Short answer: the Klipsch RP-500M II for better sound quality, the JBL Stage A120 for the lower price. The Klipsch RP-500M II ranks #17 of 71 bookshelf speakers at $389.99. The JBL Stage A120 ranks #51 at $299, $90.99 cheaper.
What the JBL Stage A120 offers: Comes with a port bung, letting you experiment between ported and sealed configurations - the reviewer found the sound improved somewhat with the port sealed. Distortion at 96dB is broadly comparable to competitors in this price range outside of some elevated low-end THD. Wide horizontal radiation pattern for a compact bookshelf speaker in the low-to-midrange. Watch for: A pronounced “Batman”-shaped frequency response: boosted bass, a scooped midrange, and elevated treble (about 3-4dB above the midrange), driven partly by confirmed cabinet panel resonance around 800Hz-1.7kHz. Directivity shows significant back-to-back peaks and dips, making the speaker harder to correct with EQ since the off-axis sound doesn’t track the direct sound cleanly. Elevated treble that some might call “detailed” reads as an unwelcome boost to the reviewer rather than genuine resolution. Compression testing shows the low end degrading substantially at high output (102dB). Overall considered one of the weaker speakers the reviewer has tested in this class, with a competing model (Emotiva Airmotiv B1+) recommended instead at a similar price.
What the Klipsch RP-500M II offers: Major mid-range clarity improvement over the original RP-500M: about a 5dB fill-in between 1-3kHz in the estimated in-room response, giving a noticeably more resolved, detailed midrange. More neutral and linear overall than its sibling RP-600M II, which carries about 2-3dB more high-frequency energy and a touch more bass but less overall balance. Very precise soundstage imaging and instrument placement. Distortion through the midrange is cleaner than the previous generation. Watch for: Klipsch’s quoted sensitivity (around 92-93dB) uses an unconventional in-room-based rating rather than the standard anechoic measurement; on an anechoic basis it measures closer to about 85dB, in line with typical bookshelf speakers this size, so it isn’t the outlier in efficiency the spec sheet implies. Horizontal dispersion of about ±40-50° is narrower and more directive than the reviewer’s preference for a wider, more enveloping soundstage. Toeing the speaker out to widen the soundstage or soften on-axis brightness comes at some cost to imaging precision. Slightly less clean in the tweeter region than the midrange, likely tied to crossover placement, though not considered a dealbreaker. Low-frequency output is limited - measured around 95dB at 4 meters for the pair before the woofers started to unload, so a subwoofer is recommended for anyone wanting real bass rather than stepping up to a larger model.
Buy the JBL Stage A120 if the price matters more than sound quality. Buy the Klipsch RP-500M II if sound quality matters more than the price.
Specifications Side By Side
| JBL Stage A120 | Klipsch RP-500M II | |
|---|---|---|
| Price | $299 Discontinued | $389.99 |
| Ranked | #51 of 71 in Medium Size Bookshelf Speakers | #17 of 71 in Medium Size Bookshelf Speakers |
| Drivers | 0.75" tweeter + 5" woofer | 5.25" Cerametallic™ cone woofer with Faraday rings, 1" LTS Titanium diaphragm tweeter with Hybrid Cross-Section Expanded Tractrix® horn |
| Discontinued | Yes | - |
| Weight | 10.6 lbs / 4.8 kg | 13 lbs / 5.9 kg each |
| Woofer Cabinet | ported | ported, rear |
| Sensitivity | 83dB (measured, Erin’s Audio Corner) | 85dB (measured, Erin’s Audio Corner) |
| Impedance | 6 ohms | 8 ohms nominal, 3.3 ohms minimum (measured, Erin’s Audio Corner) |
| Dimensions | 11.3"H x 6.8"W x 7.4"D (285.8 x 171.5 x 188.9 mm) | 13.6"H x 6.8"W x 10.6"D (344.4 x 173 x 270.5 mm) |
| Bass Extension (-3dB) | 71Hz (measured, Erin’s Audio Corner) | 67Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-10dB) | 53Hz (measured, Erin’s Audio Corner) | 53Hz (measured, Erin’s Audio Corner) |
| Crossover Frequency | - | 1530Hz |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- ELAC Uni-Fi 2.0 UB52 vs Polk T15
- ELAC Uni-Fi 2.0 UB52 vs Micca RB42
- ELAC Uni-Fi 2.0 UB52 vs JBL Control 1 Pro
- Klipsch RP-500M II vs Boston Acoustics A25
- JBL Studio 530 vs JBL Stage A120
Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
JBL Stage A120: $299 Discontinued eBay
Pros: Comes with a port bung, letting you experiment between ported and sealed configurations - the reviewer found the sound improved somewhat with the port sealed. Distortion at 96dB is broadly comparable to competitors in this price range outside of some elevated low-end THD. Wide horizontal radiation pattern for a compact bookshelf speaker in the low-to-midrange.
Cons: A pronounced “Batman”-shaped frequency response: boosted bass, a scooped midrange, and elevated treble (about 3-4dB above the midrange), driven partly by confirmed cabinet panel resonance around 800Hz-1.7kHz. Directivity shows significant back-to-back peaks and dips, making the speaker harder to correct with EQ since the off-axis sound doesn’t track the direct sound cleanly. Elevated treble that some might call “detailed” reads as an unwelcome boost to the reviewer rather than genuine resolution. Compression testing shows the low end degrading substantially at high output (102dB). Overall considered one of the weaker speakers the reviewer has tested in this class, with a competing model (Emotiva Airmotiv B1+) recommended instead at a similar price. Discontinued.
Full JBL Stage A120 review and specifications →
| Bass Extension (-10dB) | 53Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 71Hz (measured, Erin's Audio Corner) |
| Dimensions | 11.3"H x 6.8"W x 7.4"D (285.8 x 171.5 x 188.9 mm) |
| Discontinued | Yes |
| Drivers | 0.75" tweeter + 5" woofer |
| Impedance | 6 ohms |
| Sensitivity | 83dB (measured, Erin's Audio Corner) |
| Weight | 10.6 lbs / 4.8 kg |
| Woofer Cabinet | ported |
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- JBL Stage A120 vs Parts Express Copperhead Desktop Kit
- JBL Stage A120 vs ELAC Uni-Fi 2.0 UB52
- JBL Stage A120 vs KEF Q100
- JBL Stage A120 vs JBL L52 Classic
- JBL Stage A120 vs Q Acoustics 3020i
- JBL Stage A120 vs Pioneer SP-BS22-LR (Philharmonic AAM Mod)
- JBL Stage A120 vs Dynaudio X14
- JBL Stage A120 vs Micca RB42
- See all 27 comparisons
Klipsch RP-500M II: $389.99 Amazon eBay
Pros: Major mid-range clarity improvement over the original RP-500M: about a 5dB fill-in between 1-3kHz in the estimated in-room response, giving a noticeably more resolved, detailed midrange. More neutral and linear overall than its sibling RP-600M II, which carries about 2-3dB more high-frequency energy and a touch more bass but less overall balance. Very precise soundstage imaging and instrument placement. Distortion through the midrange is cleaner than the previous generation.
Cons: Klipsch’s quoted sensitivity (around 92-93dB) uses an unconventional in-room-based rating rather than the standard anechoic measurement; on an anechoic basis it measures closer to about 85dB, in line with typical bookshelf speakers this size, so it isn’t the outlier in efficiency the spec sheet implies. Horizontal dispersion of about ±40-50° is narrower and more directive than the reviewer’s preference for a wider, more enveloping soundstage. Toeing the speaker out to widen the soundstage or soften on-axis brightness comes at some cost to imaging precision. Slightly less clean in the tweeter region than the midrange, likely tied to crossover placement, though not considered a dealbreaker. Low-frequency output is limited - measured around 95dB at 4 meters for the pair before the woofers started to unload, so a subwoofer is recommended for anyone wanting real bass rather than stepping up to a larger model.
Full Klipsch RP-500M II review and specifications →
| Bass Extension (-10dB) | 53Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 67Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 1530Hz |
| Dimensions | 13.6"H x 6.8"W x 10.6"D (344.4 x 173 x 270.5 mm) |
| Drivers | 5.25" Cerametallic™ cone woofer with Faraday rings, 1" LTS Titanium diaphragm tweeter with Hybrid Cross-Section Expanded Tractrix® horn |
| Impedance | 8 ohms nominal, 3.3 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 85dB (measured, Erin's Audio Corner) |
| Weight | 13 lbs / 5.9 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Klipsch RP-500M II vs Wharfedale Super Denton
- Klipsch RP-500M II vs Wharfedale Diamond 12.1
- Klipsch RP-500M II vs Monitor Audio Silver 50 7G
- Klipsch RP-500M II vs Radiant Acoustics Clarity 4.2
- Klipsch RP-500M II vs Revel M105
- Klipsch RP-500M II vs Moondrop M4P MTM
- Klipsch RP-500M II vs KEF Q150
- Klipsch RP-500M II vs Arendal 1961 Monitor
- See all 28 comparisons