Short answer: the KEF R5 for better sound quality, the Klipsch RP-8000F II for the lower price. The KEF R5 ranks #10 of 68 floorstanding speakers at $2999. The Klipsch RP-8000F II ranks #52 at $1800, $1199 cheaper.
What the Klipsch RP-8000F II offers: Highest sensitivity of the RP II floorstander line (~92dB measured) and the best dynamics/compression behavior of the three under load - the cleanest at high output. Dual 8-inch woofers and the highest power handling in the line. Watch for: Mid-bass sounds lean despite the dual 8-inch woofers, and bass extension disappointed for its size - expected to reach 50Hz, didn’t get there in-room. Has its own edgy upper-mid bump (2-6kHz) that’s harder to EQ out than the other two models’ issues, since it stems from the vertical horn/woofer offset rather than simple tonal balance. The most placement-critical of the three, with the narrowest horizontal (~40-50 degrees) and vertical (+5/-10 degrees) dispersion.
What the KEF R5 offers: Slim three-way tower with the acoustic advantages of KEF’s coincident Uni-Q midrange/tweeter: horizontal and vertical off-axis responses track the direct sound smoothly, producing stable imaging and a well-behaved directivity index. Erin measured deep low-frequency reach for the cabinet width—77Hz F3 but 33Hz F10—and less than 1% harmonic distortion at 86dB. At 96dB it remains clean when high-passed, and its mild response deviations are suitable for equalization because the radiation pattern stays orderly. Watch for: The unusual gap between 77Hz F3 and 33Hz F10 indicates a gradual bass contour rather than flat deep-bass output; a subwoofer and roughly 80Hz high-pass are recommended for high-level playback. Erin measured a minimum near 3.5 ohms around 150Hz, although most of the curve remains above 4 ohms, so amplifier quality still matters. Sensitivity is approximately 86dB/2.83V/1m. At 102dB, compression reaches roughly 1dB around 150Hz, showing the limits of the twin 5.25-inch woofers. This original model lacks the Meta version’s MAT rear-wave absorption.
Buy the Klipsch RP-8000F II if the price matters more than sound quality. Buy the KEF R5 if sound quality matters more than the price.
If sound quality matters at all to you, skip the Klipsch RP-8000F II. It ranks near the bottom of the 68 floorstanding speakers, so look higher up the list instead.
Specifications Side By Side
| Klipsch RP-8000F II | KEF R5 | |
|---|---|---|
| Price | $1800 | $2,999/pair Discontinued |
| Ranked | #52 of 68 in Large Size Floorstanding Speakers | #10 of 68 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 33Hz (measured, Erin’s Audio Corner) | 33Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 67Hz (measured, Erin’s Audio Corner) | 77Hz (measured, Erin’s Audio Corner) |
| Sensitivity | 92dB (2.83V/1m, measured by Erin’s Audio Corner) | Approximately 86dB/2.83V/1m (measured, Erin’s Audio Corner) |
| Drivers | 1" titanium tweeter with 90x90 Tractrix horn, dual 8" cerametallic woofers | 1" aluminum tweeter coaxial with 5" midrange; dual 5.25" woofers |
| Weight | 61.3 lbs / 27.8 kg | 59.5 lb each |
| Impedance | 8 ohms nominal (3.7 ohms minimum above 80Hz, measured by Erin’s Audio Corner) | Approximately 3.5 ohms minimum near 150Hz (measured, Erin’s Audio Corner) |
| Frequency Response | 35Hz - 25kHz (+-3dB, Manufacturer specified) | - |
| Crossover Frequency | 1630Hz | - |
| Output Power | 150W continuous, 600W peak | - |
| Dimensions | 43.1" x 10.8" x 18.3" (1095 x 275 x 464 mm) | 40.4"H x 6.9"W x 13.5"D |
| Woofer Cabinet | ported, rear | ported, rear |
| Discontinued | - | Yes |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- KEF R11 Meta vs Dynaudio Emit 30
- KEF R5 Meta vs Focal Chora 816
- KEF R5 Meta vs Revel Concerta2 F35
- Klipsch Heresy IV vs Klipsch RP-8000F II
- KEF R5 vs Revel F206
Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Klipsch RP-8000F II: $1800 Amazon eBay
Pros: Highest sensitivity of the RP II floorstander line (~92dB measured) and the best dynamics/compression behavior of the three under load - the cleanest at high output. Dual 8-inch woofers and the highest power handling in the line.
Cons: Mid-bass sounds lean despite the dual 8-inch woofers, and bass extension disappointed for its size - expected to reach 50Hz, didn’t get there in-room. Has its own edgy upper-mid bump (2-6kHz) that’s harder to EQ out than the other two models’ issues, since it stems from the vertical horn/woofer offset rather than simple tonal balance. The most placement-critical of the three, with the narrowest horizontal (~40-50 degrees) and vertical (+5/-10 degrees) dispersion.
Full Klipsch RP-8000F II review and specifications →
| Bass Extension (-10dB) | 33Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 67Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 1630Hz |
| Dimensions | 43.1" x 10.8" x 18.3" (1095 x 275 x 464 mm) |
| Drivers | 1" titanium tweeter with 90x90 Tractrix horn, dual 8" cerametallic woofers |
| Frequency Response | 35Hz - 25kHz (+-3dB, Manufacturer specified) |
| Impedance | 8 ohms nominal (3.7 ohms minimum above 80Hz, measured by Erin's Audio Corner) |
| Output Power | 150W continuous, 600W peak |
| Sensitivity | 92dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 61.3 lbs / 27.8 kg |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Klipsch RP-8000F II vs Dynaudio Emit 30
- Klipsch RP-8000F II vs Klipsch RP-6000F II
- Klipsch RP-8000F II vs SVS Ultra Evolution Pinnacle
- Klipsch RP-8000F II vs Polk T50
- Klipsch RP-8000F II vs Klipsch RP-5000F II
- Klipsch RP-8000F II vs KLH Model Five
- Klipsch RP-8000F II vs KEF Q11 Meta
- Klipsch RP-8000F II vs Focal Aria Evo X N°2
- See all 36 comparisons
KEF R5: $2,999/pair Discontinued eBay
Pros: Slim three-way tower with the acoustic advantages of KEF’s coincident Uni-Q midrange/tweeter: horizontal and vertical off-axis responses track the direct sound smoothly, producing stable imaging and a well-behaved directivity index. Erin measured deep low-frequency reach for the cabinet width—77Hz F3 but 33Hz F10—and less than 1% harmonic distortion at 86dB. At 96dB it remains clean when high-passed, and its mild response deviations are suitable for equalization because the radiation pattern stays orderly.
Cons: The unusual gap between 77Hz F3 and 33Hz F10 indicates a gradual bass contour rather than flat deep-bass output; a subwoofer and roughly 80Hz high-pass are recommended for high-level playback. Erin measured a minimum near 3.5 ohms around 150Hz, although most of the curve remains above 4 ohms, so amplifier quality still matters. Sensitivity is approximately 86dB/2.83V/1m. At 102dB, compression reaches roughly 1dB around 150Hz, showing the limits of the twin 5.25-inch woofers. This original model lacks the Meta version’s MAT rear-wave absorption. Discontinued.
Full KEF R5 review and specifications →
| Bass Extension (-10dB) | 33Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 77Hz (measured, Erin's Audio Corner) |
| Dimensions | 40.4"H x 6.9"W x 13.5"D |
| Discontinued | Yes |
| Drivers | 1" aluminum tweeter coaxial with 5" midrange; dual 5.25" woofers |
| Impedance | Approximately 3.5 ohms minimum near 150Hz (measured, Erin's Audio Corner) |
| Sensitivity | Approximately 86dB/2.83V/1m (measured, Erin's Audio Corner) |
| Weight | 59.5 lb each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons