Short answer: the Dynaudio Heritage Special if sound quality matters most, the ELAC Debut 2.0 B6.2 if price matters most. The Dynaudio Heritage Special ranks #28 of 130 bookshelf speakers at $7000. The ELAC Debut 2.0 B6.2 ranks #87 at $329, $6671 cheaper.
What the ELAC Debut 2.0 B6.2 offers: Reasonably flat on-axis and listening-window response with reasonably even horizontal directivity, holding about ±60° up to roughly 8kHz for consistent stereo width whether aimed directly at the listener or toed out. Its larger-than-typical woofer lets it play very loud with minimal distortion, staying under about 1% THD down to 50Hz at 86dB, and minimum impedance stays a comfortable 5-6 ohms. In-room bass extension reaches about 50Hz without much trouble, enough for a solid kick-drum sound. Takes equalization very well - correcting the on-axis response doesn’t cost sensitivity through the midrange, and the underlying directivity behavior (diffraction, vertical mismatch) is mild enough that EQ alone gets most of the way to a well-balanced sound. Vertical tolerance is asymmetric and fairly forgiving: about 10° above the tweeter axis and 20° below it before tonal balance meaningfully shifts. One reviewer called it “a good speaker” with “a good price” rather than just good-for-the-price, and found it fairly neutral overall in-room. Watch for: A good size resonant peak around 700Hz stands out from an otherwise smooth response and lingers in cumulative spectral decay (waterfall) measurements - in one reviewer’s sighted A/B test, reducing it by about 5dB via EQ made a noticeable but not dramatic difference. Directivity error shows up around 3.3kHz, and the upper-midrange around 4-6kHz stood out as edgy and sharp, almost sibilant at times, in casual listening - the predicted in-room response shows a lack of energy between 1-2kHz and a bit too much above that, which one reviewer thought would sound bright. Distortion at 96dB SPL/1m shows two harmonic peaks the reviewer says “should not be there,” one from woofer breakup around 400Hz and another around 7-8kHz from the tweeter, and multitone distortion approaches 10% in the 500-800Hz range at that output level. Real compression shows up even at moderate volume and worsens at 96dB and above, with the woofer clearly giving up around 60-70Hz - a subwoofer is recommended for anyone wanting to listen loud, since running it full-range at high output costs real dynamic range in the midbass and bass. Don’t place it close to a wall - boundary reinforcement adds a midbass bump that undoes the otherwise smooth, linear response. Getting the best out of it takes EQ (taming the 700Hz peak, filling in the 1-2kHz dip, and trimming the highs).
What the Dynaudio Heritage Special offers: One of the rare cases where the reviewer measured a speaker as flawed but still genuinely enjoyed listening to it. A massive 4” voice coil on the midwoofer gives it exceptional output capability for a bookshelf speaker - averaged 100dB at 3.5 meters with no audible mechanical noise, port chuffing, or woofer bottoming even when deliberately pushed hard. Bass is very robust and doesn’t noticeably give up output as volume increases, staying solid at both low and high listening levels. Big, well-proportioned soundstage - wide without losing image focus. Limited run of 2,500 pairs with genuine collectible/heritage value; the tweeter (Esotar 3) and midwoofer both use premium Dynaudio-made drivers with an unusually wide, stout voice coil. Watch for: At lower listening volumes, dynamic range and kick-drum punch fell short of higher-sensitivity speakers the reviewer has tested (JBL 4367, KEF Reference 1 Meta) - the sheer output ceiling is impressive, but it isn’t a highly dynamic-sounding speaker at modest levels. A degree of “softness” in the upper mid-range. Selective sibilance in the 4-6kHz treble region that shows up on some tracks but not others, which the reviewer found mildly aggravating and would want to EQ down given the choice. Neither the tweeter nor the woofer is fully flush-mounted to the baffle, likely intentional as part of the heritage-styled look, but the reviewer wonders how much this affected linearity. At $7,000/pair MSRP (and a discontinued limited run, so used/open-box pricing around $5,000/pair is about the best you’ll do now), this is a serious investment for a bookshelf speaker.
Buy the ELAC Debut 2.0 B6.2 when the price outweighs sound quality for you, and the Dynaudio Heritage Special when sound quality outweighs the price instead.
Want more options? Browse the full Passive Home rankings.
Specifications Side By Side
| ELAC Debut 2.0 B6.2 | Dynaudio Heritage Special | |
|---|---|---|
| Price | $329.00 per pair | $7,000 per pair |
| Ranked | #87 of 130 in Large Size Bookshelf Speakers | #28 of 130 in Large Size Bookshelf Speakers |
| Bass Extension (-10dB) | 40Hz (measured, Erin's Audio Corner) | 38Hz (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 64Hz (measured, Erin's Audio Corner) | 52Hz (measured, Erin's Audio Corner) |
| Impedance | 6 ohms nominal, 5.2 ohms minimum (measured, Erin's Audio Corner) | 5.1 ohms minimum, ported mode (measured, Erin's Audio Corner) |
| Sensitivity | 86.5dB (measured, Audio Science Review) | 85dB (measured at 2.83V/1m, Erin's Audio Corner) |
| Drivers | 25mm tweeter + 165mm woofer | 18cm MSP cone woofer, 28mm Esotar 3 dome tweeter |
| Weight | 29.1 lbs (13.2 kg) | 24.3 lbs (11 kg) each |
| Dimensions | 14.8"H x 7.7"W x 10.6"D (375.0 x 195.0 x 268.0 mm) | 15.2"H x 8.2"W x 12.6"D (385 x 208 x 320 mm) |
| Woofer Cabinet | ported, front | - |
| Discontinued | - | Yes (limited run of 2,500 pairs) |
| Country | - | Denmark |
| Spinorama Preference Score | - | 3.43 |
| Spinorama Preference Score with Perfect Sub | - | 5.44 |
Related Speaker Comparisons
More worthwhile head-to-heads for Dynaudio Heritage Special:
- Perlisten S4b vs Dynaudio Heritage Special
- KEF Reference 1 Meta vs Dynaudio Heritage Special
- Dynaudio Heritage Special vs GR-Research NX-Studio
- AsciLab C6B vs Dynaudio Heritage Special
- Audio First Cadentia 3 vs Dynaudio Heritage Special
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
ELAC Debut 2.0 B6.2: $329.00 per pair Amazon Crutchfield eBay
Pros: Reasonably flat on-axis and listening-window response with reasonably even horizontal directivity, holding about ±60° up to roughly 8kHz for consistent stereo width whether aimed directly at the listener or toed out. Its larger-than-typical woofer lets it play very loud with minimal distortion, staying under about 1% THD down to 50Hz at 86dB, and minimum impedance stays a comfortable 5-6 ohms. In-room bass extension reaches about 50Hz without much trouble, enough for a solid kick-drum sound. Takes equalization very well - correcting the on-axis response doesn’t cost sensitivity through the midrange, and the underlying directivity behavior (diffraction, vertical mismatch) is mild enough that EQ alone gets most of the way to a well-balanced sound. Vertical tolerance is asymmetric and fairly forgiving: about 10° above the tweeter axis and 20° below it before tonal balance meaningfully shifts. One reviewer called it “a good speaker” with “a good price” rather than just good-for-the-price, and found it fairly neutral overall in-room. Measured bass extension of 64Hz (-3dB), with a measured sensitivity of 86.5dB.
Cons: A good size resonant peak around 700Hz stands out from an otherwise smooth response and lingers in cumulative spectral decay (waterfall) measurements - in one reviewer’s sighted A/B test, reducing it by about 5dB via EQ made a noticeable but not dramatic difference. Directivity error shows up around 3.3kHz, and the upper-midrange around 4-6kHz stood out as edgy and sharp, almost sibilant at times, in casual listening - the predicted in-room response shows a lack of energy between 1-2kHz and a bit too much above that, which one reviewer thought would sound bright. Distortion at 96dB SPL/1m shows two harmonic peaks the reviewer says “should not be there,” one from woofer breakup around 400Hz and another around 7-8kHz from the tweeter, and multitone distortion approaches 10% in the 500-800Hz range at that output level. Real compression shows up even at moderate volume and worsens at 96dB and above, with the woofer clearly giving up around 60-70Hz - a subwoofer is recommended for anyone wanting to listen loud, since running it full-range at high output costs real dynamic range in the midbass and bass. Don’t place it close to a wall - boundary reinforcement adds a midbass bump that undoes the otherwise smooth, linear response. Getting the best out of it takes EQ (taming the 700Hz peak, filling in the 1-2kHz dip, and trimming the highs).
Full ELAC Debut 2.0 B6.2 review and specifications →
| Bass Extension (-10dB) | 40Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 64Hz (measured, Erin's Audio Corner) |
| Dimensions | 14.8"H x 7.7"W x 10.6"D (375.0 x 195.0 x 268.0 mm) |
| Drivers | 25mm tweeter + 165mm woofer |
| Impedance | 6 ohms nominal, 5.2 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 86.5dB (measured, Audio Science Review) |
| Weight | 29.1 lbs (13.2 kg) |
| Woofer Cabinet | ported, front |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- ELAC Debut 2.0 B6.2 vs SVS Prime Bookshelf
- ELAC Debut 2.0 B6.2 vs Dynaudio Special Forty
- ELAC Debut 2.0 B6.2 vs KEF Q3 Meta
- ELAC Debut 2.0 B6.2 vs Polk Monitor XT20
- ELAC Debut 2.0 B6.2 vs Infinity IL10
- ELAC Debut 2.0 B6.2 vs GR-Research X-LS Encore
- ELAC Debut 2.0 B6.2 vs Sonus Faber Lumina II
- ELAC Debut 2.0 B6.2 vs XTZ Spirit 4
- See all 59 comparisons
Dynaudio Heritage Special: $7,000 per pair Safe and Sound HQ eBay
Pros: One of the rare cases where the reviewer measured a speaker as flawed but still genuinely enjoyed listening to it. A massive 4” voice coil on the midwoofer gives it exceptional output capability for a bookshelf speaker - averaged 100dB at 3.5 meters with no audible mechanical noise, port chuffing, or woofer bottoming even when deliberately pushed hard. Bass is very robust and doesn’t noticeably give up output as volume increases, staying solid at both low and high listening levels. Big, well-proportioned soundstage - wide without losing image focus. Limited run of 2,500 pairs with genuine collectible/heritage value; the tweeter (Esotar 3) and midwoofer both use premium Dynaudio-made drivers with an unusually wide, stout voice coil. Measured bass extension of 52Hz (-3dB), with a measured sensitivity of 85dB.
Cons: At lower listening volumes, dynamic range and kick-drum punch fell short of higher-sensitivity speakers the reviewer has tested (JBL 4367, KEF Reference 1 Meta) - the sheer output ceiling is impressive, but it isn’t a highly dynamic-sounding speaker at modest levels. A degree of “softness” in the upper mid-range. Selective sibilance in the 4-6kHz treble region that shows up on some tracks but not others, which the reviewer found mildly aggravating and would want to EQ down given the choice. Neither the tweeter nor the woofer is fully flush-mounted to the baffle, likely intentional as part of the heritage-styled look, but the reviewer wonders how much this affected linearity. At $7,000/pair MSRP (and a discontinued limited run, so used/open-box pricing around $5,000/pair is about the best you’ll do now), this is a serious investment for a bookshelf speaker.
Full Dynaudio Heritage Special review and specifications →
| Bass Extension (-10dB) | 38Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 52Hz (measured, Erin's Audio Corner) |
| Country | Denmark |
| Dimensions | 15.2"H x 8.2"W x 12.6"D (385 x 208 x 320 mm) |
| Discontinued | Yes (limited run of 2,500 pairs) |
| Drivers | 18cm MSP cone woofer, 28mm Esotar 3 dome tweeter |
| Impedance | 5.1 ohms minimum, ported mode (measured, Erin's Audio Corner) |
| Sensitivity | 85dB (measured at 2.83V/1m, Erin's Audio Corner) |
| Spinorama Preference Score | 3.43 |
| Spinorama Preference Score with Perfect Sub | 5.44 |
| Weight | 24.3 lbs (11 kg) each |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Dynaudio Heritage Special vs Radiant Acoustics Clarity 6.2
- Dynaudio Heritage Special vs MoFi SourcePoint 10
- Dynaudio Heritage Special vs Wharfedale Linton 85
- Dynaudio Heritage Special vs Wharfedale Super Linton
- Dynaudio Heritage Special vs Ascend Acoustics Sierra-LX
- Dynaudio Heritage Special vs Ascend Acoustics CMT-340 SE2
- Dynaudio Heritage Special vs Arendal 1528 Monitor 8
- Dynaudio Heritage Special vs Revel M126Be
- See all 47 comparisons