Short answer: the Dynaudio Heritage Special if sound quality matters most, the Sonus Faber Lumina II if price matters most. The Dynaudio Heritage Special ranks #28 of 130 bookshelf speakers at $7000. The Sonus Faber Lumina II ranks #91 at $1600, $5400 cheaper.
What the Sonus Faber Lumina II offers: Handmade in Italy with a gloss-finished front baffle and black leather-wrapped cabinet - genuinely nice-looking speaker with real brand cachet. Bass extension is competitive for the size, reaching about 50 Hz in-room with mild compression and good distortion figures, so higher output levels and greater listening distances aren’t a problem down to that point. About 20 dB of dynamic range at typical listening levels (73 dB at 4m), which comfortably covers most music without the tonal balance shifting as instruments and vocals peak. Off-axis behavior is consistent - toeing the speakers 20-30 degrees out doesn’t meaningfully change the in-room high-frequency character, so placement flexibility is good once you’ve dialed in the tonal balance. Watch for: Not a neutral speaker - has a persistent high-frequency boost/lift that makes it sound forward and bright, present whether pointed directly at the listener or toed out. A slightly nasal quality traced to a resonance around 1 kHz that EQ can address. The reviewer needed to trim treble by about 4 dB on his preamp to get the tonal balance he wanted, meaning most listeners will want equalization available to fully enjoy this speaker. At roughly the same $1,000ish price point, alternatives like the Ascend Acoustics Sierra 1 V2 measure more linear (with a tradeoff in distortion and crossover-region directivity), and the Dynaudio Emit 20 offers deeper bass extension and lower compression at the cost of a more deliberately colored tonal signature.
What the Dynaudio Heritage Special offers: One of the rare cases where the reviewer measured a speaker as flawed but still genuinely enjoyed listening to it. A massive 4” voice coil on the midwoofer gives it exceptional output capability for a bookshelf speaker - averaged 100dB at 3.5 meters with no audible mechanical noise, port chuffing, or woofer bottoming even when deliberately pushed hard. Bass is very robust and doesn’t noticeably give up output as volume increases, staying solid at both low and high listening levels. Big, well-proportioned soundstage - wide without losing image focus. Limited run of 2,500 pairs with genuine collectible/heritage value; the tweeter (Esotar 3) and midwoofer both use premium Dynaudio-made drivers with an unusually wide, stout voice coil. Watch for: At lower listening volumes, dynamic range and kick-drum punch fell short of higher-sensitivity speakers the reviewer has tested (JBL 4367, KEF Reference 1 Meta) - the sheer output ceiling is impressive, but it isn’t a highly dynamic-sounding speaker at modest levels. A degree of “softness” in the upper mid-range. Selective sibilance in the 4-6kHz treble region that shows up on some tracks but not others, which the reviewer found mildly aggravating and would want to EQ down given the choice. Neither the tweeter nor the woofer is fully flush-mounted to the baffle, likely intentional as part of the heritage-styled look, but the reviewer wonders how much this affected linearity. At $7,000/pair MSRP (and a discontinued limited run, so used/open-box pricing around $5,000/pair is about the best you’ll do now), this is a serious investment for a bookshelf speaker.
Buy the Sonus Faber Lumina II if the price is the priority over sound quality, or the Dynaudio Heritage Special if sound quality is the priority over the price.
Looking for alternatives? See the complete Passive Home rankings.
Specifications Side By Side
| Sonus Faber Lumina II | Dynaudio Heritage Special | |
|---|---|---|
| Price | $1,600 per pair | $7,000 per pair |
| Ranked | #91 of 130 in Large Size Bookshelf Speakers | #28 of 130 in Large Size Bookshelf Speakers |
| Drivers | 29mm DAD dome tweeter, 150mm paper cone mid-woofer | 18cm MSP cone woofer, 28mm Esotar 3 dome tweeter |
| Crossover Frequency | 1800Hz | - |
| Dimensions | 12" x 7.1" x 10.4" (304 x 180 x 263 mm) | 15.2"H x 8.2"W x 12.6"D (385 x 208 x 320 mm) |
| Weight | 12.5 lbs (5.65 kg) each | 24.3 lbs (11 kg) each |
| Impedance | 4 ohms nominal, 4.1 ohms minimum (measured, Erin's Audio Corner) | 5.1 ohms minimum, ported mode (measured, Erin's Audio Corner) |
| Sensitivity | 86dB (measured average, Erin's Audio Corner; matches manufacturer spec) | 85dB (measured at 2.83V/1m, Erin's Audio Corner) |
| Bass Extension (-3dB) | 60Hz (measured, Erin's Audio Corner) | 52Hz (measured, Erin's Audio Corner) |
| Bass Extension (-10dB) | 41Hz (measured, Erin's Audio Corner) | 38Hz (measured, Erin's Audio Corner) |
| Frequency Response | 55Hz - 24kHz (manufacturer specified) | - |
| Recommended Power | 30W - 150W | - |
| Spinorama Preference Score | 3.04 | 3.43 |
| Spinorama Preference Score with Perfect Sub | 5.32 | 5.44 |
| Discontinued | - | Yes (limited run of 2,500 pairs) |
| Country | - | Denmark |
Related Speaker Comparisons
How Dynaudio Heritage Special compares with other leading options:
- Perlisten S4b vs Dynaudio Heritage Special
- KEF Reference 1 Meta vs Dynaudio Heritage Special
- Dynaudio Heritage Special vs GR-Research NX-Studio
- AsciLab C6B vs Dynaudio Heritage Special
- Audio First Cadentia 3 vs Dynaudio Heritage Special
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Sonus Faber Lumina II: $1,600 per pair Crutchfield eBay
Pros: Handmade in Italy with a gloss-finished front baffle and black leather-wrapped cabinet - genuinely nice-looking speaker with real brand cachet. Bass extension is competitive for the size, reaching about 50 Hz in-room with mild compression and good distortion figures, so higher output levels and greater listening distances aren’t a problem down to that point. About 20 dB of dynamic range at typical listening levels (73 dB at 4m), which comfortably covers most music without the tonal balance shifting as instruments and vocals peak. Off-axis behavior is consistent - toeing the speakers 20-30 degrees out doesn’t meaningfully change the in-room high-frequency character, so placement flexibility is good once you’ve dialed in the tonal balance. Measured bass extension of 60Hz (-3dB), with a measured sensitivity of 86dB.
Cons: Not a neutral speaker - has a persistent high-frequency boost/lift that makes it sound forward and bright, present whether pointed directly at the listener or toed out. A slightly nasal quality traced to a resonance around 1 kHz that EQ can address. The reviewer needed to trim treble by about 4 dB on his preamp to get the tonal balance he wanted, meaning most listeners will want equalization available to fully enjoy this speaker. At roughly the same $1,000ish price point, alternatives like the Ascend Acoustics Sierra 1 V2 measure more linear (with a tradeoff in distortion and crossover-region directivity), and the Dynaudio Emit 20 offers deeper bass extension and lower compression at the cost of a more deliberately colored tonal signature.
Full Sonus Faber Lumina II review and specifications →
| Bass Extension (-10dB) | 41Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 60Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 1800Hz |
| Dimensions | 12" x 7.1" x 10.4" (304 x 180 x 263 mm) |
| Drivers | 29mm DAD dome tweeter, 150mm paper cone mid-woofer |
| Frequency Response | 55Hz - 24kHz (manufacturer specified) |
| Impedance | 4 ohms nominal, 4.1 ohms minimum (measured, Erin's Audio Corner) |
| Recommended Power | 30W - 150W |
| Sensitivity | 86dB (measured average, Erin's Audio Corner; matches manufacturer spec) |
| Spinorama Preference Score | 3.04 |
| Spinorama Preference Score with Perfect Sub | 5.32 |
| Weight | 12.5 lbs (5.65 kg) each |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Sonus Faber Lumina II vs Polk Monitor XT20
- Sonus Faber Lumina II vs XTZ Spirit 4
- Sonus Faber Lumina II vs Focal Aria 906
- Sonus Faber Lumina II vs KEF Q3 Meta
- Sonus Faber Lumina II vs Revel Performa M22
- Sonus Faber Lumina II vs SVS Prime Bookshelf
- Sonus Faber Lumina II vs ELAC Debut 2.0 B6.2
- Sonus Faber Lumina II vs Dynaudio Special Forty
- See all 56 comparisons
Dynaudio Heritage Special: $7,000 per pair Safe and Sound HQ eBay
Pros: One of the rare cases where the reviewer measured a speaker as flawed but still genuinely enjoyed listening to it. A massive 4” voice coil on the midwoofer gives it exceptional output capability for a bookshelf speaker - averaged 100dB at 3.5 meters with no audible mechanical noise, port chuffing, or woofer bottoming even when deliberately pushed hard. Bass is very robust and doesn’t noticeably give up output as volume increases, staying solid at both low and high listening levels. Big, well-proportioned soundstage - wide without losing image focus. Limited run of 2,500 pairs with genuine collectible/heritage value; the tweeter (Esotar 3) and midwoofer both use premium Dynaudio-made drivers with an unusually wide, stout voice coil. Measured bass extension of 52Hz (-3dB), with a measured sensitivity of 85dB.
Cons: At lower listening volumes, dynamic range and kick-drum punch fell short of higher-sensitivity speakers the reviewer has tested (JBL 4367, KEF Reference 1 Meta) - the sheer output ceiling is impressive, but it isn’t a highly dynamic-sounding speaker at modest levels. A degree of “softness” in the upper mid-range. Selective sibilance in the 4-6kHz treble region that shows up on some tracks but not others, which the reviewer found mildly aggravating and would want to EQ down given the choice. Neither the tweeter nor the woofer is fully flush-mounted to the baffle, likely intentional as part of the heritage-styled look, but the reviewer wonders how much this affected linearity. At $7,000/pair MSRP (and a discontinued limited run, so used/open-box pricing around $5,000/pair is about the best you’ll do now), this is a serious investment for a bookshelf speaker.
Full Dynaudio Heritage Special review and specifications →
| Bass Extension (-10dB) | 38Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 52Hz (measured, Erin's Audio Corner) |
| Country | Denmark |
| Dimensions | 15.2"H x 8.2"W x 12.6"D (385 x 208 x 320 mm) |
| Discontinued | Yes (limited run of 2,500 pairs) |
| Drivers | 18cm MSP cone woofer, 28mm Esotar 3 dome tweeter |
| Impedance | 5.1 ohms minimum, ported mode (measured, Erin's Audio Corner) |
| Sensitivity | 85dB (measured at 2.83V/1m, Erin's Audio Corner) |
| Spinorama Preference Score | 3.43 |
| Spinorama Preference Score with Perfect Sub | 5.44 |
| Weight | 24.3 lbs (11 kg) each |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Dynaudio Heritage Special vs Radiant Acoustics Clarity 6.2
- Dynaudio Heritage Special vs MoFi SourcePoint 10
- Dynaudio Heritage Special vs Wharfedale Linton 85
- Dynaudio Heritage Special vs Wharfedale Super Linton
- Dynaudio Heritage Special vs Ascend Acoustics Sierra-LX
- Dynaudio Heritage Special vs Ascend Acoustics CMT-340 SE2
- Dynaudio Heritage Special vs Arendal 1528 Monitor 8
- Dynaudio Heritage Special vs Revel M126Be
- See all 47 comparisons