Coverage note. Speaker Ranking currently covers 2 BGVP models across headphones. These are the products in our database, not a complete list of everything BGVP makes.
What this page covers. The BGVP models ranked here span headphones, including BGVP Solomon and BGVP DN3. Use each model’s category position to compare it with alternatives of the same size and use case.
This page lists all 2 BGVP speakers ranked on this site across headphones. Each model is shown in the category where it competes, with its current rank and the size of that ranking.
Use the category position rather than the brand name alone: speakers from the same manufacturer can perform very differently by size, price and product family.
Prices on this page were last checked October 10, 2026 at 5:37 PM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
In-Ear Headphones
Ranked #49 of 297 in In-Ear Headphones - BGVP Solomon: $229.00 Amazon eBay
Pros: Six hobbyist measurements on squig.link put its preference score at 81.1, with bass and low mids within about 1 dB of target and sub-bass holding flat to 20 Hz. The air band runs about 5.3 dB hot above 10 kHz, which adds an open, airy edge to strings and room ambience for listeners who like a lively top end. Very high sensitivity of 130.8 dB/Vrms means a phone or basic dongle drives it to full volume easily.
Cons: The presence region sits about 2.2 dB below target with a 3.9 dB dip near 3.1 kHz, so vocals and guitars can sound set back behind the bass and treble. A 4.8 dB peak near 10.2 kHz can make bright recordings sound slightly etched. Its very low 7.3 ohm impedance can pick up hiss from noisy sources.
Full BGVP Solomon review and specifications →
| Released | 2025 (1 year ago) |
|---|---|
| Back | Closed |
| Built-in Microphone | No |
| Connection | Wired |
| Deviation From Target | 1.41 dB standard deviation |
| Driver Type | Hybrid (2 dynamic + 3 balanced armature + 2 electrostatic + 2 bone conduction) |
| Drivers | 2 x 8mm dynamic + 3 x balanced armature + 2 x electrostatic + 2 x bone conduction |
| Form Factor | In-ear |
| Harman Preference Score | 81 (median of 6 squig.link measurements, calibrated to AutoEQ) |
| Impedance | 7.3 ohms |
| Sensitivity | 130.8 dB/Vrms |
| Sub-bass Extension | Within 6 dB of target down to 20 Hz (-0.2 dB at 30 Hz) |
| Tonal Tilt | -0.12 (negative is warmer, positive brighter) |
- Reviews, Comparisons and Sound Samples
Ranked #227 of 297 in In-Ear Headphones - BGVP DN3: $74.99 HiFiGo eBay
Pros: A dynamic driver and balanced armature hybrid that adds about 3.6 dB of bass between 60 and 200 Hz in squig.link measurements, giving rock and pop extra punch and body. Sub-bass holds within 6 dB of target down to 20 Hz. At 19 ohms and 109 dB/mW it plays loud from any phone, and each earpiece weighs just 5 g. It rates higher than the Shure SE215 while costing less.
Cons: Treble swings from a 4.3 dB peak near 8.1 kHz to a 6.3 dB dip near 9.9 kHz, so cymbals can sound splashy one moment and muted the next. A 2.1 dB lift in the low mids thickens vocals slightly. The KZ ZSX rates higher for less money, and the iBasso IT01S rates higher still for a small step up.
Full BGVP DN3 review and specifications →
| Released | Aug 2021 (5 years ago) |
|---|---|
| Back | Closed |
| Built-in Microphone | No |
| Connection | Wired |
| Deviation From Target | 3.13 dB standard deviation |
| Driver Type | Hybrid (1 dynamic + 1 balanced armature) |
| Drivers | 1 x 10mm dynamic + 1 x balanced armature |
| Form Factor | In-ear |
| Frequency Response | 10Hz - 40kHz (Manufacturer specified) |
| Harman Preference Score | 64 (measured by crinacle, via AutoEQ) |
| Impedance | 19 ohms |
| Sensitivity | 109 dB/mW |
| Sub-bass Extension | Within 6 dB of target down to 20 Hz (-2.7 dB at 30 Hz) |
| Tonal Tilt | -0.20 (negative is warmer, positive brighter) |
| Weight | 0 lbs (5 g) |
EQ preset to match the Harman target
Set a preamp of -6.2 dB, then add these filters in any parametric equalizer (Wavelet, Equalizer APO, Peace, or a player with parametric EQ). Calculated by AutoEQ from its measured frequency response.
| Filter | Frequency | Gain | Q |
|---|---|---|---|
| Low shelf | 105 Hz | +5.8 dB | 0.70 |
| Peak | 87 Hz | -4.9 dB | 0.29 |
| Peak | 7,222 Hz | +6.8 dB | 2.12 |
| Peak | 767 Hz | +3.5 dB | 0.82 |
| Peak | 2,101 Hz | -5.8 dB | 2.36 |
| High shelf | 10,000 Hz | +3.1 dB | 0.70 |
| Peak | 4,481 Hz | -6.5 dB | 5.34 |
| Peak | 3,346 Hz | +2.4 dB | 3.76 |
| Peak | 5,859 Hz | +2.6 dB | 4.87 |
| Peak | 7,355 Hz | -2.0 dB | 5.99 |
- Reviews, Comparisons and Sound Samples