Short answer: the Genelec 8361A for better sound quality, the Focal Twin6 Be for the lower price. The Genelec 8361A ranks #5 of 61 powered bookshelf speakers at $10900. The Focal Twin6 Be ranks #38 at $2200, $8700 cheaper.
What the Focal Twin6 Be offers: High-output 2.5-way studio monitor with an inverted beryllium tweeter and two 6.5-inch W-composite drivers, one covering bass/midrange and the other reinforcing only 40-150Hz. Erin measured excellent harmonic distortion at both 86 and 96dB, essentially quarter-decibel dynamic compression and clean subjective output around 95dB. Mirror-configurable driver orientation, front ports, shelving/notch controls and switchable +4dBu/-10dBV input sensitivity support professional installation. Watch for: The response and directivity are not as uniformly neutral as newer waveguided three-way monitors, and Erin suspected intermodulation-related roughness even though conventional harmonic distortion was low. The amplifier plate becomes notably warm after extended operation. Hiss is more audible in -10dBV mode, and safe output can be deceptive because the speaker gives little audible warning before excessive exposure. The active design has no passive impedance or sensitivity figure; low-bass extension should be augmented for full-range mastering.
What the Genelec 8361A offers: Three-way coaxial design: 5” mid-range with an inset 1” metal dome tweeter, flanked symmetrically above and below by two 10” front-loaded woofers, giving nearly identical vertical response whether you’re sitting or standing. Wide, consistent horizontal radiation of about ±60°, very forgiving for multiple seats or a home-theater row. Distortion at both 86dB and 96dB/1m stays below roughly 1%, and multitone distortion is also under about 1% - among the cleanest speakers reviewed. Long-term compression is practically non-existent, with no woofer bottoming or audible intermodulation even driven to 90dB+ at 10 feet. In-room bass extension reaches down to about 35Hz without a subwoofer. Extensive back-panel tuning (bass rolloff, bass profile, treble profile, and a desk/console compensation switch) for boundary placement. Watch for: Approximately $11,000 per pair; Genelec’s GLM room-correction add-on (measurement mic plus software) is another ~$450 and wasn’t used in this review. Shows an on-axis dip around 200Hz that may be tied to some rear-panel radiation or resonance the reviewer couldn’t fully explain. In far-field listening there’s a mild upper-midrange/lower-treble rise (roughly 2-3kHz) that only smooths out with 5-10° of toe-out or closer near-field placement. Short-term compression testing shows some tweeter limiting, though it didn’t translate to audible issues in real-world listening. At about 70 lbs, awkward to lift onto a stand alone.
Buy the Focal Twin6 Be if the price matters more than sound quality. Buy the Genelec 8361A if sound quality matters more than the price.
Specifications Side By Side
| Focal Twin6 Be | Genelec 8361A | |
|---|---|---|
| Price | $2,200 each | $10900 |
| Ranked | #38 of 61 in Large Size Powered Bookshelf Speakers | #5 of 61 in Large Size Powered Bookshelf Speakers |
| Bass Extension | 40Hz manufacturer specified; Erin measured strong low-frequency linearity | - |
| Bass Extension (-3dB) | 48.3Hz (measured, Erin’s Audio Corner) | 34Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-10dB) | 39.1Hz (measured, Erin’s Audio Corner) | 29Hz (measured, Erin’s Audio Corner) |
| Sensitivity | Not applicable (active studio monitor) | - |
| Drivers | 1" inverted beryllium tweeter; dual 6.5" W-cone drivers | Dual 263 x 137 mm woofers, 5.1" coaxial with tweeter midrange, 1" (25mm) coaxial tweeter |
| Amplification | 150W LF + 100W LF/MF + 100W HF | - |
| Inputs | Balanced XLR with +4dBu/-10dBV sensitivity | XLR |
| Dimensions | - | 22.5"H x 14"W x 13.6"D (571.5 x 355.6 x 345.4 mm) |
| Weight | - | 70.3 lbs / 31.9 kg each |
| App | - | Yes (GLM) |
| Bluetooth | - | No |
| DSP | - | Yes |
| EQ | - | Yes (via GLM software) |
| Frequency Response | - | 30Hz - 43kHz (±2dB) (Manufacturer specified) |
| Max SPL | - | 118dB @ 1m |
| Output Power | - | 1000w Per Speaker |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Genelec 8351B vs JBL 708P
- Genelec 8050B vs Genelec 8351B
- Neumann KH420 vs Genelec 8040B
- Genelec 8361A vs JBL 4305P
- Genelec 8361A vs Genelec 8040B
Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Focal Twin6 Be: $2,200 each Amazon eBay
Pros: High-output 2.5-way studio monitor with an inverted beryllium tweeter and two 6.5-inch W-composite drivers, one covering bass/midrange and the other reinforcing only 40-150Hz. Erin measured excellent harmonic distortion at both 86 and 96dB, essentially quarter-decibel dynamic compression and clean subjective output around 95dB. Mirror-configurable driver orientation, front ports, shelving/notch controls and switchable +4dBu/-10dBV input sensitivity support professional installation.
Cons: The response and directivity are not as uniformly neutral as newer waveguided three-way monitors, and Erin suspected intermodulation-related roughness even though conventional harmonic distortion was low. The amplifier plate becomes notably warm after extended operation. Hiss is more audible in -10dBV mode, and safe output can be deceptive because the speaker gives little audible warning before excessive exposure. The active design has no passive impedance or sensitivity figure; low-bass extension should be augmented for full-range mastering.
Full Focal Twin6 Be review and specifications →
| Amplification | 150W LF + 100W LF/MF + 100W HF |
|---|---|
| Bass Extension | 40Hz manufacturer specified; Erin measured strong low-frequency linearity |
| Bass Extension (-10dB) | 39.1Hz (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 48.3Hz (measured, Erin's Audio Corner) |
| Drivers | 1" inverted beryllium tweeter; dual 6.5" W-cone drivers |
| Inputs | Balanced XLR with +4dBu/-10dBV sensitivity |
| Sensitivity | Not applicable (active studio monitor) |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
Genelec 8361A: $10900 Bhphotovideo eBay
Pros: Three-way coaxial design: 5” mid-range with an inset 1” metal dome tweeter, flanked symmetrically above and below by two 10” front-loaded woofers, giving nearly identical vertical response whether you’re sitting or standing. Wide, consistent horizontal radiation of about ±60°, very forgiving for multiple seats or a home-theater row. Distortion at both 86dB and 96dB/1m stays below roughly 1%, and multitone distortion is also under about 1% - among the cleanest speakers reviewed. Long-term compression is practically non-existent, with no woofer bottoming or audible intermodulation even driven to 90dB+ at 10 feet. In-room bass extension reaches down to about 35Hz without a subwoofer. Extensive back-panel tuning (bass rolloff, bass profile, treble profile, and a desk/console compensation switch) for boundary placement.
Cons: Approximately $11,000 per pair; Genelec’s GLM room-correction add-on (measurement mic plus software) is another ~$450 and wasn’t used in this review. Shows an on-axis dip around 200Hz that may be tied to some rear-panel radiation or resonance the reviewer couldn’t fully explain. In far-field listening there’s a mild upper-midrange/lower-treble rise (roughly 2-3kHz) that only smooths out with 5-10° of toe-out or closer near-field placement. Short-term compression testing shows some tweeter limiting, though it didn’t translate to audible issues in real-world listening. At about 70 lbs, awkward to lift onto a stand alone.
Full Genelec 8361A review and specifications →
| App | Yes (GLM) |
|---|---|
| Bass Extension (-10dB) | 29Hz (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 34Hz (measured, Erin's Audio Corner) |
| Bluetooth | No |
| DSP | Yes |
| Dimensions | 22.5"H x 14"W x 13.6"D (571.5 x 355.6 x 345.4 mm) |
| Drivers | Dual 263 x 137 mm woofers, 5.1" coaxial with tweeter midrange, 1" (25mm) coaxial tweeter |
| EQ | Yes (via GLM software) |
| Frequency Response | 30Hz - 43kHz (±2dB) (Manufacturer specified) |
| Inputs | XLR |
| Max SPL | 118dB @ 1m |
| Output Power | 1000w Per Speaker |
| Weight | 70.3 lbs / 31.9 kg each |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons