes
Dimensions13.6"H x 10.8"W x 9.6"D (345.4 x 274.3 x 243.8 mm)
Drivers4.1" woofer, 1" fabric dome tweeter
EQYes (via DSP)
Frequency Response57 Hz - 25 kHz (+-3 dB) (Manufacturer specified)
InputsXLR
Max SPL110.7dB @ 1m
Output Power140W (90W woofer + 50W tweeter)
Sensitivity91.9dB (measured at 0.3V/1m, Erin's Audio Corner)
Weight9 lbs / 4.1 kg each
Check current price at Amazon ($598.98) →Check current price at Bhphotovideo ($599) →Search eBay for Neumann KH80 DSP →

Neumi BS5P: $150/pair Amazon eBay

Neumi BS5P ranking card

Pros: Exceptionally broad connectivity for the price: Bluetooth, optical, coaxial and RCA inputs, remote control and 75W total amplification. The 5-inch fiberglass woofer/1-inch silk-dome platform has generally useful directivity outside port resonances and therefore responds well to corrective EQ. Compact dimensions and ample nearfield volume make it practical for a desk or small room.

Cons: The original firmware Erin reviewed produces a pronounced V-curve—excess midbass and treble with recessed dialogue/midrange—and is a fidelity step backward from the passive BS5. Nearfield treble above 8kHz rises as much as 4dB relative to farfield, distortion is already substantial at 86dB, and compression becomes severe above 96dB. Port resonances further contaminate the response. Erin later measured improved firmware, but buyers must confirm revision. Passive sensitivity and impedance are not applicable.

Full Neumi BS5P review and specifications →

Bass ExtensionErin's response shows usable midbass but limited deep-bass headroom
Bass Extension (-10dB)56.1Hz (measured, Erin's Audio Corner)
Bass Extension (-3dB)90.8Hz (measured, Erin's Audio Corner)
Drivers1" silk-dome tweeter; 5" fiberglass woofer
InputsBluetooth, optical, coaxial and RCA
Power75W total
SensitivityNot applicable (active DSP loudspeaker)
Check current price at Amazon ($150/pair) →Search eBay for Neumi BS5P →