Short answer: the Klipsch RP-500M II. It ranks #27 of 160 bookshelf speakers by sound quality, rated 4.0/5, at $389.99. The Klipsch R-41M ranks #158, rated 1.3/5, at $141.55, $248.44 cheaper, a saving that is not big enough to make up the sound-quality gap.
The Klipsch RP-500M II is the more accurate, deeper-bass option. Major mid-range clarity improvement over the original Klipsch RP-500M: about a 5dB fill-in between 1-3kHz in the estimated in-room response, giving a noticeably more resolved, detailed midrange. Its measured preference score, a predictor of how neutral it sounds, is 5.22 against 3.04 for the Klipsch R-41M. Its bass reaches about 67Hz before falling 3dB, against 80Hz for the Klipsch R-41M. The catch: Klipsch’s quoted sensitivity (around 92-93dB) uses an unconventional in-room-based rating rather than the standard anechoic measurement; on an anechoic basis it measures closer to about 85dB, in line with typical bookshelf speakers this size, so it isn’t the outlier in efficiency the spec sheet implies.
What the Klipsch R-41M does well: Binding posts are unusually nice for the price point, and impedance is well controlled in the bass, easing the load on the amplifier. Watch for: CEA2034 spinorama shows a sharp, prominent peak around 1kHz that the reviewer compared to “Pinocchio’s nose,” plus poor directivity that makes the off-axis sound diverge sharply from on-axis.
Buy the Klipsch RP-500M II. It is rated higher for sound quality, and the $248.44 saving on the Klipsch R-41M is not enough to make up the difference.
Want more options? Browse the full Passive Home rankings.
Specifications Side By Side
| Klipsch RP-500M II | Klipsch R-41M | |
|---|---|---|
| Price | $389.99 per pair | $141.55 per pair |
| Ranked | #27 of 160 in Medium Size Bookshelf Speakers | #158 of 160 in Medium Size Bookshelf Speakers |
| Bass Extension (-10dB) | 53Hz (measured, Erin’s Audio Corner) | 55Hz (measured, Audio Science Review) |
| Bass Extension (-3dB) | 67Hz (measured, Erin’s Audio Corner) | 80Hz (measured, Audio Science Review) |
| Crossover Frequency | 1530Hz | - |
| Dimensions | 13.6”H x 6.8”W x 10.6”D (344.4 x 173 x 270.5 mm) | 11.3H x 5.75W x 7.9D in |
| Impedance | 8 ohms nominal, 3.3 ohms minimum (measured, Erin’s Audio Corner) | 8 ohms nominal (per spec; measured lower) |
| Sensitivity | 85dB (measured, Erin’s Audio Corner) | 85dB (2.83V/1m, measured) |
| Drivers | 5.25” Cerametallic™ cone woofer with Faraday rings, 1” LTS Titanium diaphragm tweeter with Hybrid Cross-Section Expanded Tractrix® horn | 4” spun-copper IMG woofer, 1” Tractrix horn-loaded aluminum dome tweeter |
| Weight | 13 lbs (5.9 kg) each | 7 lbs (3.18 kg) each |
| Woofer Cabinet | ported, rear | ported, rear |
| Spinorama Preference Score | 5.22 | 3.04 (spinorama.org) |
| Spinorama Preference Score with Perfect Sub | 7.84 | 6.03 (spinorama.org) |
| DIY Kit | No | No |
| Frequency Response | - | 68Hz - 21kHz (Manufacturer specified) |
| Power Handling | - | 50W RMS / 200W peak |
Related Speaker Comparisons
How Klipsch RP-500M II compares with other leading options:
- Klipsch RP-500M II vs Audio First Fidelia
- Ascend Sierra 1 v2 vs Klipsch RP-500M II
- KEF LS50 Meta vs Klipsch RP-500M II
- Arendal 1961 Monitor vs Klipsch RP-500M II
- Klipsch RP-500M II vs Moondrop M4P MTM
Prices on this page were last checked October 9, 2026 at 8:01 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Klipsch RP-500M II: $389.99 per pair Amazon eBay
Older model: the Klipsch RP-500M (ranked lower, rated 3.4/5).
Same family: the Klipsch RP-600M II (larger bookshelf, rated 3.7/5), the Klipsch RP-5000F II (smallest floorstanding, rated 4/5), the Klipsch RP-6000F II (floorstanding, rated 3.9/5), the Klipsch RP-8000F II (largest floorstanding, rated 3.9/5), the Klipsch RP-404C II (smallest center, rated 3.7/5), the Klipsch RP-500C II (center, rated 3.9/5) and the Klipsch RP-504C II (largest center, rated 3.8/5).
Pros: Major mid-range clarity improvement over the original Klipsch RP-500M: about a 5dB fill-in between 1-3kHz in the estimated in-room response, giving a noticeably more resolved, detailed midrange. More neutral and linear overall than its sibling Klipsch RP-600M II, which carries about 2-3dB more high-frequency energy and a touch more bass but less overall balance. Very precise soundstage imaging and instrument placement. Distortion through the midrange is cleaner than the previous generation. Measured bass extension of 67Hz (-3dB), with a measured sensitivity of 85dB.
Cons: Klipsch’s quoted sensitivity (around 92-93dB) uses an unconventional in-room-based rating rather than the standard anechoic measurement; on an anechoic basis it measures closer to about 85dB, in line with typical bookshelf speakers this size, so it isn’t the outlier in efficiency the spec sheet implies. Horizontal dispersion of about ±40-50° is narrower and more directive than the reviewer’s preference for a wider, more enveloping soundstage. Toeing the speaker out to widen the soundstage or soften on-axis brightness comes at some cost to imaging precision. Slightly less clean in the tweeter region than the midrange, likely tied to crossover placement, though not considered a dealbreaker. Low-frequency output is limited: measured around 95dB at 4 meters for the pair before the woofers started to unload, so a subwoofer is recommended for anyone wanting real bass rather than stepping up to a larger model.
Full Klipsch RP-500M II review and specifications →
| Bass Extension (-10dB) | 53Hz (measured, Erin’s Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 67Hz (measured, Erin’s Audio Corner) |
| Crossover Frequency | 1530Hz |
| DIY Kit | No |
| Dimensions | 13.6”H x 6.8”W x 10.6”D (344.4 x 173 x 270.5 mm) |
| Drivers | 5.25” Cerametallic™ cone woofer with Faraday rings, 1” LTS Titanium diaphragm tweeter with Hybrid Cross-Section Expanded Tractrix® horn |
| Impedance | 8 ohms nominal, 3.3 ohms minimum (measured, Erin’s Audio Corner) |
| Sensitivity | 85dB (measured, Erin’s Audio Corner) |
| Spinorama Preference Score | 5.22 |
| Spinorama Preference Score with Perfect Sub | 7.84 |
| Weight | 13 lbs (5.9 kg) each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Klipsch RP-500M II vs Wharfedale Super Denton
- Klipsch RP-500M II vs Wharfedale Diamond 12.1
- Klipsch RP-500M II vs Monitor Audio Silver 50 7G
- Klipsch RP-500M II vs Revel M105
- Klipsch RP-500M II vs Radiant Acoustics Clarity 4.2
- Klipsch RP-500M II vs Moondrop M4P MTM
- Klipsch RP-500M II vs Arendal 1961 Monitor
- Klipsch RP-500M II vs KEF Q150
- See all 39 comparisons
Klipsch R-41M: $141.55 per pair Amazon eBay
Newer model: the Klipsch Reference R-40M, ranked higher, estimated 1.4/5.
Same family: the Klipsch R-51M (larger bookshelf, ranked higher, rated 1.6/5).
Pros: Binding posts are unusually nice for the price point, and impedance is well controlled in the bass, easing the load on the amplifier. The horn-loaded tweeter can play loud without strain. Measured bass extension of 80Hz (-3dB), with a measured sensitivity of 85dB.
Cons: CEA2034 spinorama shows a sharp, prominent peak around 1kHz that the reviewer compared to “Pinocchio’s nose,” plus poor directivity that makes the off-axis sound diverge sharply from on-axis. Sensitivity is only 85dB through most of the music-energy range despite Klipsch’s horn-loaded reputation for efficiency. In an A/B against a $118/pair Pioneer SP-BS22-LR, the R-41M had “no bass” and all mid-to-treble energy; the reviewer’s verdict was “please avoid the Klipsch R-41M unless you just want a speaker as an ornament.”
Full Klipsch R-41M review and specifications →
| Bass Extension (-10dB) | 55Hz (measured, Audio Science Review) |
|---|---|
| Bass Extension (-3dB) | 80Hz (measured, Audio Science Review) |
| DIY Kit | No |
| Dimensions | 11.3H x 5.75W x 7.9D in |
| Drivers | 4” spun-copper IMG woofer, 1” Tractrix horn-loaded aluminum dome tweeter |
| Frequency Response | 68Hz - 21kHz (Manufacturer specified) |
| Impedance | 8 ohms nominal (per spec; measured lower) |
| Power Handling | 50W RMS / 200W peak |
| Sensitivity | 85dB (2.83V/1m, measured) |
| Spinorama Preference Score | 3.04 (spinorama.org) |
| Spinorama Preference Score with Perfect Sub | 6.03 (spinorama.org) |
| Weight | 7 lbs (3.18 kg) each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Klipsch R-41M vs PMC twenty.21
- Klipsch R-41M vs Pioneer Elite SP-EBS73-LR
- Klipsch R-41M vs Definitive Technology ProMonitor 1000
- Klipsch R-41M vs Polk T15
- Klipsch R-41M vs JBL Control 1 Pro
- Klipsch R-41M vs Fluance Signature HFS
- Klipsch R-41M vs JBL Stage A130
- Klipsch R-41M vs Q Acoustics 5020
- See all 24 comparisons