Short answer: the Revel F328Be for better sound quality, the Klipsch Heresy IV for the lower price. The Revel F328Be ranks #8 of 71 floorstanding speakers at $13600. The Klipsch Heresy IV ranks #44 at $3198, $10402 cheaper.
What the Klipsch Heresy IV offers: Very high 94.5dB/2.83V/1m sensitivity in Erin’s anechoic measurement—well below Klipsch’s 99dB in-room claim, but still excellent—and strong short-term output from a 12-inch woofer plus horn-loaded midrange and tweeter. The compact, furniture-grade Heritage cabinet is easier to place than most high-efficiency designs, and dynamics at moderate levels can sound lively. A stable four-ohm-capable amplifier can produce substantial SPL with relatively little voltage. Watch for: Erin measured a 77Hz F3 and response rolling away near 100Hz in-room, so a subwoofer is required for modern full-range reproduction. The impedance dips to about 4 ohms, reducing the practical amplifier advantage implied by its sensitivity. Pronounced directivity mismatch at the driver transitions, impedance/response resonances and elevated distortion spikes around the crossover remain audible concerns that EQ cannot fully solve. At 102dB Erin measured roughly 1.5dB midband compression; at 96dB distortion rises around crossover. Performance is difficult to justify at the price, and Erin explicitly did not recommend it.
What the Revel F328Be offers: CEA2034 spinorama shows a quite flat on-axis response with superb directivity and efficiency above 90dB. Predicted in-room response is extremely accurate, with a smooth ~5dB downward slope from bass to treble that suits typical rooms without correction. Early reflections sum very nicely with the direct sound. Horizontal beamwidth of about ±70 degrees is wide and quite smooth. At 96dB SPL/1m distortion stays easily below the reviewer’s audibility threshold across nearly the whole range. Watch for: Vertical directivity is asymmetric - the reviewer recommends staying between -20 and +40 degrees relative to the tweeter axis, reflecting the driver layout of this three-way tower. Impedance dips to a minimum of 3 ohms with an additional resonance-driven phase swing, calling for an amplifier comfortable with a demanding load. Very expensive and very heavy (51 kg each).
Buy the Klipsch Heresy IV if the price matters more than sound quality. Buy the Revel F328Be if sound quality matters more than the price.
Specifications Side By Side
| Klipsch Heresy IV | Revel F328Be | |
|---|---|---|
| Price | $3,198/pair | $13600 |
| Ranked | #44 of 71 in Large Size Floorstanding Speakers | #8 of 71 in Large Size Floorstanding Speakers |
| Bass Extension (-3dB) | 77Hz (measured, Erin’s Audio Corner) | 74Hz (measured, Audio Science Review) |
| Bass Extension (-10dB) | 50.0Hz (measured, Erin’s Audio Corner) | 39Hz (measured, Audio Science Review) |
| Sensitivity | 94.5dB/2.83V/1m (measured, Erin’s Audio Corner) | 91dB (measured, Audio Science Review) |
| Impedance | Approximately 4 ohms minimum (measured, Erin’s Audio Corner) | 8 ohms nominal (3 ohms minimum, measured by Audio Science Review) |
| Drivers | 1" horn-loaded tweeter; 1.75" horn-loaded midrange; 12" woofer | Three 8" (200mm) Deep Ceramic Composite aluminum cones, with cast frames woofer, 5-1/4" (130mm) Deep Ceramic Composite aluminum cone, with cast frame midrange, 1" (25mm) Beryllium dome, with acoustic lens waveguide tweeter |
| Dimensions | 24.8"H x 15.6"W x 13.3"D | 50.9"H x 13.5"W x 17.6"D (1292.9 x 342.9 x 447 mm) |
| Weight | 45 lb each | 112.4 lbs / 51 kg each |
| Woofer Cabinet | ported, rear | ported, rear |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- KEF R5 Meta vs Endow Audio Bravura 7
- KEF R5 Meta vs JBL 4367
- JBL HDI-3800 vs JBL 4367
- Revel F328Be vs KEF R5
- KEF R11 Meta vs Revel F328Be
Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Klipsch Heresy IV: $3,198/pair Amazon Crutchfield eBay
Pros: Very high 94.5dB/2.83V/1m sensitivity in Erin’s anechoic measurement—well below Klipsch’s 99dB in-room claim, but still excellent—and strong short-term output from a 12-inch woofer plus horn-loaded midrange and tweeter. The compact, furniture-grade Heritage cabinet is easier to place than most high-efficiency designs, and dynamics at moderate levels can sound lively. A stable four-ohm-capable amplifier can produce substantial SPL with relatively little voltage.
Cons: Erin measured a 77Hz F3 and response rolling away near 100Hz in-room, so a subwoofer is required for modern full-range reproduction. The impedance dips to about 4 ohms, reducing the practical amplifier advantage implied by its sensitivity. Pronounced directivity mismatch at the driver transitions, impedance/response resonances and elevated distortion spikes around the crossover remain audible concerns that EQ cannot fully solve. At 102dB Erin measured roughly 1.5dB midband compression; at 96dB distortion rises around crossover. Performance is difficult to justify at the price, and Erin explicitly did not recommend it.
Full Klipsch Heresy IV review and specifications →
| Bass Extension (-10dB) | 50.0Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 77Hz (measured, Erin's Audio Corner) |
| Dimensions | 24.8"H x 15.6"W x 13.3"D |
| Drivers | 1" horn-loaded tweeter; 1.75" horn-loaded midrange; 12" woofer |
| Impedance | Approximately 4 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 94.5dB/2.83V/1m (measured, Erin's Audio Corner) |
| Weight | 45 lb each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Klipsch Heresy IV vs Polk Audio XT60
- Klipsch Heresy IV vs KEF Q11 Meta
- Klipsch Heresy IV vs Klipsch Forte IV
- Klipsch Heresy IV vs Infinity Primus 360
- Klipsch Heresy IV vs Klipsch RP-5000F II
- Klipsch Heresy IV vs SVS Ultra Evolution Pinnacle
- Klipsch Heresy IV vs Definitive Technology BP-9020
- Klipsch Heresy IV vs Polk Reserve R500
- See all 38 comparisons
Revel F328Be: $13600 Crutchfield eBay
Pros: CEA2034 spinorama shows a quite flat on-axis response with superb directivity and efficiency above 90dB. Predicted in-room response is extremely accurate, with a smooth ~5dB downward slope from bass to treble that suits typical rooms without correction. Early reflections sum very nicely with the direct sound. Horizontal beamwidth of about ±70 degrees is wide and quite smooth. At 96dB SPL/1m distortion stays easily below the reviewer’s audibility threshold across nearly the whole range.
Cons: Vertical directivity is asymmetric - the reviewer recommends staying between -20 and +40 degrees relative to the tweeter axis, reflecting the driver layout of this three-way tower. Impedance dips to a minimum of 3 ohms with an additional resonance-driven phase swing, calling for an amplifier comfortable with a demanding load. Very expensive and very heavy (51 kg each).
Full Revel F328Be review and specifications →
| Bass Extension (-10dB) | 39Hz (measured, Audio Science Review) |
|---|---|
| Bass Extension (-3dB) | 74Hz (measured, Audio Science Review) |
| Dimensions | 50.9"H x 13.5"W x 17.6"D (1292.9 x 342.9 x 447 mm) |
| Drivers | Three 8" (200mm) Deep Ceramic Composite aluminum cones, with cast frames woofer, 5-1/4" (130mm) Deep Ceramic Composite aluminum cone, with cast frame midrange, 1" (25mm) Beryllium dome, with acoustic lens waveguide tweeter |
| Impedance | 8 ohms nominal (3 ohms minimum, measured by Audio Science Review) |
| Sensitivity | 91dB (measured, Audio Science Review) |
| Weight | 112.4 lbs / 51 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons