Short answer: the Revel F328Be for better sound quality, the Klipsch RP-8000F II for the lower price. The Revel F328Be ranks #8 of 68 floorstanding speakers at $13600. The Klipsch RP-8000F II ranks #52 at $1800, $11800 cheaper.
What the Klipsch RP-8000F II offers: Highest sensitivity of the RP II floorstander line (~92dB measured) and the best dynamics/compression behavior of the three under load - the cleanest at high output. Dual 8-inch woofers and the highest power handling in the line. Watch for: Mid-bass sounds lean despite the dual 8-inch woofers, and bass extension disappointed for its size - expected to reach 50Hz, didn’t get there in-room. Has its own edgy upper-mid bump (2-6kHz) that’s harder to EQ out than the other two models’ issues, since it stems from the vertical horn/woofer offset rather than simple tonal balance. The most placement-critical of the three, with the narrowest horizontal (~40-50 degrees) and vertical (+5/-10 degrees) dispersion.
What the Revel F328Be offers: CEA2034 spinorama shows a quite flat on-axis response with superb directivity and efficiency above 90dB. Predicted in-room response is extremely accurate, with a smooth ~5dB downward slope from bass to treble that suits typical rooms without correction. Early reflections sum very nicely with the direct sound. Horizontal beamwidth of about ±70 degrees is wide and quite smooth. At 96dB SPL/1m distortion stays easily below the reviewer’s audibility threshold across nearly the whole range. Watch for: Vertical directivity is asymmetric - the reviewer recommends staying between -20 and +40 degrees relative to the tweeter axis, reflecting the driver layout of this three-way tower. Impedance dips to a minimum of 3 ohms with an additional resonance-driven phase swing, calling for an amplifier comfortable with a demanding load. Very expensive and very heavy (51 kg each).
Buy the Klipsch RP-8000F II if the price matters more than sound quality. Buy the Revel F328Be if sound quality matters more than the price.
If sound quality matters at all to you, skip the Klipsch RP-8000F II. It ranks near the bottom of the 68 floorstanding speakers, so look higher up the list instead.
Specifications Side By Side
| Klipsch RP-8000F II | Revel F328Be | |
|---|---|---|
| Price | $1800 | $13600 |
| Ranked | #52 of 68 in Large Size Floorstanding Speakers | #8 of 68 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 33Hz (measured, Erin’s Audio Corner) | 39Hz (measured, Audio Science Review) |
| Bass Extension (-3dB) | 67Hz (measured, Erin’s Audio Corner) | 74Hz (measured, Audio Science Review) |
| Sensitivity | 92dB (2.83V/1m, measured by Erin’s Audio Corner) | 91dB (measured, Audio Science Review) |
| Drivers | 1" titanium tweeter with 90x90 Tractrix horn, dual 8" cerametallic woofers | Three 8" (200mm) Deep Ceramic Composite aluminum cones, with cast frames woofer, 5-1/4" (130mm) Deep Ceramic Composite aluminum cone, with cast frame midrange, 1" (25mm) Beryllium dome, with acoustic lens waveguide tweeter |
| Weight | 61.3 lbs / 27.8 kg | 112.4 lbs / 51 kg each |
| Impedance | 8 ohms nominal (3.7 ohms minimum above 80Hz, measured by Erin’s Audio Corner) | 8 ohms nominal (3 ohms minimum, measured by Audio Science Review) |
| Frequency Response | 35Hz - 25kHz (+-3dB, Manufacturer specified) | - |
| Crossover Frequency | 1630Hz | - |
| Output Power | 150W continuous, 600W peak | - |
| Dimensions | 43.1" x 10.8" x 18.3" (1095 x 275 x 464 mm) | 50.9"H x 13.5"W x 17.6"D (1292.9 x 342.9 x 447 mm) |
| Woofer Cabinet | ported, rear | ported, rear |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- KEF R5 Meta vs Endow Audio Bravura 7
- JBL HDI-3800 vs MoFi SourcePoint V10 Master Edition
- Revel F226Be vs JBL HDI-3800
- Revel F328Be vs Revel F206
- Dynaudio Emit 30 vs Revel F328Be
Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Klipsch RP-8000F II: $1800 Amazon eBay
Pros: Highest sensitivity of the RP II floorstander line (~92dB measured) and the best dynamics/compression behavior of the three under load - the cleanest at high output. Dual 8-inch woofers and the highest power handling in the line.
Cons: Mid-bass sounds lean despite the dual 8-inch woofers, and bass extension disappointed for its size - expected to reach 50Hz, didn’t get there in-room. Has its own edgy upper-mid bump (2-6kHz) that’s harder to EQ out than the other two models’ issues, since it stems from the vertical horn/woofer offset rather than simple tonal balance. The most placement-critical of the three, with the narrowest horizontal (~40-50 degrees) and vertical (+5/-10 degrees) dispersion.
Full Klipsch RP-8000F II review and specifications →
| Bass Extension (-10dB) | 33Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 67Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 1630Hz |
| Dimensions | 43.1" x 10.8" x 18.3" (1095 x 275 x 464 mm) |
| Drivers | 1" titanium tweeter with 90x90 Tractrix horn, dual 8" cerametallic woofers |
| Frequency Response | 35Hz - 25kHz (+-3dB, Manufacturer specified) |
| Impedance | 8 ohms nominal (3.7 ohms minimum above 80Hz, measured by Erin's Audio Corner) |
| Output Power | 150W continuous, 600W peak |
| Sensitivity | 92dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 61.3 lbs / 27.8 kg |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Klipsch RP-8000F II vs Dynaudio Emit 30
- Klipsch RP-8000F II vs Klipsch RP-6000F II
- Klipsch RP-8000F II vs SVS Ultra Evolution Pinnacle
- Klipsch RP-8000F II vs Polk T50
- Klipsch RP-8000F II vs Klipsch RP-5000F II
- Klipsch RP-8000F II vs KLH Model Five
- Klipsch RP-8000F II vs KEF Q11 Meta
- Klipsch RP-8000F II vs Focal Aria Evo X N°2
- See all 36 comparisons
Revel F328Be: $13600 Crutchfield eBay
Pros: CEA2034 spinorama shows a quite flat on-axis response with superb directivity and efficiency above 90dB. Predicted in-room response is extremely accurate, with a smooth ~5dB downward slope from bass to treble that suits typical rooms without correction. Early reflections sum very nicely with the direct sound. Horizontal beamwidth of about ±70 degrees is wide and quite smooth. At 96dB SPL/1m distortion stays easily below the reviewer’s audibility threshold across nearly the whole range.
Cons: Vertical directivity is asymmetric - the reviewer recommends staying between -20 and +40 degrees relative to the tweeter axis, reflecting the driver layout of this three-way tower. Impedance dips to a minimum of 3 ohms with an additional resonance-driven phase swing, calling for an amplifier comfortable with a demanding load. Very expensive and very heavy (51 kg each).
Full Revel F328Be review and specifications →
| Bass Extension (-10dB) | 39Hz (measured, Audio Science Review) |
|---|---|
| Bass Extension (-3dB) | 74Hz (measured, Audio Science Review) |
| Dimensions | 50.9"H x 13.5"W x 17.6"D (1292.9 x 342.9 x 447 mm) |
| Drivers | Three 8" (200mm) Deep Ceramic Composite aluminum cones, with cast frames woofer, 5-1/4" (130mm) Deep Ceramic Composite aluminum cone, with cast frame midrange, 1" (25mm) Beryllium dome, with acoustic lens waveguide tweeter |
| Impedance | 8 ohms nominal (3 ohms minimum, measured by Audio Science Review) |
| Sensitivity | 91dB (measured, Audio Science Review) |
| Weight | 112.4 lbs / 51 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons