Short answer: the IK Multimedia iLoud MTM MKII. It ranks #20 of 64 powered bookshelf speakers by sound quality at $799.99; the Reflector Audio Square Two ranks #26 and costs $6499, so there is not much of a tradeoff to weigh.
What the IK Multimedia iLoud MTM MKII offers: Compact MTM layout (two 3.5” midwoofers flanking a 1” tweeter) powered monitor rated at 100W per speaker with XLR input, sold as a pair with an ARC room-correction microphone included. Well-suited to nearfield desktop use, with linearity good enough for mixing or mastering. The bundled auto room-correction mic is genuinely effective - in testing it resolved specific room resonance peaks around 150Hz and 220Hz, making the midrange sound noticeably more lifelike. Back-panel switches allow desktop vs. free-field placement plus treble and bass trim. Harmonic distortion is good at a moderate 86dB output, appropriate for a speaker of this size. Watch for: Native treble tuning still runs about 3dB hot on-axis; the back-panel -3dB treble switch overcorrects, and roughly -1.5dB via external EQ works better. Vertical MTM lobing means staying within about 20-25° of the tweeter axis, or the upper-midrange to treble transition suffers significant suckout - the speaker should never be laid on its side unless the tweeter is pointed directly at the listener, or comb filtering results. Bass falls off sharply below its F3 of 51Hz (F10 45Hz), so a subwoofer is needed for anything lower. Multitone distortion rises sharply at 96dB/1m, and the reviewer recommends not exceeding about 86dB for extended listening at any distance - broadband output for the pair tops out around 94dB at 1 meter, with dynamic range essentially collapsing approaching 102dB. Horizontal directivity narrows with frequency rather than staying constant. Adding a subwoofer with an 80Hz crossover doesn’t meaningfully improve the distortion headroom, even though it does extend the low end.
What the Reflector Audio Square Two offers: An exceptionally flat on-axis deviation of just 0.10dB from a coaxial horn design (four 5” woofers around a compression-driver tweeter) giving nominal 60x60 degree directivity from a compact 32cm cube, with a well-damped bass-alignment Q of 1.31. Sound on Sound’s review praised its detailed, neutral sound that stays phase-coherent with no appreciable latency. Watch for: A directivity-index standard deviation of 4.90, well above the 3-4 range typical of most monitors this size, reflects the narrow, symmetric horn pattern that Sound on Sound and ASR forum members flagged as double-edged, helpful in some rooms but limiting the sweet spot in others. Predicted in-room smoothness (0.49) is only middling, not matching the excellent on-axis figure. It’s a low-volume Latvian product with no published warranty term found anywhere.
Buy the IK Multimedia iLoud MTM MKII. It ranks higher for sound quality than the Reflector Audio Square Two and costs less, so there is no real case for the other one.
Specifications Side By Side
| IK Multimedia iLoud MTM MKII | Reflector Audio Square Two | |
|---|---|---|
| Price | $799.99 | $6,499/pair |
| Ranked | #20 of 64 in Medium Size Powered Bookshelf Speakers | #26 of 64 in Medium Size Powered Bookshelf Speakers |
| Dimensions | 10.4"H x 5.1"W x 6.3"D (264.2 x 129.5 x 160 mm) | 12.6"W x 13.6"H x 12.8"D (320 x 345 x 325 mm) |
| Frequency Response | 48 Hz - 28 kHz (±2dB) (Manufacturer specified) | 40Hz-26kHz (-6dB) |
| Bass Extension (-3dB) | 52.7Hz (measured, Erin’s Audio Corner) | - |
| Bass Extension (-10dB) | 46.3Hz (measured, Erin’s Audio Corner) | - |
| Inputs | XLR | Analogue XLR/RCA, AES digital XLR, S/PDIF, TOSLINK optical |
| Drivers | 2x 3.5" (89mm) woofers, 1" silk dome tweeter | 4x 5" woofers, 1x horn-loaded compression driver (ring diaphragm) |
| App | Yes (X-MONITOR speaker emulation) | - |
| Bluetooth | No | - |
| EQ | Yes (Room adjustment) | - |
| Output Power | 100w Per Speaker | - |
| Weight | 5.5 lbs / 2.5 kg (5.5 lbs) each | 42.8 lbs / 19.4 kg (42.8 lbs) each |
| Max SPL | 112.5dB peak | 118dB @ 1m (EIA-426B, single monitor) |
| Enclosure | - | 2-way active coaxial horn monitor, bass-reflex (convertible to sealed) |
| Power Output | - | 250W to woofers, 100W to compression driver (Hypex Class-D) |
| Country | - | Made in Latvia |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- IK Multimedia iLoud MTM vs Genelec 8331A
- KEF LSX II LT vs Genelec 8331A
- Presonus Eris E5 XT vs Genelec 8331A
- Edifier S2000MKIII vs Reflector Audio Square Two
- Neumann KH80 DSP vs Reflector Audio Square Two
Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
IK Multimedia iLoud MTM MKII: $799.99 Amazon eBay
Pros: Compact MTM layout (two 3.5” midwoofers flanking a 1” tweeter) powered monitor rated at 100W per speaker with XLR input, sold as a pair with an ARC room-correction microphone included. Well-suited to nearfield desktop use, with linearity good enough for mixing or mastering. The bundled auto room-correction mic is genuinely effective - in testing it resolved specific room resonance peaks around 150Hz and 220Hz, making the midrange sound noticeably more lifelike. Back-panel switches allow desktop vs. free-field placement plus treble and bass trim. Harmonic distortion is good at a moderate 86dB output, appropriate for a speaker of this size.
Cons: Native treble tuning still runs about 3dB hot on-axis; the back-panel -3dB treble switch overcorrects, and roughly -1.5dB via external EQ works better. Vertical MTM lobing means staying within about 20-25° of the tweeter axis, or the upper-midrange to treble transition suffers significant suckout - the speaker should never be laid on its side unless the tweeter is pointed directly at the listener, or comb filtering results. Bass falls off sharply below its F3 of 51Hz (F10 45Hz), so a subwoofer is needed for anything lower. Multitone distortion rises sharply at 96dB/1m, and the reviewer recommends not exceeding about 86dB for extended listening at any distance - broadband output for the pair tops out around 94dB at 1 meter, with dynamic range essentially collapsing approaching 102dB. Horizontal directivity narrows with frequency rather than staying constant. Adding a subwoofer with an 80Hz crossover doesn’t meaningfully improve the distortion headroom, even though it does extend the low end.
Full IK Multimedia iLoud MTM MKII review and specifications →
| App | Yes (X-MONITOR speaker emulation) |
|---|---|
| Bass Extension (-10dB) | 46.3Hz (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 52.7Hz (measured, Erin's Audio Corner) |
| Bluetooth | No |
| Dimensions | 10.4"H x 5.1"W x 6.3"D (264.2 x 129.5 x 160 mm) |
| Drivers | 2x 3.5" (89mm) woofers, 1" silk dome tweeter |
| EQ | Yes (Room adjustment) |
| Frequency Response | 48 Hz - 28 kHz (±2dB) (Manufacturer specified) |
| Inputs | XLR |
| Max SPL | 112.5dB peak |
| Output Power | 100w Per Speaker |
| Weight | 5.5 lbs / 2.5 kg (5.5 lbs) each |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- IK Multimedia iLoud MTM MKII vs IK Multimedia iLoud MTM
- IK Multimedia iLoud MTM MKII vs Presonus Eris E5 XT
- IK Multimedia iLoud MTM MKII vs KRK Rokit 5 G4
- IK Multimedia iLoud MTM MKII vs JBL 705P
- IK Multimedia iLoud MTM MKII vs Airpulse A100
- IK Multimedia iLoud MTM MKII vs HEDD Type 05 A-CORE
- IK Multimedia iLoud MTM MKII vs KEF LS50 Wireless II
- IK Multimedia iLoud MTM MKII vs Sigberg Audio SBS Gen 2
- See all 62 comparisons
Reflector Audio Square Two: $6,499/pair Monheim Microphones eBay
Pros: An exceptionally flat on-axis deviation of just 0.10dB from a coaxial horn design (four 5” woofers around a compression-driver tweeter) giving nominal 60x60 degree directivity from a compact 32cm cube, with a well-damped bass-alignment Q of 1.31. Sound on Sound’s review praised its detailed, neutral sound that stays phase-coherent with no appreciable latency.
Cons: A directivity-index standard deviation of 4.90, well above the 3-4 range typical of most monitors this size, reflects the narrow, symmetric horn pattern that Sound on Sound and ASR forum members flagged as double-edged, helpful in some rooms but limiting the sweet spot in others. Predicted in-room smoothness (0.49) is only middling, not matching the excellent on-axis figure. It’s a low-volume Latvian product with no published warranty term found anywhere.
Full Reflector Audio Square Two review and specifications →
| Country | Made in Latvia |
|---|---|
| Dimensions | 12.6"W x 13.6"H x 12.8"D (320 x 345 x 325 mm) |
| Drivers | 4x 5" woofers, 1x horn-loaded compression driver (ring diaphragm) |
| Enclosure | 2-way active coaxial horn monitor, bass-reflex (convertible to sealed) |
| Frequency Response | 40Hz-26kHz (-6dB) |
| Inputs | Analogue XLR/RCA, AES digital XLR, S/PDIF, TOSLINK optical |
| Max SPL | 118dB @ 1m (EIA-426B, single monitor) |
| Power Output | 250W to woofers, 100W to compression driver (Hypex Class-D) |
| Weight | 42.8 lbs / 19.4 kg (42.8 lbs) each |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Reflector Audio Square Two vs KEF LSX II LT
- Reflector Audio Square Two vs Edifier S2000MKIII
- Reflector Audio Square Two vs KRK Classic 5
- Reflector Audio Square Two vs Edifier R1280DB
- Reflector Audio Square Two vs Kali Audio IN-5
- Reflector Audio Square Two vs Yamaha HS5
- Reflector Audio Square Two vs Adam Audio T5V
- Reflector Audio Square Two vs JBL 305P MKII
- See all 10 comparisons