Short answer: the KEF R11 Meta for better sound quality, the Klipsch RP-6000F II for the lower price. The KEF R11 Meta ranks #26 of 68 floorstanding speakers at $3499.99. The Klipsch RP-6000F II ranks #54 at $1500, $1999.99 cheaper.
What the KEF R11 Meta offers: CEA2034 spinorama shows a generally flat on-axis response with good directivity and very deep bass extension (F10 of 30Hz). Predicted in-room response is very smooth aside from the small 1-1.5kHz dip. The coaxial Uni-Q driver gives excellent, symmetric vertical directivity, unusual for a tower speaker. Distortion is incredibly low even down to 30Hz at 86dB SPL/1m, and stays low even at 96dB and 102dB SPL/1m - the reviewer found essentially no audible tonality change across that whole output range. Watch for: A dip around 1-1.2kHz on-axis is attributed to a diffraction effect, and shows up as a smaller dip in the predicted in-room response. Horizontal beamwidth of about ±40 degrees is on the narrower side, though the transition from wide to constant directivity is smooth. Minimum impedance dips to 3.2 ohms around 580Hz, calling for an amplifier comfortable with a demanding load. 4-ohm nominal impedance overall.
What the Klipsch RP-6000F II offers: Highest power handling and clean, well-behaved compression at typical volumes. Precise imaging from the controlled horn directivity. Watch for: Worse baffle-step coloration than the smaller RP-5000F II (3-4dB swing vs 2dB), plus a sibilance issue the 5000F doesn’t have - a real regression in tonal balance despite the higher price. Bass extension is mixed - less deep at -3dB (67Hz) than the 5000F - and needs a subwoofer regardless. Narrow horizontal dispersion (~50-60 degrees).
Buy the KEF R11 Meta if sound quality matters more than the price. Buy the Klipsch RP-6000F II if the price matters more than sound quality.
If sound quality matters at all to you, skip the Klipsch RP-6000F II. It ranks near the bottom of the 68 floorstanding speakers, so look higher up the list instead.
Specifications Side By Side
| KEF R11 Meta | Klipsch RP-6000F II | |
|---|---|---|
| Price | $3,499.99 | $1500 |
| Ranked | #26 of 68 in Large Size Floorstanding Speakers | #54 of 68 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 31Hz (measured, Audio Science Review) | 33Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 64Hz (measured, Audio Science Review) | 67Hz (measured, Erin’s Audio Corner) |
| Dimensions | 51"H x 12.2"W x 15.1"D (1295.4 x 309.9 x 383.5 mm) | 39.6" x 9.3" x 17.6" (1006 x 236 x 446 mm) |
| Impedance | 4 ohms | 8 ohms nominal (3.7 ohms minimum, measured, Erin’s Audio Corner) |
| Drivers | 4 x 165 mm (6.5 in.) hybrid aluminium cone woofers, 125 mm (5 in.) aluminium cone midrange, 25 mm (1 in.) vented aluminium dome with MAT tweeter | 1" titanium tweeter with Tractrix horn, dual 6.5" cerametallic woofers |
| Sensitivity | 89.5dB | 90dB (2.83V/1m, measured by Erin’s Audio Corner) |
| Weight | 80.5 lbs / 36.5 kg each | 49.4 lbs / 22.4 kg |
| Woofer Cabinet | ported, rear | ported, rear |
| Frequency Response | - | 38Hz - 25kHz (+-3dB, Manufacturer specified) |
| Crossover Frequency | - | 1770Hz |
| Output Power | - | 125W continuous, 500W peak |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- JBL HDI-3600 vs Dynaudio Emit 30
- SVS Ultra Evolution Pinnacle vs Polk T50
- Arendal 1961 Tower vs PSB Imagine T65
- KEF R11 Meta vs Magnepan LRS+
- KEF R11 Meta vs Dynaudio Emit 30
Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
KEF R11 Meta: $3,499.99 Amazon eBay
Pros: CEA2034 spinorama shows a generally flat on-axis response with good directivity and very deep bass extension (F10 of 30Hz). Predicted in-room response is very smooth aside from the small 1-1.5kHz dip. The coaxial Uni-Q driver gives excellent, symmetric vertical directivity, unusual for a tower speaker. Distortion is incredibly low even down to 30Hz at 86dB SPL/1m, and stays low even at 96dB and 102dB SPL/1m - the reviewer found essentially no audible tonality change across that whole output range.
Cons: A dip around 1-1.2kHz on-axis is attributed to a diffraction effect, and shows up as a smaller dip in the predicted in-room response. Horizontal beamwidth of about ±40 degrees is on the narrower side, though the transition from wide to constant directivity is smooth. Minimum impedance dips to 3.2 ohms around 580Hz, calling for an amplifier comfortable with a demanding load. 4-ohm nominal impedance overall.
Full KEF R11 Meta review and specifications →
| Bass Extension (-10dB) | 31Hz (measured, Audio Science Review) |
|---|---|
| Bass Extension (-3dB) | 64Hz (measured, Audio Science Review) |
| Dimensions | 51"H x 12.2"W x 15.1"D (1295.4 x 309.9 x 383.5 mm) |
| Drivers | 4 x 165 mm (6.5 in.) hybrid aluminium cone woofers, 125 mm (5 in.) aluminium cone midrange, 25 mm (1 in.) vented aluminium dome with MAT tweeter |
| Impedance | 4 ohms |
| Sensitivity | 89.5dB |
| Weight | 80.5 lbs / 36.5 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
Klipsch RP-6000F II: $1500 Amazon eBay
Pros: Highest power handling and clean, well-behaved compression at typical volumes. Precise imaging from the controlled horn directivity.
Cons: Worse baffle-step coloration than the smaller RP-5000F II (3-4dB swing vs 2dB), plus a sibilance issue the 5000F doesn’t have - a real regression in tonal balance despite the higher price. Bass extension is mixed - less deep at -3dB (67Hz) than the 5000F - and needs a subwoofer regardless. Narrow horizontal dispersion (~50-60 degrees).
Full Klipsch RP-6000F II review and specifications →
| Bass Extension (-10dB) | 33Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 67Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 1770Hz |
| Dimensions | 39.6" x 9.3" x 17.6" (1006 x 236 x 446 mm) |
| Drivers | 1" titanium tweeter with Tractrix horn, dual 6.5" cerametallic woofers |
| Frequency Response | 38Hz - 25kHz (+-3dB, Manufacturer specified) |
| Impedance | 8 ohms nominal (3.7 ohms minimum, measured, Erin's Audio Corner) |
| Output Power | 125W continuous, 500W peak |
| Sensitivity | 90dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 49.4 lbs / 22.4 kg |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Klipsch RP-6000F II vs Dynaudio Emit 30
- Klipsch RP-6000F II vs Polk T50
- Klipsch RP-6000F II vs Klipsch RP-8000F II
- Klipsch RP-6000F II vs Focal Aria Evo X N°2
- Klipsch RP-6000F II vs Sony SS-CS3
- Klipsch RP-6000F II vs SVS Ultra Evolution Pinnacle
- Klipsch RP-6000F II vs Klipsch RP-5000F II
- Klipsch RP-6000F II vs Infinity Reference 253
- See all 19 comparisons